Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Hot ion implantation for creating dense NV ensemble near the diamond surface

Midrel Wilfried Ngandeu Ngambou, Perrin, Pauline, Alexandre Tallaire, Ovidiu Brinza, Vianney Mille, Valentin, Audrey, Fabien Bénédic, Philippe Goldner, Jocelyn Achard

Published Feb 28, 2024• 0 citations
OpenAlex

Related papers

Long dephasing time of NV center spins in diamond layers formed by hot ion implantation and high pressure high temperature annealing

V. P. Popov, Sergey N. Podlesny, I. A. Kartashov +2 more

Diamond and Related Materials•Oct 28, 2021•18 citations

Detection and Manipulation of Single NV Centers in Diamond

Sorawis Sangtawesin, T.O. Brundage, S.A. Perlman +1 more

Bulletin of the American Physical Society•Mar 20, 2013•1 citation

Efficient creation of shallow NV$^-$ ensembles by high-angle ion implantation

Kento Sasaki, Hideyuki Watanabe, Tokuyuki Teraji +3 more

Negatively charged nitrogen-vacancy (NV$^-$) centers located a few nanometers below the diamond surface are key quantum defects for nanoscale sensing of external spins. However, the creation of shallow NV$^-$ centers with high yield remains a materials challenge. Here, we demonstrate that high-angle ion implantation enhances the creation efficiency of shallow NV$^-$ centers. By implanting $^{15}$N ions at angles exceeding 60$^\circ$, we achieve high NV$^-$ yields approaching 10% with effective NV$^-$ depths below 10 nm. These yields are significantly higher than those typically reported for shallow NV$^-$ creation. The enhanced NV$^-$ yield is consistent with an increased vacancy-to-nitrogen ratio in the near-surface region, which is expected to promote NV formation during annealing. The created NV$^-$ ensembles show coherence properties comparable to those of single shallow NV$^-$ centers at similar depths, and allow detection of nuclear spins in van der Waals materials attached to the diamond surface. Our results establish geometric control of ion implantation as a simple and broadly applicable approach to engineer shallow vacancy-related quantum defects.

quant-pharXiv:2609.22937•Physical Review Materials•Sep 22, 2026•0 citations

Hot ion implantation to create dense NV center ensembles in diamond

Midrel Wilfried Ngandeu Ngambou, Pauline Perrin, Ionuț Gabriel Balașa +9 more

Creating dense and shallow nitrogen-vacancy (NV) ensembles with good spin properties is a prerequisite for developing diamond-based quantum sensors exhibiting better performance. Ion implantation is a key enabling tool for precisely controlling spatial localization and density of NV color centers in diamond. However, it suffers from a low creation yield, while higher ion fluences significantly damage the crystal lattice. In this work, we realize N2+ ion implantation in the 30–40 keV range at high temperatures. At 800 °C, NV's ensemble photoluminescence emission is three to four times higher than room temperature implanted films, while narrow electron spin resonance linewidths of 1.5 MHz, comparable to well-established implantation techniques, are obtained. In addition, we found that ion fluences above 2 × 1014 ions/cm2 can be used without graphitization of the diamond film, in contrast to room temperature implantation. This study opens promising perspectives in optimizing diamond films with implanted NV ensembles that could be integrated into quantum sensing devices.

arXiv:2311.05328•Applied Physics Letters•Mar 25, 2024•19 citations

Enhancement of the creation yield of NV ensembles in a chemically vapour deposited diamond

Priyadharshini Balasubramanian, Christian Osterkamp, Ovidiu Brinza +7 more

Carbon•Apr 4, 2022•37 citations

Impact of Helium Ion Implantation Dose and Annealing on Dense Near-Surface Layers of NV Centers

Andris Bērziņš, Hugo Grube, Einārs Sprūģis +2 more

The implantation of diamonds with helium ions has become a common method to create hundreds-nanometers-thick near-surface layers of NV centers for high-sensitivity sensing and imaging applications; however, optimal implantation dose and annealing temperature are still a matter of discussion. In this study, we irradiated HPHT diamonds with an initial nitrogen concentration of 100 ppm using different implantation doses of helium ions to create 200-nm thick NV layers. We compare a previously considered optimal implantation dose of ∼1012 He+/cm2 to double and triple doses by measuring fluorescence intensity, contrast, and linewidth of magnetic resonances, as well as longitudinal and transversal relaxation times T1 and T2. From these direct measurements, we also estimate concentrations of P1 and NV centers. In addition, we compare the three diamond samples that underwent three consequent annealing steps to quantify the impact of processing at 1100 °C, which follows initial annealing at 800 °C. By tripling the implantation dose, we have increased the magnetic sensitivity of our sensors by 28±5%. By projecting our results to higher implantation doses, we demonstrate that it is possible to achieve a further improvement of up to 70%. At the same time, additional annealing steps at 1100 °C improve the sensitivity only by 6.6 ± 2.7%.

arXiv:2204.14201•Nanomaterials•Jun 29, 2022•12 citations
Efficient creation of shallow NV−^-− ensembles by high-angle ion implantation
Negatively charged nitrogen-vacancy (NV−^-−) centers located a few nanometers below the diamond surface are key quantum defects for nanoscale sensing of external spins. However, the creation of shallow NV−^-− centers with high yield remains a materials challenge. Here, we demonstrate that high-angle ion implantation enhances the creation efficiency of shallow NV−^-− centers. By implanting 15^{15}15N ions at angles exceeding 60∘^\circ∘, we achieve high NV−^-− yields approaching 10% with effective NV−^-− depths below 10 nm. These yields are significantly higher than those typically reported for shallow NV−^-− creation. The enhanced NV−^-− yield is consistent with an increased vacancy-to-nitrogen ratio in the near-surface region, which is expected to promote NV formation during annealing. The created NV−^-− ensembles show coherence properties comparable to those of single shallow NV−^-− centers at similar depths, and allow detection of nuclear spins in van der Waals materials attached to the diamond surface. Our results establish geometric control of ion implantation as a simple and broadly applicable approach to engineer shallow vacancy-related quantum defects.
Creating dense and shallow nitrogen-vacancy (NV) ensembles with good spin properties is a prerequisite for developing diamond-based quantum sensors exhibiting better performance. Ion implantation is a key enabling tool for precisely controlling spatial localization and density of NV color centers in diamond. However, it suffers from a low creation yield, while higher ion fluences significantly damage the crystal lattice. In this work, we realize N2+ ion implantation in the 30–40 keV range at high temperatures. At 800 °C, NV's ensemble photoluminescence emission is three to four times higher than room temperature implanted films, while narrow electron spin resonance linewidths of 1.5 MHz, comparable to well-established implantation techniques, are obtained. In addition, we found that ion fluences above 2 × 1014 ions/cm2 can be used without graphitization of the diamond film, in contrast to room temperature implantation. This study opens promising perspectives in optimizing diamond films with implanted NV ensembles that could be integrated into quantum sensing devices.
The implantation of diamonds with helium ions has become a common method to create hundreds-nanometers-thick near-surface layers of NV centers for high-sensitivity sensing and imaging applications; however, optimal implantation dose and annealing temperature are still a matter of discussion. In this study, we irradiated HPHT diamonds with an initial nitrogen concentration of 100 ppm using different implantation doses of helium ions to create 200-nm thick NV layers. We compare a previously considered optimal implantation dose of ∼1012 He+/cm2 to double and triple doses by measuring fluorescence intensity, contrast, and linewidth of magnetic resonances, as well as longitudinal and transversal relaxation times T1 and T2. From these direct measurements, we also estimate concentrations of P1 and NV centers. In addition, we compare the three diamond samples that underwent three consequent annealing steps to quantify the impact of processing at 1100 °C, which follows initial annealing at 800 °C. By tripling the implantation dose, we have increased the magnetic sensitivity of our sensors by 28±5%. By projecting our results to higher implantation doses, we demonstrate that it is possible to achieve a further improvement of up to 70%. At the same time, additional annealing steps at 1100 °C improve the sensitivity only by 6.6 ± 2.7%.