Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optical Computing

High-Speed Storage of Wavelength-Multiplexed Volume Spectral Holograms

Xiao A. Shen, Yu Bai, Ravinder Kachru

Published Jan 1, 1995• 0 citations
Publisher

Abstract

One of the most attractive features of an optical memory is its ability to write and read data in a bit-parallel format, giving rise to theoretically very high (in excess of 1 Gbps) data transfer rates. However, such a potential has not been demonstrated experimentally because of various inherent technical difficulties associated with existing optical storage techniques. In a photorefractive or a persistent spectral hole-burning (PSHB) memory, for example, the time required to record one page varies from a fraction of a second to several seconds.1-3 For a page containing 1000 × 1000 bits of data, it translates to a bandwidth of approximately 1 Mbps, substantially slower than any existing semiconductor memories.

DOI
10.1364/optcomp.1995.owa5

Related papers

High-Speed Holographic Recording of 500 Images in Hole Burning Rare-Earth Doped Crystals

Ravinder Kachru, Xiao A. Shen

One of the unique and perhaps the most attractive features of an optical memory is its ability to store and retrieve information in a bit-parallel format.1-3 Recently, we have proposed a new scheme for parallel data storage in TDOM.4,5 This scheme was proven to be practical and can be implemented with existing technologies. In a proof-of-principle experiment, four wavelength-multiplexed single-page volume spectral holograms, generated with black-and-white transparencies, were successfully stored in a single spatial location at a speed of approximately 23 μs/frame. The experimental results project system's input/output bandwidth to exceed 40 Gbps, two orders of magnitude faster than a semiconductor cache memory.

Topical Meeting on Holography•Jan 1, 1996•0 citations

High-speed Spectroholographic Parallel Digital Optical Memory

Xiao A. Shen, A.D. Nguyen, John Weir Perry +2 more

Page-oriented optical memories have shown promising potential for fast data transfer rate and short data access time. Parallel optical storage and retrieval has been performed in photorefractive and persistent spectral hole burning materials.1,2

Conference on Lasers and Electro-Optics•Aug 24, 2005•0 citations

Optical Data Storage Using Persistent Spectral Hole Burning

Eric S. Maniloff, Stefan B. Altner, Stefan Bernet +2 more

The use of holography is attractive for optical data storage due to its poten­tial for implementing page oriented data storage systems. However, multiplexed recording using Bragg selective materials has not provided a large enough stor­age capability to justify the expense of these systems. Persistent spectral hole burning holography allows multiplexed recording using much smaller wavelength separations between the holograms, and hence dramatically increases the storage capacity possible in holographic memory systems [1]. A comparison between the wavelength selectivity obtained for transmission gratings recorded using hole burning in a dye doped polymer film versus Bragg selectivity in a 1 cm thick iron-doped lithium niobate crystal is shown in Fig. (1).

Joint International Symposium on Optical Memory and Optical Data Storage•Jan 1, 1993•0 citations

High-speed optical recording with rare-earth-doped hole-burning materials

Ravinder Kachru, Xiao A. Shen

We are developing a high density, high speed optical memory, using rare-earth doped hole- burning materials. These materials are theoretically capable of achieving storage densities of 1000 Gigabits/cm3 at input/output (I/O) rates of several gigabits/sec. One remarkable attribute of this storage concept is that both the temporal and spatial information encoded on a laser beam can be stored. Because both the temporal and spatial information can be stored, digital data can be recorded serially as a data or packet stream as well as holographically using the page format. During the past year we have achieved a breakthrough in demonstrating random access holographic data storage at high frame rates. Five hundred holograms were stored and retrieved with very good fidelity at 30 Hz (video rate). Each holographic image with 512 multiplied by 488 pixels could be randomly accessed during the storage and retrieval process. This frame rate is the highest demonstrated frame rate for any optical technique. This breakthrough was achieved through the invention of a memory architecture that allows multiple holographic frames to be stored without any mechanical beam scanning. In this new architecture multiplexing of 500 holograms was achieved by stepping the laser frequency over a range covered by high speed acousto-optic modulators (AOM).

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 15, 1996•0 citations

Spectral memory & other applications of spatial-spectral holography

THOMAS W. MOSSBERG

Optical devices have been slower to mature than those based purely on electronics. Yet optical interactions offer a number of unique capabilities expected to support entirely new classes of devices-devices offering unprecedented performance in communications, computing, and data storage applications. In the present work, optical devices based on the interaction of light with frequency-selective recording materials are discussed. A frequency-selective recording material has the capability of supporting multiple independent recording channels. Each channel is addressed by light within a specific narrow band of optical frequencies. In some materials, operative at cryogenic temperatures, millions of distinct spectral channels are available. Through the mechanism of persistent spectral hole-burning, light can be employed to transiently or even permanently modify the absorptive or dispersive properties of the recording material within a selected channel. Such modifications provide a means of recording multiple bits of optical information within single spatial locations. Spectral multiplexing of information has clear potential in information storage systems. Less obviously, the ability to spectrally encode information provides an enabling basis for ultrahigh speed, content-controlled, all-optical switching devices operable at data speeds up to the Terabit/sec level.

IEEE Lasers and Electro-Optics Society Annual Meeting (LEOS)•Dec 23, 2002•0 citations

Optical Modelling of Neural Networks as a Realization of Spectral Hole Burning Distributed Data Storage

Karl K. Rebane

Optimistic estimates put the limits for PSHB storage up to 1012 bits per cm2 (i.e. 104 spectral holes per each diffraction limited surface pixel of the size of λ·λ=10-8 cm2, λ- wavelength) or 1016 bits per cm3 for a volume storage memory (cell size λ·λ·λ=1012 cm3). Energy transfer between impurities destroys the storage. Interaction is absent at low concentrations, however, the latter may result in critical decrease of the number of impurity moleculess available to burn a hole at a fixed wavelength at a fixed spatial spot. If we assume concentration of non-interacting impurities 1018 molecules per cm3, and the storage density of 1012 bits per cm2 or 1016 bits per cm3, there is only 100 molecules on average to store one bit of information. It is a too small amount because of the fluctuations of the number of molecules per cell [1,2] and references therein.

Spectral Hole-Burning and Related Spectroscopies: Science and Applications•Jan 1, 1992•0 citations
One of the most attractive features of an optical memory is its ability to write and read data in a bit-parallel format, giving rise to theoretically very high (in excess of 1 Gbps) data transfer rates. However, such a potential has not been demonstrated experimentally because of various inherent technical difficulties associated with existing optical storage techniques. In a photorefractive or a persistent spectral hole-burning (PSHB) memory, for example, the time required to record one page varies from a fraction of a second to several seconds.1-3 For a page containing 1000 × 1000 bits of data, it translates to a bandwidth of approximately 1 Mbps, substantially slower than any existing semiconductor memories.
One of the unique and perhaps the most attractive features of an optical memory is its ability to store and retrieve information in a bit-parallel format.1-3 Recently, we have proposed a new scheme for parallel data storage in TDOM.4,5 This scheme was proven to be practical and can be implemented with existing technologies. In a proof-of-principle experiment, four wavelength-multiplexed single-page volume spectral holograms, generated with black-and-white transparencies, were successfully stored in a single spatial location at a speed of approximately 23 μs/frame. The experimental results project system's input/output bandwidth to exceed 40 Gbps, two orders of magnitude faster than a semiconductor cache memory.
The use of holography is attractive for optical data storage due to its poten­tial for implementing page oriented data storage systems. However, multiplexed recording using Bragg selective materials has not provided a large enough stor­age capability to justify the expense of these systems. Persistent spectral hole burning holography allows multiplexed recording using much smaller wavelength separations between the holograms, and hence dramatically increases the storage capacity possible in holographic memory systems [1]. A comparison between the wavelength selectivity obtained for transmission gratings recorded using hole burning in a dye doped polymer film versus Bragg selectivity in a 1 cm thick iron-doped lithium niobate crystal is shown in Fig. (1).
We are developing a high density, high speed optical memory, using rare-earth doped hole- burning materials. These materials are theoretically capable of achieving storage densities of 1000 Gigabits/cm3 at input/output (I/O) rates of several gigabits/sec. One remarkable attribute of this storage concept is that both the temporal and spatial information encoded on a laser beam can be stored. Because both the temporal and spatial information can be stored, digital data can be recorded serially as a data or packet stream as well as holographically using the page format. During the past year we have achieved a breakthrough in demonstrating random access holographic data storage at high frame rates. Five hundred holograms were stored and retrieved with very good fidelity at 30 Hz (video rate). Each holographic image with 512 multiplied by 488 pixels could be randomly accessed during the storage and retrieval process. This frame rate is the highest demonstrated frame rate for any optical technique. This breakthrough was achieved through the invention of a memory architecture that allows multiple holographic frames to be stored without any mechanical beam scanning. In this new architecture multiplexing of 500 holograms was achieved by stepping the laser frequency over a range covered by high speed acousto-optic modulators (AOM).
Optical devices have been slower to mature than those based purely on electronics. Yet optical interactions offer a number of unique capabilities expected to support entirely new classes of devices-devices offering unprecedented performance in communications, computing, and data storage applications. In the present work, optical devices based on the interaction of light with frequency-selective recording materials are discussed. A frequency-selective recording material has the capability of supporting multiple independent recording channels. Each channel is addressed by light within a specific narrow band of optical frequencies. In some materials, operative at cryogenic temperatures, millions of distinct spectral channels are available. Through the mechanism of persistent spectral hole-burning, light can be employed to transiently or even permanently modify the absorptive or dispersive properties of the recording material within a selected channel. Such modifications provide a means of recording multiple bits of optical information within single spatial locations. Spectral multiplexing of information has clear potential in information storage systems. Less obviously, the ability to spectrally encode information provides an enabling basis for ultrahigh speed, content-controlled, all-optical switching devices operable at data speeds up to the Terabit/sec level.
Optimistic estimates put the limits for PSHB storage up to 1012 bits per cm2 (i.e. 104 spectral holes per each diffraction limited surface pixel of the size of λ·λ=10-8 cm2, λ- wavelength) or 1016 bits per cm3 for a volume storage memory (cell size λ·λ·λ=1012 cm3). Energy transfer between impurities destroys the storage. Interaction is absent at low concentrations, however, the latter may result in critical decrease of the number of impurity moleculess available to burn a hole at a fixed wavelength at a fixed spatial spot. If we assume concentration of non-interacting impurities 1018 molecules per cm3, and the storage density of 1012 bits per cm2 or 1016 bits per cm3, there is only 100 molecules on average to store one bit of information. It is a too small amount because of the fluctuations of the number of molecules per cell [1,2] and references therein.