Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

Theory of optical-gain measurements

Peter S. Cross, William G. Oldham

Published May 1, 1975• 66 citations
Publisher

Abstract

The widely used technique for determining optical gain and absorption from single-pass, amplified spontaneous emission (ASE) is analyzed with particular attention given to active-volume saturation and three-dimensional effects. The results for homogeneously broadened media show that the population inversion and hence the gain in the active region is diminished by high levels of spontaneous and ASE. The externally measured gain is further reduced for large output collection apertures that admit incompletely amplified off-axis rays. Criteria are given for the excitation and detection geometries required to ensure accurate (∼10-percent) gain measurement. The simultaneous measurement of the equilibrium absorption coefficient can be made under less restrictive conditions.

DOI
10.1109/jqe.1975.1068592

Related papers

Small signal gain measurement by amplified spontaneous emission content of an inverted medium: simplified treatment

Davood Razzaghi, Fereshteh Hajiesmaeilbaigi, Mohsen Ruzbehani +1 more

A method is introduced for small signal gain measurement in a low-saturation regime using an amplified spontaneous emission (ASE) footprint of a gain media. By this method, the ratio of intensities, with and without a reflector, is measured beside the bandwidth of the ASE, hence two equations are formed. An iterative solution of these equations will simultaneously determine both the small signal gain and the loss.

Optical Engineering•Oct 5, 2012•2 citations

Amplified Spontaneous Emission in Slab Amplifiers

Chana Goren, Y. Tzuk, Gilad Marcus +1 more

Amplified spontaneous emission (ASE) occurs in media with large gain, and affects both the magnitude and the spatial distribution of the inversion. In this work we theoretically study the effect of ASE in three-dimensional, rectangular slab amplifiers, using Monte Carlo type computer simulations. We found that in one-dimensional amplifiers ASE is always larger at the edges so that the inversion has a maxima at the center of the amplifier. However, in two- and three-dimensional amplifiers, the inversion has a minimum at the center of the amplifier for low gain, and a maximum at the center of the amplifier for high gain. Thus, the inversion profile can be changed by increasing the gain from a minimum at the center, through a plateau, to a maximum at the center. A simple analytical theory was developed and agrees with these results.

IEEE Journal of Quantum Electronics•Dec 1, 2006•25 citations

Wave-optics description of amplified spontaneous emission

J. C. Garrison, Burke Ritchie, Howard Nathel +2 more

Paraxial Maxwell-Bloch theory is used to describe amplified spontaneous emission (ASE) in strongly inverted media. Counterpropagation of waves coupled through gain saturation and diffraction, and pumping by a laser beam which propagates transverse to the amplifier are included in the treatment. The reactive part of the medium polarization is calculated by population-rate equations in the limit of rapid dephasing of the atomic dipoles. The spontaneous emission noise source needed for the numerical simulation of Maxwell's equations is derived from microscopic theory by coarse-graining, thereby establishing the compatibility of the spherically symmetric microscopic source with paraxial propagation theory. The three coupled Maxwell equations for the counterpropagating ASE waves and the transversely propagating pump wave are solved numerically in time and two spatial dimensions. This simulation is used to calculate the longitudinal profile of the transverse fluorescence, which measures the saturation of the gain, the longitudinal profile of the transmitted pump wave, which measures the saturation of pump absorption, and the transverse coherence function of the radiation emitted from the ends of the amplifier.

Physical Review A•May 1, 1991•9 citations

Amplified spontaneous emission and maximum gain–length product revised for general line shapes

Riccardo Tommasini, Juerg E. Balmer

The theory of amplified spontaneous emission (ASE) and the gain–length product at saturation is revised. Formulas valid for both peak and integrated lines are given. In the latter case the solution for a general Voigt stimulated-emission line shape is presented, whereas in the two limiting cases of Gaussian and Lorentzian line shapes an approximation better than the one obtained by the steepest-descent method is successfully achieved. Various parameters that take into account the ratio of spontaneous to stimulated linewidths, the form factor depending on the linewidths of the inhomogeneous and homogeneous convoluted line shapes, and the population inversion fraction arise from the theory, giving the complete functional dependence for both the ASE photon flux and the gain–length product.

Journal of the Optical Society of America B•Apr 1, 1999•12 citations

Novel gain measurement technique for high gain amplifiers

Brian K. Garside, T. Efthymiopoulos

A new method for determining the gain in high gain amplifiers is reported. The technique only requires measurements of the relative intensity and the output spectral width of the amplified spontaneous emission from the amplifier as a function of input pumping. The results of an experimental test of this technique using a flashlamp-pumped rhodamine 6G dye amplifier are described. Simple approximate analytical models are used to compare with experiment thereby determining the gain. The results are found to be in good agreement with both more accurate gain measurements and an alternative technique which can be applied over a restricted range of operational parameters.

Applied Optics•Sep 1, 1979•2 citations

Amplification of spontaneous emission and gain measurement in dye amplifiers

Thomas Efthimiopoulos, Brian K. Garside

A comparison is reported of the observed spectral narrowing of amplified spontaneous emission from dye amplifiers with predictions from a dynamical model based on rate equations. This is employed to develop a generally applicable method of determining the unsaturated gain within the dye medium. Comparison is made with another technique for determining gain over the restricted pumping range for which it is applicable. The matching of theory to experiment is sufficiently sensitive that good values can also be determined for the wavelength dependence of the excited singlet state absorption cross section.

Canadian Journal of Physics•Jun 1, 1981•6 citations
The widely used technique for determining optical gain and absorption from single-pass, amplified spontaneous emission (ASE) is analyzed with particular attention given to active-volume saturation and three-dimensional effects. The results for homogeneously broadened media show that the population inversion and hence the gain in the active region is diminished by high levels of spontaneous and ASE. The externally measured gain is further reduced for large output collection apertures that admit incompletely amplified off-axis rays. Criteria are given for the excitation and detection geometries required to ensure accurate (∼10-percent) gain measurement. The simultaneous measurement of the equilibrium absorption coefficient can be made under less restrictive conditions.
Amplified spontaneous emission (ASE) occurs in media with large gain, and affects both the magnitude and the spatial distribution of the inversion. In this work we theoretically study the effect of ASE in three-dimensional, rectangular slab amplifiers, using Monte Carlo type computer simulations. We found that in one-dimensional amplifiers ASE is always larger at the edges so that the inversion has a maxima at the center of the amplifier. However, in two- and three-dimensional amplifiers, the inversion has a minimum at the center of the amplifier for low gain, and a maximum at the center of the amplifier for high gain. Thus, the inversion profile can be changed by increasing the gain from a minimum at the center, through a plateau, to a maximum at the center. A simple analytical theory was developed and agrees with these results.
Paraxial Maxwell-Bloch theory is used to describe amplified spontaneous emission (ASE) in strongly inverted media. Counterpropagation of waves coupled through gain saturation and diffraction, and pumping by a laser beam which propagates transverse to the amplifier are included in the treatment. The reactive part of the medium polarization is calculated by population-rate equations in the limit of rapid dephasing of the atomic dipoles. The spontaneous emission noise source needed for the numerical simulation of Maxwell's equations is derived from microscopic theory by coarse-graining, thereby establishing the compatibility of the spherically symmetric microscopic source with paraxial propagation theory. The three coupled Maxwell equations for the counterpropagating ASE waves and the transversely propagating pump wave are solved numerically in time and two spatial dimensions. This simulation is used to calculate the longitudinal profile of the transverse fluorescence, which measures the saturation of the gain, the longitudinal profile of the transmitted pump wave, which measures the saturation of pump absorption, and the transverse coherence function of the radiation emitted from the ends of the amplifier.
The theory of amplified spontaneous emission (ASE) and the gain–length product at saturation is revised. Formulas valid for both peak and integrated lines are given. In the latter case the solution for a general Voigt stimulated-emission line shape is presented, whereas in the two limiting cases of Gaussian and Lorentzian line shapes an approximation better than the one obtained by the steepest-descent method is successfully achieved. Various parameters that take into account the ratio of spontaneous to stimulated linewidths, the form factor depending on the linewidths of the inhomogeneous and homogeneous convoluted line shapes, and the population inversion fraction arise from the theory, giving the complete functional dependence for both the ASE photon flux and the gain–length product.
A new method for determining the gain in high gain amplifiers is reported. The technique only requires measurements of the relative intensity and the output spectral width of the amplified spontaneous emission from the amplifier as a function of input pumping. The results of an experimental test of this technique using a flashlamp-pumped rhodamine 6G dye amplifier are described. Simple approximate analytical models are used to compare with experiment thereby determining the gain. The results are found to be in good agreement with both more accurate gain measurements and an alternative technique which can be applied over a restricted range of operational parameters.
A comparison is reported of the observed spectral narrowing of amplified spontaneous emission from dye amplifiers with predictions from a dynamical model based on rate equations. This is employed to develop a generally applicable method of determining the unsaturated gain within the dye medium. Comparison is made with another technique for determining gain over the restricted pumping range for which it is applicable. The matching of theory to experiment is sufficiently sensitive that good values can also be determined for the wavelength dependence of the excited singlet state absorption cross section.