Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Bulletin of the American Physical Society

Flexible Low-power SiGe HBT Amplifier Circuits for Fast Single-shot Spin Readout

Troy D. England, Michael P Lilly, Matthew Curry, Stephen M Carr, Malcolm S. Carroll

Published Mar 16, 2016• 1 citation
OpenAlex

Abstract

SAND2016-1807C  We want fast, high-fidelity, single-shot spin readout  Stand-alone SETs' SNR is too low at wide bandwidths  RF SETs require complex systems and extensive tuning  We continue to investigate cryogenic pre-amplification  Predictable, linear gain with low experiment overhead  Discrete COTS SiGe heterojunction bipolar transistors  New amplifier provides power-efficient, reliable gain Fast Single Shot Spin Readout Why Not HEMTs?Consistency  Variation in current versus input voltage  HBT ≈ 5 mV  HEMT ≈ 100 mV  This is an indicator for offsets in TIAs, ADCs, and DACs Why Not HEMTs?Output Current  Good design relies on constant current across output voltage  Flat lines are the goal  This is an indicator for maximum gain available in amplifiers  Unplotted: low frequency noise

Related papers

Single-Shot Readout Performance of Two Heterojunction-Bipolar-Transistor Amplification Circuits at Millikelvin Temperatures

Matthew Curry, M. Rudolph, Troy D. England +12 more

Abstract High-fidelity single-shot readout of spin qubits requires distinguishing states much faster than the T 1 time of the spin state. One approach to improving readout fidelity and bandwidth (BW) is cryogenic amplification, where the signal from the qubit is amplified before noise sources are introduced and room-temperature amplifiers can operate at lower gain and higher BW. We compare the performance of two cryogenic amplification circuits: a current-biased heterojunction bipolar transistor circuit (CB-HBT), and an AC-coupled HBT circuit (AC-HBT). Both circuits are mounted on the mixing-chamber stage of a dilution refrigerator and are connected to silicon metal oxide semiconductor (Si-MOS) quantum dot devices on a printed circuit board (PCB). The power dissipated by the CB-HBT ranges from 0.1 to 1 μ W whereas the power of the AC-HBT ranges from 1 to 20 μ W. Referred to the input, the noise spectral density is low for both circuits, in the 15 to 30 fA/ $$\sqrt{{\bf{Hz}}}$$ Hz range. The charge sensitivity for the CB-HBT and AC-HBT is 330 μ e/ $$\sqrt{{\bf{Hz}}}$$ Hz and 400 μ e/ $$\sqrt{{\bf{Hz}}}$$ Hz , respectively. For the single-shot readout performed, less than 10 μ s is required for both circuits to achieve bit error rates below 10 −3 , which is a putative threshold for quantum error correction.

arXiv:1901.04570•Scientific Reports•Nov 18, 2019•31 citations

Current-Biased SET-HBT Cryogenic Preamplifier for High-Fidelity Single-Shot Spin Readout

Matthew Curry, Andrew M. Mounce, Troy D. England +5 more

Bulletin of the American Physical Society•Mar 7, 2018•0 citations

Single-Shot Readout of a S/T Qubit with a Cryogenic AC-Coupled Amplifier in a Lithographic MOS Double Quantum Dot.

Rudolph, Martin; Mounce, Andrew; England, Troy Daniel; Jock, Ryan Michael; Sharma, Peter Anand; Jacobson, Noah Tobias; Ward, Daniel Robert; Pluym, Tammy; Silva, Beverly L.; Anderson, John Moses; Wendt, Joel R.; Lilly, Michael; Carroll, Malcolm S.

Tunable tunnel coupling s AC-coupled single stage SiGe HBT amplification s Readout

•Jul 14, 2021•0 citations

Improving the Readout of Semiconducting Qubits

Matthew Curry

Semiconducting qubits are a promising platform for quantum computers. In particular, silicon spin qubits have made a number of advancements recently including long coherence times, high-fidelity single-qubit gates, two-qubit gates, and high-fidelity readout. However, all operations likely require improvement in fidelity and speed, if possible, to realize a quantum computer. Readout fidelity and speed, in general, are limited by circuit challenges centered on extracting low signal from a device in a dilution refrigerator connected to room temperature amplifiers by long coaxial cables with relatively high capacitance. Readout fidelity specifically is limited by the time it takes to reliably distinguish qubit states relative to the characteristic decay time of the excited state, T1. This dissertation explores the use of heterojunction bipolar transistor (HBT) circuits to amplify the readout signal of silicon spin qubits at cryogenic temperatures. The cryogenic amplification approach has numerous advantages including low implementation overhead, low power relative to the available cooling power, and high signal gain at the mixing chamber stage leading to around a factor of ten speedup in readout time for a similar signal-to-noise ratio. The faster readout time generally increases fidelity, since it is much faster than the T1 time. Two HBT amplification circuits have been designed and characterized. One design is a low-power, base-current biased configuration with non-linear gain (CB-HBT), and the second is a linear-gain, AC-coupled configuration (AC-HBT). They can operate at powers of 1 and 10 μW, respectfully, and not significantly heat electrons. The noise spectral density referred to the input for both circuits is around 15 to 30 fA/√Hz, which is low compared to previous cases such as the dual-stage, AC-coupled HEMT circuit at ~ 70 fA/√Hz. Both circuits achieve charge sensitivity between 300 and 400 μe/√Hz, which approaches the best alternatives (e.g., RF-SET at ~ 140 μe/√Hz) but with much less implementation overhead. For the single-shot latched charge readout performed, both circuits achieve high-fidelity readout in times < 10 μs with bit error rates < 10-3, which is a great improvement over previous work at > 70 μs. The readout speed-up in principle also reduces the production of errors due to excited state relaxation by a factor of ~ 10. All of these results are possible with relatively simple, low-power transistor circuits which can be mounted close to the qubit device at the mixing chamber stage of the dilution refrigerator.

•Jan 1, 2019•0 citations

Cryogenic preamplification of a single-electron-transistor using a silicon-germanium heterojunction-bipolar-transistor

Matthew Curry, Troy D. England, N. C. Bishop +6 more

We examine a silicon-germanium heterojunction bipolar transistor (HBT) for cryogenic pre-amplification of a single electron transistor (SET). The SET current modulates the base current of the HBT directly. The HBT-SET circuit is immersed in liquid helium, and its frequency response from low frequency to several MHz is measured. The current gain and the noise spectrum with the HBT result in a signal-to-noise-ratio (SNR) that is a factor of 10–100 larger than without the HBT at lower frequencies. The transition frequency defined by SNR = 1 has been extended by as much as a factor of 10 compared to without the HBT amplification. The power dissipated by the HBT cryogenic pre-amplifier is approximately 5 nW to 5 μW for the investigated range of operation. The circuit is also operated in a single electron charge read-out configuration in the time-domain as a proof-of-principle demonstration of the amplification approach for single spin read-out.

arXiv:1509.08201•Applied Physics Letters•May 18, 2015•39 citations

SiGe HBT cryogenic preamplification for higher bandwidth donor spin read-out

Matthew Curry, Stephen M Carr, Greg Ten-Eyck +4 more

Bulletin of the American Physical Society•Mar 6, 2014•0 citations
SAND2016-1807C  We want fast, high-fidelity, single-shot spin readout  Stand-alone SETs' SNR is too low at wide bandwidths  RF SETs require complex systems and extensive tuning  We continue to investigate cryogenic pre-amplification  Predictable, linear gain with low experiment overhead  Discrete COTS SiGe heterojunction bipolar transistors  New amplifier provides power-efficient, reliable gain Fast Single Shot Spin Readout Why Not HEMTs?Consistency  Variation in current versus input voltage  HBT ≈ 5 mV  HEMT ≈ 100 mV  This is an indicator for offsets in TIAs, ADCs, and DACs Why Not HEMTs?Output Current  Good design relies on constant current across output voltage  Flat lines are the goal  This is an indicator for maximum gain available in amplifiers  Unplotted: low frequency noise
Abstract High-fidelity single-shot readout of spin qubits requires distinguishing states much faster than the T 1 time of the spin state. One approach to improving readout fidelity and bandwidth (BW) is cryogenic amplification, where the signal from the qubit is amplified before noise sources are introduced and room-temperature amplifiers can operate at lower gain and higher BW. We compare the performance of two cryogenic amplification circuits: a current-biased heterojunction bipolar transistor circuit (CB-HBT), and an AC-coupled HBT circuit (AC-HBT). Both circuits are mounted on the mixing-chamber stage of a dilution refrigerator and are connected to silicon metal oxide semiconductor (Si-MOS) quantum dot devices on a printed circuit board (PCB). The power dissipated by the CB-HBT ranges from 0.1 to 1 μ W whereas the power of the AC-HBT ranges from 1 to 20 μ W. Referred to the input, the noise spectral density is low for both circuits, in the 15 to 30 fA/ Hz\sqrt{{\bf{Hz}}}Hz​ Hz range. The charge sensitivity for the CB-HBT and AC-HBT is 330 μ e/ Hz\sqrt{{\bf{Hz}}}Hz​ Hz and 400 μ e/ Hz\sqrt{{\bf{Hz}}}Hz​ Hz , respectively. For the single-shot readout performed, less than 10 μ s is required for both circuits to achieve bit error rates below 10 −3 , which is a putative threshold for quantum error correction.
Semiconducting qubits are a promising platform for quantum computers. In particular, silicon spin qubits have made a number of advancements recently including long coherence times, high-fidelity single-qubit gates, two-qubit gates, and high-fidelity readout. However, all operations likely require improvement in fidelity and speed, if possible, to realize a quantum computer. Readout fidelity and speed, in general, are limited by circuit challenges centered on extracting low signal from a device in a dilution refrigerator connected to room temperature amplifiers by long coaxial cables with relatively high capacitance. Readout fidelity specifically is limited by the time it takes to reliably distinguish qubit states relative to the characteristic decay time of the excited state, T1. This dissertation explores the use of heterojunction bipolar transistor (HBT) circuits to amplify the readout signal of silicon spin qubits at cryogenic temperatures. The cryogenic amplification approach has numerous advantages including low implementation overhead, low power relative to the available cooling power, and high signal gain at the mixing chamber stage leading to around a factor of ten speedup in readout time for a similar signal-to-noise ratio. The faster readout time generally increases fidelity, since it is much faster than the T1 time. Two HBT amplification circuits have been designed and characterized. One design is a low-power, base-current biased configuration with non-linear gain (CB-HBT), and the second is a linear-gain, AC-coupled configuration (AC-HBT). They can operate at powers of 1 and 10 μW, respectfully, and not significantly heat electrons. The noise spectral density referred to the input for both circuits is around 15 to 30 fA/√Hz, which is low compared to previous cases such as the dual-stage, AC-coupled HEMT circuit at ~ 70 fA/√Hz. Both circuits achieve charge sensitivity between 300 and 400 μe/√Hz, which approaches the best alternatives (e.g., RF-SET at ~ 140 μe/√Hz) but with much less implementation overhead. For the single-shot latched charge readout performed, both circuits achieve high-fidelity readout in times < 10 μs with bit error rates < 10-3, which is a great improvement over previous work at > 70 μs. The readout speed-up in principle also reduces the production of errors due to excited state relaxation by a factor of ~ 10. All of these results are possible with relatively simple, low-power transistor circuits which can be mounted close to the qubit device at the mixing chamber stage of the dilution refrigerator.
We examine a silicon-germanium heterojunction bipolar transistor (HBT) for cryogenic pre-amplification of a single electron transistor (SET). The SET current modulates the base current of the HBT directly. The HBT-SET circuit is immersed in liquid helium, and its frequency response from low frequency to several MHz is measured. The current gain and the noise spectrum with the HBT result in a signal-to-noise-ratio (SNR) that is a factor of 10–100 larger than without the HBT at lower frequencies. The transition frequency defined by SNR = 1 has been extended by as much as a factor of 10 compared to without the HBT amplification. The power dissipated by the HBT cryogenic pre-amplifier is approximately 5 nW to 5 μW for the investigated range of operation. The circuit is also operated in a single electron charge read-out configuration in the time-domain as a proof-of-principle demonstration of the amplification approach for single spin read-out.