Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optical and Quantum Electronics

Investigation of ASE contribution to copper bromide amplifier output signal

Nikolai A. Vasnev, Maxim V. Trigub

Published Dec 14, 2023• 4 citations
Publisher

Abstract

Abstract The paper is devoted to research the single-pass operating mode of active element on copper bromide vapors and time dependence of ratio «signal/ASE». The results show how the single-pass radiation power depends on time delay between ASE pulse and moment when the input signal enters to active element. Light waveforms (ASE, input signal, output signal) are recorded at each time delay. The minimal time delay was 5.2 ns, power radiation in this case was 3.47 W. The radiation power was reducing as the time delay was increased in increments of about 2 ns. The waveforms prove that the active element output signal contains two components: the first – ASE (amplified spontaneous emission), which is formed as result of the active substance atom excitation and their further spontaneous transitions; the second – single-pass radiation amplified by means of inverse population of the active media. The waveforms allow to estimate the useful signal to noise ratio or other words «signal/ASE». The highest gain is provided with the lowest time delay due to the population inversion is maximum in this case.

DOI
10.1007/s11082-023-05724-6

Related papers

Bidirectional GHz bandwidth amplified spontaneous emission generation and high output power single-pass optical amplification through a hot Cs vapor cell

Mingyu Lee, Siheon Ryu, Seokjin Kim +4 more

We report the characteristics of GHz bandwidth amplified spontaneous emission (ASE) from a hot Cs atom vapor cell, where the optical feedback was inhibited. When pumped by an 852 nm laser, both forward and backward ASE output near 894 nm showed a nonlinear increase in its power without a pump power threshold. A continual decrease in spectral width down to 4.7 GHz was experimentally observed as the ASE output power increased. Using the same vapor cell, we injected a 1mW signal to configure a single-pass optical amplifier, and we monitored the forward output both in temporal and spectral domains. We found the signal laser efficiently suppressed the ASE and obtained a large amplification factor over 700 at the pump power of 1.2 W.

Optics Continuum•Jan 13, 2022•4 citations

A CuBr-Based Brightness Amplifier with a Repetition Frequency of Superradiance/Amplification Pulses up to 200 kHz

Ilya S. Musorov, S. N. Torgaev, Gennadiy S. Evtushenko

Abstract The results of research and development of a high-speed brightness amplifier based on an active medium on copper bromide vapors with a pulse repetition frequency of up to 200 kHz are presented. Operation at such repetition frequency was made possible owing to the mode of reduced energy input into the discharge (less than 60 μJ/cm3 per pulse) by means of shortening the front of the high-voltage pump pulse to 20 ns and the duration (at half-height) to 30 ns.

Technical Physics Letters•Dec 1, 2021•3 citations

Theory of optical-gain measurements

Peter S. Cross, William G. Oldham

The widely used technique for determining optical gain and absorption from single-pass, amplified spontaneous emission (ASE) is analyzed with particular attention given to active-volume saturation and three-dimensional effects. The results for homogeneously broadened media show that the population inversion and hence the gain in the active region is diminished by high levels of spontaneous and ASE. The externally measured gain is further reduced for large output collection apertures that admit incompletely amplified off-axis rays. Criteria are given for the excitation and detection geometries required to ensure accurate (∼10-percent) gain measurement. The simultaneous measurement of the equilibrium absorption coefficient can be made under less restrictive conditions.

IEEE Journal of Quantum Electronics•May 1, 1975•66 citations

Imaging systems based on active optical signal converters

Maxim V. Trigub, Dmitriy V. Shiyanov, Nikolay A. Vasnev +1 more

The use of metal atom active media allows to convert optical signals with the transferring of the adjusted contrast. Due to the opportunities of metal vapor active media it makes possible to increase the intensity of the signal in the narrow spectral range. As a result, the signal-to-noise ratio can be dramatically increased. It makes possible to build active optical systems for high speed imaging of processes which are hidden by high intensive radiation. In the systems is available the image active filtration due to induced transition on metal atoms. Active optical systems with metal vapor brightness amplifiers (which is called Laser monitor), have shown the high efficiency for reducing the background radiation effect on the observing processes in the real-time mode. Moreover, the use of different active media makes it possible to change the spectral contest of the input signal with the increasing of the intensity. In the work the result of the research such systems are presented. The method of transformation IR images to VIS images is discussed. The work presents the results of the using of different active optical systems for high speed imaging.

Unconventional Optical Imaging•Mar 30, 2020•0 citations

Stimulated emission in optically pumped atomic-copper vapor

Jin Joong Kim, Nackchin Sung

We have observed, for the first time to our knowledge, stimulated emission in atomic-copper vapor that is excited by a resonant tunable laser beam. One of the important and interesting results obtained in this experiment is that excitation of the (2)P(1/2) level of the copper atoms generates strong amplified spontaneous emission (ASE) for both(2)P(1/2)-(2)D(3/2) and (2)P(3/2)-(2)D(5/2) transitions. This is the first reported direct experimental evidence observed for collisional mixing between the (2)P(1/2) and (2)P(3/2) levels in a copper-vapor laser. Excitation of the (2)P(3/2) level induces substantially weaker ASE for the (2)P(1/2)-(2)D(3/2) transition. In addition, we observed collision-induced ASE for both transitions over a wide range of detuning of the pump frequency. The preliminary results of the experiment are presented, and the implications of the results for high-pressure copper-vapor lasers are discussed.

Optics Letters•Nov 1, 1987•6 citations

Amplified spontaneous emission and maximum gain–length product revised for general line shapes

Riccardo Tommasini, Juerg E. Balmer

The theory of amplified spontaneous emission (ASE) and the gain–length product at saturation is revised. Formulas valid for both peak and integrated lines are given. In the latter case the solution for a general Voigt stimulated-emission line shape is presented, whereas in the two limiting cases of Gaussian and Lorentzian line shapes an approximation better than the one obtained by the steepest-descent method is successfully achieved. Various parameters that take into account the ratio of spontaneous to stimulated linewidths, the form factor depending on the linewidths of the inhomogeneous and homogeneous convoluted line shapes, and the population inversion fraction arise from the theory, giving the complete functional dependence for both the ASE photon flux and the gain–length product.

Journal of the Optical Society of America B•Apr 1, 1999•12 citations
Abstract The paper is devoted to research the single-pass operating mode of active element on copper bromide vapors and time dependence of ratio «signal/ASE». The results show how the single-pass radiation power depends on time delay between ASE pulse and moment when the input signal enters to active element. Light waveforms (ASE, input signal, output signal) are recorded at each time delay. The minimal time delay was 5.2 ns, power radiation in this case was 3.47 W. The radiation power was reducing as the time delay was increased in increments of about 2 ns. The waveforms prove that the active element output signal contains two components: the first – ASE (amplified spontaneous emission), which is formed as result of the active substance atom excitation and their further spontaneous transitions; the second – single-pass radiation amplified by means of inverse population of the active media. The waveforms allow to estimate the useful signal to noise ratio or other words «signal/ASE». The highest gain is provided with the lowest time delay due to the population inversion is maximum in this case.
We report the characteristics of GHz bandwidth amplified spontaneous emission (ASE) from a hot Cs atom vapor cell, where the optical feedback was inhibited. When pumped by an 852 nm laser, both forward and backward ASE output near 894 nm showed a nonlinear increase in its power without a pump power threshold. A continual decrease in spectral width down to 4.7 GHz was experimentally observed as the ASE output power increased. Using the same vapor cell, we injected a 1mW signal to configure a single-pass optical amplifier, and we monitored the forward output both in temporal and spectral domains. We found the signal laser efficiently suppressed the ASE and obtained a large amplification factor over 700 at the pump power of 1.2 W.
The widely used technique for determining optical gain and absorption from single-pass, amplified spontaneous emission (ASE) is analyzed with particular attention given to active-volume saturation and three-dimensional effects. The results for homogeneously broadened media show that the population inversion and hence the gain in the active region is diminished by high levels of spontaneous and ASE. The externally measured gain is further reduced for large output collection apertures that admit incompletely amplified off-axis rays. Criteria are given for the excitation and detection geometries required to ensure accurate (∼10-percent) gain measurement. The simultaneous measurement of the equilibrium absorption coefficient can be made under less restrictive conditions.
The use of metal atom active media allows to convert optical signals with the transferring of the adjusted contrast. Due to the opportunities of metal vapor active media it makes possible to increase the intensity of the signal in the narrow spectral range. As a result, the signal-to-noise ratio can be dramatically increased. It makes possible to build active optical systems for high speed imaging of processes which are hidden by high intensive radiation. In the systems is available the image active filtration due to induced transition on metal atoms. Active optical systems with metal vapor brightness amplifiers (which is called Laser monitor), have shown the high efficiency for reducing the background radiation effect on the observing processes in the real-time mode. Moreover, the use of different active media makes it possible to change the spectral contest of the input signal with the increasing of the intensity. In the work the result of the research such systems are presented. The method of transformation IR images to VIS images is discussed. The work presents the results of the using of different active optical systems for high speed imaging.
We have observed, for the first time to our knowledge, stimulated emission in atomic-copper vapor that is excited by a resonant tunable laser beam. One of the important and interesting results obtained in this experiment is that excitation of the (2)P(1/2) level of the copper atoms generates strong amplified spontaneous emission (ASE) for both(2)P(1/2)-(2)D(3/2) and (2)P(3/2)-(2)D(5/2) transitions. This is the first reported direct experimental evidence observed for collisional mixing between the (2)P(1/2) and (2)P(3/2) levels in a copper-vapor laser. Excitation of the (2)P(3/2) level induces substantially weaker ASE for the (2)P(1/2)-(2)D(3/2) transition. In addition, we observed collision-induced ASE for both transitions over a wide range of detuning of the pump frequency. The preliminary results of the experiment are presented, and the implications of the results for high-pressure copper-vapor lasers are discussed.
The theory of amplified spontaneous emission (ASE) and the gain–length product at saturation is revised. Formulas valid for both peak and integrated lines are given. In the latter case the solution for a general Voigt stimulated-emission line shape is presented, whereas in the two limiting cases of Gaussian and Lorentzian line shapes an approximation better than the one obtained by the steepest-descent method is successfully achieved. Various parameters that take into account the ratio of spontaneous to stimulated linewidths, the form factor depending on the linewidths of the inhomogeneous and homogeneous convoluted line shapes, and the population inversion fraction arise from the theory, giving the complete functional dependence for both the ASE photon flux and the gain–length product.