Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Terahertz Science and Technology

Noise and Conversion Analyses for High-T c Superconducting Harmonic Mixers: Theoretical Modeling and Experimental Verification

Huanxin Li, Xiang Gao, Jianping An, Xiangyuan Bu, Heng Liu

Published Feb 24, 2022• 5 citations
Publisher

Abstract

High-Tcsuperconducting (HTS) harmonic mixers are attractive frontends for terahertz wireless communication and sensing applications. However, the investigation of HTS harmonic mixers has long been hindered by the lack of effective theoretical method in device modeling. This article presents a modeling approach for analyzing the noise and conversion properties of HTS harmonic mixers. By quantitively analyzing the contribution of the parasitic components to frequency conversion, a parasitics-selection based equivalent circuit model is built with the architecture complexity reduced to a six-port network. Besides, a fast hybrid-solution method that combines the single-tone current excitation and perturbation-derivation processing techniques, is developed for efficiently calculating the conversion impedance matrix for harmonic mixing. Detailed derivations are then carried out to acquire the semianalytic expressions of noise temperature and conversion gain after solving the noise correlation matrix for harmonic mixing. The presented modeling method has been verified by the fourth harmonic mixing experiments for a dual-band antenna-coupled HTS Josephson-junction mixer module. The measured and simulated results are in good agreement in terms of the noise temperature and conversion gain as well as their dependance on dc biasing, local oscillator pumping, and operating temperatures. The results have validated the effectiveness of the presented modeling method for analyzing the properties of HTS Josephson junction mixers.

DOI
10.1109/tthz.2022.3154094

Related papers

Noise and conversion performance of a high-Tc superconducting Josephson junction mixer at 0.6 THz

Xiang Gao, Jia Du, Ting Zhang +1 more

This letter presents both theoretical and experimental investigations on the noise and conversion performance of a high-Tc superconducting (HTS) step-edge Josephson-junction mixer at the frequency of 0.6 THz and operating temperatures of 20–40 K. Based on the Y-factor and U-factor methods, a double-sideband noise temperature of around 1000 K and a conversion gain of −3.5 dB were experimentally obtained at 20 K. At the temperature of 40 K, the measured mixer noise and conversion efficiency are around 2100 K and −10 dB, respectively. The experimental data are in good agreement with the numerical analysis results using the three-port model. A detailed performance comparison with other reported HTS terahertz mixers has confirmed the superior performance of our presented mixer device.

Applied Physics Letters•Nov 6, 2017•25 citations

Design and modeling of a single-balanced high-Tc superconducting Josephson-junction terahertz mixer

Xiang Gao, Huanxin Li, Jia Du +5 more

High-Tc superconducting (HTS) receivers are promising candidates for terahertz (THz) communication applications due to their superior sensitivity and the cooling attainability with a miniature cryogenic system. Nevertheless, currently reported HTS mixers are mostly single-junction devices, and a more complicated architecture like the balanced configuration has not been investigated. This paper presents the design of a 600-GHz single-balanced HTS mixer, where detailed electromagnetic simulations are carried out to optimize the coupling efficiency and port isolation, as well as desired amplitude and phase relationship. To predict the noise and conversion performance, we present an innovative multiport network interleaving-based modeling method that enables powerful simulation verifications for single-balanced HTS Josephson mixers. Simulation results show that the presented device exhibits very good HTS mixer performance at the 600-GHz band, which validates the effectiveness of the design and the potential of the mixer for THz communication applications.

Journal of Applied Physics•Jan 20, 2022•8 citations

The effects of nonlinear thermal fluctuation and series junction array on high- T c superconducting terahertz mixer performance

Xiang Gao, Jia Du, Ting Zhang +2 more

Abstract Sensitive high- T c superconducting (HTS) heterodyne receivers are envisioned as promising technologies for terahertz (THz) communication and sensing applications due to the lack of power efficient sources in the band. HTS device properties, particularly the noise temperature, are dependent on complicated factors that include multiple noise sources as well as the interaction between Josephson junction and radio-frequency (RF) networks. We report investigations on the device properties of an HTS THz mixer in the presence of nonlinear thermal fluctuation and series junction array. By using the three-port analysis method, it is observed that the Planck and quantum noises representing nonlinear thermal fluctuation plays a significant role in the cases of smaller fluctuation parameters and higher signal frequencies. The influence of series junction array on mixer performance is also studied, which shows that there is an optimum junction number dependent on the normalized RF source impedance. The measured results of a broadband antenna-coupled HTS single-junction mixer agree well with that obtained by numerical simulation. The results predict that noise performance, conversion gain and operating bandwidth would be considerably improved if a series junction array with a suitable junction number is used for heterodyne mixing.

Superconductor Science and Technology•Oct 2, 2020•4 citations

Operation With Terahertz Mixer Based on YBaCuO Josephson Junction: Analysis and Numerical Simulation

Ekaterina A. Matrozova, L. S. Revin

This paper presents theoretical analysis and modeling of YBaCuO superconducting Josephson mixer for terahertz frequency band. The study was carried out both for the mixing at the first harmonic and for the case of high harmonic mixing. The numerical solution based on resistively shunted junction model was obtained for the YBaCuO junction with typical experimental parameters. Optimizing mixer performance included choosing the proper operating point and the local oscillator power. A study on the effect of RF input power, frequency and the harmonic number on conversion efficiency was carried out. The theoretical predictions presented in the work provide a simple method for optimal control of the Josephson mixer and demonstrate good qualitative agreement with direct modeling. For the first time, the optimum of the conversion efficiency versus signal frequency was analytically obtained.

IEEE Transactions on Applied Superconductivity•Jun 4, 2024•3 citations

A wideband terahertz high- T c superconducting Josephson-junction mixer: electromagnetic design, analysis and characterization

Xiang Gao, Ting Zhang, Jia Du +3 more

Abstract This paper presents a wideband terahertz (THz) mixer based on a thin-film antenna-coupled high-temperature superconducting (HTS) YBa 2 Cu 3 O 7−x (YBCO) step-edge Josephson junction. The HTS mixer enables the flexible harmonic mixing operation at multiple THz bands with the same microwave local oscillator (LO) source, and features very wide intermediate-frequency or instantaneous bandwidth. In order to optimize the frequency down-conversion performance of the mixer, systematic electromagnetic design and analysis have been carried out to improve the power coupling of THz radiation as well as wideband transmission of microwave signals. Experimental characterization of a fabricated device prototype has demonstrated that the mixer exhibits good performance at both the 200 GHz and 600 GHz bands. Detailed measurement results including the DC characteristics, LO pumping requirement, frequency response, mixing linearity and conversion gain are presented in this paper.

Superconductor Science and Technology•Jun 30, 2017•43 citations

Terahertz harmonic mixer based on HTS Josephson junction

Mei Yu, Weiwei Xu, Jin Shi +3 more

High temperature superconducting (HTS) Josephson junction (JJ) mixers are attractive candidates in receivers for terahertz (THz) communication due to their high sensitivity, wide bandwidth, low local oscillator (LO) power requirement and high harmonic numbers. The required LO frequencies and the cost can be greatly reduced when harmonic signals can be detected at high orders (more than 100). In this paper, up to 114thharmonic mixings is presented in a HTS bicrystal YBa2Cu3O7-δ(YBCO) JJ harmonic mixer coupled with a bowtie loaded meander antenna at 0.21 THz. HTS JJs will be promising high-order harmonic mixers for THz practical applications on reception or detection at THz bands.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Aug 29, 2021•0 citations
High-Tcsuperconducting (HTS) harmonic mixers are attractive frontends for terahertz wireless communication and sensing applications. However, the investigation of HTS harmonic mixers has long been hindered by the lack of effective theoretical method in device modeling. This article presents a modeling approach for analyzing the noise and conversion properties of HTS harmonic mixers. By quantitively analyzing the contribution of the parasitic components to frequency conversion, a parasitics-selection based equivalent circuit model is built with the architecture complexity reduced to a six-port network. Besides, a fast hybrid-solution method that combines the single-tone current excitation and perturbation-derivation processing techniques, is developed for efficiently calculating the conversion impedance matrix for harmonic mixing. Detailed derivations are then carried out to acquire the semianalytic expressions of noise temperature and conversion gain after solving the noise correlation matrix for harmonic mixing. The presented modeling method has been verified by the fourth harmonic mixing experiments for a dual-band antenna-coupled HTS Josephson-junction mixer module. The measured and simulated results are in good agreement in terms of the noise temperature and conversion gain as well as their dependance on dc biasing, local oscillator pumping, and operating temperatures. The results have validated the effectiveness of the presented modeling method for analyzing the properties of HTS Josephson junction mixers.
This letter presents both theoretical and experimental investigations on the noise and conversion performance of a high-Tc superconducting (HTS) step-edge Josephson-junction mixer at the frequency of 0.6 THz and operating temperatures of 20–40 K. Based on the Y-factor and U-factor methods, a double-sideband noise temperature of around 1000 K and a conversion gain of −3.5 dB were experimentally obtained at 20 K. At the temperature of 40 K, the measured mixer noise and conversion efficiency are around 2100 K and −10 dB, respectively. The experimental data are in good agreement with the numerical analysis results using the three-port model. A detailed performance comparison with other reported HTS terahertz mixers has confirmed the superior performance of our presented mixer device.
High-Tc superconducting (HTS) receivers are promising candidates for terahertz (THz) communication applications due to their superior sensitivity and the cooling attainability with a miniature cryogenic system. Nevertheless, currently reported HTS mixers are mostly single-junction devices, and a more complicated architecture like the balanced configuration has not been investigated. This paper presents the design of a 600-GHz single-balanced HTS mixer, where detailed electromagnetic simulations are carried out to optimize the coupling efficiency and port isolation, as well as desired amplitude and phase relationship. To predict the noise and conversion performance, we present an innovative multiport network interleaving-based modeling method that enables powerful simulation verifications for single-balanced HTS Josephson mixers. Simulation results show that the presented device exhibits very good HTS mixer performance at the 600-GHz band, which validates the effectiveness of the design and the potential of the mixer for THz communication applications.
Abstract Sensitive high- T c superconducting (HTS) heterodyne receivers are envisioned as promising technologies for terahertz (THz) communication and sensing applications due to the lack of power efficient sources in the band. HTS device properties, particularly the noise temperature, are dependent on complicated factors that include multiple noise sources as well as the interaction between Josephson junction and radio-frequency (RF) networks. We report investigations on the device properties of an HTS THz mixer in the presence of nonlinear thermal fluctuation and series junction array. By using the three-port analysis method, it is observed that the Planck and quantum noises representing nonlinear thermal fluctuation plays a significant role in the cases of smaller fluctuation parameters and higher signal frequencies. The influence of series junction array on mixer performance is also studied, which shows that there is an optimum junction number dependent on the normalized RF source impedance. The measured results of a broadband antenna-coupled HTS single-junction mixer agree well with that obtained by numerical simulation. The results predict that noise performance, conversion gain and operating bandwidth would be considerably improved if a series junction array with a suitable junction number is used for heterodyne mixing.
This paper presents theoretical analysis and modeling of YBaCuO superconducting Josephson mixer for terahertz frequency band. The study was carried out both for the mixing at the first harmonic and for the case of high harmonic mixing. The numerical solution based on resistively shunted junction model was obtained for the YBaCuO junction with typical experimental parameters. Optimizing mixer performance included choosing the proper operating point and the local oscillator power. A study on the effect of RF input power, frequency and the harmonic number on conversion efficiency was carried out. The theoretical predictions presented in the work provide a simple method for optimal control of the Josephson mixer and demonstrate good qualitative agreement with direct modeling. For the first time, the optimum of the conversion efficiency versus signal frequency was analytically obtained.
Abstract This paper presents a wideband terahertz (THz) mixer based on a thin-film antenna-coupled high-temperature superconducting (HTS) YBa 2 Cu 3 O 7−x (YBCO) step-edge Josephson junction. The HTS mixer enables the flexible harmonic mixing operation at multiple THz bands with the same microwave local oscillator (LO) source, and features very wide intermediate-frequency or instantaneous bandwidth. In order to optimize the frequency down-conversion performance of the mixer, systematic electromagnetic design and analysis have been carried out to improve the power coupling of THz radiation as well as wideband transmission of microwave signals. Experimental characterization of a fabricated device prototype has demonstrated that the mixer exhibits good performance at both the 200 GHz and 600 GHz bands. Detailed measurement results including the DC characteristics, LO pumping requirement, frequency response, mixing linearity and conversion gain are presented in this paper.
High temperature superconducting (HTS) Josephson junction (JJ) mixers are attractive candidates in receivers for terahertz (THz) communication due to their high sensitivity, wide bandwidth, low local oscillator (LO) power requirement and high harmonic numbers. The required LO frequencies and the cost can be greatly reduced when harmonic signals can be detected at high orders (more than 100). In this paper, up to 114thharmonic mixings is presented in a HTS bicrystal YBa2Cu3O7-δ(YBCO) JJ harmonic mixer coupled with a bowtie loaded meander antenna at 0.21 THz. HTS JJs will be promising high-order harmonic mixers for THz practical applications on reception or detection at THz bands.