Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Current-Induced Switching in Superconducting Break Junctions

David Weber

Published Jan 1, 2018• 0 citations
OpenAlex

Related papers

LTS Josephson junction critical current uniformities for LSI applications

L.A. Abelson, K.P. Daly, N. Martinez +1 more

Manufacturing yields of large scale superconducting circuits depend strongly on the uniformity of junction critical currents. We report on junction manufacturing tolerances based on extensive measurements of Nb- and NbN-based junction arrays and individual junctions. Transient waveforms induced by switching of a single junction have sufficient amplitude to switch other junctions in a series array. We have measured the effect of sympathetic switching and developed damping structures to dissipate switching transients. Comparisons of critical current distributions measured on individual junctions with critical current distributions determined from series junction arrays are presented. In addition, the validity of using series arrays of large numbers of junctions to assess the critical current uniformity is discussed.>

IEEE Transactions on Applied Superconductivity•Jun 1, 1995•19 citations

A New Nonlinearity for Superconducting Circuits

Marric Stephens

Physics•Sep 5, 2024•0 citations

Hybrid superconducting junctions

Βασίλειος Παλτόγλου

•Jan 1, 2009•0 citations

Thermal noise induced switching of Josephson logic devices

M. Klein, A. Mukherjee

Thermal noise induced switching of Josephson logic devices is studied, both theoretically and experimentally. The results are critical for the design of the operating bias points for these devices. An analysis of the relevant energy contours shows that a three-junction superconducting quantum interference device has the same noise switching rate as a point junction with the same maximum critical current. Experimental results, for the dependence of the thermal noise induced switching rate on the gate current bias ratio, are in very good agreement with the theory.

Applied Physics Letters•Apr 15, 1982•37 citations

Current-induced SQUID behavior of superconducting Nb nano-rings

Omri J. Sharon, A. Shaulov, Jorge Berger +2 more

The critical temperature in a superconducting ring changes periodically with the magnetic flux threading it, giving rise to the well-known Little-Parks magnetoresistance oscillations. Periodic changes of the critical current in a superconducting quantum interference device (SQUID), consisting of two Josephson junctions in a ring, lead to a different type of magnetoresistance oscillations utilized in detecting extremely small changes in magnetic fields. Here we demonstrate current-induced switching between Little-Parks and SQUID magnetoresistance oscillations in a superconducting nano-ring without Josephson junctions. Our measurements in Nb nano-rings show that as the bias current increases, the parabolic Little-Parks magnetoresistance oscillations become sinusoidal and eventually transform into oscillations typical of a SQUID. We associate this phenomenon with the flux-induced non-uniformity of the order parameter along a superconducting nano-ring, arising from the superconducting leads ('arms') attached to it. Current enhanced phase slip rates at the points with minimal order parameter create effective Josephson junctions in the ring, switching it into a SQUID.

Scientific Reports•Jun 20, 2016•18 citations

Bistability and Critical Slowing Down in Superconducting Circuits

Paul Brookes, Giovanna Tancredi, Themis Mavrogordatos +6 more

Bulletin of the American Physical Society•Mar 5, 2019•0 citations
Manufacturing yields of large scale superconducting circuits depend strongly on the uniformity of junction critical currents. We report on junction manufacturing tolerances based on extensive measurements of Nb- and NbN-based junction arrays and individual junctions. Transient waveforms induced by switching of a single junction have sufficient amplitude to switch other junctions in a series array. We have measured the effect of sympathetic switching and developed damping structures to dissipate switching transients. Comparisons of critical current distributions measured on individual junctions with critical current distributions determined from series junction arrays are presented. In addition, the validity of using series arrays of large numbers of junctions to assess the critical current uniformity is discussed.>
Thermal noise induced switching of Josephson logic devices is studied, both theoretically and experimentally. The results are critical for the design of the operating bias points for these devices. An analysis of the relevant energy contours shows that a three-junction superconducting quantum interference device has the same noise switching rate as a point junction with the same maximum critical current. Experimental results, for the dependence of the thermal noise induced switching rate on the gate current bias ratio, are in very good agreement with the theory.
The critical temperature in a superconducting ring changes periodically with the magnetic flux threading it, giving rise to the well-known Little-Parks magnetoresistance oscillations. Periodic changes of the critical current in a superconducting quantum interference device (SQUID), consisting of two Josephson junctions in a ring, lead to a different type of magnetoresistance oscillations utilized in detecting extremely small changes in magnetic fields. Here we demonstrate current-induced switching between Little-Parks and SQUID magnetoresistance oscillations in a superconducting nano-ring without Josephson junctions. Our measurements in Nb nano-rings show that as the bias current increases, the parabolic Little-Parks magnetoresistance oscillations become sinusoidal and eventually transform into oscillations typical of a SQUID. We associate this phenomenon with the flux-induced non-uniformity of the order parameter along a superconducting nano-ring, arising from the superconducting leads ('arms') attached to it. Current enhanced phase slip rates at the points with minimal order parameter create effective Josephson junctions in the ring, switching it into a SQUID.