Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Umbau und Inbetriebnahme eines MOTReMi-Aufbaus für zukünftige Experimente mit ultrakaltem 6Li

C. Bogda

Published Jan 1, 2015• 0 citations
OpenAlex

Abstract

This thesis deals with the reconstruction of a MOTRe- Mi apparatus, which represents the combination of a magneto-optical trap (MOT) and a Reaction Microscope (ReMi). With this setup an ultracold degenerate Fermi gas consisting of 6Li atoms will be generated and studied in future. Primarily the Li atoms will be vaporized, precooled in a Zeeman Slower, trapped and stored with the MOT at typical temperatures of a few 100 μK. Within the scope of this thesis initially the parameters of the Zeeman Slower were optimized. For this purpose the magnetic field profiles of the single coils were measured and the ideal coil currents determined. The efficiency and other properties of the Zeeman Slower were calculated with a simulation programme. The focus of this thesis was on planning and reconstructing the laser system and the optical setup for the magneto-optical trap. This included among others the adaptation of the laser frequencies from 7Li to 6Li and the integration of an additional amplifier in order to achieve a higher output power. Using the frequency stabilization scheme of a frequency offset lock ([SEG+99]) it is now possible to tune the laser frequency over a large range at a constant laser power. This is required on the one hand for the later transfer of the atoms to a dipole trap and on the other hand for the imaging of the atom cloud by light absorption at high magnetic fields. Finally the vacuum chamber and the Reaction microscope was baked out and activated at a vacuum of about 7 · 10-10 mbar.

Related papers

Apparatus for the preparation of ultracold Fermi gases

P Ringer Simon

This thesis reports on the first steps towards an experimental setup capable of realizing an ultracold three-component Fermi gas in an optical lattice: the construction of an apparatus that captures and cools 6Li -atoms inside a magneto optical trap (MOT). The focus of this thesis was the implementation of the Zeeman slower, the laser system and hard- and software controlling the experiment. Since these provide the starting point for all future developments it was especially important to ensure that they do not limit future experiments. With a MOT loading rate of L ~ 3 x 108 atoms/second at an oven temperature of 350 °C it is possible to capture enough atoms for further experiments in about one second allowing fast cycle times of the experiment. The achieved background pressure in the vacuum chamber, essential for the next experimental steps, is excellent as indicated by the background gas collision limited MOT lifetime of τ ~ 23 minutes. The next step will be to implement a dipole trap to further cool the 6Li -atoms.

•Jan 1, 2010•0 citations

Setup and Characterization of a Single-Focused Beam Optical Trap for Lithium

Lars Heinen

Within the MOTREMI experiment at the Max-Plank-Institut für Kernphysik a new optical trap was constructed. A already installed magneto-optical trap cools 6Li atoms down to temperatures on the order of 100 μK. From the corresponding atoms an ultracold lithium gas is trapped inside the center of the main vacuum chamber. In the further course of the experiment, ionization measurements with a degenerate quantum gas will be carried out. In order to create theses gases, one needs to surpass the temperature limit of the magneto-optical trap. Traps using a high intensity, far red-detuned focused laser beam are able to achieve temperatures on the order of 100 nK. An intensity stabilization which is able to extend the lifetime of trapped gas was constructed in the scope of this thesis. With the use of two different photodiodes, every intensity level of the laser is covered. The high laser powers which are needed for the trap, can lead to thermal effects in the entire setup. Consequently, the properties of the laser and the optical elements the laser is passing through can change. Therefore, a quantitative analysis of these thermal effects has been carried out. Besides the shift and reduction of the focused laser beam, the thermal effect on the trap size was obtained.

•Jan 1, 2017•0 citations

Experimental advances toward a compact dual-species laser cooling apparatus

Keith Ladouceur

This thesis describes the advances made towards a dual-species magneto-optical trap (MOT) of Li and Rb for use in photoassociation spectroscopy, Feshbach resonance studies, and, as long-term aspirations, the formation of ultracold heteronuclear polar molecules. The initial discussion will focus on a brief theoretical overview of laser cooling and trapping and the production of ultracold molecules from a cold atom source. Subsequently, details of the experimental system, including those pertaining to the required laser light, the vacuum chamber, and the computer control system will be presented. Finally, preliminary optimization and characterization measurements showing the performance of a single species Li MOT are introduced. These measurements demonstrated the loading of over 8 x 107 Li atoms directly into a MOT without the need for a Zeeman slower.

•Jan 1, 2008•1 citation

A magneto-optical trap for the preparation of a three-component Fermi gas in an optical lattice

M. G. Ries

This thesis reports on the first steps towards the preparation of an ultracold threecomponent Fermi gas of 6Li in an optical lattice. A vacuum chamber and a magneto-optical trap (MOT) for 6Li were set up and characterized. The MOT will serve as a first trapping and cooling stage, from which atoms can be loaded into an optical dipole trap for further cooling. The crucial parameters of the apparatus are a high MOT loading rate for fast experiment cycles, and a low background pressure, which will provide an undisturbed environment and thus a long lifetime for atoms in the lattice. The loading rate of the MOT was measured to be L ~ 3 x 108 atoms/s at an oven temperature of Toven = 350 C, which exceeds current state of the art experiments and will allow for loading times of less than one second in the planned experiments. The background collision limited lifetime of atoms in the MOT is t ~ 23 min. Collisions with the background gas are therefore not expected to be a limiting factor for the lifetime of atoms in the optical lattice.

•Jan 1, 2010•1 citation

A Laser Cooled Lithium Beam Source for the Loading of a Magneto-Optical Trap in a Reaction Microscope

Dominik Globig

A new experiment is being built at the Max-Planck-Institut für Kernphysik (MPIK) within the PRIOC project (Precision studies on Ion Collisions) where a reaction microscope (Remi) and a magneto-optical trap (MOT) as target are combined to a so called MOTRemi. This setup will be implemented into the ion storage ring 'Testspeicherring' (TSR) of the MPIK. The world-wide unique combination of these three state-of-the-art technologies shall enable to perform kinematically complete studies of ion-atom collision with unprecedented detail and resolution. In this thesis, a two-dimensional magneto-optical trap (2D-MOT) was developed and tested as a source of slow lithium atoms for the loading of the target MOT. This method allows a very compact setup and oers a collimated beam and a ux of cold atoms comparable to the highest uxes achieved by using laser cooling. The temperature of the atomic beam was determined to be at the scale of a few Kelvin and, thus, it is already an adequate stand-alone target for momentum resolved experiments.

•Jan 1, 2011•0 citations

An apparatus for the production of molecular Bose-Einstein condensates

Thomas Lompe

This thesis reports on the construction of an apparatus capable of producing a molecular Bose-Einstein-Condensate (BEC) of 6Li2. To create a condensate fermionic lithium is first evaporated in an oven, slowed by a Zeeman slower and captured in a magneto-optical-trap (MOT). A scheme for creating time-averaged arbitrary optical potentials for optimized transfer of the atoms from the MOT to a high-power, far detuned optical dipole trap was implemented, as well as magnetic field coils to tune the interactions of the atoms via Feshbach resonances. The first experiments with the new machine include the characterization of the optical dipole trap and evaporative cooling of 6Li.

•Jan 1, 2008•1 citation
This thesis deals with the reconstruction of a MOTRe- Mi apparatus, which represents the combination of a magneto-optical trap (MOT) and a Reaction Microscope (ReMi). With this setup an ultracold degenerate Fermi gas consisting of 6Li atoms will be generated and studied in future. Primarily the Li atoms will be vaporized, precooled in a Zeeman Slower, trapped and stored with the MOT at typical temperatures of a few 100 μK. Within the scope of this thesis initially the parameters of the Zeeman Slower were optimized. For this purpose the magnetic field profiles of the single coils were measured and the ideal coil currents determined. The efficiency and other properties of the Zeeman Slower were calculated with a simulation programme. The focus of this thesis was on planning and reconstructing the laser system and the optical setup for the magneto-optical trap. This included among others the adaptation of the laser frequencies from 7Li to 6Li and the integration of an additional amplifier in order to achieve a higher output power. Using the frequency stabilization scheme of a frequency offset lock ([SEG+99]) it is now possible to tune the laser frequency over a large range at a constant laser power. This is required on the one hand for the later transfer of the atoms to a dipole trap and on the other hand for the imaging of the atom cloud by light absorption at high magnetic fields. Finally the vacuum chamber and the Reaction microscope was baked out and activated at a vacuum of about 7 · 10-10 mbar.
This thesis reports on the first steps towards an experimental setup capable of realizing an ultracold three-component Fermi gas in an optical lattice: the construction of an apparatus that captures and cools 6Li -atoms inside a magneto optical trap (MOT). The focus of this thesis was the implementation of the Zeeman slower, the laser system and hard- and software controlling the experiment. Since these provide the starting point for all future developments it was especially important to ensure that they do not limit future experiments. With a MOT loading rate of L ~ 3 x 108 atoms/second at an oven temperature of 350 °C it is possible to capture enough atoms for further experiments in about one second allowing fast cycle times of the experiment. The achieved background pressure in the vacuum chamber, essential for the next experimental steps, is excellent as indicated by the background gas collision limited MOT lifetime of τ ~ 23 minutes. The next step will be to implement a dipole trap to further cool the 6Li -atoms.
Within the MOTREMI experiment at the Max-Plank-Institut für Kernphysik a new optical trap was constructed. A already installed magneto-optical trap cools 6Li atoms down to temperatures on the order of 100 μK. From the corresponding atoms an ultracold lithium gas is trapped inside the center of the main vacuum chamber. In the further course of the experiment, ionization measurements with a degenerate quantum gas will be carried out. In order to create theses gases, one needs to surpass the temperature limit of the magneto-optical trap. Traps using a high intensity, far red-detuned focused laser beam are able to achieve temperatures on the order of 100 nK. An intensity stabilization which is able to extend the lifetime of trapped gas was constructed in the scope of this thesis. With the use of two different photodiodes, every intensity level of the laser is covered. The high laser powers which are needed for the trap, can lead to thermal effects in the entire setup. Consequently, the properties of the laser and the optical elements the laser is passing through can change. Therefore, a quantitative analysis of these thermal effects has been carried out. Besides the shift and reduction of the focused laser beam, the thermal effect on the trap size was obtained.
This thesis describes the advances made towards a dual-species magneto-optical trap (MOT) of Li and Rb for use in photoassociation spectroscopy, Feshbach resonance studies, and, as long-term aspirations, the formation of ultracold heteronuclear polar molecules. The initial discussion will focus on a brief theoretical overview of laser cooling and trapping and the production of ultracold molecules from a cold atom source. Subsequently, details of the experimental system, including those pertaining to the required laser light, the vacuum chamber, and the computer control system will be presented. Finally, preliminary optimization and characterization measurements showing the performance of a single species Li MOT are introduced. These measurements demonstrated the loading of over 8 x 107 Li atoms directly into a MOT without the need for a Zeeman slower.
This thesis reports on the first steps towards the preparation of an ultracold threecomponent Fermi gas of 6Li in an optical lattice. A vacuum chamber and a magneto-optical trap (MOT) for 6Li were set up and characterized. The MOT will serve as a first trapping and cooling stage, from which atoms can be loaded into an optical dipole trap for further cooling. The crucial parameters of the apparatus are a high MOT loading rate for fast experiment cycles, and a low background pressure, which will provide an undisturbed environment and thus a long lifetime for atoms in the lattice. The loading rate of the MOT was measured to be L ~ 3 x 108 atoms/s at an oven temperature of Toven = 350 C, which exceeds current state of the art experiments and will allow for loading times of less than one second in the planned experiments. The background collision limited lifetime of atoms in the MOT is t ~ 23 min. Collisions with the background gas are therefore not expected to be a limiting factor for the lifetime of atoms in the optical lattice.
A new experiment is being built at the Max-Planck-Institut für Kernphysik (MPIK) within the PRIOC project (Precision studies on Ion Collisions) where a reaction microscope (Remi) and a magneto-optical trap (MOT) as target are combined to a so called MOTRemi. This setup will be implemented into the ion storage ring 'Testspeicherring' (TSR) of the MPIK. The world-wide unique combination of these three state-of-the-art technologies shall enable to perform kinematically complete studies of ion-atom collision with unprecedented detail and resolution. In this thesis, a two-dimensional magneto-optical trap (2D-MOT) was developed and tested as a source of slow lithium atoms for the loading of the target MOT. This method allows a very compact setup and oers a collimated beam and a ux of cold atoms comparable to the highest uxes achieved by using laser cooling. The temperature of the atomic beam was determined to be at the scale of a few Kelvin and, thus, it is already an adequate stand-alone target for momentum resolved experiments.
This thesis reports on the construction of an apparatus capable of producing a molecular Bose-Einstein-Condensate (BEC) of 6Li2. To create a condensate fermionic lithium is first evaporated in an oven, slowed by a Zeeman slower and captured in a magneto-optical-trap (MOT). A scheme for creating time-averaged arbitrary optical potentials for optimized transfer of the atoms from the MOT to a high-power, far detuned optical dipole trap was implemented, as well as magnetic field coils to tune the interactions of the atoms via Feshbach resonances. The first experiments with the new machine include the characterization of the optical dipole trap and evaporative cooling of 6Li.