Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Low Temperature Physics

Determination of the Parameters of High-T C RF SQUID from Its Small Signal Voltage-Frequency Characteristics

Ya. S. Greenberg

Published Feb 1, 1999• 9 citations
Publisher
DOI
10.1023/a:1022528300952

Related papers

Self-consistent theory of a voltage-current characteristic and of intrinsic noise of hysteretic RF SQUID

Ya. S. Greenberg

Journal of Low Temperature Physics•Sep 1, 1993•2 citations

RF-SQUID CHARACTERISTICS IN A HIGH-FREQUENCY LIMIT

Oleg V. Snigirev

•Jan 1, 1981•0 citations

Detection of Far-Field Radio-Frequency Signals by Niobium Superconducting Quantum Interference Device Arrays

Marcio C. de Andrade, Anna Leese de Escobar, B. J. Taylor +7 more

The capability of an all-niobium superconducting quantum interference device (SQUID) array to operate as an electrically small antenna capable of detecting radio frequency from distant sources was demonstrated. The measurements were performed in three different arrays, with each array consisting of 2400 identical cells. The intrinsic broadband characteristics of the device were confirmed by the flat frequency response of the ratio of the output and input voltages (the S21 parameter) of the array between 300 kHz and 1 GHz. Setting the device to its optimal operating parameters allowed the detection of signals from local frequency-modulation stations.

IEEE Transactions on Applied Superconductivity•Aug 31, 2015•32 citations

Self-Consistent Theory of the Voltage-Current Characteristic and Intrinsic Noise of the Hysteretic RF-SQUID

Ya. S. Greenberg

Springer proceedings in physics•Jan 1, 1992•0 citations

SIGNAL AND NOISE CHARACTERISTICS OF RF-SQUIDS

V. I. Shnyrkov, Georgy M. Tsoi

WORLD SCIENTIFIC eBooks•Jun 1, 1992•6 citations

Design and implementation of A 06 GHz - 09 GHz RF-SQUID Read-out system and investigation of rf-SQUID signal characteristics

Taylan Eker

Design and implementation of a transceiver system for rf-SQUID (Superconducting Quantum Interference Device) operation is investigated in this work. Besides, experiments to characterize the rf-SQUID have been performed using the implemented system. The steps in system design and implementation are presented. The difficulties and drawbacks of the system are reported and alternative techniques required to overcome these problems are determined. Also, for the operation of the rf-SQUID at much higher frequencies, different transceiver architecture is proposed and possible drawbacks are stated. Using implemented system, several experiments were performed on two high Tc rfSQUID gradiometers with a tank-circuit resonating at 720 MHz. In these experiments, the frequency and amplitude of the applied rf signal were swept and output flux to voltage transfer signal (modulation added by rf-SQUID), Vspp, and incoming rf signal spectrum are reported and analyzed.

•Jan 1, 2005•0 citations
The capability of an all-niobium superconducting quantum interference device (SQUID) array to operate as an electrically small antenna capable of detecting radio frequency from distant sources was demonstrated. The measurements were performed in three different arrays, with each array consisting of 2400 identical cells. The intrinsic broadband characteristics of the device were confirmed by the flat frequency response of the ratio of the output and input voltages (the S21 parameter) of the array between 300 kHz and 1 GHz. Setting the device to its optimal operating parameters allowed the detection of signals from local frequency-modulation stations.
Design and implementation of a transceiver system for rf-SQUID (Superconducting Quantum Interference Device) operation is investigated in this work. Besides, experiments to characterize the rf-SQUID have been performed using the implemented system. The steps in system design and implementation are presented. The difficulties and drawbacks of the system are reported and alternative techniques required to overcome these problems are determined. Also, for the operation of the rf-SQUID at much higher frequencies, different transceiver architecture is proposed and possible drawbacks are stated. Using implemented system, several experiments were performed on two high Tc rfSQUID gradiometers with a tank-circuit resonating at 720 MHz. In these experiments, the frequency and amplitude of the applied rf signal were swept and output flux to voltage transfer signal (modulation added by rf-SQUID), Vspp, and incoming rf signal spectrum are reported and analyzed.