Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Simulation Framework for Microwave Loss in Multimaterial Superconducting Circuits

Haoran Duan

Published Jan 1, 2026• 0 citations
Publisher
DOI
10.5445/ir/1000193049

Related papers

Simulation Framework for Thermal Quasi-Particle Microwave Loss in Multimaterial Superconducting Quantum Circuit Elements

Haoran Duan, Ritika Dhundhwal, Gabriel Cadilha Marques +4 more

Superconducting quantum circuits constitute one of the most advanced and promising platforms for building faulttolerant quantum computers. However, the associated relatively short coherence times remain a major challenge. Therefore quantifying the various responsible loss mechanisms is key, which can be achieved effectively by refined loss modeling. An important source of dissipation is thermal quasi-particles, for which many simulation tools exist. Here we improve on these by integrating two of them in a self-consistent manner into an automated workflow for a circuit composed of two materials. Namely, the workflow consists of a numerical simulation of the Mattis-Bardeen surface impedance and electromagnetic finite element simulation using Ansys HFSS to predict temperature-dependent quasi-particle loss from normal state material properties. As a test, we use it to simulate the quality factors as a function of the temperature of superconducting resonators composed of tantalum. Tantalum resonators are often found to be dominated by quasi-particle loss at a significantly lower temperature (less than 1 K) than what would be expected from the bulk critical temperature (4.4 K) observed to good approximation in DC transport measurements. A likely cause is a defect phase with a low critical temperature, potentially associated with the tantalum beta phase. By fitting the temperature-dependent loss data to the workflow results, we estimate the concentration of the defect phase. This is an important step forward in correlating materials design and microwave loss.

IEEE Transactions on Applied Superconductivity•Aug 29, 2025•2 citations

Microwave design for superconductor circuits

Pascal Febvre

•Sep 29, 2024•0 citations

Origins of microwave losses in superconducting circuits made with silicon-on-insulator substrates

Simon Messelot, Nicolás Aparicio, Kazi Rafsanjani Amin +10 more

This repository contains data and a jupyter notebook that were used to analyze them and create the figures for the manuscript: "Origins of microwave losses in superconducting circuits made with silicon-on-insulator substrates". The Qcodes databases (.db) contain the raw data. csv files contain analyzed and fitted data used for generating the figures. Python scripts (.py) used for the analysis are included. txt files contains the results of simulations that are used for Figure 4.The notebook (.ipynb) calls the different files and generate the figures.

•Jul 29, 2026•0 citations

Study of high temperature superconducting circuits for microwave applications

E. Carlsson

•Jan 1, 1996•0 citations

Improvement of dielectric loss in superconducting microwave resonators

Wei Qiu

The Japan Society of Applied Physics•Jul 8, 2014•0 citations

Microwave response of vortices in superconducting thin films of Re and Al

Chao Song, Tom Heitmann, M. P. DeFeo +5 more

Vortices in superconductors driven at microwave frequencies exhibit a response related to the interplay between the vortex viscosity, pinning strength, and flux creep effects. At the same time, the trapping of vortices in superconducting microwave resonant circuits contributes excess loss and can result in substantial reductions in the quality factor. Thus, understanding the microwave vortex response in superconducting thin films is important for the design of such circuits, including superconducting qubits and photon detectors, which are typically operated in small, but nonzero, magnetic fields. By cooling in fields on the order of $100\text{ }\ensuremath{\mu}\text{T}$ and below, we have characterized the magnetic field and frequency dependence of the microwave response of a small density of vortices in resonators fabricated from thin films of Re and Al, which are common materials used in superconducting microwave circuits. Above a certain threshold cooling field, which is different for the Re and Al films, vortices become trapped in the resonators. Vortices in the Al resonators contribute greater loss and are influenced more strongly by flux creep effects than in the Re resonators. This different behavior can be described in the framework of a general vortex dynamics model.

arXiv:0812.3645•Physical Review B•May 8, 2009•172 citations
Superconducting quantum circuits constitute one of the most advanced and promising platforms for building faulttolerant quantum computers. However, the associated relatively short coherence times remain a major challenge. Therefore quantifying the various responsible loss mechanisms is key, which can be achieved effectively by refined loss modeling. An important source of dissipation is thermal quasi-particles, for which many simulation tools exist. Here we improve on these by integrating two of them in a self-consistent manner into an automated workflow for a circuit composed of two materials. Namely, the workflow consists of a numerical simulation of the Mattis-Bardeen surface impedance and electromagnetic finite element simulation using Ansys HFSS to predict temperature-dependent quasi-particle loss from normal state material properties. As a test, we use it to simulate the quality factors as a function of the temperature of superconducting resonators composed of tantalum. Tantalum resonators are often found to be dominated by quasi-particle loss at a significantly lower temperature (less than 1 K) than what would be expected from the bulk critical temperature (4.4 K) observed to good approximation in DC transport measurements. A likely cause is a defect phase with a low critical temperature, potentially associated with the tantalum beta phase. By fitting the temperature-dependent loss data to the workflow results, we estimate the concentration of the defect phase. This is an important step forward in correlating materials design and microwave loss.
This repository contains data and a jupyter notebook that were used to analyze them and create the figures for the manuscript: "Origins of microwave losses in superconducting circuits made with silicon-on-insulator substrates". The Qcodes databases (.db) contain the raw data. csv files contain analyzed and fitted data used for generating the figures. Python scripts (.py) used for the analysis are included. txt files contains the results of simulations that are used for Figure 4.The notebook (.ipynb) calls the different files and generate the figures.
Vortices in superconductors driven at microwave frequencies exhibit a response related to the interplay between the vortex viscosity, pinning strength, and flux creep effects. At the same time, the trapping of vortices in superconducting microwave resonant circuits contributes excess loss and can result in substantial reductions in the quality factor. Thus, understanding the microwave vortex response in superconducting thin films is important for the design of such circuits, including superconducting qubits and photon detectors, which are typically operated in small, but nonzero, magnetic fields. By cooling in fields on the order of $100\text{ }\ensuremath{\mu}\text{T}$ and below, we have characterized the magnetic field and frequency dependence of the microwave response of a small density of vortices in resonators fabricated from thin films of Re and Al, which are common materials used in superconducting microwave circuits. Above a certain threshold cooling field, which is different for the Re and Al films, vortices become trapped in the resonators. Vortices in the Al resonators contribute greater loss and are influenced more strongly by flux creep effects than in the Re resonators. This different behavior can be described in the framework of a general vortex dynamics model.