High-density nitrogen-vacancy (NV) centers exceeding 1016/cm3 inside a diamond can be achieved by femtosecond laser irradiation. The number of pulses and pulse energy were adjusted considering the increasing trend of the NV concentration and damage generation. The NV concentration first grew as the number of laser pulses was increased, and then the concentration was temporarily saturated or decreased. By increasing the number of laser pulses more than 2.5–5 × 107, the concentration increased again. The Hahn-echo measurement revealed that electron spins of the substitutional nitrogen center (P1) were dominant source for decoherence and the number of paramagnetic defects induced by the laser irradiation was not significant for degradation of spin coherence of the laser-induced NV centers even without a post-annealing process. Such high-dense ensemble NV centers are crucial for a high-sensitive quantum sensor.
High-density nitrogen-vacancy (NV) centers exceeding 1016/cm3 inside a diamond can be achieved by femtosecond laser irradiation. The number of pulses and pulse energy were adjusted considering the increasing trend of the NV concentration and damage generation. The NV concentration first grew as the number of laser pulses was increased, and then the concentration was temporarily saturated or decreased. By increasing the number of laser pulses more than 2.5–5 × 107, the concentration increased again. The Hahn-echo measurement revealed that electron spins of the substitutional nitrogen center (P1) were dominant source for decoherence and the number of paramagnetic defects induced by the laser irradiation was not significant for degradation of spin coherence of the laser-induced NV centers even without a post-annealing process. Such high-dense ensemble NV centers are crucial for a high-sensitive quantum sensor.
Abstract The nitrogen-vacancy (NV) center in diamond is a promising quantum system for magnetometry applications exhibiting optical readout of minute energy shifts in its spin sub-levels. Key material requirements for NV ensembles are a high NV − concentration, a long spin coherence time and a stable charge state. However, these are interdependent and can be difficult to optimize during diamond growth and subsequent NV creation. In this work, we systematically investigate the NV center formation and properties in bulk chemical vapor deposition (CVD) diamond. The nitrogen flow during growth is varied by over four orders of magnitude, resulting in a broad range of single substitutional nitrogen concentrations of 0.2–20 parts per million. For a fixed nitrogen concentration, we optimize electron-irradiation fluences with two different accelerated electron energies, and we study defect formation via optical characterizations. We discuss a general approach to determine the optimal irradiation conditions, for which an enhanced NV concentration and an optimum of NV charge states can both be satisfied. We achieve spin–spin coherence times T 2 ranging from 45.5 to 549 μ s for CVD diamonds containing 168 to 1 parts per billion NV − centers, respectively. This study shows a pathway to engineer properties of NV-doped CVD diamonds for improved sensitivity.
Emerging quantum technologies based on the nitrogen-vacancy (NV) centre in diamond require carefully engineered material with controlled defect density, optimised NV formation processes, and minimal crystal strain. The choice of NV generation technique plays a crucial role in determining the quality and performance of these centres. In this work, we investigate NV centre formation in nitrogen-doped diamond using femtosecond (fs) laser processing. We systematically examine the effect of laser pulse energy on NV production and quality using photoluminescence and optically detected magnetic resonance measurements. We also probe the role of pre-existing lattice defects formed by electron irradiation and consider defect evolution over extended dwell times. Finally, we are able to identify a regime where the main action of the fs-laser is to diffuse rather than create vacancies. This local annealing capability expands the toolkit for tailored NV production and presents opportunities for fine tuning defect populations.
Among quantum sensors, the single nitrogen-vacancy (NV) defect in diamond has the highest sensitivity-to-size factor. For instance, a single-NV spin when used as a magnetometer could achieve sensitivities of the order of nT/Hz, while the dimensions of the sensor are merely atomic in size. The sensitivity is limited only by the photon shot noise. One method to boost the magnetometer sensitivity to pico-tesla scales is to use many NV defect centers as an ensemble sensor [Phys. Rev. X5, 041001 (2015)PRXHAE2160-330810.1103/PhysRevX.5.041001]. However, during the absorption-emission (fluorescence) optical cycles, the NV centers transfer a portion of the irradiation laser energy into phonons and heat the diamond matrix. This results in unintended fluorescence decrease, spin resonance lines shifts, and fluctuations. Hence, the advantages gained by packing a high density of NV centers are significantly reduced. Here we investigate the heat generation of ensemble NV centers in micrometer-sized diamond under 532 nm laser irradiation and its effects pertaining to sensing applications. These investigations help us to find strategies that mitigate the detrimental effects of heating and yet permits the use of ensemble NV defects for improved metrology applications.
The negatively charged nitrogen-vacancy (NV-) center in diamond is a promising spin system for quantum sensing applications. NV-ensembles are favored for an improved signal-to-noise ratio and sensitivity. The optimization of diamond with NV-ensembles often requires a high NV concentration, a long spin coherence time T2 and a stable charge state. However, these key requirements are interdependent and can be difficult to optimize: nitrogen impurities as the main decoherence source of the NV spin limits the coherence time T2, and pursuing high NV concentration can deteriorate the NV-charge-state stability. Consequently, their best achievable combination becomes an essential question for the material characterization. In this work, we systematically investigate the NV center creation and properties in chemical vapor deposition (CVD) diamond. We have grown CVD diamond series with a varying nitrogen flow over four orders of magnitude, leading to a broad range of single substitutional nitrogen (P1 center) densities from 0.2 to 20 ppm. On these series, we study P1, NV creations and NV charge states after growth, as well as their transformation under subsequent electron beam irradiation. Furthermore, for a fixed nitrogen concentration, we optimize electron-irradiation fluences with two different accelerated electron energies. We discuss a general approach to determine the optimal irradiation conditions, for which an enhanced NV concentration and an optimum of NV charge states can both be satisfied. Moreover, through irradiation and annealing treatments, we monitor the change in T2 and aim to increase the NV density without compromising T2. We achieve NV concentrations from 1 to 168 ppb with T2 from 549 to 45.5 µs respectively. This study shows a pathway to engineer properties of NV-doped CVD diamonds for improved sensitivity.
The studies of many-body dynamics of interacting spin ensembles, as well as quantum sensing in solid state systems, are often limited by the need for high spin concentrations, along with efficient decoupling of the spin ensemble from its environment. In particular, for an ensemble of nitrogen-vacancy (NV) centers in diamond, high conversion efficiencies between nitrogen (P1) defects and NV centers are essential while maintaining long coherence times of an NV ensemble. In this work, we study the effect of electron irradiation on the conversion efficiency and the coherence time of various types of diamond samples with different initial nitrogen concentrations. The samples were irradiated using a 200 keV transmission electron microscope. Our study reveals that the efficiency of NV creation strongly depends on the initial conversion efficiency and on the initial nitrogen concentration. The irradiation of the examined samples exhibits an order of magnitude improvement in the NV concentration (up to ∼1011 NV/cm2), without degradation in their coherence time of ∼180 μs. We address the potential of this technique toward the study of many-body physics of NV ensembles and the creation of non-classical spin states for quantum sensing.
We report on a novel method to fabricate single, multiple and large-area high-density ensembles of nitrogen vacancy (NV) color centers in synthetic type Ib bulk diamond by femtosecond laser illumination. Electron beams generated in propagation of intense infrared laser pulses in air sputtered on a diamond sample under high temperature aroused by the laser illumination, creating NV color centers. Typical photoluminescence (PL) spectra of NV centers could be observed on the illuminated spots. Photon streams from individual photoluminescent points exhibited anti-bunching effect by the second-order correlation measurement, evidencing single and multiple photon-emitters around the laser illuminated spots.