Fabrication of Tin vacancy centers in nanodiamonds
Hideaki Takashima, Konosuke Shimazaki, Abe Hiroshi +2 more
Nanodiamonds with color centers have recently become a focus of photonic quantum information technologies. Among the various vacancies in diamonds, Tin vacancy (SnV) centers have promising properties[3], such as high brightness, high emission efficiency (60%) from a zero-phonon line (ZPL) at about 620 nm, lifetime-limited linewidths, and a long coherence time of the electronic spin. A reported method for fabricating nanodiamonds, including SnV centers, is the synthesis by microwave plasma chemical vapor deposition[4]. In this method, inorganic compounds were used to introduce a layer of oxides and chlorides that serve Sn ions. However, this method would be difficult to precisely control both the size of the nanodiamonds and the number of defect centers. Here, we report an alternative approach for creating SnV centers in nanodiamonds using ion implantation. We use type-Ib diamond monocrystalline suspension (MSY 0.05, purchased from Microdiamant). Small amounts of the suspension are spin-coated several times on substrates. Sn ions are implanted into the samples with an energy of 800 KeV and ion fluence of 1014 ions/cm2. We then anneal the implanted samples in a high vacuum for about 20 hours at 1200oC. After annealing, the samples are heated at about 500 degrees to remove the sp2 carbon layer on the surface. Finally, the nanodiamonds are transferred to silica substrates. We use a confocal microscope system for the optical measurement. A continuous-wave laser (λ=520 nm) is used to excite the SnV centers in the nanodiamonds. The laser's excitation power is about 10 mW. The laser beam is focused on the nanodiamonds with an objective lens with a numerical aperture of 0.95. The samples are scanned at a step size of 200 nm using a three-axis piezo actuator. The fluorescence is collected with the same objective lens and measured by a single-photon counting module and a spectrometer.
•Nov 19, 2024•0 citations