Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Laser Physics

2.8 km fiber link with phase noise compensation for transportable Yb + optical clock characterization

K. S. Kudeyarov, Gulnara A. Vishnyakova, Ksenia Yu. Khabarova, N. Kolachevsky

Published Jul 25, 2018• 13 citations
Publisher

Abstract

Abstract The operation of a 2.8 km fiber link at 1.14 µ m for ultrastable optical frequency dissemination, which will allow for the characterization of transportable Yb + based optical clock instability via a comparison to another frequency standard, was demonstrated. Active fiber noise compensation allows for the obtaining of a fractional frequency instability of at a 1100 s averaging time. The performance of the link under the influence of mechanical perturbations was also tested.

DOI
10.1088/1555-6611/aacfa1

Related papers

Coherent Optical Frequency Transfer via a 490 km Noisy Fiber Link

Xiang Zhang, Xue Deng, Qi Zang +9 more

We demonstrate the coherent transfer of an ultrastable optical frequency reference over a 490 km noisy field fiber link. The fiber-induced phase noise power spectrum density per-unit-length at 1 Hz offset frequency can reach up to 510 rad2⋅Hz−1⋅km−1, which is much higher than the fiber noise observed in previous reports. This extreme level of phase noise is mainly due to the fiber link laying underground along the highway. Appropriate phase-locked loop parameters are chosen to complete the active compensation of fiber noise by measuring the intensity fluctuation of additional phase noise and designing a homemade digital frequency division phase discriminator with a large phase detection range of 212 π rad. Finally, a noise suppression intensity of approximately 40 dB at 1 Hz is obtained, with fractional frequency instability of 1.1 × 10−14 at 1 s averaging time, and 3.7 × 10−19 at 10000 s. The transfer system will be used for remote atomic clock comparisons and optical frequency distribution over a long-distance communication network established in China.

Chinese Physics Letters•Mar 25, 2022•14 citations

Enhanced Phase Noise Reduction in Localized Two-Way Optical Frequency Comparison

Long Wang, Ruimin Xue, Wenhai Jiao +3 more

High-stability optical frequency comparison over fiber link enables the establishment of ultrastable optical clock networks, having the potential to promote a series of applications, including metrology, geodesy, and astronomy. In this article, we theoretically analyze and experimentally demonstrate a time-delayed local two-way (TD-LTW) optical frequency comparison scheme with improved comparison stability, showing that the fractional instability of optical frequency comparison over a 50-km transfer link can be reduced from$1.30\times 10^{-15}$to$5.25\times 10^{-16}$at the 1 s integration time with an improvement factor of 2.48. Additionally, we also for the first time model and experimentally verify the effect of the inhomogeneous phase noise along the fiber link on the system performance. We believe that the theory and technique proposed here will be helpful in developing the high-stability optical clock networks over large-area fiber links.

arXiv:2203.10556•Journal of Lightwave Technology•Mar 15, 2022•5 citations

Phase-coherent comparison of two optical frequency standards over 146 km using a telecommunication fiber link

Osama Terra, Gesine Grosche, Katharina Predehl +5 more

We have explored the performance of two “dark fibers” of a commercial telecommunication fiber link for a remote comparison of optical clocks. The two fibers, linking the Leibniz University of Hanover (LUH) with the Physikalisch-Technische Bundesanstalt (PTB) in Braunschweig, are connected in Hanover to form a total fiber length of 146 km. At PTB the performance of an optical frequency standard operating at 456 THz was imprinted to a cw transfer laser at 194 THz, and its frequency was transmitted over the fiber. In order to detect and compensate phase noise related to the optical fiber link we have built a low-noise optical fiber interferometer and investigated noise sources that affect the overall performance of the optical link. The frequency stability at the remote end has been measured using the clock laser of PTB’s Yb+ frequency standard operating at 344 THz. We show that the frequency of a frequency-stabilized fiber laser can be transmitted over a total fiber length of 146 km with a relative frequency uncertainty below 1×10−19, and short term frequency instability given by the fractional Allan deviation of σ y (τ)=3.3×10−15/(τ/s).

arXiv:0906.3476•Applied Physics B•Jul 29, 2009•61 citations

Optical fiber link for ultra-stable frequency dissemination and atomic clock comparisons

Anne Amy‐Klein, Nicolas Quintin, N. Chiodo +42 more

The transfer of ultra-stable frequencies between distant laboratories is required by many applications from fundamental metrology to high-precision measurements. For that purpose, optical fibre links have been intensively studied over the last decade. They have demonstrated impressive results far beyond the GPS capabilities on distances up to 2000 km, thanks to an active compensation of the fiber propagation noise.Up to now, optical links has been mainly implemented between two labs, when future applications will require the development of metrological fiber networks. Towards this goal, we have developed a few techniques which allow us to distribute the ultrastable optical signal to many users simultaneously. We have designed repeater laser stations, which can be used to build a cascaded link or to distribute the ultrastable signal among two optical links [1]. These stations allow us also to compare the output end signals of two optical links. These versatile stations will be a key-component of the national metrological network currently being developed in France within the Refimeve+ project. To complete the network, we have demonstrated the extraction of the ultrastable signal from a main link and its seeding to a secondary link [2].Optical links are already been successfully used for clocks comparison. Recently we were able to compare the atomic clocks of the French and German National Metrology Institutes through two connected optical links of total length 1415-km [3]. We found that the two fully independent Sr lattice optical clocks at the two sites agreed to better than 5x10-17 limited only by the clocks uncertainties. A fractional statistical uncertainty of 3x10-17 was reached after only 1000 s averaging time, which is 10 times better, and more than four orders of magnitude faster than with any other existing frequency transfer method. The atomic fountain primary frequency standards from the two institutes were also compared and they were found to agree well within their combined uncertainties of a few 10-16 [4].

•Jan 1, 2017•0 citations

Ultra-stable Optical Frequency Transfer via 609 km Communication Fiber Link

Xiang Zhang, Qi Zang, Xue Deng +5 more

SummaryIn this paper, we demonstrated coherent optical frequency transfer via 609 km communication fiber link. The phase noise per-unit-length of this fiber links at 1Hz and 10Hz are 175 rad2/(Hz*km) and 5 rad2/(Hz*km), respectively. After being compensated, optical frequency transfer achieves a fractional frequency instability of 2.7×10−15at an integration time of 1 s and 2.2×10−19at 16000 s in terms of Mod-ADEV.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Apr 24, 2022•0 citations

Novel techniques for optical fiber links beyond current practice

Claudio Eligio Calosso, Elio K. Bertacco, Davide Calonico +7 more

It is well known that temperature variations and acoustic noise affect ultrastable frequency dissemination along optical fiber. Active stabilization techniques are in general adopted to compensate for the fiber-induced phase noise. However, despite this compensation, the ultimate link performances remain limited by the so called delay-unsuppressed fiber noise that is related to the propagation delay of the light in the fiber. In this paper, we demonstrate a data post-processing approach which enables us to overcome this limit. We implement a subtraction algorithm between the optical signal delivered at the remote link end and the round-trip signal. In this way, a 6dB improvement beyond the fundamental limit imposed by delay-unsuppressed noise is obtained. This result enhances the resolution of possible comparisons between remote optical clocks by a factor of 2. We confirm the theoretical prediction with experimental data obtained on a 47km metropolitan fiber link, and propose how to extend this method for frequency dissemination purposes as well.

European Frequency and Time Forum•Jun 1, 2014•2 citations
Abstract The operation of a 2.8 km fiber link at 1.14 µ m for ultrastable optical frequency dissemination, which will allow for the characterization of transportable Yb + based optical clock instability via a comparison to another frequency standard, was demonstrated. Active fiber noise compensation allows for the obtaining of a fractional frequency instability of at a 1100 s averaging time. The performance of the link under the influence of mechanical perturbations was also tested.
We demonstrate the coherent transfer of an ultrastable optical frequency reference over a 490 km noisy field fiber link. The fiber-induced phase noise power spectrum density per-unit-length at 1 Hz offset frequency can reach up to 510 rad2⋅Hz−1⋅km−1, which is much higher than the fiber noise observed in previous reports. This extreme level of phase noise is mainly due to the fiber link laying underground along the highway. Appropriate phase-locked loop parameters are chosen to complete the active compensation of fiber noise by measuring the intensity fluctuation of additional phase noise and designing a homemade digital frequency division phase discriminator with a large phase detection range of 212 π rad. Finally, a noise suppression intensity of approximately 40 dB at 1 Hz is obtained, with fractional frequency instability of 1.1 × 10−14 at 1 s averaging time, and 3.7 × 10−19 at 10000 s. The transfer system will be used for remote atomic clock comparisons and optical frequency distribution over a long-distance communication network established in China.
High-stability optical frequency comparison over fiber link enables the establishment of ultrastable optical clock networks, having the potential to promote a series of applications, including metrology, geodesy, and astronomy. In this article, we theoretically analyze and experimentally demonstrate a time-delayed local two-way (TD-LTW) optical frequency comparison scheme with improved comparison stability, showing that the fractional instability of optical frequency comparison over a 50-km transfer link can be reduced from1.30×10−151.30\times 10^{-15}1.30×10−15to5.25×10−165.25\times 10^{-16}5.25×10−16at the 1 s integration time with an improvement factor of 2.48. Additionally, we also for the first time model and experimentally verify the effect of the inhomogeneous phase noise along the fiber link on the system performance. We believe that the theory and technique proposed here will be helpful in developing the high-stability optical clock networks over large-area fiber links.
We have explored the performance of two “dark fibers” of a commercial telecommunication fiber link for a remote comparison of optical clocks. The two fibers, linking the Leibniz University of Hanover (LUH) with the Physikalisch-Technische Bundesanstalt (PTB) in Braunschweig, are connected in Hanover to form a total fiber length of 146 km. At PTB the performance of an optical frequency standard operating at 456 THz was imprinted to a cw transfer laser at 194 THz, and its frequency was transmitted over the fiber. In order to detect and compensate phase noise related to the optical fiber link we have built a low-noise optical fiber interferometer and investigated noise sources that affect the overall performance of the optical link. The frequency stability at the remote end has been measured using the clock laser of PTB’s Yb+ frequency standard operating at 344 THz. We show that the frequency of a frequency-stabilized fiber laser can be transmitted over a total fiber length of 146 km with a relative frequency uncertainty below 1×10−19, and short term frequency instability given by the fractional Allan deviation of σ y (τ)=3.3×10−15/(τ/s).
The transfer of ultra-stable frequencies between distant laboratories is required by many applications from fundamental metrology to high-precision measurements. For that purpose, optical fibre links have been intensively studied over the last decade. They have demonstrated impressive results far beyond the GPS capabilities on distances up to 2000 km, thanks to an active compensation of the fiber propagation noise.Up to now, optical links has been mainly implemented between two labs, when future applications will require the development of metrological fiber networks. Towards this goal, we have developed a few techniques which allow us to distribute the ultrastable optical signal to many users simultaneously. We have designed repeater laser stations, which can be used to build a cascaded link or to distribute the ultrastable signal among two optical links [1]. These stations allow us also to compare the output end signals of two optical links. These versatile stations will be a key-component of the national metrological network currently being developed in France within the Refimeve+ project. To complete the network, we have demonstrated the extraction of the ultrastable signal from a main link and its seeding to a secondary link [2].Optical links are already been successfully used for clocks comparison. Recently we were able to compare the atomic clocks of the French and German National Metrology Institutes through two connected optical links of total length 1415-km [3]. We found that the two fully independent Sr lattice optical clocks at the two sites agreed to better than 5x10-17 limited only by the clocks uncertainties. A fractional statistical uncertainty of 3x10-17 was reached after only 1000 s averaging time, which is 10 times better, and more than four orders of magnitude faster than with any other existing frequency transfer method. The atomic fountain primary frequency standards from the two institutes were also compared and they were found to agree well within their combined uncertainties of a few 10-16 [4].
It is well known that temperature variations and acoustic noise affect ultrastable frequency dissemination along optical fiber. Active stabilization techniques are in general adopted to compensate for the fiber-induced phase noise. However, despite this compensation, the ultimate link performances remain limited by the so called delay-unsuppressed fiber noise that is related to the propagation delay of the light in the fiber. In this paper, we demonstrate a data post-processing approach which enables us to overcome this limit. We implement a subtraction algorithm between the optical signal delivered at the remote link end and the round-trip signal. In this way, a 6dB improvement beyond the fundamental limit imposed by delay-unsuppressed noise is obtained. This result enhances the resolution of possible comparisons between remote optical clocks by a factor of 2. We confirm the theoretical prediction with experimental data obtained on a 47km metropolitan fiber link, and propose how to extend this method for frequency dissemination purposes as well.