Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

MRS Advances

Electrodynamic simulation of an antenna-coupled Pb–graphene–Pb Josephson junction at millimeter wavelengths

Emily Frederick, Swastik Ballav, Javier González, R. E. Peale, Masa Ishigami

Published May 19, 2026• 0 citations
Publisher

Abstract

Potential for single-photon mm-wave detection by antenna-coupled Pb–graphene–Pb Josephson junctions (JJ) is evaluated. We consider the high-speed “video” (non-thermal) detection based on Shapiro steps induced by antenna-sourced AC currents across the JJ. Electrodynamic simulation informs the bowtie antenna design and estimates the AC current through JJ. Standard JJ models are used to estimate the corresponding AC voltage and the downward shift of the maximum zero-voltage DC current Ic, where a sharp transition occurs in the DC voltage–current curve. Calculated voltage responsivity for current biasing near Ic is compared with Johnson noise to estimate a lower limit for noise equivalent photon flux. Estimated responsivity is 0.9 $$MV/W$$ M V / W at 300 $$GHz$$ GHz , and the lower bound on the noise equivalent power is 0.11 fW/ $$\sqrt {{\text{Hz}}}$$ Hz giving a 2 photons per microsecond. Graphical abstract

DOI
10.1557/s43580-026-01676-7

Related papers

Millimeter-wave detection by YBaCuO step-edge microbridge Josephson junction

Yoshito Fukumoto, Rikuo Ogawa, Yoshio Kawate

Millimeter-wave detection was investigated using a step-edge microbridge Josephson junction fabricated by a YBaCuO thin film for both the video detection and harmonic mixing detection. Current–voltage (I–V) characteristics, which could be described by the resistively shunted junction (RSJ) model, were obtained up to 70 K with the IcR product of 150 μV at 70 K. The responsivity and noise equivalent input power were calculated as 2400 W/V and 4.4×10−14 W/√Hz, respectively, in the video detection assuming the RSJ model approximation. Clear dependence of the intermediate frequency output on the applied dc bias voltage was observed in the harmonic mixing detection with the harmonic numbers of 5–16, reflecting the change of dynamic resistance at the constant voltage steps induced by the local oscillation signal on the I–V curve. A minimum detection power of −59.4 dB m and a conversion efficiency (η) of −49.6 dB were obtained for the harmonic number (N) of 5 at 60 K. The relationship between the η and N was expressed as η∝N−2.2.

Journal of Applied Physics•Sep 1, 1993•14 citations

Bowtie loaded meander antenna for a high-temperature superconducting terahertz detector and its characterization by the Josephson effect

Mei Yu, Haifeng Geng, Shoulu Jiang +8 more

In a quasi-optical system, the high temperature superconducting terahertz detector often suffers from a fundamental problem of low coupling efficiency with the terahertz signal, especially for the detector based on YBa2Cu3O7-δ (YBCO) bicrystal Josephson junction (JJ) due to a small normal-state resistance. Here, we developed a bowtie loaded meander antenna to enhance coupling efficiency. Differing from the conventional characterization confining on vector network analyzers, we applied three methods to evaluate the antenna, including the measurements of the maximal size of the first order Shapiro step under per incident power, the coupling efficiency between the antenna and the junction, and voltage responsivity. Furthermore, with simulation analysis, we propose that the inductive reactance of the YBCO bicrystal JJ is around 60 ohms under terahertz irradiation at 210 GHz, thus, the reactance is comparable as that of the antenna.

Optics Express•Apr 19, 2020•7 citations

Millimeter wave video detection using pb thin film microbridge josephson junction

Shigeru Yoshimori, Mitsuo Kawamura

Abstract An experiment in video signal detection at 70 GHz was conducted with a Pb micro‐bridge prepared by electron‐beam exposure and the lift‐off method. It was found that for the dc Josephson effect the external noise is dominant over the internal noise of the specimen and that the equivalent noise becomes large near the critical temperature. The response to 100 kHz amplitude‐modulated signals was found to be ten times more rapid than that of the superconductor bolometer. Theoretically the maximum responsivity is obtained near the first Shapiro step, which, however, does not give a stable bias; maximum responsivity was actually observed near the zeroth Shapiro step, where it exceeded 6.3 × 104 V/W. The responsivity was found to increase with increasing IcRn.

Electronics and Communications in Japan (Part I Communications)•Jan 1, 1982•2 citations

Sensitivity of Josephson junctions in video detection of microwave and millimeter-wave radiation

Hiroshi Ohta

The responsivity and the noise equivalent power (NEP) of Josephson junctions in video detection of microwave and millimeter-wave radiation have been calculated. The sensitivity to radiation is assumed to be limited by the rounding of the voltage-current curve due to thermal noise of both the source resistance and the junction resistance. The calculated NEP is at least several tens of times better than any experimentally established.

Journal of Applied Physics•Dec 1, 1972•12 citations

Wideband detection of electromagnetic signals by high-Tc Josephson junctions with comparable Josephson and thermal energies

Valery V. Pavlovskiy, I. Gundareva, O. Yu. Volkov +1 more

Detection mechanisms in Josephson junctions with energies Ej comparable to thermal energies kT have been studied. The responses ΔV of YBa2Cu3O7−x bicrystal junctions to monochromatic radiation with frequencies f ranging from 94 GHz to 3.1 THz can be described in terms of classical rectification on a static nonlinear V–I curve at low frequencies and frequency modulation of the ac Josephson current at high frequencies, with an interplay between these mechanisms at intermediate frequencies. An electrical noise-equivalent power of (9 ± 3) × 10−15 W/Hz1/2, a responsivity of (3.4 ± 0.5) × 105 V/W, and a dynamic power range of 5 × 104 have been demonstrated for the square-law classical detection of 94 GHz radiation with the junctions at 50 K. The effect of background radiation on the V–I curves of YBa2Cu3O7−x bicrystal junctions was found to have an optical noise-equivalent temperature of ≤30 mK/Hz1/2. The main contribution to the effect comes from the interplay between the classical and Josephson detection mechanisms. The spectral and power dependencies of the responses ΔV of Josephson junctions have been numerically simulated within the resistively shunted junction model at various values of kT/Ej, and the results are in acceptable agreement with the experimental data.

Applied Physics Letters•Feb 24, 2020•10 citations

Josephson junction infrared single-photon detector

Evan D. Walsh, Woochan Jung, Gil-Ho Lee +9 more

Josephson junctions are superconducting devices used as high-sensitivity magnetometers and voltage amplifiers as well as the basis of high-performance cryogenic computers and superconducting quantum computers. Although device performance can be degraded by the generation of quasiparticles formed from broken Cooper pairs, this phenomenon also opens opportunities to sensitively detect electromagnetic radiation. We demonstrate single near-infrared photon detection by coupling photons to the localized surface plasmons of a graphene-based Josephson junction. Using the photon-induced switching statistics of the current-biased device, we reveal the critical role of quasiparticles generated by the absorbed photon in the detection mechanism. The photon sensitivity will enable a high-speed, low-power optical interconnect for future superconducting computing architectures.

arXiv:2011.02624•Science•Apr 22, 2021•106 citations
Potential for single-photon mm-wave detection by antenna-coupled Pb–graphene–Pb Josephson junctions (JJ) is evaluated. We consider the high-speed “video” (non-thermal) detection based on Shapiro steps induced by antenna-sourced AC currents across the JJ. Electrodynamic simulation informs the bowtie antenna design and estimates the AC current through JJ. Standard JJ models are used to estimate the corresponding AC voltage and the downward shift of the maximum zero-voltage DC current Ic, where a sharp transition occurs in the DC voltage–current curve. Calculated voltage responsivity for current biasing near Ic is compared with Johnson noise to estimate a lower limit for noise equivalent photon flux. Estimated responsivity is 0.9 MV/WMV/WMV/W M V / W at 300 GHzGHzGHz GHz , and the lower bound on the noise equivalent power is 0.11 fW/ Hz\sqrt {{\text{Hz}}}Hz​ Hz giving a 2 photons per microsecond. Graphical abstract
Millimeter-wave detection was investigated using a step-edge microbridge Josephson junction fabricated by a YBaCuO thin film for both the video detection and harmonic mixing detection. Current–voltage (I–V) characteristics, which could be described by the resistively shunted junction (RSJ) model, were obtained up to 70 K with the IcR product of 150 μV at 70 K. The responsivity and noise equivalent input power were calculated as 2400 W/V and 4.4×10−14 W/√Hz, respectively, in the video detection assuming the RSJ model approximation. Clear dependence of the intermediate frequency output on the applied dc bias voltage was observed in the harmonic mixing detection with the harmonic numbers of 5–16, reflecting the change of dynamic resistance at the constant voltage steps induced by the local oscillation signal on the I–V curve. A minimum detection power of −59.4 dB m and a conversion efficiency (η) of −49.6 dB were obtained for the harmonic number (N) of 5 at 60 K. The relationship between the η and N was expressed as η∝N−2.2.
In a quasi-optical system, the high temperature superconducting terahertz detector often suffers from a fundamental problem of low coupling efficiency with the terahertz signal, especially for the detector based on YBa2Cu3O7-δ (YBCO) bicrystal Josephson junction (JJ) due to a small normal-state resistance. Here, we developed a bowtie loaded meander antenna to enhance coupling efficiency. Differing from the conventional characterization confining on vector network analyzers, we applied three methods to evaluate the antenna, including the measurements of the maximal size of the first order Shapiro step under per incident power, the coupling efficiency between the antenna and the junction, and voltage responsivity. Furthermore, with simulation analysis, we propose that the inductive reactance of the YBCO bicrystal JJ is around 60 ohms under terahertz irradiation at 210 GHz, thus, the reactance is comparable as that of the antenna.
Abstract An experiment in video signal detection at 70 GHz was conducted with a Pb micro‐bridge prepared by electron‐beam exposure and the lift‐off method. It was found that for the dc Josephson effect the external noise is dominant over the internal noise of the specimen and that the equivalent noise becomes large near the critical temperature. The response to 100 kHz amplitude‐modulated signals was found to be ten times more rapid than that of the superconductor bolometer. Theoretically the maximum responsivity is obtained near the first Shapiro step, which, however, does not give a stable bias; maximum responsivity was actually observed near the zeroth Shapiro step, where it exceeded 6.3 × 104 V/W. The responsivity was found to increase with increasing IcRn.
Detection mechanisms in Josephson junctions with energies Ej comparable to thermal energies kT have been studied. The responses ΔV of YBa2Cu3O7−x bicrystal junctions to monochromatic radiation with frequencies f ranging from 94 GHz to 3.1 THz can be described in terms of classical rectification on a static nonlinear V–I curve at low frequencies and frequency modulation of the ac Josephson current at high frequencies, with an interplay between these mechanisms at intermediate frequencies. An electrical noise-equivalent power of (9 ± 3) × 10−15 W/Hz1/2, a responsivity of (3.4 ± 0.5) × 105 V/W, and a dynamic power range of 5 × 104 have been demonstrated for the square-law classical detection of 94 GHz radiation with the junctions at 50 K. The effect of background radiation on the V–I curves of YBa2Cu3O7−x bicrystal junctions was found to have an optical noise-equivalent temperature of ≤30 mK/Hz1/2. The main contribution to the effect comes from the interplay between the classical and Josephson detection mechanisms. The spectral and power dependencies of the responses ΔV of Josephson junctions have been numerically simulated within the resistively shunted junction model at various values of kT/Ej, and the results are in acceptable agreement with the experimental data.
Josephson junctions are superconducting devices used as high-sensitivity magnetometers and voltage amplifiers as well as the basis of high-performance cryogenic computers and superconducting quantum computers. Although device performance can be degraded by the generation of quasiparticles formed from broken Cooper pairs, this phenomenon also opens opportunities to sensitively detect electromagnetic radiation. We demonstrate single near-infrared photon detection by coupling photons to the localized surface plasmons of a graphene-based Josephson junction. Using the photon-induced switching statistics of the current-biased device, we reveal the critical role of quasiparticles generated by the absorbed photon in the detection mechanism. The photon sensitivity will enable a high-speed, low-power optical interconnect for future superconducting computing architectures.