Profound advancements in quantum optics create necessity to analyze and detect correlated photon pairs.Technologies so far developed to support quantum optics are done mainly to offer new possibilities towards experimental tests dealing with basic principles of quantum mechanics.Dynamic range amplifier is designed for detection of shot noise current obtained due to squeezing or entanglement in laser.The amplification of the Ac current (shot noise current) and DC current is done using this enhanced amplifier with the available input power.The performance of the system is notable from the significant increase in amplifier gain over a wide range of frequency.Therefore this design is tested for various input powers and it is concluded that it plays a very important role for a wide variety of applications, especially in weak signal detection.
Profound advancements in quantum optics create necessity to analyze and detect correlated photon pairs.Technologies so far developed to support quantum optics are done mainly to offer new possibilities towards experimental tests dealing with basic principles of quantum mechanics.Dynamic range amplifier is designed for detection of shot noise current obtained due to squeezing or entanglement in laser.The amplification of the Ac current (shot noise current) and DC current is done using this enhanced amplifier with the available input power.The performance of the system is notable from the significant increase in amplifier gain over a wide range of frequency.Therefore this design is tested for various input powers and it is concluded that it plays a very important role for a wide variety of applications, especially in weak signal detection.
The basic equations governing noise phenomena are derived from first principles and applied to examples in optical communications. Quantum noise arises from two sources, the momentum fluctuations of electrons at optical frequencies and the uncertainty-related fluctuations of the electromagnetic field. Shot noise results from the beating of the noise sources with the signal field. In high-gain amplifiers, the spontaneous-emission noise dominates shot noise and results in a noise figure of at least 3 dB. It is shown explicitly how, at high power, both the laser field and the laser noise source become classical. The increase in noise in lasers with open cavities is not due to enhanced spontaneous emission as once thought, but to single-pass amplification. The noise fields and spontaneous currents have Gaussian distributions, while nonlasing modes have exponential photon-number distributions. Low-frequency intensity fluctuations arise from the electric current driving the laser and can be sub-Poissonian, in contrast to shot noise, which has a Poissonian distribution. The calculational tools are a wave equation for the field operator and a rate equation for the carrier-number operator, each containing spontaneous current noise sources. The correlation functions of these sources are determined by the fluctuation-dissipation theorem. [S0034-6861(96)00503-X]
Quantum states of light play a pivotal role in pushing the boundaries of sensitivity and accuracy in optical sensing and metrology, surpassing the limitations of classical laser sources. This thesis explores the innovative approach of harnessing the unique correlation and entanglement properties of quantum light for two vital applications in the field: optical target detection and fiber optical sensing and metrology. In the first half of this thesis, we explore the possibilities of using time-frequency correlation and entanglement of quantum (and quantum-inspired) light sources to enhance the noise resilience of optical target detection. We present three optical target detection protocols based on different yet similar operational principles, and they correspondingly offer different quantum (or quantum-inspired) enhancements. First, it is shown that by characterizing the temporal correlation between entangled photons through temporal domain photon counting, the impact of uncorrelated background noise can be drastically reduced. Second, we show that in addition to temporal correlation, frequency correlation can also be simultaneously analyzed through the joint measurement of time-frequency entanglement. Theoretical analysis shows that, by doing so, twice as much noise resilience can be achieved as compared to using temporal correlation alone. Third, we show that the coherent optical receiver used in the previous protocol can also be used in classical LiDARs. Such a quantum-inspired LiDAR is capable of a larger detection range (with high-power classical sources) while retaining similar noise resilience enhancement (over 100 dB rejection of inband noise with a 100 ms integration time). In the second half of the thesis, we present a novel all-fiber-based squeezed light source based on travelling-wave optical parametric amplification. Its operational principle is inspired by the time-frequency entanglement properties of quantum photon pairs and the bichromatic local oscillator technique. We experimentally demonstrate over 5.05 dB shot noise reduction (detection limited) using balanced homodyne detection. We anticipate that its robust, all-fiber form factor can benefit practical fiber optical sensing and metrology applications, such as fiber optical gyroscopes and distributed fiber sensing.
The optical shot-noise limit of a laser beam represents the classical limit in precision and signal to noise ratio achievable in optical sensors and imaging systems. It is known that quantum states of light, such as squeezed light and quantum correlated twin beams can be used to enhance precision and signal to noise ratio to beyond this limit. This promises optical sensors with fundamentally superior performance to the state of the art. While quantum-enhanced signal to noise ratio has been demonstrated with macroscopic powers of squeezed probe beam, demonstrations of quantum enhanced precision have remained at extremely low powers of light (femto-Watts). Here we will give examples where increasing SNR with quantum light is not sufficient to increase precision and we will review proof of principle experiments that have demonstrated sub shot noise precision, including for absorption spectroscopy and imaging. We will also report our efforts to achieve this sub-shot-noise precision performance for transmission measurement with ~0.1mW of average probe power, equating to ~10W peak power in a pulsed experiment. Time permitting, we will discuss how integrated optics and integrated electronics enables 10s GHz bandwidth in the detection of squeezed light, for integrated quantum sensor technology.
A proposed method of suppressing the effect of background noise in an optical communication system would exploit the transmission and reception of correlated photons at the receiver. The method would not afford any advantage in a system in which performance is limited by shot noise. However, if the performance of the system is limited by background noise (e.g., sunlight in the case of a free-space optical communication system or incoherently scattered in-band photons in the case of a fiber-optic communication system), then the proposed method could offer an advantage: the proposed method would make it possible to achieve a signal-to-noise ratio (S/N) significantly greater than that of an otherwise equivalent background- noise-limited optical communication system based on the classical transmission and reception of uncorrelated photons. The figure schematically depicts a classical optical-communication system and a system according to the proposed method. In the classical system, a modulated laser beam is transmitted along an optical path to a receiver, the optics of which include a narrow-band-pass filter that suppresses some of the background noise. A photodetector in the receiver detects the laser-beam and background photons, most or all of which are uncorrelated. In the proposed system, correlated photons would be generated at the transmitter by making a modulated laser beam pass through a nonlinear parametric down-conversion crystal. The sum of frequencies of the correlated photons in each pair would equal the frequency of the incident photon from which they were generated. As in the classical system, the correlated photons would travel along an optical path to a receiver, where they would be band-pass filtered and detected. Unlike in the classical system, the photodetector in the receiver in this system would be one that intrinsically favors the detection of pairs of correlated photons over the detection of uncorrelated photons. Even though there would be no way of knowing the precise location and time of creation of a given pair of correlated signal photons in the nonlinear down-conversion crystal, the fact that the photons are necessarily created at the same time and place makes it possible to utilize conventional geometrical imaging optics to reunite the photons in coincidence in the receiving photodetector. Because most or all of the signal photons would be correlated while most or all of the noise photons would be uncorrelated, the S/N would be correspondingly enhanced in the photodetector output. An additional advantage to be gained by use of a correlated-photon detector is that it could be capable of recovering the signal even in the presence of background light so bright that a classical uncorrelated-photon detector would be saturated. A blocked-impurity-band (BIB) photodetector that preferentially detects pairs of correlated photons over uncorrelated ones and that operates at a quantum efficiency of 88 percent is commercially available. This detector must be cooled to the temperature of liquid helium to obtain the desired low-noise performance. It is planned to use this detector in a proof-of-principle demonstration. In addition, it may be possible to develop GaN-based photodetectors that could offer the desired low-noise performance at room temperature.
Conventional interferometers usually utilize beam splitters for wave splitting and recombination. These interferometers are widely used for precision measurement. Their sensitivity for phase measurement is limited by the shot noise, which can be suppressed with squeezed states of light. Here we study a new type of interferometer in which the beam splitting and recombination elements are parametric amplifiers. We observe an improvement of 4.1±0.3 dB in signal-to-noise ratio compared with a conventional interferometer under the same operating condition, which is a 1.6-fold enhancement in rms phase measurement sensitivity beyond the shot noise limit. The improvement is due to signal enhancement. Combined with the squeezed state technique for shot noise suppression, this interferometer promises further improvement in sensitivity. Furthermore, because nonlinear processes are involved in this interferometer, we can couple a variety of different waves and form new types of hybrid interferometers, opening a door for many applications in metrology. Interferometers play a key role in precision measurements and metrology. Here, the authors demonstrate a new type of interferometer that replaces the standard beam splitter elements with parametric amplifiers, which provides enhanced performance compared with a Mach–Zehnder interferometer.
Low-current, high-impedance microelectronic devices can be affected by electric current shot noise more than they are affected by Nyquist noise, even at room temperature. An approach to implementing a sub-shot noise current source for powering such devices is based on direct conversion of amplitude-squeezed light to photocurrent. The phenomenon of optical squeezing allows for the optical measurements below the fundamental shot noise limit, which would be impossible in the domain of classical optics. This becomes possible by affecting the statistical properties of photons in an optical mode, which can be considered as a case of information encoding. Once encoded, the information describing the photon (or any other elementary excitations) statistics can be also transmitted. In fact, it is such information transduction from optics to an electronics circuit, via photoelectric effect, that has allowed the observation of the optical squeezing. It is very difficult, if not technically impossible, to directly measure the statistical distribution of optical photons except at extremely low light level. The photoelectric current, on the other hand, can be easily analyzed using RF spectrum analyzers. Once it was observed that the photocurrent noise generated by a tested light source in question is below the shot noise limit (e.g. produced by a coherent light beam), it was concluded that the light source in question possess the property of amplitude squeezing. The main novelty of this technology is to turn this well-known information transduction approach around. Instead of studying the statistical property of an optical mode by measuring the photoelectron statistics, an amplitude-squeezed light source and a high-efficiency linear photodiode are used to generate photocurrent with sub-Poissonian electron statistics. By powering microelectronic devices with this current source, their performance can be improved, especially their noise parameters. Therefore, a room-temperature sub-shot noise current source can be built that will be beneficial for a very broad range of low-power, low-noise electronic instruments and applications, both cryogenic and room-temperature. Taking advantage of recent demonstrations of the squeezed light sources based on optical micro-disks, this sub-shot noise current source can be made compatible with the size/power requirements specific of the electronic devices it will support.