Single atoms are a promising candidate for the creation of a scalable quantum computer. Neutral atoms trapped by optical fields are especially encouraging due to the full controllability of the trap potential. Single neutral atoms trapped within a fibre-fibre cavity allow us to strongly couple atoms and photons. This creates an efficient atom-photon interface which can compensate for the short state transfer distance inherent of neutral atoms. A spatial light modulator allows for the creation and manipulation of an array of these single atom traps.\n\nIn this research we create a setup to cool and trap neutral rubidium-87 atoms by a combination of a magneto-optical trap (MOT) and a dipole trap. The dipole trap uses a strongly focused, far red-detuned laser, which enables us to trap single atoms via the collisional blockade regime. These traps are realised within a novel glass cell, allowing for great optical access.\n\nThe MOT in this setup is able to trap (4.27 +/- 0.10) * 10^3 atoms with a density of (7.89 +/- 0.56) * 10^9 atoms cm^-3 . The MOT temperature is in the order of 100 μK. We also show the manipulation of these properties, allowing us to tailor the MOT. The dipole trap is created with a trap waist of 37 μm, allowing us to trap a cloud of atoms. With the dipole trap we achieve a lifetime of atoms of (34.8 +/- 2.0) ms.
Single atoms are a promising candidate for the creation of a scalable quantum computer. Neutral atoms trapped by optical fields are especially encouraging due to the full controllability of the trap potential. Single neutral atoms trapped within a fibre-fibre cavity allow us to strongly couple atoms and photons. This creates an efficient atom-photon interface which can compensate for the short state transfer distance inherent of neutral atoms. A spatial light modulator allows for the creation and manipulation of an array of these single atom traps.\n\nIn this research we create a setup to cool and trap neutral rubidium-87 atoms by a combination of a magneto-optical trap (MOT) and a dipole trap. The dipole trap uses a strongly focused, far red-detuned laser, which enables us to trap single atoms via the collisional blockade regime. These traps are realised within a novel glass cell, allowing for great optical access.\n\nThe MOT in this setup is able to trap (4.27 +/- 0.10) * 10^3 atoms with a density of (7.89 +/- 0.56) * 10^9 atoms cm^-3 . The MOT temperature is in the order of 100 μK. We also show the manipulation of these properties, allowing us to tailor the MOT. The dipole trap is created with a trap waist of 37 μm, allowing us to trap a cloud of atoms. With the dipole trap we achieve a lifetime of atoms of (34.8 +/- 2.0) ms.
Hybrid quantum devices, incorporating both atoms and photons, are able to exploit the benefits of both systems. Compact, robust atom-photon interfaces will enable scalable architectures for quantum computing and quantum communication, as well as chip-scale sensors and single-photon sources. We demonstrate a new type of interface and show the interaction of cold cesium atoms with resonant photons. For this atoms are cooled in a magneto-optical trap, transferred to an optical dipole trap and positioned inside a transverse, 30 µm diameter through-hole in an optical fibre, created via laser micromachining. The intersection is orthogonal to the propagation direction of the light mode. We trap about 300 atoms at a temperature of 120µK. When the guided light is on resonance with the caesium D2 line, up to 87% of it is absorbed by the atoms. Our technique can be applied in 2-dimensional systems, i.e. in optical waveguide chips and other existing photonic systems. We also discuss the influence of hole shapes on transmission and prospects of adding a micro-cavity.
This thesis presents experiments concerning the preparation and manipulation of single neutral atoms in optical traps. The experimental setup as well as the properties of the optical dipole trap are described. The examination and control of all trapping parameters and heating effects is a prerequisite for the future realization of quantum gates. A magneto-optical trap captures and cools down a few cesium atoms. By efficiently detecting their fluorescence, we are able to determine their exact number. They are then transferred without loss into a standing-wave optical dipole trap. The temperature of the atoms in this trap is measured using two methods which are devised to work with small numbers of atoms: By adiabatically lowering the trap depth, an energy-selective loss of atoms is obtained, which yields the energy distribution of the atoms in the trap. Alternatively, the temperature is inferred from the size of the cloud and from the oscillation frequencies of the atoms in the dipole trap. The oscillation frequencies are determined using resonant and parametric excitation. Various intrinsic as well as technical heating mechanisms in the dipole trap are examined experimentally and theoretically. Finally, the setup of a miniature ultra-high finesse optical resonator is presented, which will be used to couple two trapped atoms via the exchange of a photon. The optical resonance frequency of the resonator is successfully stabilized to the atomic transition by an electronic servo loop.
This thesis reports on the design, setup, and operation of a new atom trap apparatus, which is developed to confine few rubidium atoms in ultrahigh vacuum by means of taylored and dynamically variable light potentials (dipole traps), thus making the atoms available for spectroscopy and controlled manipulations. To maintain low background pressure, atoms of a vapour cell are transferred into a cold atomic beam by laser cooling techniques, and accumulated by a magneto-optic trap (MOT) in a separate part of the vacuum system. The laser cooled atoms are then transferred into dipole traps made of focused far-off-resonant laser fields in single or crossed-beam geometry, which are superimposed with the center of the MOT. Gaussian as well as hollow Laguerre-Gaussian (LG01) beam profiles are used with red-detuned and blue-detuned light. Microfabricated dielectric phase objects allow the efficient and robust mode conversion of Gaussian into Laguerre-Gaussian laser beams. Trap geometries can easily be changed due to the highly flexible experimental setup. The dipole trap laser beams have powers up to several hundred milliwatts and are focused to around 10 m. At a detuning of several tens of nanometers from the atomic resonance, the resulting traps are a few millikelvin deep, and the trapped atoms exhibit motional frequencies near 30 kHz, trap light scattering rates of a few hundred photons per second per atom, and storage times of several seconds. The number of dipole-trapped atoms ranges from more than ten thousand to below ten. The dipole-trapped atoms are detected either by a photon counting system with efficient straylight discrimination, or by recapture into the MOT, which is imaged onto a sensitive photodiode and a CCD-camera. Due to the strong AC-Stark shift imposed by the high-intensity trapping light, energy-selective resonant excitation and detection of the stored atoms is possible. The measured energy distribution is consistent with a harmonic potential shape and allows for the determination of temperatures and heating rates. From initial measurements, the thermal energy is found to be about 10 % of the trap depth. Using a crossed-beam geometry with red-detuned laser light, efficient transfer of atoms between the beams is observed. Optimum transfer occurs when the two beams cross at a radial offset, which can qualitatively be understood when the particle energy and geometrical properties of the two-beam trapping potential are considered. Numerical simulations reproduce the general features of the measured transfer efficiency vs. radial beam offset. This experiment is a first step towards dynamically variable potentials. Atoms have been radially confined in a blue-detuned hollow beam, and their decay time has been determined. This configuration is currently extended to a three-dimensionally confining blue-detuned dipole trap. For advanced laser cooling, state manipulation and spectroscopy of trapped atoms, a system of two diode lasers has been set up which are phase-coherently locked with a difference frequency near 6.834 GHz, to drive Raman transitions between the hyperfine-split ground states of 87Rb atoms. Resonances of such a transition have been recorded in a buffer gas loaded rubidium vapour cell with linewidths below 100 Hz.
Constructing a quantum network comprising of matter-based stationary qubits and photonic flying qubits is a key goal towards scalable quantum computing. Individually trapped neutral atoms are amongst the most promising candidates for stationary qubits, while single photons emitted from optical cavities appears to be the best approach to forming flying qubits. This thesis presents a fast and versatile method to trap and transport an array of neutral atoms, with the aid of a spatial light modulator (SLM). We demonstrate trapped 87Rb atoms adapting to the arbitrary and dynamic potential landscapes imposed by the SLM. On top of this we also investigate the inclusion of fibre-tip cavities into the experiment. In these microcavities, the mirrors are replaced by ablated fibre-tip faces, coated in a highly reflective dielectric stack. These have the benefit of small geometries, increasing their scalability; which in turns leads to extremely small mode volumes, allowing for strong coupling with atoms inside the cavity modes. We construct and characterise a high finesse ℱ = 120, 000 fibre-tip cavity constructed from two single mode fibres.
A leading strategy for the creation of a scalable quantum computer is through a networked architecture. This would comprise stationary nodes for quantum information processing and photonic channels for their communication and entanglement distribution. In this scheme a coherent interface between light and matter is a critical component, facilitating the deterministic and reversible transfer of quantum information between stationary and travelling qubits. This requirement may be fulfilled by a high finesse optical cavity, whose radiation field is strongly coupled to a trapped quantised emitter. Neutral atoms are an ideal species for the development of such a device, given their inherent compatibility with dielectric mirror surfaces. However, an outstanding challenge in building an elementary network of neutral atom-cavity systems is in establishing a single atom dipole trap within each cavity mode. This thesis presents the development of an open-access cavity suitable for single atom localisation, whilst maintaining strong atom-cavity coupling, {g0,κ,γ} = {11,2.1,3} × 2πMHz, and the efficient extraction of generated photons, η=0.5. We consider cavity design methodology, deriving a connection between the physical properties of the optical resonator and its intended role in the production of single photons. An experimental platform is developed for the creation of cavity mirrors by laser ablation, with a high degree of geometrical control. This is used to produce a set of pyramidal micro-mirrors, demonstrated to represent a favourable alternative to the widespread adoption of fibre-tip cavities. These pyramidal mirrors are shown to support multi-feature resonators, allowing several atom-cavity interfaces to be formed using a pair of substrates. By developing a novel procedure for mirror alignment, a hybrid mirror cavity is fabricated and integrated into an experimental architecture tailored for atomic trapping. Suitability of the cavity for future experimentation is demonstrated by frequency stabilisation to an atomic resonance of 87Rb.
This thesis focuses on the construction of an atom trapping system utilising a hybrid trap setup to create a Bose-Einstein Condensate. The system involves a three chamber system, consisting of two magneto-optical traps for initial atom trapping and a science chamber to create and observe a BEC. The alkali metal of choice used in this experiment is ⁸⁷Rb, as it possesses favourable properties to create a BEC. A combination of Zeeman modulation frequency stabilisation and polarisation spectroscopy is used to lock our external-cavity diode laser into the right transition frequency and a tiny open-hardware called a Beaglebone is used to remotely access these controls. Beaglebones are also utilised for a double pass configuration of acousto-optic modulators for their convenient remote access which ultimately becomes the primary parameter for troubleshooting the optical part of the experiment. A standard push beam, with a much lower intensity compared to the MOT beams, is pulsed to transport the atoms from the first MOT chamber to the second MOT chamber. By moving the atom cloud to a much lower atmosphere (≈ 10⁻¹¹Torr), we are able to create a bigger atom cloud with a lower temperature which is essential in creating a BEC.