Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

High efficiency photodetection below the quantum noise limit

Elizabeth Caryn Bullard

Published Jan 1, 2005• 0 citations
OpenAlex

Abstract

Two low-noise, high quantum efficiency, high bandwidth photodetectors have constructed to form a balanced homodyne detector to detect squeezed light. The detectors have quantum efficiencies of 85% and 90%, a bandwidth of 1MHz, and a dark noise of ... at 1MHz.

Related papers

Detecting squeezed light

Svante Fridström, Axel von Malmborg

Squeezed light is a non-classical state of light in which the uncertainty in the electricfield strength at certain phases of oscillation is reduced below the vacuum noise level,at the cost of increased uncertainty at other phases. It has applications ranging fromgravitational wave detection to quantum communication, where the bandwidth of thesqueezed states directly limits protocol speed. Squeezed light is commonly measured us-ing balanced homodyne detection, in which the attainable squeezing level is restrictedby the photodetector’s quantum efficiency and dark noise. Currently, no commerciallyavailable photodetector combines high quantum efficiency with low dark noise over alarge bandwidth. This thesis presents the design and construction of a photodetectorintended to address this gap, with the aim of achieving high quantum efficiency and suf-ficient dark noise clearance over at least 1 GHz of bandwidth. The design was guidedby LTspice simulations and implemented on a two-layer printed circuit board. Twocommercially available reference detectors were characterised, illustrating the trade-offbetween high quantum efficiency and large bandwidth. Since the photodiodes for thenew detector had not arrived at the time of completion, its characterisation remains tobe carried out.

•Jan 1, 2026•0 citations

Fundamental limits to observations of squeezing via balanced homodyne detection

Samuel L. Braunstein, David D. Crouch

A photodetector's electronic bandwidth is the frequency range over which beats between different frequencies in the input can be observed in the output. The output of a balanced homodyne detector, the prototypical device for detecting squeezed light, consists of beats between a signal to be measured and a local oscillator. Beats between the signal and quantum local-oscillator fluctuations lead to noise that degrades the observed squeezing. Through wide-band calculations, we show that this noise contains contributions from the entire signal bandwidth, even when this bandwidth is orders of magnitude larger than the detector's electronic bandwidth. This allows us to place an upper limit on the total power that can enter the detector's signal port (both signal and extraneous light) within the detector's optical bandwidth in order for a given level of squeezing to be observable.

Physical Review A•Jan 1, 1991•10 citations

A highly efficient photodetector for squeezed light measurement in the gigahertz range

D. M. Wilken, J. Junker, M. Heurs

Squeezed light plays a crucial role in state-of-the-art quantum metrology and quantum information experiments. There is significant interest in utilizing squeezed states at high MHz and GHz frequencies. However, past efforts to build suitable photodetectors at these frequencies have yet to yield the required high quantum efficiency. Here, we present the development of a high-frequency balanced photodetector with near-unity quantum efficiency, realized with off-the-shelf components. The detector operates in balanced mode up to approximately 500 MHz, above which the differential frequency response limits its performance. To obtain high sensitivity above 500 MHz, the detector can be efficiently used in an unbalanced homodyne detection scheme. We employ our detector in this unbalanced mode to measure a squeezing comb up to 6.4 GHz, achieving a squeezing level of up to 10.7 dB. By sharing our experience, specifically in identifying the unequal frequency response as a limiting factor, we aim to enable and advance further developments in the field.

Applied Physics Letters•Oct 6, 2025•1 citation

A highly efficient photodetector for squeezed light measurement in the gigahertz range

Dennis Wilken, J. Junker, M. Heurs

Squeezed light plays a crucial role in state-of-the-art quantum metrology and quantum information experiments. There is significant interest in utilizing squeezed states at high MHz and GHz frequencies. However, past efforts to build suitable photodetectors at these frequencies have yet to yield the required high quantum efficiency. Here, we present the development of a high-frequency balanced photodetector with near-unity quantum efficiency, realized with off-the-shelf components. The detector operates in balanced mode up to approximately 500 MHz, above which the differential frequency response limits its performance. To obtain high sensitivity above 500 MHz, the detector can be efficiently used in an unbalanced homodyne detection scheme. We employ our detector in this unbalanced mode to measure a squeezing comb up to 6.4 GHz, achieving a squeezing level of up to 10.7 dB. By sharing our experience, specifically in identifying the unequal frequency response as a limiting factor, we aim to enable and advance further developments in the field.

Applied Physics Letters•Jan 1, 2025•0 citations

Wideband photon counting and homodyne detection

Bernard Yurke

Homodyne detection has been proposed as a means of detecting squeezed coherent radiation. Here the response of a balanced homodyne detector to wideband squeezed coherent states is presented. In order to carry out the analysis the theory of wideband photodetection is reviewed and in order to determine the ultimate performance limits of photoemissive detectors small terms of order \ensuremath{\Delta}\ensuremath{\omega}/${\ensuremath{\omega}}_{0}$ that are usually neglected, where ${\ensuremath{\omega}}_{0}$ is the optical carrier frequency and \ensuremath{\Delta}\ensuremath{\omega} is the electronics bandwidth, have been kept. It is shown that the ultimate noise reduction that can be achieved in the noise-power spectrum of a homodyne detector, detecting squeezed coherent radiation, is a factor of 2 worse when photoemissive detectors are used instead of power flux detectors.

Physical Review A•Jul 1, 1985•122 citations

Die-Level Balanced Homodyne Receiver for Squeezed Light Detection in the GHz Regime

Emmily Zaiser, Alessandro Trenti, Dinka Milovančev +3 more

Quantum receiver scalability and cost-effectiveness are crucial in the evolving quantum landscape. Application based on squeezed light (e.g. high-precision measurements and quantum communication), can profit especially from integrated and low-noise detectors. The presented die-level receiver is shown in figure 1 a) and combines a novel custom transimpedance amplifier (TIA) with commercial photodiodes (PDs) [1]. This offers a more scalable solution than bulk balanced homodyne detectors (BHDs) while being low-cost compared to fully customized receivers. This design targets a high bandwidth operation while maintaining low-noise properties for the detection of weak quantum signals. To characterize this receiver, we evaluate its performance through measurements of clearance, and common-mode rejection ratio (CMRR). Based on these parameters, a simulation for its performance in the squeezed light detection measurement is presented.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 23, 2025•1 citation
Squeezed light is a non-classical state of light in which the uncertainty in the electricfield strength at certain phases of oscillation is reduced below the vacuum noise level,at the cost of increased uncertainty at other phases. It has applications ranging fromgravitational wave detection to quantum communication, where the bandwidth of thesqueezed states directly limits protocol speed. Squeezed light is commonly measured us-ing balanced homodyne detection, in which the attainable squeezing level is restrictedby the photodetector’s quantum efficiency and dark noise. Currently, no commerciallyavailable photodetector combines high quantum efficiency with low dark noise over alarge bandwidth. This thesis presents the design and construction of a photodetectorintended to address this gap, with the aim of achieving high quantum efficiency and suf-ficient dark noise clearance over at least 1 GHz of bandwidth. The design was guidedby LTspice simulations and implemented on a two-layer printed circuit board. Twocommercially available reference detectors were characterised, illustrating the trade-offbetween high quantum efficiency and large bandwidth. Since the photodiodes for thenew detector had not arrived at the time of completion, its characterisation remains tobe carried out.
A photodetector's electronic bandwidth is the frequency range over which beats between different frequencies in the input can be observed in the output. The output of a balanced homodyne detector, the prototypical device for detecting squeezed light, consists of beats between a signal to be measured and a local oscillator. Beats between the signal and quantum local-oscillator fluctuations lead to noise that degrades the observed squeezing. Through wide-band calculations, we show that this noise contains contributions from the entire signal bandwidth, even when this bandwidth is orders of magnitude larger than the detector's electronic bandwidth. This allows us to place an upper limit on the total power that can enter the detector's signal port (both signal and extraneous light) within the detector's optical bandwidth in order for a given level of squeezing to be observable.
Squeezed light plays a crucial role in state-of-the-art quantum metrology and quantum information experiments. There is significant interest in utilizing squeezed states at high MHz and GHz frequencies. However, past efforts to build suitable photodetectors at these frequencies have yet to yield the required high quantum efficiency. Here, we present the development of a high-frequency balanced photodetector with near-unity quantum efficiency, realized with off-the-shelf components. The detector operates in balanced mode up to approximately 500 MHz, above which the differential frequency response limits its performance. To obtain high sensitivity above 500 MHz, the detector can be efficiently used in an unbalanced homodyne detection scheme. We employ our detector in this unbalanced mode to measure a squeezing comb up to 6.4 GHz, achieving a squeezing level of up to 10.7 dB. By sharing our experience, specifically in identifying the unequal frequency response as a limiting factor, we aim to enable and advance further developments in the field.
Squeezed light plays a crucial role in state-of-the-art quantum metrology and quantum information experiments. There is significant interest in utilizing squeezed states at high MHz and GHz frequencies. However, past efforts to build suitable photodetectors at these frequencies have yet to yield the required high quantum efficiency. Here, we present the development of a high-frequency balanced photodetector with near-unity quantum efficiency, realized with off-the-shelf components. The detector operates in balanced mode up to approximately 500 MHz, above which the differential frequency response limits its performance. To obtain high sensitivity above 500 MHz, the detector can be efficiently used in an unbalanced homodyne detection scheme. We employ our detector in this unbalanced mode to measure a squeezing comb up to 6.4 GHz, achieving a squeezing level of up to 10.7 dB. By sharing our experience, specifically in identifying the unequal frequency response as a limiting factor, we aim to enable and advance further developments in the field.
Homodyne detection has been proposed as a means of detecting squeezed coherent radiation. Here the response of a balanced homodyne detector to wideband squeezed coherent states is presented. In order to carry out the analysis the theory of wideband photodetection is reviewed and in order to determine the ultimate performance limits of photoemissive detectors small terms of order \ensuremath{\Delta}\ensuremath{\omega}/${\ensuremath{\omega}}_{0}$ that are usually neglected, where ${\ensuremath{\omega}}_{0}$ is the optical carrier frequency and \ensuremath{\Delta}\ensuremath{\omega} is the electronics bandwidth, have been kept. It is shown that the ultimate noise reduction that can be achieved in the noise-power spectrum of a homodyne detector, detecting squeezed coherent radiation, is a factor of 2 worse when photoemissive detectors are used instead of power flux detectors.
Quantum receiver scalability and cost-effectiveness are crucial in the evolving quantum landscape. Application based on squeezed light (e.g. high-precision measurements and quantum communication), can profit especially from integrated and low-noise detectors. The presented die-level receiver is shown in figure 1 a) and combines a novel custom transimpedance amplifier (TIA) with commercial photodiodes (PDs) [1]. This offers a more scalable solution than bulk balanced homodyne detectors (BHDs) while being low-cost compared to fully customized receivers. This design targets a high bandwidth operation while maintaining low-noise properties for the detection of weak quantum signals. To characterize this receiver, we evaluate its performance through measurements of clearance, and common-mode rejection ratio (CMRR). Based on these parameters, a simulation for its performance in the squeezed light detection measurement is presented.