Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

European Frequency and Time Forum

Novel techniques for optical fiber links beyond current practice

Claudio Eligio Calosso, Elio K. Bertacco, Davide Calonico, Cecilia Clivati, Giovanni Antonio Costanzo, Matteo Frittelli, Filippo Levi, Salvatore Micalizio, Alberto Mura, A. Godone

Published Jun 1, 2014• 2 citations
Publisher

Abstract

It is well known that temperature variations and acoustic noise affect ultrastable frequency dissemination along optical fiber. Active stabilization techniques are in general adopted to compensate for the fiber-induced phase noise. However, despite this compensation, the ultimate link performances remain limited by the so called delay-unsuppressed fiber noise that is related to the propagation delay of the light in the fiber. In this paper, we demonstrate a data post-processing approach which enables us to overcome this limit. We implement a subtraction algorithm between the optical signal delivered at the remote link end and the round-trip signal. In this way, a 6dB improvement beyond the fundamental limit imposed by delay-unsuppressed noise is obtained. This result enhances the resolution of possible comparisons between remote optical clocks by a factor of 2. We confirm the theoretical prediction with experimental data obtained on a 47km metropolitan fiber link, and propose how to extend this method for frequency dissemination purposes as well.

DOI
10.1109/eftf.2014.7331413

Related papers

Multi-node optical frequency dissemination with post automatic phase correction

Liang Hu, Xueyang Tian, Guiling Wu +3 more

We report a technique for coherence transfer of laser light through a fiber link, where the optical phase noise induced by environmental perturbations via the fiber link is compensated by remote users with passive phase noise correction, rather than at the local site as is conventional. Neither phase discrimination nor active phase tracking is required due to the open-loop design, mitigating some technical problems such as the limited compensation speed and the finite compensation precision as conventional active phase noise cancellation. We theoretically analyze and experimentally demonstrate that the delay-limited residual fiber phase noise after phase noise compensation is a factor of seven higher than the conventional techniques. Using this technique, we demonstrate the transfer laser light through a 145-km-long, lab-based spooled fiber. After being compensated, a relative frequency instability is 1.9 × 10-15at the integration time of 1 s and scales down to the level of 10-18-range at 10,000 s. The frequency uncertainty of the light after transferring through the fiber relative to that of the input light is (-0.36 ± 2.6) × 10-18. As the transmitted optical signal remains unaltered until it reaches the remote sites, it can be transmitted simultaneously to multiple remote sites on an arbitrarily complex fiber network, paving a way to develop a multi-node optical frequency dissemination system with post automatic phase noise correction for a number of end-users.

arXiv:2001.05712•Journal of Lightwave Technology•Jan 1, 2020•24 citations

Hybrid Fiber-Optic Time-Frequency Transfer for Enhanced Long-Term Frequency Stability

Libo Li, Lina Bai, Kan Zhao +3 more

Coherent Doppler noise cancellation is a cornerstone technique for the high-fidelity dissemination of optical frequency references. However, conventional implementations exhibit an inherent asymmetry by employing offset optical frequencies at the remote end to separate parasitic reflections from the return signal in a round-trip configuration. This asymmetry induces a residual phase error that accumulates with variations in the link propagation delay, fundamentally limiting the long-term frequency stability. We present a hybrid time-frequency transfer scheme that simultaneously disseminates a timing signal to probe the link delay and actively correct this asymmetry-induced error. Experimentally, we validate the method over a 300 km fiber spool subjected to a 7 °C temperature change, inducing a round trip link delay variation of 92.2 ns. With real-time monitoring and active compensation, the optical frequency instability is reduced from 2.1 × 10-19to 1.3 × 10-20at 30000 s averaging—an order-of-magnitude improvement. Simultaneously, the time transfer achieves 1.2 ps stability over the same period. This approach enables simultaneous high-precision time and frequency dissemination over long-haul fiber links with enhanced environmental immunity, establishing a practical pathway toward next-generation phase-stabilized fiber networks.

Journal of Lightwave Technology•Jan 1, 2026•0 citations

Study on a Precise Frequency Comparison System using an Optical Carrier

Masato Wada, Ken-ichi Watabe, Sho Okubo +3 more

We have investigated the performance of an optical carrier transfer system for a remote comparison of optical clocks. In the frequency transfer system, technical problems and fundamental principles limit the coherent transfer on a long-haul optical fiber. They contribute to noise processes that come from the propagation delay in the fiber, the design of an interferometer, burst length fluctuations of the fiber, asymmetrical propagation characteristics, and so on. The feasibility of a full optical link with high stability is discussed. The phase detection with a high degree of precision and cancellation of the fiber-induced noise on the round-trip light are achieved with a well-known standard technique using an all-fiber-based interferometer. We report the characteristics of these noise processes with results on a spooled fiber. An Allan deviation of the compensated link which is extended to 90 km reaches 5 × 10-18 close to the theoretical limit imposed by the delay-unsuppressed fiber noise at averaging time of 103s.

IEEJ Transactions on Electronics Information and Systems•Jan 1, 2014•0 citations

Tackling the limits of optical fiber links

Fabio Stefani, Olivier Lopez, Anthony Bercy +5 more

We theoretically and experimentally investigate relevant noise processes arising in optical fiber links, which fundamentally limit their relative stability. We derive the unsuppressed delay noise for three configurations of optical links: two-way method, Sagnac interferometry, and actively compensated link, respectively designed for frequency comparison, rotation sensing, and frequency transfer. We also consider an alternative two-way setup allowing real-time frequency comparison and demonstrate its effectiveness on a proof-of-principle experiment with a 25 km fiber spool. For these three configurations, we analyze the noise arising from uncommon fiber paths in the interferometric ensemble and design optimized interferometers. We demonstrate interferometers with very low temperature sensitivity of −2.2, −0.03, and 1 fs/K. We use one of these optimized interferometers on a long haul compensated fiber link of 540 km. We obtain a relative frequency stability of 3·10−20 after 10,000 s of integration time.

arXiv:1412.2496•Journal of the Optical Society of America B•Apr 8, 2015•68 citations

High-resolution optical frequency dissemination on a telecommunication network

Anne Amy‐Klein, Olivier Lopez, F. Kéfélian +3 more

We transferred the frequency of an ultrastable laser over a 108-km-long urban fiber link comprising 22 km of an optical communication network fiber simultaneously carrying Internet data traffic. The metrological signal and the digital data signal were transferred over two different frequency channels in a dense wavelength-division multiplexing scheme. The metrological signal was inserted in and extracted from the communication network using bidirectional off-the-shelf optical add-drop multiplexers. The link-induced phase noise was measured and canceled with a round-trip technique using an all-fiber-based interferometer. The compensated link showed an Allan deviation of a few 10−16at one second and below 10−19at 10,000 s This work paves the way to a wide dissemination of ultrastable optical clock signals between distant laboratories via the Internet network.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Apr 1, 2009•3 citations

High-resolution optical frequency dissemination on a telecommunications network with data traffic

F. Kéfélian, Olivier Lopez, Haifeng Jiang +3 more

We transferred the frequency of an ultrastable laser over a 108-km-long urban fiber link comprising 22 km of an optical communications network fiber simultaneously carrying Internet data traffic. The metrological signal and the digital data signal were transferred over two different frequency channels in a dense wavelength-division multiplexing scheme. The metrological signal was inserted in and extracted from the communication network using bidirectional off-the-shelf optical add-drop multiplexers. The link-induced phase noise was measured and canceled with a round-trip technique using an all-fiber-based interferometer. The compensated link showed an Allan deviation of a few 10(-16) at 1 s and below 10(-19) at 10,000 s. This work paves the way to a wide dissemination of ultrastable optical clock signals between distant laboratories via the Internet.

arXiv:0902.2143•Optics Letters•May 11, 2009•58 citations
It is well known that temperature variations and acoustic noise affect ultrastable frequency dissemination along optical fiber. Active stabilization techniques are in general adopted to compensate for the fiber-induced phase noise. However, despite this compensation, the ultimate link performances remain limited by the so called delay-unsuppressed fiber noise that is related to the propagation delay of the light in the fiber. In this paper, we demonstrate a data post-processing approach which enables us to overcome this limit. We implement a subtraction algorithm between the optical signal delivered at the remote link end and the round-trip signal. In this way, a 6dB improvement beyond the fundamental limit imposed by delay-unsuppressed noise is obtained. This result enhances the resolution of possible comparisons between remote optical clocks by a factor of 2. We confirm the theoretical prediction with experimental data obtained on a 47km metropolitan fiber link, and propose how to extend this method for frequency dissemination purposes as well.
We report a technique for coherence transfer of laser light through a fiber link, where the optical phase noise induced by environmental perturbations via the fiber link is compensated by remote users with passive phase noise correction, rather than at the local site as is conventional. Neither phase discrimination nor active phase tracking is required due to the open-loop design, mitigating some technical problems such as the limited compensation speed and the finite compensation precision as conventional active phase noise cancellation. We theoretically analyze and experimentally demonstrate that the delay-limited residual fiber phase noise after phase noise compensation is a factor of seven higher than the conventional techniques. Using this technique, we demonstrate the transfer laser light through a 145-km-long, lab-based spooled fiber. After being compensated, a relative frequency instability is 1.9 × 10-15at the integration time of 1 s and scales down to the level of 10-18-range at 10,000 s. The frequency uncertainty of the light after transferring through the fiber relative to that of the input light is (-0.36 ± 2.6) × 10-18. As the transmitted optical signal remains unaltered until it reaches the remote sites, it can be transmitted simultaneously to multiple remote sites on an arbitrarily complex fiber network, paving a way to develop a multi-node optical frequency dissemination system with post automatic phase noise correction for a number of end-users.
Coherent Doppler noise cancellation is a cornerstone technique for the high-fidelity dissemination of optical frequency references. However, conventional implementations exhibit an inherent asymmetry by employing offset optical frequencies at the remote end to separate parasitic reflections from the return signal in a round-trip configuration. This asymmetry induces a residual phase error that accumulates with variations in the link propagation delay, fundamentally limiting the long-term frequency stability. We present a hybrid time-frequency transfer scheme that simultaneously disseminates a timing signal to probe the link delay and actively correct this asymmetry-induced error. Experimentally, we validate the method over a 300 km fiber spool subjected to a 7 °C temperature change, inducing a round trip link delay variation of 92.2 ns. With real-time monitoring and active compensation, the optical frequency instability is reduced from 2.1 × 10-19to 1.3 × 10-20at 30000 s averaging—an order-of-magnitude improvement. Simultaneously, the time transfer achieves 1.2 ps stability over the same period. This approach enables simultaneous high-precision time and frequency dissemination over long-haul fiber links with enhanced environmental immunity, establishing a practical pathway toward next-generation phase-stabilized fiber networks.
We have investigated the performance of an optical carrier transfer system for a remote comparison of optical clocks. In the frequency transfer system, technical problems and fundamental principles limit the coherent transfer on a long-haul optical fiber. They contribute to noise processes that come from the propagation delay in the fiber, the design of an interferometer, burst length fluctuations of the fiber, asymmetrical propagation characteristics, and so on. The feasibility of a full optical link with high stability is discussed. The phase detection with a high degree of precision and cancellation of the fiber-induced noise on the round-trip light are achieved with a well-known standard technique using an all-fiber-based interferometer. We report the characteristics of these noise processes with results on a spooled fiber. An Allan deviation of the compensated link which is extended to 90 km reaches 5 × 10-18 close to the theoretical limit imposed by the delay-unsuppressed fiber noise at averaging time of 103s.
We theoretically and experimentally investigate relevant noise processes arising in optical fiber links, which fundamentally limit their relative stability. We derive the unsuppressed delay noise for three configurations of optical links: two-way method, Sagnac interferometry, and actively compensated link, respectively designed for frequency comparison, rotation sensing, and frequency transfer. We also consider an alternative two-way setup allowing real-time frequency comparison and demonstrate its effectiveness on a proof-of-principle experiment with a 25 km fiber spool. For these three configurations, we analyze the noise arising from uncommon fiber paths in the interferometric ensemble and design optimized interferometers. We demonstrate interferometers with very low temperature sensitivity of −2.2, −0.03, and 1 fs/K. We use one of these optimized interferometers on a long haul compensated fiber link of 540 km. We obtain a relative frequency stability of 3·10−20 after 10,000 s of integration time.
We transferred the frequency of an ultrastable laser over a 108-km-long urban fiber link comprising 22 km of an optical communication network fiber simultaneously carrying Internet data traffic. The metrological signal and the digital data signal were transferred over two different frequency channels in a dense wavelength-division multiplexing scheme. The metrological signal was inserted in and extracted from the communication network using bidirectional off-the-shelf optical add-drop multiplexers. The link-induced phase noise was measured and canceled with a round-trip technique using an all-fiber-based interferometer. The compensated link showed an Allan deviation of a few 10−16at one second and below 10−19at 10,000 s This work paves the way to a wide dissemination of ultrastable optical clock signals between distant laboratories via the Internet network.
We transferred the frequency of an ultrastable laser over a 108-km-long urban fiber link comprising 22 km of an optical communications network fiber simultaneously carrying Internet data traffic. The metrological signal and the digital data signal were transferred over two different frequency channels in a dense wavelength-division multiplexing scheme. The metrological signal was inserted in and extracted from the communication network using bidirectional off-the-shelf optical add-drop multiplexers. The link-induced phase noise was measured and canceled with a round-trip technique using an all-fiber-based interferometer. The compensated link showed an Allan deviation of a few 10(-16) at 1 s and below 10(-19) at 10,000 s. This work paves the way to a wide dissemination of ultrastable optical clock signals between distant laboratories via the Internet.