Abstract A platform for heteroepitaxial (111) chemical vapor deposition (CVD) diamond quantum sensors with preferentially aligned nitrogen vacancy (NV) centers on a large substrate is developed, and its operation as an electric vehicle (EV) battery monitor is demonstrated. A self‐standing heteroepitaxial CVD diamond film with a (111) orientation and a thickness of 150 µm is grown on a non‐diamond substrate and subsequently separated from it. The high uniformity and crystallinity of the (111)‐oriented diamond is confirmed. A 150‐µm thick NV‐diamond layer is then deposited on the heteroepitaxial diamond. The T 2 value measured by confocal microscopy is 20 µs, which corresponds to substitutional nitrogen defect concentration of 8 ppm. The nitrogen‐vacancy concentration and T 2 * are estimated to be 0.05 ppm and 0.05 µs by continuous wave optically detected magnetic resonance (CW‐ODMR) spectroscopy in a fiber‐top sensor configuration. In a gradiometer, where two sensors are placed on both sides of the busbar, the noise floor is 17 nT/Hz 0.5 in the frequency range of 10–40 Hz without magnetic shielding. The Allan deviation of the magnetic field noise in the laboratory is below 0.3 µT, which corresponds to a busbar current of 10 mA, in the accumulation time range of 10 ms to 100 s.
Here, we report the fabrication and characterization of single crystal diamond films on a two-inch wafer-scale containing three-dimensional layered structures of negatively charged nitrogen-vacancy color centers (NV
−). The (100)-oriented layered diamond films were grown by chemical vapor deposition (CVD) to create spatially separated regions of enhanced emission associated with NV
− centers. Such localized emission enhancement as well as 2D and 3D arrays of spins could enable close-packed architectures for emerging quantum devices, such as data processors, memory cells, and magnetic sensors. A cyclic sequence of CVD growth and oxygen-plasma etching is employed, resulting in the in-situ formation of layered inverted pyramidal structures with flat $\{
111\}$ sidewalls. These pits are subsequently overgrown by nitrogen-doped diamond to achieve NV
−-rich facets with a uniform N-V bond arrangement and improved nitrogen incorporation efficiency.
We report the formation of perfectly aligned, high-density, shallow nitrogen vacancy (NV) centers on the (111) surface of a diamond. The study involved step-flow growth with a high flux of nitrogen during chemical vapor deposition (CVD) growth, which resulted in the formation of a highly concentrated (>1019 cm−3) nitrogen layer approximately 10 nm away from the substrate surface. Photon counts obtained from the NV centers indicated the presence of 6.1 × 1015–3.1 × 1016 cm−3 NV centers, which suggested the formation of an ensemble of NV centers. The optically detected magnetic resonance (ODMR) spectrum confirmed perfect alignment (more than 99%) for all the samples fabricated by step-flow growth via CVD. Perfectly aligned shallow ensemble NV centers indicated a high Rabi contrast of approximately 30% which is comparable to the values reported for a single NV center. Nanoscale nuclear magnetic resonance demonstrated surface-sensitive nuclear spin detection and provided a confirmation of the NV centers' depth. Single NV center approximation indicated that the depth of the NV centers was approximately 9–10.7 nm from the surface with error of less than ±0.8 nm. Thus, a route for material control of shallow NV centers has been developed by step-flow growth using a CVD system. Our finding pioneers on the atomic level control of NV center alignment for large area quantum magnetometry.
Nitrogen-vacancy (NV) centers in chemical-vapor-deposition (CVD) diamond can form preferentially oriented ensembles with high sensing performance and low densities of lattice defects. Thin films of this material are a cornerstone of various imaging modalities. However, nitrogen injection needed to produce such films can transiently drive growth out of equilibrium, generating interfacial strain and spin defects that degrade NV coherence. Here, we investigate this disorder in
12C-enriched, preferentially oriented NV layers grown on (111) diamond using two nitrogen-injection procedures, combined with nanometer-scale selective plasma etching and NV spin-coherence measurements. Pulsed nitrogen injection produces a pronounced nitrogen overshoot within a 60--80 nm interfacial region, generating excessive amounts of defects. By contrast, smooth nitrogen delivery through mass flow controllers substantially suppresses interfacial disorder, yielding coherence properties close to the theoretical limit imposed by spin-bath noise. A 50-nm NV layer is used to demonstrate proton nuclear magnetic resonance detection. This work reveals the role of interfacial disorder associated with the nitrogen-doping procedure and provides a route to growing high-quality, thin NV-doped layers for quantum-sensing applications.