Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Detecting squeezed light

Svante Fridström, Axel von Malmborg

Published Jan 1, 2026• 0 citations
OpenAlex

Abstract

Squeezed light is a non-classical state of light in which the uncertainty in the electricfield strength at certain phases of oscillation is reduced below the vacuum noise level,at the cost of increased uncertainty at other phases. It has applications ranging fromgravitational wave detection to quantum communication, where the bandwidth of thesqueezed states directly limits protocol speed. Squeezed light is commonly measured us-ing balanced homodyne detection, in which the attainable squeezing level is restrictedby the photodetector’s quantum efficiency and dark noise. Currently, no commerciallyavailable photodetector combines high quantum efficiency with low dark noise over alarge bandwidth. This thesis presents the design and construction of a photodetectorintended to address this gap, with the aim of achieving high quantum efficiency and suf-ficient dark noise clearance over at least 1 GHz of bandwidth. The design was guidedby LTspice simulations and implemented on a two-layer printed circuit board. Twocommercially available reference detectors were characterised, illustrating the trade-offbetween high quantum efficiency and large bandwidth. Since the photodiodes for thenew detector had not arrived at the time of completion, its characterisation remains tobe carried out.

Related papers

High efficiency photodetection below the quantum noise limit

Elizabeth Caryn Bullard

Two low-noise, high quantum efficiency, high bandwidth photodetectors have constructed to form a balanced homodyne detector to detect squeezed light. The detectors have quantum efficiencies of 85% and 90%, a bandwidth of 1MHz, and a dark noise of ... at 1MHz.

•Jan 1, 2005•0 citations

Die-Level Balanced Homodyne Receiver for Squeezed Light Detection in the GHz Regime

Emmily Zaiser, Alessandro Trenti, Dinka Milovančev +3 more

Quantum receiver scalability and cost-effectiveness are crucial in the evolving quantum landscape. Application based on squeezed light (e.g. high-precision measurements and quantum communication), can profit especially from integrated and low-noise detectors. The presented die-level receiver is shown in figure 1 a) and combines a novel custom transimpedance amplifier (TIA) with commercial photodiodes (PDs) [1]. This offers a more scalable solution than bulk balanced homodyne detectors (BHDs) while being low-cost compared to fully customized receivers. This design targets a high bandwidth operation while maintaining low-noise properties for the detection of weak quantum signals. To characterize this receiver, we evaluate its performance through measurements of clearance, and common-mode rejection ratio (CMRR). Based on these parameters, a simulation for its performance in the squeezed light detection measurement is presented.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 23, 2025•1 citation

A highly efficient photodetector for squeezed light measurement in the gigahertz range

D. M. Wilken, J. Junker, M. Heurs

Squeezed light plays a crucial role in state-of-the-art quantum metrology and quantum information experiments. There is significant interest in utilizing squeezed states at high MHz and GHz frequencies. However, past efforts to build suitable photodetectors at these frequencies have yet to yield the required high quantum efficiency. Here, we present the development of a high-frequency balanced photodetector with near-unity quantum efficiency, realized with off-the-shelf components. The detector operates in balanced mode up to approximately 500 MHz, above which the differential frequency response limits its performance. To obtain high sensitivity above 500 MHz, the detector can be efficiently used in an unbalanced homodyne detection scheme. We employ our detector in this unbalanced mode to measure a squeezing comb up to 6.4 GHz, achieving a squeezing level of up to 10.7 dB. By sharing our experience, specifically in identifying the unequal frequency response as a limiting factor, we aim to enable and advance further developments in the field.

Applied Physics Letters•Oct 6, 2025•1 citation

A highly efficient photodetector for squeezed light measurement in the gigahertz range

Dennis Wilken, J. Junker, M. Heurs

Squeezed light plays a crucial role in state-of-the-art quantum metrology and quantum information experiments. There is significant interest in utilizing squeezed states at high MHz and GHz frequencies. However, past efforts to build suitable photodetectors at these frequencies have yet to yield the required high quantum efficiency. Here, we present the development of a high-frequency balanced photodetector with near-unity quantum efficiency, realized with off-the-shelf components. The detector operates in balanced mode up to approximately 500 MHz, above which the differential frequency response limits its performance. To obtain high sensitivity above 500 MHz, the detector can be efficiently used in an unbalanced homodyne detection scheme. We employ our detector in this unbalanced mode to measure a squeezing comb up to 6.4 GHz, achieving a squeezing level of up to 10.7 dB. By sharing our experience, specifically in identifying the unequal frequency response as a limiting factor, we aim to enable and advance further developments in the field.

Applied Physics Letters•Jan 1, 2025•0 citations

Amplification of 2um squeezed light

Kar Meng Kwan

Squeezed states of light enable the reduction of quantum noise in precision interferometric measurements and are routinely employed in gravitational-wave detectors. Future gravitational-wave detector upgrades based on cryogenic silicon optics are expected to operate at longer wavelengths near 1984nm, to take advantage of reduced coating thermal noise and substrate absorption. However, at these wavelengths, the observable squeezing is severely limited by optical loss, in particular the reduced quantum efficiency of available photodiodes. This thesis presents the development and experimental demonstration of a loss-tolerant detection scheme for squeezed states at 1984nm. A phase-sensitive optical parametric amplifier is implemented as a pre-amplifier, amplifying the squeezed quadrature prior to photodetection. A theoretical framework is developed to describe the generation, amplification, and detection of squeezed states in the presence of optical loss and phase noise, introducing the concept of effective detection efficiency for amplified readout. The model predicts that phase-sensitive amplification can mitigate detection loss without significantly degrading the quantum correlations of the squeezed state. Experimentally, a squeezed-light source operating at 1984nm is employed, consisting of second-harmonic generation for pump production and an optical parametric oscillator for squeezed vacuum generation. A phase-controlled optical parametric amplifier is added to the squeezed light output for amplified readout. The individual subsystems are characterized in terms of cavity parameters, escape efficiency, nonlinear gain, and control-loop performance. Amplified squeezing is demonstrated with substantially improved effective detection efficiency compared to conventional homodyne readout, despite the limited photodiode quantum efficiency. The technique also enhances noise clearance above the electronic noise floor, extending the usable measurement bandwidth. These results establish phase-sensitive amplification as a practical strategy for overcoming detection loss at long wavelengths and demonstrate its relevance for next-generation gravitational-wave detectors designed for the 2um regime.

•Jan 1, 2026•0 citations

A low-noise, high-SNR and large-dynamic-range balanced homodyne detector for broadband squeezed light measurement

Jinrong Wang, Shuange Wu, Liying Hou +3 more

Squeezing-based quantum metrology has been extensively applied in the field of precision measurement. Performance characteristics of squeezed light are obtained by a balanced homodyne detector. Here, we report a large dynamic range balanced homodyne detector with low-noise and high-signal-to-noise-ratio (SNR) for broadband squeezed light measurement. We perform a comprehensive theoretical analysis of the SNR in a wide bandwidth and experimentally analyze the important printed circuit board (PCB) layout and electronic components. Consequently, in the 100 MHz frequency band, the SNR and common mode rejection ratio (CMRR) rise over 12.6 dB and 55 dB, respectively, and the electronic noise is suppressed below −90 dB. The directly observed squeezing level at 1550 nm with the specified detector is 11.8 dB at 2 MHz and 3.1 dB at 100 MHz.

Results in Physics•Jan 18, 2024•5 citations
Squeezed light is a non-classical state of light in which the uncertainty in the electricfield strength at certain phases of oscillation is reduced below the vacuum noise level,at the cost of increased uncertainty at other phases. It has applications ranging fromgravitational wave detection to quantum communication, where the bandwidth of thesqueezed states directly limits protocol speed. Squeezed light is commonly measured us-ing balanced homodyne detection, in which the attainable squeezing level is restrictedby the photodetector’s quantum efficiency and dark noise. Currently, no commerciallyavailable photodetector combines high quantum efficiency with low dark noise over alarge bandwidth. This thesis presents the design and construction of a photodetectorintended to address this gap, with the aim of achieving high quantum efficiency and suf-ficient dark noise clearance over at least 1 GHz of bandwidth. The design was guidedby LTspice simulations and implemented on a two-layer printed circuit board. Twocommercially available reference detectors were characterised, illustrating the trade-offbetween high quantum efficiency and large bandwidth. Since the photodiodes for thenew detector had not arrived at the time of completion, its characterisation remains tobe carried out.
Quantum receiver scalability and cost-effectiveness are crucial in the evolving quantum landscape. Application based on squeezed light (e.g. high-precision measurements and quantum communication), can profit especially from integrated and low-noise detectors. The presented die-level receiver is shown in figure 1 a) and combines a novel custom transimpedance amplifier (TIA) with commercial photodiodes (PDs) [1]. This offers a more scalable solution than bulk balanced homodyne detectors (BHDs) while being low-cost compared to fully customized receivers. This design targets a high bandwidth operation while maintaining low-noise properties for the detection of weak quantum signals. To characterize this receiver, we evaluate its performance through measurements of clearance, and common-mode rejection ratio (CMRR). Based on these parameters, a simulation for its performance in the squeezed light detection measurement is presented.
Squeezed light plays a crucial role in state-of-the-art quantum metrology and quantum information experiments. There is significant interest in utilizing squeezed states at high MHz and GHz frequencies. However, past efforts to build suitable photodetectors at these frequencies have yet to yield the required high quantum efficiency. Here, we present the development of a high-frequency balanced photodetector with near-unity quantum efficiency, realized with off-the-shelf components. The detector operates in balanced mode up to approximately 500 MHz, above which the differential frequency response limits its performance. To obtain high sensitivity above 500 MHz, the detector can be efficiently used in an unbalanced homodyne detection scheme. We employ our detector in this unbalanced mode to measure a squeezing comb up to 6.4 GHz, achieving a squeezing level of up to 10.7 dB. By sharing our experience, specifically in identifying the unequal frequency response as a limiting factor, we aim to enable and advance further developments in the field.
Squeezed light plays a crucial role in state-of-the-art quantum metrology and quantum information experiments. There is significant interest in utilizing squeezed states at high MHz and GHz frequencies. However, past efforts to build suitable photodetectors at these frequencies have yet to yield the required high quantum efficiency. Here, we present the development of a high-frequency balanced photodetector with near-unity quantum efficiency, realized with off-the-shelf components. The detector operates in balanced mode up to approximately 500 MHz, above which the differential frequency response limits its performance. To obtain high sensitivity above 500 MHz, the detector can be efficiently used in an unbalanced homodyne detection scheme. We employ our detector in this unbalanced mode to measure a squeezing comb up to 6.4 GHz, achieving a squeezing level of up to 10.7 dB. By sharing our experience, specifically in identifying the unequal frequency response as a limiting factor, we aim to enable and advance further developments in the field.
Squeezed states of light enable the reduction of quantum noise in precision interferometric measurements and are routinely employed in gravitational-wave detectors. Future gravitational-wave detector upgrades based on cryogenic silicon optics are expected to operate at longer wavelengths near 1984nm, to take advantage of reduced coating thermal noise and substrate absorption. However, at these wavelengths, the observable squeezing is severely limited by optical loss, in particular the reduced quantum efficiency of available photodiodes. This thesis presents the development and experimental demonstration of a loss-tolerant detection scheme for squeezed states at 1984nm. A phase-sensitive optical parametric amplifier is implemented as a pre-amplifier, amplifying the squeezed quadrature prior to photodetection. A theoretical framework is developed to describe the generation, amplification, and detection of squeezed states in the presence of optical loss and phase noise, introducing the concept of effective detection efficiency for amplified readout. The model predicts that phase-sensitive amplification can mitigate detection loss without significantly degrading the quantum correlations of the squeezed state. Experimentally, a squeezed-light source operating at 1984nm is employed, consisting of second-harmonic generation for pump production and an optical parametric oscillator for squeezed vacuum generation. A phase-controlled optical parametric amplifier is added to the squeezed light output for amplified readout. The individual subsystems are characterized in terms of cavity parameters, escape efficiency, nonlinear gain, and control-loop performance. Amplified squeezing is demonstrated with substantially improved effective detection efficiency compared to conventional homodyne readout, despite the limited photodiode quantum efficiency. The technique also enhances noise clearance above the electronic noise floor, extending the usable measurement bandwidth. These results establish phase-sensitive amplification as a practical strategy for overcoming detection loss at long wavelengths and demonstrate its relevance for next-generation gravitational-wave detectors designed for the 2um regime.
Squeezing-based quantum metrology has been extensively applied in the field of precision measurement. Performance characteristics of squeezed light are obtained by a balanced homodyne detector. Here, we report a large dynamic range balanced homodyne detector with low-noise and high-signal-to-noise-ratio (SNR) for broadband squeezed light measurement. We perform a comprehensive theoretical analysis of the SNR in a wide bandwidth and experimentally analyze the important printed circuit board (PCB) layout and electronic components. Consequently, in the 100 MHz frequency band, the SNR and common mode rejection ratio (CMRR) rise over 12.6 dB and 55 dB, respectively, and the electronic noise is suppressed below −90 dB. The directly observed squeezing level at 1550 nm with the specified detector is 11.8 dB at 2 MHz and 3.1 dB at 100 MHz.