Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review Letters

Noiseless Optical Amplifier Operating on Hundreds of Spatial Modes

Neil Corzo, Alberto M. Marino, K. M. Jones, Paul D. Lett

Published Jul 26, 2012• 96 citations
Publisher

Abstract

We implement a noiseless optical amplifier using a phase-sensitive four-wave mixing process in rubidium vapor. We observe performance near the quantum limit for this type of amplifier over a range of experimental parameters and show that the noise figure is always better than would be obtained with a phase-insensitive amplifier with the same gain. Additionally, we observe that the amplifier supports hundreds of spatial modes, making it possible to amplify complex two-dimensional spatial patterns with less than a 10% degradation of the input signal-to-noise ratio for gains up to 4.6. To confirm the multimode character of the amplifier, we study the noise figure as a function of spatially-varying losses. Additionally, we investigate the spatial resolution of the amplifier and show that it supports a range of spatial frequencies from 1.3 to more than 35 line pairs per millimeter.

DOI
10.1103/physrevlett.109.043602

Related papers

Multi-Spatial-Mode Noiseless Optical Amplifier

Alberto M. Marino, Neil Corzo, K. M. Jones +1 more

We implement a noiseless optical amplifier through a phase-sensitive four-wave mixing process in rubidium vapor and show that it does not significantly degrade the signal-to-noise ratio. Preliminary results show its multi-spatial-mode nature.

Frontiers in Optics•Jan 1, 2011•0 citations

Phase-sensitive amplification via multi-phase-matched four-wave mixing

Erin M. Knutson, J. Sam Cross, Sara K. Wyllie +1 more

Phase-sensitive nonlinear gain processes have been implemented as noise-reduced optical amplifiers, which have the potential to achieve signal-to-noise ratios beyond the classical limit. We experimentally demonstrate a novel phase-sensitive four-wave mixing amplification process in a single atomic vapor cell with only two input frequencies and two input vacuum modes. The amount of phase sensitivity depends on the power ratio between the inserted probes as well as on the input frequency of the probes. We find that, for certain phase values, the intensity noise of an output mode is lower than that of its phase-insensitive counterpart.

Optics Express•Jun 24, 2020•6 citations

Observation of Noiseless Image Amplification by an Optical Parametric Amplifier

Sang-Kyung Choi, Michael Vasilyev, Prem Kumar

A spatially-broadband optical parametric amplifier is used for image amplification. In the phase-sensitive configuration, we observe a noise figure of −0.1± 0.3dB for a gain of 2.4, which is 2dB lower than the quantum limit for an ideal phase-insensitive amplifier. Image pre-amplification before loss is shown to improve the detected signal-to-noise ratio.

Kluwer Academic Publishers eBooks•Dec 19, 2005•1 citation

Low-Noise Amplification of a Continuous-Variable Quantum State

Raphael C. Pooser, Alberto M. Marino, Vincent Boyer +2 more

We present an experimental realization of a low-noise, phase-insensitive optical amplifier using a four-wave mixing interaction in hot Rb vapor. Performance near the quantum limit for a range of amplifier gains, including near unity, can be achieved. Such low-noise amplifiers are essential for so-called quantum cloning machines and are useful in quantum information protocols. We demonstrate that amplification and "cloning" of one half of a two-mode squeezed state is possible while preserving entanglement.

Physical Review Letters•Jun 29, 2009•132 citations

Noiseless Amplification of Images by Four-Wave Mixing

Paul D. Lett, Neil Corzo, Alberto M. Marino +1 more

We have constructed a phase sensitive optical amplifier based on four-wave-mixing in rubidium vapor. This low-gain amplifier operates in the quantum regime and is capable of noiseless amplification of images.

Nonlinear Optics•Jan 1, 2013•0 citations

Noiseless Optical Amplification of Images

Sang-Kyung Choi, Michael Vasilyev, Prem Kumar

We used a spatially broadband optical parametric amplifier for image amplification. In the phase-sensitive configuration of the amplifier, we observed noiseless amplification of input images. For a gain of $\ensuremath{\simeq}2.5$, we measured noise-figure values of ( $0.2\ifmmode\pm\else\textpm\fi{}0.6$) and ( $0.4\ifmmode\pm\else\textpm\fi{}0.5$) dB, respectively, for two amplifiers of different lengths. These experimental values agree with theory (for an ideal noiseless amplifier the noise figure is 0 dB) and are almost 2 dB lower than the quantum limit of an ideal phase-insensitive amplifier.

Physical Review Letters•Sep 6, 1999•135 citations
We implement a noiseless optical amplifier using a phase-sensitive four-wave mixing process in rubidium vapor. We observe performance near the quantum limit for this type of amplifier over a range of experimental parameters and show that the noise figure is always better than would be obtained with a phase-insensitive amplifier with the same gain. Additionally, we observe that the amplifier supports hundreds of spatial modes, making it possible to amplify complex two-dimensional spatial patterns with less than a 10% degradation of the input signal-to-noise ratio for gains up to 4.6. To confirm the multimode character of the amplifier, we study the noise figure as a function of spatially-varying losses. Additionally, we investigate the spatial resolution of the amplifier and show that it supports a range of spatial frequencies from 1.3 to more than 35 line pairs per millimeter.
Phase-sensitive nonlinear gain processes have been implemented as noise-reduced optical amplifiers, which have the potential to achieve signal-to-noise ratios beyond the classical limit. We experimentally demonstrate a novel phase-sensitive four-wave mixing amplification process in a single atomic vapor cell with only two input frequencies and two input vacuum modes. The amount of phase sensitivity depends on the power ratio between the inserted probes as well as on the input frequency of the probes. We find that, for certain phase values, the intensity noise of an output mode is lower than that of its phase-insensitive counterpart.
We present an experimental realization of a low-noise, phase-insensitive optical amplifier using a four-wave mixing interaction in hot Rb vapor. Performance near the quantum limit for a range of amplifier gains, including near unity, can be achieved. Such low-noise amplifiers are essential for so-called quantum cloning machines and are useful in quantum information protocols. We demonstrate that amplification and "cloning" of one half of a two-mode squeezed state is possible while preserving entanglement.
We used a spatially broadband optical parametric amplifier for image amplification. In the phase-sensitive configuration of the amplifier, we observed noiseless amplification of input images. For a gain of $\ensuremath{\simeq}2.5$, we measured noise-figure values of ( $0.2\ifmmode\pm\else\textpm\fi{}0.6$) and ( $0.4\ifmmode\pm\else\textpm\fi{}0.5$) dB, respectively, for two amplifiers of different lengths. These experimental values agree with theory (for an ideal noiseless amplifier the noise figure is 0 dB) and are almost 2 dB lower than the quantum limit of an ideal phase-insensitive amplifier.