Optical coherence tomography (OCT) in the mid infrared (MIR) spectral range by using spontaneous parametric down conversion (SPDC) in a nonlinear interferometer offers an elegant way for miniaturizing said OCT systems in the MIR by detecting correlated near infrared (NIR) photons only. This “sensing with undetected photons” was recently miniaturized and allowed non-destructive optical testing of ceramics in an industrial environment. The demonstrated quantum interferometer module featured a footprint of 80 × 60 mm2. The module included a 700 mW continues wave 660 nm pump laser, a 2.5 mm long ppKTP crystal for type-0 colinear SPDC, a 3.8 µm MIR free space emission port to the device under test and a NIR fiber port to connect to a NIR grating spectrometer with a 50 nm wavelength span near 800 nm. While the SPDC at maximum pump power resulted in about 108 photons per second detected on the NIR spectrometer, we explored whether optimized focusing conditions could potentially further improve this. To this end, we devised an experiment to investigate the impact of a range of different pump focusing conditions on the SPDC-brightness, while always matching the effective focusing parameter for the signal-photon fiber coupling. Experimentally, this was achieved by employing a three-lens beam expander telescope in the collimated part of the pump (and signal) beam, carefully monitoring the collimation condition and optimizing the NIR fiber coupling. Thus, we were able to obtain a maximally optimized SPDC brightness and quantum interference visibility for a large range of different focusing conditions. The maximum brightness was observed for a pump beam diameter of approximately 30 µm in a 2.5 mm long ppKTP crystal, corresponding to a focusing parameter of about 0.7. This result supports the optimized designing and miniaturizing of SPDC experiments and thereby allows a wider application in real-world measurement systems.
Optical coherence tomography (OCT) in the mid infrared (MIR) spectral range by using spontaneous parametric down conversion (SPDC) in a nonlinear interferometer offers an elegant way for miniaturizing said OCT systems in the MIR by detecting correlated near infrared (NIR) photons only. This “sensing with undetected photons” was recently miniaturized and allowed non-destructive optical testing of ceramics in an industrial environment. The demonstrated quantum interferometer module featured a footprint of 80 × 60 mm2. The module included a 700 mW continues wave 660 nm pump laser, a 2.5 mm long ppKTP crystal for type-0 colinear SPDC, a 3.8 µm MIR free space emission port to the device under test and a NIR fiber port to connect to a NIR grating spectrometer with a 50 nm wavelength span near 800 nm. While the SPDC at maximum pump power resulted in about 108 photons per second detected on the NIR spectrometer, we explored whether optimized focusing conditions could potentially further improve this. To this end, we devised an experiment to investigate the impact of a range of different pump focusing conditions on the SPDC-brightness, while always matching the effective focusing parameter for the signal-photon fiber coupling. Experimentally, this was achieved by employing a three-lens beam expander telescope in the collimated part of the pump (and signal) beam, carefully monitoring the collimation condition and optimizing the NIR fiber coupling. Thus, we were able to obtain a maximally optimized SPDC brightness and quantum interference visibility for a large range of different focusing conditions. The maximum brightness was observed for a pump beam diameter of approximately 30 µm in a 2.5 mm long ppKTP crystal, corresponding to a focusing parameter of about 0.7. This result supports the optimized designing and miniaturizing of SPDC experiments and thereby allows a wider application in real-world measurement systems.
Optical coherence tomography (OCT) in the mid infrared (MIR) spectral range offers an elegant way of non-destructive optical testing of coatings that are opaque at visible and near infrared (NIR) wavelengths. However, light sources and detection equipment in the MIR are somewhat cumbersome due to low emission intensity and detectivity. Here we use spontaneous parametric down-conversion (SPDC) in a periodically poled KTP crystal pumped with 700 mW at 660 nm. The SPDC produces MIR photons near 3.8 µm and entangled NIR photons near 800 nm. All three wavelengths are used in a Michelson-type quantum interferometer. Only MIR photons interact with the device under test (DUT) and share their interference information with the NIR via the entanglement. The NIR photons are then analyzed with a conventional silicon-based spectrometer, thus, allowing MIR "sensing with undetected photons". We were able to shrink the quantum interferometer module to a footprint of 80 x 60 mm² including the 660 nm pump laser. The external MIR beam path offers a length of 235 mm ± 1.5 mm to the DUT and a single mode fiber port to the spectrometer. Using a mirror as a DUT we achieved a visibility of the quantum interference of up to 39%.
Metrology with undetected photons is an emerging technique that leverages quantum effects and photon correlations (entanglement) to retrieve valuable information in a target spectral range (e.g., mid-infrared, mid-IR) using measurements in an easily accessible domain (e.g., visible, near-IR). The underlying quantum process of spontaneous parametric down-conversion (SPDC) is utilized to generate non-degenerate correlated signal and idler photons to serve as detection and probing photons, respectively. Sensing with undetected photons enables important advantages, such as ultra-low probe powers, room-temperature operation, and shot-noise-limited detection. In this contribution, we apply a quantum nonlinear interferometer based on an SPDC source to perform applied mid-IR spectroscopy, mid-IR microscopy, and mid-IR optical coherence tomography (OCT) as among the most promising techniques for quantum-based routine non-destructive testing. Moreover, we characterize the system, benchmark it against classical systems, and provide a prospective outlook for this new technology.
Sensing applications in the mid-infrared (MIR) spectral range are challenging due to the high cost and low performance of the available light sources and detectors. This issue can be bypassed by utilizing the process of spontaneous parametric down-conversion (SPDC) to generate tailored MIR-NIR photon-pairs. The nature of SPDC enforces the generation of frequency-entanglement between these paired photons which can be used for spectroscopy: Within a nonlinear interferometric configuration, the MIR radiation is employed for the illumination of a specific material, whereas the NIR radiation is analyzed using a conventional spectrometer. This technique, which is referred to as sensing with ”undetected photons”, so far relied on a breadboard optical setup that is both space-consuming, heavy and complex. Here we present the design, manufacturing and application of a miniaturized quantum light module, with a footprint of less than 80 x 60 mm², which is powered by a direct emitting diode laser at 720 nm. The module contains the nonlinear crystal as the quantum light source, the optical path for the NIR beam, and mechanical connectors leading to the MIR sensing arm. It also provides an interconnection to a spectrometer for the information-carrying NIR photons. This study presents insights into the optical design of the module, its manufacturing and the nonlinear optics quantum light source. The module emits a MIR-NIR photon-pair rate of 1.7 × 109 s−1 W−1, which allows for the implementation of time-efficient sensing applications. The design is optimized for a first application - the detection of synthetic polymers in aqueous solutions, which will be illustrated by concepts for the detection of micro-plastics in wastewater in the field with a mobile device. The potential for integrating a sophisticated, non-linear optical interference configuration into a user-friendly micro-module paves the way for the development of industry-ready setups. This enables a variety of other applications, which are covered by sensing with undetected photons.
Recent years have seen the development of quantum sensing concepts utilizing nonlinear interferometers based on correlated photon pairs generated by spontaneous parametric down-conversion (SPDC). Using SPDC far from frequency degeneracy allows a “division of labor” between the mid-infrared photon for the strongest sample interaction and the correlated near-infrared photon for low-noise detection. The small number of photons provided by SPDC and the resulting inferior signal-to-noise ratio are, however, a limiting factor preventing the wide applicability of the novel sensing concept. Here, we demonstrate a nonlinear interferometer based on pump-enhanced SPDC with strongly improved emission rates while maintaining broadband spontaneous emission. For validation of the concept, we demonstrate high-resolution mid-infrared spectroscopy with near-infrared detection, showcasing improved accuracy. Although the number of mid-infrared photons is about five orders of magnitude smaller than in classical spectrometers, the sensitivity of the quantum spectrometer becomes comparable, marking an essential step toward real-world applications.
Photon pairs from spontaneous parametric down-conversion (SPDC) are important for a wide range of quantum optics experiments with spectral properties such as their bandwidths often being a crucial concern. Here we show the generic existence of particular phase-matching conditions in quasi-phase-matched KTP, MgO:LN, and SLT crystals that lead to ultra-broadband, widely nondegenerate photon pairs. It is based on the existence of group-velocity-matched, far apart wavelength pairs and, for 2 mm long crystals, results in SPDC bandwidths between 15 and 25 THz for photon pairs with the idler photon in the technologically relevant mid-IR range of 3-5 μm and the signal photon in the near-IR below 1100 nm. We experimentally demonstrate this type of broadband phase matching in ppKTP crystals for photon pairs centered at 800 and 3800 nm and measure a bandwidth of 15 THz. This novel method of generating broadband photon pairs will be highly beneficial for SPDC-based imaging, spectroscopy, refractometry, and optical coherence tomography with undetected mid-IR photons.
Both correlated-mode coupling efficiency and photon pair flux (brightness) of spontaneous parametric down-conversion (SPDC) coupled into single-mode fibers are key parameters for various quantum information science applications. We present an experimental investigation on the optimization of the correlated-mode coupling efficiency and the brightness of frequency-degenerated SPDC photon pairs into single-mode optical fibers. Using photon pairs generated from a type-I phase-matched bulk $\ensuremath{\beta}$-barium borate crystal pumped by a continuous-wave laser, we carefully evaluated both the correlated-mode coupling efficiency and the brightness of SPDC light coupled to a single-mode optical fiber, while continuously changing the focusing of the pump and collection modes, experimenting with Rayleigh lengths from 3 to 280 (for the pump) and 0.2 to 20 (for the collection) times the crystal length. The measured data suggest that the correlated-mode coupling efficiency can be close to unity for any pump focus, however, the optimal Rayleigh length of the collection mode depends on the pump focus parameter, and the brightness can be increased by tightening the pump focus, provided that the Rayleigh length of the collection mode is precisely adjusted. A maximal correlated-mode coupling efficiency of $99.0\ifmmode\pm\else\textpm\fi{}1.3%$ was experimentally achieved. These results will be useful for photonic quantum science and technology using SPDC sources with high heralding efficiencies.