Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Solid-state dual-frequency laser free from anti-phase noise

Abdelkrim El Amili, Goulc’Hen Loas, Syamsundar De, Sylvain Schwartz, Gilles A. Feugnet, Jean-Paul Pocholle, Fabien Bretenaker, Mehdi Alouini

Published May 12, 2013• 0 citations
OpenAlex

Abstract

Dual-frequency solid-state lasers are attractive for a large number of applications such as microwave photonics, spectroscopy, and metrology. As far as dual-frequency lasers are considered, the intensity noise spectrum of each eigenmode exhibits two peaks lying at the well-known in-phase and anti-phase eigen-frequencies of two coupled oscillators. The in-phase noise, which corresponds to the standard relaxation oscillations of the laser, can be reduced either electronically or optically using feedback loops. However, the anti-phase noise, which is related to a resonant exchange of energy between the two laser modes, is very difficult to circumvent because the reduction of this noise would require additional servo-loop acting on the difference of the intensities of the two modes or two servo-loops acting independently on the intensity of each mode. An optimal dual-frequency laser in terms of intensity noise and beat frequency stability would be a single axis laser in which the population inversions related to each mode are independent. We experimentally demonstrate how the proper design of a two polarization dual-frequency solid-state laser allows to get rid of the anti-phase noise in the simplest possible architecture and without using any electronic or optical feedback loop. This design is based on an appropriate choice of the active medium cut and orientation in order to assign two almost independent families of active atoms to the two laser modes

Related papers

Solid-state dual-frequency laser free from anti-phase noise

Abdelkrim El Amili, Goulc’Hen Loas, Syamsundar De +5 more

We experimentally demonstrate how the proper design of a two polarization dual-frequency solid-state laser allows to get rid of the anti-phase noise in the simplest possible architecture and without using any electronic or optical feedback loop. This design is based on an appropriate choice of the active medium cut and orientation in order to assign two almost independent families of active atoms to the two laser modes.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•May 1, 2013•0 citations

A tunable dual-frequency rubidium Faraday laser

Xiaomin Qin, Zijie Liu, Zhiyang Wang +7 more

Dual-frequency (DF) lasers with specific frequency intervals have crucial applications in geometric measurement, optical microwave generation, quantum precision measurement, etc. Here, we report a 780 nm DF rubidium Faraday laser, with two modes’ frequencies corresponding to the 85 Rb and 87 Rb D 2 transitions. The microwave signal generated from the two laser modes’ beat has a linewidth of 671 Hz and is tunable from 4.7–4.95 GHz to 5.94–6.7 GHz by adjusting the diode current. Moreover, we use modulation transfer spectroscopy to lock one of the laser modes to the 87 Rb hyperfine transition, and the frequency stability improves nearly an order of magnitude. The noise characteristics are also measured, where the phase noise is suppressed over 25 dB at 100 Hz offset compared to the microwave signal generated by two single-mode lasers’ heterodyne beat. This 780 nm DF rubidium Faraday laser has two coherent modes with frequencies related to Rb transitions, which provides a promising and convenient method for compact atomic physics applications, such as coherent population trapping clocks, atom gravimeters, and so on.

Optics & Laser Technology•Jun 26, 2025•4 citations

Quantum noise limits to simultaneous quadrature amplitude and phase stabilization of solid-state lasers

Elanor H. Huntington, C. C. Harb, M. Heurs +1 more

A quantum mechanical model is formulated to describe the coupling between pump intensity noise and laser frequency noise in a solid-state laser. The model allows us to investigate the limiting effects of closed-loop stabilization schemes that utilize this coupling. Two schemes are considered: active control of the quadrature phase noise of the laser and active control of the amplitude noise of the laser. We show that the noise of the laser in the actively stabilized quadrature is ultimately limited by the vacuum noise introduced by the feedback beamsplitter in both schemes. In the case of active control of the quadrature phase noise, the noise is also limited by the intensity noise floor of the detection scheme. We also show that some sources of noise in the passively stabilized quadrature can be suppressed and that it is possible to achieve simultaneous quadrature amplitude and phase stabilization of a solid-state laser. However, the quantum mechanically driven noise in the passively stabilized quadrature cannot be suppressed. While this poses the ultimate limit to the noise in the passively stabilized quadrature, we show that it is experimentally feasible to observe squeezing directly generated by a solid-state laser using this technique.

Physical Review A•Jan 5, 2007•8 citations

The Quantum Noise Limits to Simultaneous Intensity and Frequency Stabilization of Solid-State Lasers

Elanor H. Huntington, C. C. Harb, M. Heurs +1 more

We incorporate the coupling between pump intensity and laser frequency noise into a quantum mechanical model for a solid-state laser. A frequency feedback loop can reduce laser intensity noise to below the quantum noise limit.

Conference on Lasers and Electro-Optics•May 1, 2007•0 citations

The quantum noise limits to simultaneous intensity and frequency stabilization of solid-state lasers

Elanor H. Huntington, C. C. Harb, M. Heurs +1 more

We incorporate the coupling between pump intensity and laser frequency noise into a quantum mechanical model for a solid-state laser. A frequency feedback loop can reduce laser intensity noise to below the quantum noise limit.

Quantum Electronics and Laser Science Conference•May 1, 2007•0 citations

Bridging the Optical and Microwave Frequencies with the Dual-frequency Faraday Laser

Jianxiang Miao, Tiantian Shi, Pengyuan Chang +3 more

The dual-frequency Faraday laser, utilizing the two-peak transmission of a Faraday anomalous dispersion optical filter (FADOF), can achieve simultaneous lasing on two modes both determined by the atomic transition. The beating frequency between the two modes is close to the frequency interval between hyperfine energy levels of the atomic ground state. Since the frequency of the beat signal and output laser modes all depend on the cavity length, locking one of them can also improve the stability of the others. Therefore, by locking the beat frequency to a stable microwave frequency reference, the stability of the reference can be transferred to the laser frequencies; Similarly, locking one of the output laser frequencies will also transfer its stability to the beat frequency in the microwave regime. This can serve as a means to bridge the gap between the optical and microwave frequency regimes, and can have wide applications, such as absolute frequency measurement of a laser, or photonic microwave generation.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Jul 7, 2021•0 citations
Dual-frequency solid-state lasers are attractive for a large number of applications such as microwave photonics, spectroscopy, and metrology. As far as dual-frequency lasers are considered, the intensity noise spectrum of each eigenmode exhibits two peaks lying at the well-known in-phase and anti-phase eigen-frequencies of two coupled oscillators. The in-phase noise, which corresponds to the standard relaxation oscillations of the laser, can be reduced either electronically or optically using feedback loops. However, the anti-phase noise, which is related to a resonant exchange of energy between the two laser modes, is very difficult to circumvent because the reduction of this noise would require additional servo-loop acting on the difference of the intensities of the two modes or two servo-loops acting independently on the intensity of each mode. An optimal dual-frequency laser in terms of intensity noise and beat frequency stability would be a single axis laser in which the population inversions related to each mode are independent. We experimentally demonstrate how the proper design of a two polarization dual-frequency solid-state laser allows to get rid of the anti-phase noise in the simplest possible architecture and without using any electronic or optical feedback loop. This design is based on an appropriate choice of the active medium cut and orientation in order to assign two almost independent families of active atoms to the two laser modes
Dual-frequency (DF) lasers with specific frequency intervals have crucial applications in geometric measurement, optical microwave generation, quantum precision measurement, etc. Here, we report a 780 nm DF rubidium Faraday laser, with two modes’ frequencies corresponding to the 85 Rb and 87 Rb D 2 transitions. The microwave signal generated from the two laser modes’ beat has a linewidth of 671 Hz and is tunable from 4.7–4.95 GHz to 5.94–6.7 GHz by adjusting the diode current. Moreover, we use modulation transfer spectroscopy to lock one of the laser modes to the 87 Rb hyperfine transition, and the frequency stability improves nearly an order of magnitude. The noise characteristics are also measured, where the phase noise is suppressed over 25 dB at 100 Hz offset compared to the microwave signal generated by two single-mode lasers’ heterodyne beat. This 780 nm DF rubidium Faraday laser has two coherent modes with frequencies related to Rb transitions, which provides a promising and convenient method for compact atomic physics applications, such as coherent population trapping clocks, atom gravimeters, and so on.
A quantum mechanical model is formulated to describe the coupling between pump intensity noise and laser frequency noise in a solid-state laser. The model allows us to investigate the limiting effects of closed-loop stabilization schemes that utilize this coupling. Two schemes are considered: active control of the quadrature phase noise of the laser and active control of the amplitude noise of the laser. We show that the noise of the laser in the actively stabilized quadrature is ultimately limited by the vacuum noise introduced by the feedback beamsplitter in both schemes. In the case of active control of the quadrature phase noise, the noise is also limited by the intensity noise floor of the detection scheme. We also show that some sources of noise in the passively stabilized quadrature can be suppressed and that it is possible to achieve simultaneous quadrature amplitude and phase stabilization of a solid-state laser. However, the quantum mechanically driven noise in the passively stabilized quadrature cannot be suppressed. While this poses the ultimate limit to the noise in the passively stabilized quadrature, we show that it is experimentally feasible to observe squeezing directly generated by a solid-state laser using this technique.
The dual-frequency Faraday laser, utilizing the two-peak transmission of a Faraday anomalous dispersion optical filter (FADOF), can achieve simultaneous lasing on two modes both determined by the atomic transition. The beating frequency between the two modes is close to the frequency interval between hyperfine energy levels of the atomic ground state. Since the frequency of the beat signal and output laser modes all depend on the cavity length, locking one of them can also improve the stability of the others. Therefore, by locking the beat frequency to a stable microwave frequency reference, the stability of the reference can be transferred to the laser frequencies; Similarly, locking one of the output laser frequencies will also transfer its stability to the beat frequency in the microwave regime. This can serve as a means to bridge the gap between the optical and microwave frequency regimes, and can have wide applications, such as absolute frequency measurement of a laser, or photonic microwave generation.