The remarkable advances of quantum computation technology with superconducting qubits based on circuit quantum electrodynamics (QED) architecture have been achieved by improving control, protection and measurement of the quantum states at the same time. At the heart of all these quantum operations, the significant enhancement of the qubit coherence time during the last decades was the key. Even after all these advances, the coherence and relaxation time of superconducting qubits still requires further improvements toward fault-tolerant quantum computation. Here, we report our observation of a strongly enhanced lifetime of an in-situ tunable superconducting transmon qubit on a silicon substrate that is embedded in a three-dimensional copper cavity. We measured a lifetime of the qubit of up to 84 µs, which is the best reported value of an in-situ tunable transmon on a silicon substrate. In our experiment, the in-situ frequency tunability over a broad range enabled the Purcell factor to be controlled continuously by detuning the qubit frequency against the resonator frequency in the strong dispersive regime. The silicon substrate has its own importance because the substrate should be fully compatible with the conventional semiconductor processes so that scalability and multi-chip module capability are guaranteed. In order to control the Purcell factor with another parameter, we displaced the qubit position in the cavity and observed a longer relaxation time with a smaller coupling coefficient. We believe that this systematic study and the control technique of the Purcell effect in the circuit QED design, together with minimizing the microwave photon loss through an improvement of the fabrication, will contribute to the realization of a practical large-scale quantum computer based on superconducting qubit technology.
The remarkable advances of quantum computation technology with superconducting qubits based on circuit quantum electrodynamics (QED) architecture have been achieved by improving control, protection and measurement of the quantum states at the same time. At the heart of all these quantum operations, the significant enhancement of the qubit coherence time during the last decades was the key. Even after all these advances, the coherence and relaxation time of superconducting qubits still requires further improvements toward fault-tolerant quantum computation. Here, we report our observation of a strongly enhanced lifetime of an in-situ tunable superconducting transmon qubit on a silicon substrate that is embedded in a three-dimensional copper cavity. We measured a lifetime of the qubit of up to 84 µs, which is the best reported value of an in-situ tunable transmon on a silicon substrate. In our experiment, the in-situ frequency tunability over a broad range enabled the Purcell factor to be controlled continuously by detuning the qubit frequency against the resonator frequency in the strong dispersive regime. The silicon substrate has its own importance because the substrate should be fully compatible with the conventional semiconductor processes so that scalability and multi-chip module capability are guaranteed. In order to control the Purcell factor with another parameter, we displaced the qubit position in the cavity and observed a longer relaxation time with a smaller coupling coefficient. We believe that this systematic study and the control technique of the Purcell effect in the circuit QED design, together with minimizing the microwave photon loss through an improvement of the fabrication, will contribute to the realization of a practical large-scale quantum computer based on superconducting qubit technology.
Abstract Superconducting quantum circuits are a leading platform for quantum-information processing, but their development requires expertise spanning device design, microfabrication, cryogenic operation, microwave control, and quantum characterization. In this work, we report the realization of a flux-tunable superconducting transmon platform and present an integrated workflow encompassing design, fabrication, measurement, and numerical modeling. The device consists of an Al/AlOx/Al transmon coupled to a three-dimensional microwave cavity operating in the circuit quantum electrodynamics (cQED) dispersive regime. Two-tone spectroscopy reveals a fundamental transition frequency of ω01=5.0122GHz and an anharmonicity of α/2π=−202.4MHz , corresponding to EJ/EC≈82.9 . Flux spectroscopy yields a cavity-qubit coupling strength of g/2π=260MHz , while the cavity linewidth gives a loaded quality factor of QL=6127 and a Purcell limit of T1Purcell≈82μs . Time-domain measurements yield coherence times of T1=17.4μs and T2∗=5.8μs . To investigate coherence and dissipation in the device, the experimental observations are analyzed within a Lindblad master-equation framework describing cavity photon loss and thermal excitation, qubit energy relaxation, and pure dephasing processes. Using a set of experimentally extracted parameters, the model reproduces the measured spectroscopic and time-domain observables, providing a quantitative description of the open-system dynamics of the transmon-cavity platform. The analysis shows that the measured coherence is primarily limited by pure dephasing and energy-relaxation processes, whereas thermal excitation plays a minor role under the experimental conditions. Inspired by the broader framework of quantum dissipation in macroscopic quantum systems pioneered by Caldeira and collaborators, this approach enables a quantitative analysis of relaxation and dephasing processes in superconducting quantum circuits. Beyond the characterization of a single device, the present work demonstrates the establishment of the expertise, infrastructure, and experimental workflow required for the design, fabrication, measurement, and modeling of superconducting quantum circuits, contributing to the development of quantum technologies in Brazil and related applications.
Spontaneous emission through a coupled cavity can be a significant decay channel for qubits in circuit quantum electrodynamics. We present a circuit design that effectively eliminates spontaneous emission due to the Purcell effect while maintaining strong coupling to a low-Q cavity. Excellent agreement over a wide range in frequency is found between measured qubit relaxation times and the predictions of a circuit model. Using fast (nanosecond time-scale) flux biasing of the qubit, we demonstrate in situ control of qubit lifetime over a factor of 50. We realize qubit reset with 99.9% fidelity in 120 ns.
We present a planar qubit design based on a superconducting circuit that we call concentric transmon. While employing a straightforward fabrication process using Al evaporation and lift-off lithography, we observe qubit lifetimes and coherence times in the order of 10 μs. We systematically characterize loss channels such as incoherent dielectric loss, Purcell decay and radiative losses. The implementation of a gradiometric SQUID loop allows for a fast tuning of the qubit transition frequency and therefore for full tomographic control of the quantum circuit. Due to the large loop size, the presented qubit architecture features a strongly increased magnetic dipole moment as compared to conventional transmon designs. This renders the concentric transmon a promising candidate to establish a site-selective passive direct Ẑ coupling between neighboring qubits, being a pending quest in the field of quantum simulation.
We describe a tunable-cavity quantum electrodynamics (QED) architecture with an rf SQUID phase qubit inductively coupled to a single-mode, resonant cavity with a tunable frequency that allows for both microwave readout of tunneling and dispersive measurements of the qubit. Dispersive measurement is well characterized by a three-level model, strongly dependent on qubit anharmonicity, qubit-cavity coupling, and detuning. A tunable-cavity frequency provides a way to strongly vary both the qubit-cavity detuning and coupling strength, which can reduce Purcell losses, cavity-induced dephasing of the qubit, and residual bus coupling for a system with multiple qubits. With our qubit-cavity system, we show that dynamic control over the cavity frequency enables one to avoid Purcell losses during coherent qubit evolutions and optimize state readout during qubit measurements. The maximum qubit decay time ${T}_{1}=1.5\phantom{\rule{0.222222em}{0ex}}\ensuremath{\mu}$s is found to be limited by surface dielectric losses from a design geometry similar to planar transmon qubits.
We present a planar qubit design based on a superconducting circuit that we call concentric transmon. While employing a straightforward fabrication process using Al evaporation and lift-off lithography, we observe qubit lifetimes and coherence times in the order of 10us. We systematically characterize loss channels such as incoherent dielectric loss, Purcell decay and radiative losses. The implementation of a gradiometric SQUID loop allows for a fast tuning of the qubit transition frequency and therefore for full tomographic control of the quantum circuit. Due to the large loop size, the presented qubit architecture features a strongly increased magnetic dipole moment as compared to conventional transmon designs. This renders the concentric transmon a promising candidate to establish a site-selective passive direct Z coupling between neighboring qubits, being a pending quest in the field of quantum simulation.
Superconducting quantum circuits have emerged as a leading platform for building large-scale quantum computers, owing to their ability to engineer strong, highly tunable interactions. However, achieving high-fidelity quantum operations requires overcoming the fundamental isolation-andcontrol challenge: qubits must be well-isolated from their electromagnetic environment to maintain long coherence times, yet they require strong external coupling for fast control, readout, and initialization. In current architectures, this trade-off often demands complex auxiliary circuitry that can introduce additional noise and thermal loads. This thesis presents novel circuit designs and control techniques to address the isolation-and-control challenge in superconducting transmon qubits. First, we introduce integrated on-chip filters, in particular, 𝜆/4 and 𝜆/2 transmission line filters that exhibit a stopband at the qubit frequency. This design protects the qubit from Purcell decay, yielding up to a 200-fold improvement in the energy relaxation time 𝑇1 at the stopband. To achieve fast single-qubit gates despite this isolation, we employ subharmonic driving, demonstrating sub-ten-nanosecond control and Rabi oscillations with a 12-ns pulse duration while significantly reducing the cryogenic thermal load. Building upon these static filters, we propose and experimentally demonstrate the quantum dial, a dynamically tunable band-stop filter consisting of a series array of direct-current superconducting quantum interference devices. The quantum dial enables on-demand tuning of the qubit–environment coupling, including a reduction of 𝑇1 from over 150 μs to roughly 200 ns, while introducing minimal ac Stark shifts. We demonstrate its versatility by dialing between three operational regimes: an idle state with 99.99% fidelity, a control state enabling 99.9% fidelity for 40-ns single-qubit gates at −110 dBm, and a strongly coupled state for unconditional, state-independent qubit reset. Furthermore, the quantum dial enables qubit thermometry close to the quantum-Fisherinformation bound, with a noise-equivalent temperature down to 0.6 mK/√Hz at 60 mK. Alongside the development of these dedicated control architectures, this thesis contributes to the broader framework of circuit quantum electrodynamics by advancing specific microwave engineering and characterization techniques. In particular, we explore the miniaturization of circuit footprints through the realization of compact sub-gigahertz inductor-capacitor resonators. Additionally, we contribute to the optimization of unconditional qubit reset using a single-junction quantum-circuit refrigerator, and to the advanced characterization of microwave fields via computed tomography of propagating microwave photons. In summary, these results demonstrate fixed and tunable drive-line filters that suppress idle-state radiative decay while preserving selected control, reset, and thermometry operations. By replacing static coupling compromises with temporally programmable environments, these architectures offer a promising route to reducing noise, mitigating crosstalk, and accelerating error-correction cycles in future superconducting quantum processors.