Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Bulletin of the American Physical Society

Multi-Spatial-Mode Noiseless Optical Amplifier

Neil Corzo, Alberto M. Marino, Paul D. Lett

Published Jun 7, 2012• 0 citations
OpenAlex

Related papers

A non-deterministic noiseless optical amplifier

Franck Ferreyrol, Rémi Blandino, Marco Barbieri +3 more

•Aug 22, 2010•0 citations

Using an Optical Parametric Amplifier as a Noiseless Attenuator

R. A. Brewster, J. D. Franson

Bulletin of the American Physical Society•Mar 8, 2018•0 citations

Multi-Spatial-Mode Noiseless Optical Amplifier

Alberto M. Marino, Neil Corzo, K. M. Jones +1 more

We implement a noiseless optical amplifier through a phase-sensitive four-wave mixing process in rubidium vapor and show that it does not significantly degrade the signal-to-noise ratio. Preliminary results show its multi-spatial-mode nature.

Frontiers in Optics•Jan 1, 2011•0 citations

Noiseless Optical Amplifier Operating on Hundreds of Spatial Modes

Neil Corzo, Alberto M. Marino, K. M. Jones +1 more

We implement a noiseless optical amplifier using a phase-sensitive four-wave mixing process in rubidium vapor. We observe performance near the quantum limit for this type of amplifier over a range of experimental parameters and show that the noise figure is always better than would be obtained with a phase-insensitive amplifier with the same gain. Additionally, we observe that the amplifier supports hundreds of spatial modes, making it possible to amplify complex two-dimensional spatial patterns with less than a 10% degradation of the input signal-to-noise ratio for gains up to 4.6. To confirm the multimode character of the amplifier, we study the noise figure as a function of spatially-varying losses. Additionally, we investigate the spatial resolution of the amplifier and show that it supports a range of spatial frequencies from 1.3 to more than 35 line pairs per millimeter.

Physical Review Letters•Jul 26, 2012•96 citations

Optical frequency amplifiers

Christophér C. Davis

Cambridge University Press eBooks•Mar 20, 2014•0 citations

A noiseless amplifier paradox

Scott Roger Shepard

Semiclassically, the signal-spontaneous beat noise in an optical amplifier can be reduced by 3 dB via a filtering technique. This creates a paradox since the noise figure's quantum limit of 3 dB could then be reduced to 0 dB, implying noiseless amplification even though noise is still being introduced by the amplifier. We discuss ways in which this paradox might be resolved and present experimental evidence that dispenses (up to the noise floor of our detectors) with one of these. A semiclassical treatment of the effects of a real (rather than ideal) filter is also presented and suggestions are made for improved (multi-mode) quantum models of this noise.

Journal of Optics B Quantum and Semiclassical Optics•May 24, 2002•1 citation
We implement a noiseless optical amplifier using a phase-sensitive four-wave mixing process in rubidium vapor. We observe performance near the quantum limit for this type of amplifier over a range of experimental parameters and show that the noise figure is always better than would be obtained with a phase-insensitive amplifier with the same gain. Additionally, we observe that the amplifier supports hundreds of spatial modes, making it possible to amplify complex two-dimensional spatial patterns with less than a 10% degradation of the input signal-to-noise ratio for gains up to 4.6. To confirm the multimode character of the amplifier, we study the noise figure as a function of spatially-varying losses. Additionally, we investigate the spatial resolution of the amplifier and show that it supports a range of spatial frequencies from 1.3 to more than 35 line pairs per millimeter.
Semiclassically, the signal-spontaneous beat noise in an optical amplifier can be reduced by 3 dB via a filtering technique. This creates a paradox since the noise figure's quantum limit of 3 dB could then be reduced to 0 dB, implying noiseless amplification even though noise is still being introduced by the amplifier. We discuss ways in which this paradox might be resolved and present experimental evidence that dispenses (up to the noise floor of our detectors) with one of these. A semiclassical treatment of the effects of a real (rather than ideal) filter is also presented and suggestions are made for improved (multi-mode) quantum models of this noise.