Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)

Solid-state dual-frequency laser free from anti-phase noise

Abdelkrim El Amili, Goulc’Hen Loas, Syamsundar De, Sylvain Schwartz, Gilles A. Feugnet, Jean-Paul Pocholle, Fabien Bretenaker, Mehdi Alouini

Published May 1, 2013• 0 citations
Publisher

Abstract

We experimentally demonstrate how the proper design of a two polarization dual-frequency solid-state laser allows to get rid of the anti-phase noise in the simplest possible architecture and without using any electronic or optical feedback loop. This design is based on an appropriate choice of the active medium cut and orientation in order to assign two almost independent families of active atoms to the two laser modes.

DOI
10.1109/cleoe-iqec.2013.6800603

Related papers

Solid-state dual-frequency laser free from anti-phase noise

Abdelkrim El Amili, Goulc’Hen Loas, Syamsundar De +5 more

Dual-frequency solid-state lasers are attractive for a large number of applications such as microwave photonics, spectroscopy, and metrology. As far as dual-frequency lasers are considered, the intensity noise spectrum of each eigenmode exhibits two peaks lying at the well-known in-phase and anti-phase eigen-frequencies of two coupled oscillators. The in-phase noise, which corresponds to the standard relaxation oscillations of the laser, can be reduced either electronically or optically using feedback loops. However, the anti-phase noise, which is related to a resonant exchange of energy between the two laser modes, is very difficult to circumvent because the reduction of this noise would require additional servo-loop acting on the difference of the intensities of the two modes or two servo-loops acting independently on the intensity of each mode. An optimal dual-frequency laser in terms of intensity noise and beat frequency stability would be a single axis laser in which the population inversions related to each mode are independent. We experimentally demonstrate how the proper design of a two polarization dual-frequency solid-state laser allows to get rid of the anti-phase noise in the simplest possible architecture and without using any electronic or optical feedback loop. This design is based on an appropriate choice of the active medium cut and orientation in order to assign two almost independent families of active atoms to the two laser modes

•May 12, 2013•0 citations

A low phase noise Raman lasers system based on optical injection and an optical phase-lock loop

Chang-Jen Wu, Xueshu Yan, J.H. Tu +4 more

Raman lasers with a frequency difference equal to the hyperfine splitting of ground state have been widely used in quantum precision measurements. In this paper, we report a hybrid Raman lasers system combined with the optical injection and optical phase-lock loop. This design not only offers us the convenience to independently adjust the intensity and polarization of Raman lasers, but also suppress the phase noise caused by the air turbulence and vibration of mirrors.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Jul 1, 2017•1 citation

Quantum noise limits to simultaneous quadrature amplitude and phase stabilization of solid-state lasers

Elanor H. Huntington, C. C. Harb, M. Heurs +1 more

A quantum mechanical model is formulated to describe the coupling between pump intensity noise and laser frequency noise in a solid-state laser. The model allows us to investigate the limiting effects of closed-loop stabilization schemes that utilize this coupling. Two schemes are considered: active control of the quadrature phase noise of the laser and active control of the amplitude noise of the laser. We show that the noise of the laser in the actively stabilized quadrature is ultimately limited by the vacuum noise introduced by the feedback beamsplitter in both schemes. In the case of active control of the quadrature phase noise, the noise is also limited by the intensity noise floor of the detection scheme. We also show that some sources of noise in the passively stabilized quadrature can be suppressed and that it is possible to achieve simultaneous quadrature amplitude and phase stabilization of a solid-state laser. However, the quantum mechanically driven noise in the passively stabilized quadrature cannot be suppressed. While this poses the ultimate limit to the noise in the passively stabilized quadrature, we show that it is experimentally feasible to observe squeezing directly generated by a solid-state laser using this technique.

Physical Review A•Jan 5, 2007•8 citations

The Quantum Noise Limits to Simultaneous Intensity and Frequency Stabilization of Solid-State Lasers

Elanor H. Huntington, C. C. Harb, M. Heurs +1 more

We incorporate the coupling between pump intensity and laser frequency noise into a quantum mechanical model for a solid-state laser. A frequency feedback loop can reduce laser intensity noise to below the quantum noise limit.

Conference on Lasers and Electro-Optics•May 1, 2007•0 citations

The quantum noise limits to simultaneous intensity and frequency stabilization of solid-state lasers

Elanor H. Huntington, C. C. Harb, M. Heurs +1 more

We incorporate the coupling between pump intensity and laser frequency noise into a quantum mechanical model for a solid-state laser. A frequency feedback loop can reduce laser intensity noise to below the quantum noise limit.

Quantum Electronics and Laser Science Conference•May 1, 2007•0 citations

Absolute active frequency locking of a diode laser with optical feedback generated by Doppler-free collinear polarization spectroscopy

Zi Dong Liu, Daniel Bloch, M. Ducloy

Absolute stabilization of the emission frequency of a laser diode can be achieved in a nearly all-optical scheme involving a resonant optical feedback from an atomic signal. We propose here two novel schemes of collinear Doppler-free polarization spectroscopy and report on preliminary experimental demonstrations of diode frequency locking performed on the D2 line of Rb.

Applied Physics Letters•Jul 18, 1994•7 citations
We experimentally demonstrate how the proper design of a two polarization dual-frequency solid-state laser allows to get rid of the anti-phase noise in the simplest possible architecture and without using any electronic or optical feedback loop. This design is based on an appropriate choice of the active medium cut and orientation in order to assign two almost independent families of active atoms to the two laser modes.
Dual-frequency solid-state lasers are attractive for a large number of applications such as microwave photonics, spectroscopy, and metrology. As far as dual-frequency lasers are considered, the intensity noise spectrum of each eigenmode exhibits two peaks lying at the well-known in-phase and anti-phase eigen-frequencies of two coupled oscillators. The in-phase noise, which corresponds to the standard relaxation oscillations of the laser, can be reduced either electronically or optically using feedback loops. However, the anti-phase noise, which is related to a resonant exchange of energy between the two laser modes, is very difficult to circumvent because the reduction of this noise would require additional servo-loop acting on the difference of the intensities of the two modes or two servo-loops acting independently on the intensity of each mode. An optimal dual-frequency laser in terms of intensity noise and beat frequency stability would be a single axis laser in which the population inversions related to each mode are independent. We experimentally demonstrate how the proper design of a two polarization dual-frequency solid-state laser allows to get rid of the anti-phase noise in the simplest possible architecture and without using any electronic or optical feedback loop. This design is based on an appropriate choice of the active medium cut and orientation in order to assign two almost independent families of active atoms to the two laser modes
A quantum mechanical model is formulated to describe the coupling between pump intensity noise and laser frequency noise in a solid-state laser. The model allows us to investigate the limiting effects of closed-loop stabilization schemes that utilize this coupling. Two schemes are considered: active control of the quadrature phase noise of the laser and active control of the amplitude noise of the laser. We show that the noise of the laser in the actively stabilized quadrature is ultimately limited by the vacuum noise introduced by the feedback beamsplitter in both schemes. In the case of active control of the quadrature phase noise, the noise is also limited by the intensity noise floor of the detection scheme. We also show that some sources of noise in the passively stabilized quadrature can be suppressed and that it is possible to achieve simultaneous quadrature amplitude and phase stabilization of a solid-state laser. However, the quantum mechanically driven noise in the passively stabilized quadrature cannot be suppressed. While this poses the ultimate limit to the noise in the passively stabilized quadrature, we show that it is experimentally feasible to observe squeezing directly generated by a solid-state laser using this technique.