Abstract It is already evident from the basic physical picture developed in Chapter l that mainly two parameters determine radiation trapping: the strength of the absorption and the spectral shape of the absorption. The strength of the absorption is characterized by the opacity of the atomic vapour, which is proportional to the absorption cross-section of the atoms and to the density of atoms. Hence, before we enter the mathematics of the trapping problem, we first have to determine the absorption cross-section and lineshape. We will not go into details (these are beyond the scope of this book), but only review the facts needed to approach our problem. In addition, there is another motivation for this chapter. It is not only nice but absolutely necessary to have all required formulas compiled in one consistent notation. One has to take really great care not to become completely lost by widely differing notation in the literature—the cgs-system and esu-units versus the SI-system, frequency versus angular frequency, atomic constants referenced to photon density, to energy density or to light intensity, the ubiquitous factor of two for polarization, and the like.
Abstract It is already evident from the basic physical picture developed in Chapter l that mainly two parameters determine radiation trapping: the strength of the absorption and the spectral shape of the absorption. The strength of the absorption is characterized by the opacity of the atomic vapour, which is proportional to the absorption cross-section of the atoms and to the density of atoms. Hence, before we enter the mathematics of the trapping problem, we first have to determine the absorption cross-section and lineshape. We will not go into details (these are beyond the scope of this book), but only review the facts needed to approach our problem. In addition, there is another motivation for this chapter. It is not only nice but absolutely necessary to have all required formulas compiled in one consistent notation. One has to take really great care not to become completely lost by widely differing notation in the literature—the cgs-system and esu-units versus the SI-system, frequency versus angular frequency, atomic constants referenced to photon density, to energy density or to light intensity, the ubiquitous factor of two for polarization, and the like.
Abstract Radiation from spectral lines can be absorbed and re- emitted many times in atomic vapours before it reaches the boundaries of the container encasing the vapour. This effect is known as radiation trapping. It plays an important role practically everywhere where atomic vapours occur, e.g. in spectroscopy, in gas lasers, in atomic line filters, in the determination of atomic lifetimes, in measurements of atomic interaction potentials, and in electric discharge lamps. This book for the first time assembles all the information necessary for a treatment of practical problems, emphasizing both physical insights and mathematical methods. After an introduction that reviews resonance radiation and collisional processes in atomic vapours, physical effects and mathematical methods for various types of problems (e.g. with or without saturation, particle diffusion, reflecting cell walls, etc.) are explained in detail. The last part of the book describes the applications of these methods to a variety of practical problems like cross-section measurements or the design of discharge lamps.Atoms can both absorb and emit electromagnetic radiation like visible light In an assembly of many atoms, e.g., in a vapour or in a gas, radiation emitted by one atom may be reabsorbed by one of its neighbours, just to be reemitted a little later. The game can go on for quite some time—until the photon manages somehow to escape from this prison. At first glance, quite easy to understand. On the other hand, there must be some reason for this voluminous book full of sums, integrals and matrices. Our interest in this subject originally stemmed from investigations on atomic line filters we did for the European Space Agency, ESA. We believed that radiation trapping would have some influence on the performance of these filters and were looking for a simple means to take it into account We started out the same way as probably anyone new to the field would have done when faced with the problem of trapping. We read the classical paper of Holstein, and thought that was all there was to it. We soon had to realize, however, that the assumptions made by Holstein were not fulfilled in our problem, and decided to give the whole matter a closer look. That ‘closer look’ obtained a momentum of its own, and trapping became the centre of our own research in the following years. As our overview of the subject increased. we found that trapping plays a role in a staggering variety of situations. Trapping appears to be important in most experimental setups and in most engineering applications where atomic vapours are involved.
Starting from the classical oscillator model of an atom, this chapter obtains some of the most important formulas used to describe the absorption and emission of light. It went beyond the classical oscillator model by introducing the oscillator strength and the fact that absorption and emission involve transitions between allowed energy levels. We showed that the thermal radiation spectrum implies that there must be stimulated emission as well as spontaneous emission and absorption. Thermal radiation is broadband in the sense that its spectrum is much broader than the lineshape function of the atoms with which it is in equilibrium. In the opposite, narrowband limit of interest for lasers, the rates are proportional to the atomic lineshape function S (n), where S (n) is a Lorentzian function in the collision-broadening limit. The formulas obtained for the absorption or gain coefficient will be central to much of the discussion of laser theory. Controlled Vocabulary Terms absorption; heat radiation; laser theory; light; spontaneous emission
So far we have treated the energy levels of an atomic system as stable states with infinite lifetimes. The presence of an electromagnetic field changes this picture. Absorption of photons will excite atoms and ions to higher levels, while stimulated emission will make excited ones decay. Einstein (1917) showed, using purely statistical arguments, that an excited ion will decay through spontaneous emission in the absence of an electromagnetic field. This process can also be derived by using a rigorous quantum electrodynamic treatment, where the field is quantized. In this chapter we start by discussing transitions between atomic levels in a general sense, postulating the operators responsible for the decay. After the first few sections we will concentrate on the most important few multipoles or terms in the expansion of the electromagnetic field. We will introduce a number of different properties describing the transition, and eventually arrive at the measurable transition rate and, directly linked to it, the lifetime of an excited state. We will start, however, with the most basic property, the component strength. Our aim is to arrive at computationally useful expressions as soon as possible. For a more thorough treatment of the theory of radiative transitions we refer to the book by Sobelman (1972). For a brief review of the many factors affecting spectra of atoms, see Martin and Wiese (1996) .
III-8.Comparison of optical pumping signals for two spherical cells with different buffer gas pressures as a function of density times diameter of cell for equal D2/D1.60 IV-1.Energy level diagram showing hyperfine structure of Rb Di line.Units are 10*3 cm-1.67 IV-2.Equivalent circuit for rate equations involving ex change polarization.73 IV-3.Diagram of optical system for optical pumping of Rb. 83 IV-4.Block diagram of Rb optical pumping signal detection system.85 IV-5.Block diagram of Rb light detection system.90 IV-6.Typical photograph from which relaxation time measure ments are made..Time increases from left to right.Scale is 1 millisecond per division.92 IV-7.Lines determined from measurements on time dependence of Rb87 signals at 50°C for the two different light in tensities.Scatter of points is too small to be notice able on graph.93 A-1.Spectral profile of D1 radiation from a Varian spectral lamp containing natural Rb.Ill A-2.Spectral profile of Di radiation from a Varian spectral lamp containing Rb87.112 A-3-Spectral profile of Di radiation from a Varian spectral lamp containing Rb87 after filtering by an Rb85 absorption cell.113 vi CHAPTER I2 atomic ground states and the parameters of various relaxation processes of gaseous systems.These investigations led to the development of mag netometers of unique sensitivity.More recently, very precise frequency standards have been developed using the methods of optical pumping and the knowledge gained through their application.The present work was undertaken in the context of extending our knowledge of the dynamics of optical pumping methods and of exploiting these methods for the deter mination of an interesting atomic exchange cross section.Optical pumping may be considered as a specialized technique used in conjunction with magnetic resonance phenomena.All magnetic reso nance techniques depend upon obtaining an oriented (polarized) macro scopic sample of matter, that is, matter with a net magnetic moment.In the atomic beam magnetic resonance method, this is accomplished by sort ing out, spatially, atoms whose magnetic moments have a particular ori entation with respect to a magnetic field.In nuclear or electron para magnetic resonance work in solids, liquids, or gases, the small thermal equilibrium polarization that matter possesses in a magnetic field is exploited.Optical pumping enhances this equilibrium polarization through selective optical absorption, by a gaseous atomic system, of polarized resonance radiation.Optical pumping offers the great advan tage of experimental simplicity, as compared to other magnetic resonance techniques, but suffers from severe limitations in application.Since the original suggestion by Brossel and Nastier^ and subse quent development by many others, optical pumping, in conjunction with the transmission monitoring technique of signal detection, has became a standard technique in the study of alkali metal ground states.By far the greatest amount of work in optical pumping has been concerned with alkali metal vapors.Bell, Bloom/ and others^ have considered the process of the optical pumping of the alkalis with attention to the spec tral composition of the pumping light, that is, the resonance radiation incident on the alkali vapor.Colegrove and Franken? have recently dis cussed the complication in the analyses of optical pumping signals for Q helium when the helium absorption cell is optically thick.Hobart has considered this same complication for sodium.Prediction of signals must take into account the fact that the pumping light is absorbed ap proximately exponentially in the optical pumping absorption cell.This means that the absorption coefficient, which is proportional to the al kali density, times the length of the cell is a significant parameter in determining the strength of the signal.Similar calculations of the dependence of optical pumping signals on alkali density and spectral com position of the pumping light will be presented in this work.In order to test the signal predictions> a high resolution Fabry-Perot spectrometer was constructed.This instrument can be used for two purposes : the investigation of the intensity distribution of the pumping light, and, more importantly, determinations of the alkali vapor density in the absorption cell.The desired data are curves of optical pumping signals, for a typical sodium optical pumping experiment, as a function of density.It is often necessary to know these densities in order to is limited to the accuracy to which the density is known.Since the Fabry-Perot spectrometer used to measure sodium vapor densities in conjunction with the signal strength versus density meas urements can be applied to different systems, it was decided to make a determination of the rubidium 85-rubidium 87 spin exchange cross sec tion.The reasons for this choice are discussed in detail in Chapt.IV.In brief, work on rubidium exchange offered some experimental sim plifications and rubidium has previously been studied more thoroughly than other systems.
Abstract Since the beginning of this century we have a rough understanding about the structure of atoms. They consist of a nucleus and electrons orbiting around this nucleus. We know that electrons occupy only certain discrete energy states. When they decay from a high-energy state to a low-energy state, they emit electromagnetic radiation. Usually, the low-energy state will be the ground state. In that case, the emitted radiation is called resonance radiation.1 Since the resonance photons have an energy that corresponds to the energy of the transition, they can easily be absorbed by other ground-state atoms. A ground-state atom that absorbs the resonance photon is excited to the upper state for some time and will eventually release the photon again. This absorption/reemission process can be repeated many times, until the photon finally escapes from the vapour. This process is called ‘radiation trapping’ (also known as ‘imprisonment of resonance radiation’, ‘radiative transfer of spectral lines’, ‘line transfer’, or ‘radiation diffusion’).
This thesis presents a comparative study of the measured and calculated absolute absorption and dispersion properties of the Rb D lines through a dense thermal vapour in the absence and presence of an applied magnetic field. A detailed theoretical model valid in the weak-probe regime is calculated. The model uses a matrix representation of the atomic Hamiltonian including the magnetic field interaction for Rb in the completely uncoupled basis. Numerical diagonalisation allows the frequency detunings and transition strengths to be calculated. The lineshape of each transition is modelled as a Voigt profile, a convolution of the inhomogeneous and homogeneous profiles. The medium’s susceptibility is found by summing over all the electric-dipole-allowed transitions. For dense thermal vapours a modification to the homogeneous linewidth of each transition, which grows linearly with the number density of atoms, arises due to resonant dipole-dipole interactions between identical atoms in superpositions of the ground and excited terms. In the presence of an applied magnetic field we investigate the Stokes parameters of light propagating through a dense thermal vapour. For fields larger than 0.33 T we enter the hyperfine Paschen-Back regime on the Rb D lines. We present a compact optical isolator based on an atomic vapour, exploiting the spectral region of high transmission and large dispersion where we would normally expect absorption on the Rb D lines. Frequency up-conversion is shown in the fluorescence measurements over the visible and near infra-red regions for strong excitation. Low density transfer arises due to the energy-pooling effect between two identical atoms in their first excited terms. At high densities resonant dipole-dipole interactions give rise to a threshold for the energy transfer. We characterise the threshold behaviour with increasing number density.