Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Beilstein Journal of Nanotechnology

A wideband cryogenic microwave low-noise amplifier

Boris I Ivanov, Dmitry I. Volkhin, Ilya L. Novikov, Dmitriy K. Pitsun, Dmitriy O. Moskalev, Ilya A. Rodionov, Evgeni V. Il’ichev, Вострецов Алексей Геннадьевич

Published Sep 30, 2020• 8 citations
Publisher

Abstract

A broadband low-noise four-stage high-electron-mobility transistor amplifier was designed and characterized in a cryogen-free dilution refrigerator at the 3.8 K temperature stage. The obtained power dissipation of the amplifier is below 20 mW. In the frequency range from 6 to 12 GHz its gain exceeds 30 dB. The equivalent noise temperature of the amplifier is below 6 K for the presented frequency range. The amplifier is applicable for any type of cryogenic microwave measurements. As an example we demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator.

DOI
10.3762/bjnano.11.131

Related papers

Cryogenic Low Noise Amplifiers and Filters for Superconducting Qubit Readout

Boris I. Ivanov, Dmitry I. Volkhin, Ilya L. Novikov +1 more

We show an experimental study of superconducting X-mon qubit based on low noise wideband measurement setup. The setup includes wide stop-band low frequency filters with a stopband frequency up to 13 GHz, the broadband low-noise cryogenic microwave amplifier (cLNA) operating at 3.8 K. The obtained power dissipation of the cLNA is below 20 mW, the frequency operating ranges from 6 GHz to 12 GHz with a gain of 30 dB. The equivalent noise temperature of the amplifier is bellow 6 K for the presented frequency range. We demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator. We show standard qubit experiments: one and two-tones qubit spectroscopy, ac-Stark shift experiments for probing and excitation power sweeps.

International Conference of Young Specialists on Micro/Nanotechnologies and Electron Devices•Jun 1, 2020•1 citation

A microwave cryogenic low-noise amplifier based on sige heterostructures

Boris I. Ivanov, M. Grajcar, Ilya L. Novikov +2 more

A low-noise cryogenic amplifier for the measurement of weak microwave signals at sub-Kelvin temperatures is constructed. The amplifier has five stages based on SiGe bipolar heterostructure transistors and has a gain factor of 35 dB in the frequency band from 100 MHz to 4 GHz at an operating temperature of 800 mK. The parameters of a superconducting quantum bit measured with this amplifier in the ultralow-power mode are presented as an application example. The amplitude–frequency response of the “supercon-ducting qubit–coplanar cavity” structure is demonstrated. The ground state of the qubit is characterized in the quasi-dispersive measurement mode.

Technical Physics Letters•Apr 1, 2016•19 citations

A 3.5~7.5 GHz GaAs HEMT Cryogenic Low-NoiseAmplifier Achieving 5 Kelvin Noise Temperature for Qubits Measurement

Yatao Peng, Youpeng Zhong, Zechen Guo +2 more

The measurement of the fast-increasing number of qubits necessitates the use of a large number of specialized cryogenic low-noise amplifiers (LNAs).). This work presents a broadband LNA designed with discrete GaAs HEMT components which operate well at ~3.6 K temperature. The dual-frequency optimum noise matching network and output matching elements of the first stage were employed to optimize the equivalent noise temperature (NT) and the input return loss in a wideband. Measurement results at 3.6 K ambient temperature show that the LNA achieved an equivalent NT of30 dB in the 3.5 GHz to 7.5 GHz band with a minimum of 5 Kelvin at ~6.5 GHz. The best visibility of ~0.891 is achieved when using the LNA to observe a superconducting transmon qubit without using a JPA.

IEEE MTT-S International Microwave Symposium digest•Jun 11, 2023•9 citations

A 4–8 GHz GaAs LNA with 15K Noise Temperature for Superconducting Qubit Readout

Zhe Wang, Ruihao Yin, Hua Chen

This paper presents a cryogenic low-noise amplifier designed for superconducting qubit readout in quantum computing systems. The proposed LNA adopts a three-stage cascaded to achieve a balanced trade-off between gain and noise. Moreover, optimized inter-stage matching is also used. At 300K, the LNA exhibits a bandwidth of 4–8 GHz with a gain ranging from 33 to 35 dB, and a noise figure of 1.5 dB at 6 GHz. At 4K, it delivers over 32 dB gain across 4-8 GHz with noise temperature below 20K (minimum 15K), while power only 12 mW. Additionally, this C-band cryogenic MMIC LNA is designed in a 250 nm GaAs pHEMT process.

International Conference on Microwave and Millimeter Wave Technology (ICMMT)•May 1, 2026•0 citations

Cryogenic Semiconductor Amplifier for RSFQ-Circuits With High Data Rates at 4.2 K

S. Wünsch, Thomas Ortlepp, E. Crocoll +2 more

The connection of RSFQ circuits with commercial room temperature electronics and amplifying SFQ pulses with high data rates require cryogenic interface amplifiers. Such amplifiers should provide extremely high bandwidth, low noise and low power consumption at the same time. Various hybrid amplifiers based on commercial p-HEMT transistors in an embedded microwave design were designed and characterized. Towards the p-HEMT transistor characterization at cryogenic temperature the biasing settings according to an optimum between voltage gain and low power consumption were determined. Thus a total power consumption of 2 mW and a voltage gain of 12 dB per single stage were achieved. For a preamplifier and an amplifier concept a multiple number of these stages were implemented in a microstrip and a coplanar transmission line design with a special matched interconnect taper towards the RSFQ components. Measurements of the amplifiers, the combination of an amplifier with a RSFQ circuit at 4.2 K showed their good performances without any disturbance of the RSFQ circuit. Due to the losses between the stages a total gain of 25 dB with a four stage amplifier was achieved; pulse rates went up to 3 Gb/s. The total power consumption was in the range of 8 mW. Further increase of data rates will be achieved by improving the matching between RSFQ output stage and amplifier.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•15 citations

Design and Analysis on a Cryogenic Current Amplifier with a Superconducting Microwave Resonator

Yuma Okazaki, Nobu‐Hisa Kaneko

We propose a new type of cryogenic current amplifiers, in which low-frequency power spectrum of current can be measured through a measurement of microwave response of a superconducting resonant circuit shunted by a series array of Josephson junctions. From numerical analysis on the equivalent circuit, the numerical value of the input-referred current noise of the proposed amplifier is found to be two orders of magnitude lower than the noise floor measured with the conventional cryogenic current amplifiers based on high-electron-mobility transistors or superconducting quantum interference devices. Our proposal can open new avenues for investigating low-temperature solid-state devices that require lower noise and wider bandwidth power spectrum measurements of current.

arXiv:1508.03131•IEEE International Superconductive Electronics Conference (ISEC)•Jul 1, 2015•0 citations
A broadband low-noise four-stage high-electron-mobility transistor amplifier was designed and characterized in a cryogen-free dilution refrigerator at the 3.8 K temperature stage. The obtained power dissipation of the amplifier is below 20 mW. In the frequency range from 6 to 12 GHz its gain exceeds 30 dB. The equivalent noise temperature of the amplifier is below 6 K for the presented frequency range. The amplifier is applicable for any type of cryogenic microwave measurements. As an example we demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator.
We show an experimental study of superconducting X-mon qubit based on low noise wideband measurement setup. The setup includes wide stop-band low frequency filters with a stopband frequency up to 13 GHz, the broadband low-noise cryogenic microwave amplifier (cLNA) operating at 3.8 K. The obtained power dissipation of the cLNA is below 20 mW, the frequency operating ranges from 6 GHz to 12 GHz with a gain of 30 dB. The equivalent noise temperature of the amplifier is bellow 6 K for the presented frequency range. We demonstrate here the characterization of the superconducting X-mon qubit coupled to an on-chip coplanar waveguide resonator. We show standard qubit experiments: one and two-tones qubit spectroscopy, ac-Stark shift experiments for probing and excitation power sweeps.
A low-noise cryogenic amplifier for the measurement of weak microwave signals at sub-Kelvin temperatures is constructed. The amplifier has five stages based on SiGe bipolar heterostructure transistors and has a gain factor of 35 dB in the frequency band from 100 MHz to 4 GHz at an operating temperature of 800 mK. The parameters of a superconducting quantum bit measured with this amplifier in the ultralow-power mode are presented as an application example. The amplitude–frequency response of the “supercon-ducting qubit–coplanar cavity” structure is demonstrated. The ground state of the qubit is characterized in the quasi-dispersive measurement mode.
The measurement of the fast-increasing number of qubits necessitates the use of a large number of specialized cryogenic low-noise amplifiers (LNAs).). This work presents a broadband LNA designed with discrete GaAs HEMT components which operate well at ~3.6 K temperature. The dual-frequency optimum noise matching network and output matching elements of the first stage were employed to optimize the equivalent noise temperature (NT) and the input return loss in a wideband. Measurement results at 3.6 K ambient temperature show that the LNA achieved an equivalent NT of30 dB in the 3.5 GHz to 7.5 GHz band with a minimum of 5 Kelvin at ~6.5 GHz. The best visibility of ~0.891 is achieved when using the LNA to observe a superconducting transmon qubit without using a JPA.
This paper presents a cryogenic low-noise amplifier designed for superconducting qubit readout in quantum computing systems. The proposed LNA adopts a three-stage cascaded to achieve a balanced trade-off between gain and noise. Moreover, optimized inter-stage matching is also used. At 300K, the LNA exhibits a bandwidth of 4–8 GHz with a gain ranging from 33 to 35 dB, and a noise figure of 1.5 dB at 6 GHz. At 4K, it delivers over 32 dB gain across 4-8 GHz with noise temperature below 20K (minimum 15K), while power only 12 mW. Additionally, this C-band cryogenic MMIC LNA is designed in a 250 nm GaAs pHEMT process.
The connection of RSFQ circuits with commercial room temperature electronics and amplifying SFQ pulses with high data rates require cryogenic interface amplifiers. Such amplifiers should provide extremely high bandwidth, low noise and low power consumption at the same time. Various hybrid amplifiers based on commercial p-HEMT transistors in an embedded microwave design were designed and characterized. Towards the p-HEMT transistor characterization at cryogenic temperature the biasing settings according to an optimum between voltage gain and low power consumption were determined. Thus a total power consumption of 2 mW and a voltage gain of 12 dB per single stage were achieved. For a preamplifier and an amplifier concept a multiple number of these stages were implemented in a microstrip and a coplanar transmission line design with a special matched interconnect taper towards the RSFQ components. Measurements of the amplifiers, the combination of an amplifier with a RSFQ circuit at 4.2 K showed their good performances without any disturbance of the RSFQ circuit. Due to the losses between the stages a total gain of 25 dB with a four stage amplifier was achieved; pulse rates went up to 3 Gb/s. The total power consumption was in the range of 8 mW. Further increase of data rates will be achieved by improving the matching between RSFQ output stage and amplifier.
We propose a new type of cryogenic current amplifiers, in which low-frequency power spectrum of current can be measured through a measurement of microwave response of a superconducting resonant circuit shunted by a series array of Josephson junctions. From numerical analysis on the equivalent circuit, the numerical value of the input-referred current noise of the proposed amplifier is found to be two orders of magnitude lower than the noise floor measured with the conventional cryogenic current amplifiers based on high-electron-mobility transistors or superconducting quantum interference devices. Our proposal can open new avenues for investigating low-temperature solid-state devices that require lower noise and wider bandwidth power spectrum measurements of current.