Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Fundamental limits of laser power stabilization via a radiation pressure transfer scheme

Marina Trad Nery, S. L. Danilishin, Jasper R. Venneberg, B. Willke

Published Jun 15, 2020• 4 citations
Publisher

Abstract

Traditional active laser power stabilization schemes are fundamentally limited by quantum shot noise on the in-loop photodetector. One way to overcome this limitation is to implement a nondemolition sensing scheme where laser power fluctuations are transferred to motion of a micro-oscillator, which can be sensed with a high signal-to-noise ratio. In this Letter, we analyze the power stability achievable in a nondemolition scheme limited by quantum and thermal noise. Under the assumption of realistic experimental parameters, we show that generation of a strong bright squeezed quantum state of light should be possible.

DOI
10.1364/ol.394547

Related papers

Bright squeezed light generation via nonclassical power stabilization

Jasper R. Venneberg, H. Vahlbruch, Marina Trad Nery +1 more

Low-power-noise lasers are essential for many high-precision experiments. Shot noise imposes a fundamental limit on the power stability achievable with classical light sources. In this Letter, we report the generation of bright squeezed light in the audio band, which can improve the sensitivity of otherwise shot-noise-limited measurements. The bright squeezed light source is experimentally realized via the use of squeezed vacuum in a power stabilization scheme. We demonstrate a laser beam at a power of 9.9 mW with a broadband power noise suppression below the classical stabilization limit by up to 8 . 7 − 0.4 + 0.3 dB in the audio band, resulting in a bright squeezed beam with a power noise of 5 . 7 − 0.4 + 0.3 dB below shot noise for frequencies from 6 kHz to 20 kHz. We further conceptually outline a method to surpass this result in the future.

Physical Review Research•May 20, 2025•7 citations

Laser Power Stabilization beyond the Shot Noise Limit Using Squeezed Light

H. Vahlbruch, D. M. Wilken, Moritz Mehmet +1 more

High levels of laser power stability are necessary for high precision metrology applications. The classical limit for the achievable power stability is determined by the shot noise of the light used to generate a power control signal. Increasing the power of the detected light reduces the relative shot noise level and allows higher stabilities. However, sufficiently high power is not always available and the detection of high laser powers is challenging. Here, we demonstrate a nonclassical way to improve the achievable power stability without increasing the detected power. By the injection of a squeezed vacuum field of light we improve the classical laser power stability beyond its shot noise limit by 9.4_{-0.6}^{+0.6} dB at Fourier frequencies between 5 and 80 kHz. For only 90.6 μA of detected photocurrent we achieve a relative laser power noise of 2.0_{-0.1}^{+0.1}×10^{-8}/sqrt[Hz]. This is the first demonstration of a squeezed light-enhanced laser power stabilization and its performance is equivalent to an almost tenfold increase of detected laser power in a classical scheme. The analysis reveals that the technique presented here has the potential to achieve stability levels of 4.2×10^{-10}/sqrt[Hz] with 58 mA photocurrent measured on a single photodetector.

Physical Review Letters•Oct 22, 2018•64 citations

Generating long-term stable squeezed states via multiple pump noise suppression

Lijun Gao, Shaoping Shi, Bo Lu +5 more

Pump power fluctuations are a critical factor in limiting the long-term stability of quantum sensing light sources. However, existing laser power stabilization techniques fail to efficiently address power fluctuations caused by downstream beam-pointing noise coupling. Here, we propose an optimized suppression scheme of pump power fluctuations that integrates a passive second harmonic process and active feedback control, achieving multiple noise suppression of both pointing and intensity noise in the pump field. Within the measurement time of 8.5 hours, we achieve a quantum sensing light source with a squeezing factor of 10.0 dB and its fluctuations below 0.4 dB. The proposed approach effectively boosts the long-term stability of the quantum squeezing source, thus paving a solid way for expanding the utilization of squeezing sources within the realm of quantum precision measurement.

Optics Letters•Jun 23, 2025•5 citations

Bright squeezed light in the kilohertz frequency band

Ruixin Li, Bingnan An, Nanjing Jiao +4 more

The dominant technical noise of a free-running laser practically limits bright squeezed light generation, particularly within the MHz band. To overcome this, we develop a comprehensive theoretical model for nonclassical power stabilization, and propose a novel bright squeezed light generation scheme incorporating hybrid power noise suppression. Our approach integrates broadband passive power stabilization with nonclassical active stabilization, extending the feedback bandwidth to MHz frequencies. This hybrid technique achieves an additional 9 dB technical noise suppression, establishing critical prerequisites for broadband bright squeezed light generation. Finally, a -5.5 dB bright squeezed light at 1 mW with kHz-MHz squeezing bandwidth was generated. The experimental results show excellent agreement with theoretical predictions, which represent we have comprehensively demonstrated a milliwatt-order bright squeezed light across kHz-MHz frequencies. Our work enables new quantum metrology applications and paves the way for next-generation quantum-enhanced technologies. Nonclassical hybrid passive-active power stabilization enables milliwatt-level bright squeezing across kHz-MHz band.

arXiv:2504.00627•Light Science & Applications•Sep 8, 2025•20 citations

Suppression of classic and quantum radiation pressure noise by electro-optic feedback

B. C. Buchler, Malcolm B. Gray, D. A. Shaddock +2 more

We present theoretical results that demonstrate a new technique that can be used to improve the sensitivity of thermal noise measurements: intracavity intensity stabilization. It is demonstrated that electro-optic feedback can be used to reduce intracavity intensity fluctuations, and the consequent radiation pressure fluctuations, by a factor of 2 below the quantum-noise limit. We show that this reduction is achievable in the presence of large classic intensity fluctuations in the incident laser beam. The benefits of this scheme are a consequence of the sub-Poissonian intensity statistics of the field inside a feedback loop and the quantum nondemolition nature of radiation pressure noise as a readout system for the intracavity intensity fluctuations.

arXiv:quant-ph/9811014•Optics Letters•Feb 15, 1999•34 citations

Increasing the optical power in sub-shot noise precision measurements of absorption

Jonathan C. F. Matthews

The optical shot-noise limit of a laser beam represents the classical limit in precision and signal to noise ratio achievable in optical sensors and imaging systems. It is known that quantum states of light, such as squeezed light and quantum correlated twin beams can be used to enhance precision and signal to noise ratio to beyond this limit. This promises optical sensors with fundamentally superior performance to the state of the art. While quantum-enhanced signal to noise ratio has been demonstrated with macroscopic powers of squeezed probe beam, demonstrations of quantum enhanced precision have remained at extremely low powers of light (femto-Watts). Here we will give examples where increasing SNR with quantum light is not sufficient to increase precision and we will review proof of principle experiments that have demonstrated sub shot noise precision, including for absorption spectroscopy and imaging. We will also report our efforts to achieve this sub-shot-noise precision performance for transmission measurement with ~0.1mW of average probe power, equating to ~10W peak power in a pulsed experiment. Time permitting, we will discuss how integrated optics and integrated electronics enables 10s GHz bandwidth in the detection of squeezed light, for integrated quantum sensor technology.

Emerging Imaging and Sensing Technologies for Security and Defence; and Advanced Manufacturing Technologies for Micro- and Nanosystems in Security and Defence•Sep 18, 2020•0 citations
Traditional active laser power stabilization schemes are fundamentally limited by quantum shot noise on the in-loop photodetector. One way to overcome this limitation is to implement a nondemolition sensing scheme where laser power fluctuations are transferred to motion of a micro-oscillator, which can be sensed with a high signal-to-noise ratio. In this Letter, we analyze the power stability achievable in a nondemolition scheme limited by quantum and thermal noise. Under the assumption of realistic experimental parameters, we show that generation of a strong bright squeezed quantum state of light should be possible.
Low-power-noise lasers are essential for many high-precision experiments. Shot noise imposes a fundamental limit on the power stability achievable with classical light sources. In this Letter, we report the generation of bright squeezed light in the audio band, which can improve the sensitivity of otherwise shot-noise-limited measurements. The bright squeezed light source is experimentally realized via the use of squeezed vacuum in a power stabilization scheme. We demonstrate a laser beam at a power of 9.9 mW with a broadband power noise suppression below the classical stabilization limit by up to 8 . 7 − 0.4 + 0.3 dB in the audio band, resulting in a bright squeezed beam with a power noise of 5 . 7 − 0.4 + 0.3 dB below shot noise for frequencies from 6 kHz to 20 kHz. We further conceptually outline a method to surpass this result in the future.
High levels of laser power stability are necessary for high precision metrology applications. The classical limit for the achievable power stability is determined by the shot noise of the light used to generate a power control signal. Increasing the power of the detected light reduces the relative shot noise level and allows higher stabilities. However, sufficiently high power is not always available and the detection of high laser powers is challenging. Here, we demonstrate a nonclassical way to improve the achievable power stability without increasing the detected power. By the injection of a squeezed vacuum field of light we improve the classical laser power stability beyond its shot noise limit by 9.4_{-0.6}^{+0.6} dB at Fourier frequencies between 5 and 80 kHz. For only 90.6 μA of detected photocurrent we achieve a relative laser power noise of 2.0_{-0.1}^{+0.1}×10^{-8}/sqrt[Hz]. This is the first demonstration of a squeezed light-enhanced laser power stabilization and its performance is equivalent to an almost tenfold increase of detected laser power in a classical scheme. The analysis reveals that the technique presented here has the potential to achieve stability levels of 4.2×10^{-10}/sqrt[Hz] with 58 mA photocurrent measured on a single photodetector.
Pump power fluctuations are a critical factor in limiting the long-term stability of quantum sensing light sources. However, existing laser power stabilization techniques fail to efficiently address power fluctuations caused by downstream beam-pointing noise coupling. Here, we propose an optimized suppression scheme of pump power fluctuations that integrates a passive second harmonic process and active feedback control, achieving multiple noise suppression of both pointing and intensity noise in the pump field. Within the measurement time of 8.5 hours, we achieve a quantum sensing light source with a squeezing factor of 10.0 dB and its fluctuations below 0.4 dB. The proposed approach effectively boosts the long-term stability of the quantum squeezing source, thus paving a solid way for expanding the utilization of squeezing sources within the realm of quantum precision measurement.
The dominant technical noise of a free-running laser practically limits bright squeezed light generation, particularly within the MHz band. To overcome this, we develop a comprehensive theoretical model for nonclassical power stabilization, and propose a novel bright squeezed light generation scheme incorporating hybrid power noise suppression. Our approach integrates broadband passive power stabilization with nonclassical active stabilization, extending the feedback bandwidth to MHz frequencies. This hybrid technique achieves an additional 9 dB technical noise suppression, establishing critical prerequisites for broadband bright squeezed light generation. Finally, a -5.5 dB bright squeezed light at 1 mW with kHz-MHz squeezing bandwidth was generated. The experimental results show excellent agreement with theoretical predictions, which represent we have comprehensively demonstrated a milliwatt-order bright squeezed light across kHz-MHz frequencies. Our work enables new quantum metrology applications and paves the way for next-generation quantum-enhanced technologies. Nonclassical hybrid passive-active power stabilization enables milliwatt-level bright squeezing across kHz-MHz band.
We present theoretical results that demonstrate a new technique that can be used to improve the sensitivity of thermal noise measurements: intracavity intensity stabilization. It is demonstrated that electro-optic feedback can be used to reduce intracavity intensity fluctuations, and the consequent radiation pressure fluctuations, by a factor of 2 below the quantum-noise limit. We show that this reduction is achievable in the presence of large classic intensity fluctuations in the incident laser beam. The benefits of this scheme are a consequence of the sub-Poissonian intensity statistics of the field inside a feedback loop and the quantum nondemolition nature of radiation pressure noise as a readout system for the intracavity intensity fluctuations.
The optical shot-noise limit of a laser beam represents the classical limit in precision and signal to noise ratio achievable in optical sensors and imaging systems. It is known that quantum states of light, such as squeezed light and quantum correlated twin beams can be used to enhance precision and signal to noise ratio to beyond this limit. This promises optical sensors with fundamentally superior performance to the state of the art. While quantum-enhanced signal to noise ratio has been demonstrated with macroscopic powers of squeezed probe beam, demonstrations of quantum enhanced precision have remained at extremely low powers of light (femto-Watts). Here we will give examples where increasing SNR with quantum light is not sufficient to increase precision and we will review proof of principle experiments that have demonstrated sub shot noise precision, including for absorption spectroscopy and imaging. We will also report our efforts to achieve this sub-shot-noise precision performance for transmission measurement with ~0.1mW of average probe power, equating to ~10W peak power in a pulsed experiment. Time permitting, we will discuss how integrated optics and integrated electronics enables 10s GHz bandwidth in the detection of squeezed light, for integrated quantum sensor technology.