Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Optics

THE POPULATION INVERSION CONDITION OF A SATURABLE ABSORBER Q SWITCH

Da Peng Gao

Published Jan 1, 1999• 0 citations
OpenAlex

Abstract

In this paper we start from the rate equations describing a Q switched laser system with a saturable absorber and finally deduce the condition of this kind of Q switching which should be satisfied by the laser crystal population inversion. We also give a discussion and analyse it. Using this condition, some experiment phenomena can be successfully explained.

Related papers

ANALYTICAL MODEL FOR OPTICAL BISTABILITY IN LASER WITH SATURABLE ABSORBER

Smail Djabi, H. Boudoukha, Saïd Meguellati

In this paper, we develop a theoretical model that accurately describes the nonlinear phenomenon of optical bistability in Fabry-Perot laser containing a saturable absorber "LSA". We present an analytical model for optical bistability in a LSA. The physics of optical bistability in a classical optical resonant system such as Fabry-Perot etalon has been well-established, and can be described by simple analytical models. The photon intensities were determined as a function of the pumping rate of the active medium, and we analyzed the linear stability of the stationary solutions obtained.

Journal of Nonlinear Optical Physics & Materials•Sep 1, 2011•1 citation

Gas Laser with Saturable Absorber. I. Single-Mode Characteristics

Rainer Salomaa, Stig Stenholm

This paper discusses the case of a Doppler-broadened gas laser with a saturable intracavity absorber gas. The semiclassical equations governing the field intensities and the atomic density-matrix elements are set up. The latter are written as Fourier series, the components of which are shown to obey coupled difference equations. In this paper the exact steady-state solution in single-mode operation is obtained. The lowest approximation (rate-equation approximation) is used to compute detailed characteristics of the system. In particular, the influence of the pumping rates in the two cells are investigated and displayed in the figures. The regions of bistable operation are determined and conditions for the occurrence of an inverted Lamb dip are given. The effect of a slow modulation of the pumping rates is discussed. The range of validity of the lowest approximation is investigated both analytically and numerically. Finally, there is a brief discussion of the influence of pressure on the parameters of the theory.

Physical Review A•Nov 1, 1973•67 citations

Population Inversion, Saturation, and Laser Systems

Surendra Singh

This chapter begins with a heuristic derivation of atomic population rate equations which include changes to level populations due to stimulated transitions as well as level relaxations and pump. These equations are used to study the saturation of population inversion with increasing light intensity and its dependence on the type of gain medium (three-level gain media vs. four-level gain media), lineshape and nature of line broadening (homogeneous vs inhomogeneous broadening). How saturation affects lineshape and thus gain and absorption giving rise to phenomena like power broadening and spectral hole burning is also discussed. The chapter summarizes the equations of motion for atomic polarization, inversion and the cavity field describing their nonlinear dynamical coupling. These equations, known as the Maxwell-Bloch equations, provide a complete description of atom-field interaction in a laser. Approximations of these equations, including the rate equation approximation, to deal with different laser classes are briefly described. These will be used in the next few chapters to explore and understand the rich and varied behavior of lasers. The chapter ends with a summary of select gain media for different types of commonly used lasers.

CRC Press eBooks•Sep 23, 2026•0 citations

Dynamic behavior of bistability in a laser with a saturable absorber

E. Arimondo, Didier Dangoisse, C. Gabbanini +2 more

Optical bistability in a CO2 infrared laser containing SF6 as a saturable intracavity absorber has been studied under dynamic conditions as a function of a time-dependent laser control parameter. The width of the optical bistability region, the fluctuations in the bistability switching values, and the dependence on the initial conditions have been investigated in this transient optical bistability. A numerical solution of the laser rate equations provides a good interpretation of the experimental results, but some experimental observations cannot be completely explained.

Journal of the Optical Society of America B•Jun 1, 1987•32 citations

Spectroscopic Effects of Stimulated Emission Under Fast Pumping Conditions

Michael L. Kliewer, A. Suchocki, Richard C. Powell

Solutions of the rate equations for a two-level system describing spectral properties in the presence of stimulated emission under picosecond-pulse pumping conditions are examined. The materials of interest are broad band tunable, vibronic laser crystals whose lasing properties under normal pumping conditions have been related to spectral properties through the McCumber theory1. The population inversion at threshold can then be determined by three methods: lifetime shortening, band narrowing, and peak gain measurements.

Advanced Solid-State Lasers•Jan 1, 1987•0 citations

LIGHT AMPLIFICATION IN SATURABLE ABSORBERS

M. Mack

It has been found that an absorber driven into saturation by a strong light pulse can amplify a weak light pulse simultaneously incident upon the medium. Gains as high as 20 cm−1 have been observed. This effect is believed to be related to the ability of a saturable absorber to bring about mode locking in a laser cavity.

Applied Physics Letters•May 15, 1968•16 citations
In this paper we start from the rate equations describing a Q switched laser system with a saturable absorber and finally deduce the condition of this kind of Q switching which should be satisfied by the laser crystal population inversion. We also give a discussion and analyse it. Using this condition, some experiment phenomena can be successfully explained.
In this paper, we develop a theoretical model that accurately describes the nonlinear phenomenon of optical bistability in Fabry-Perot laser containing a saturable absorber "LSA". We present an analytical model for optical bistability in a LSA. The physics of optical bistability in a classical optical resonant system such as Fabry-Perot etalon has been well-established, and can be described by simple analytical models. The photon intensities were determined as a function of the pumping rate of the active medium, and we analyzed the linear stability of the stationary solutions obtained.
This paper discusses the case of a Doppler-broadened gas laser with a saturable intracavity absorber gas. The semiclassical equations governing the field intensities and the atomic density-matrix elements are set up. The latter are written as Fourier series, the components of which are shown to obey coupled difference equations. In this paper the exact steady-state solution in single-mode operation is obtained. The lowest approximation (rate-equation approximation) is used to compute detailed characteristics of the system. In particular, the influence of the pumping rates in the two cells are investigated and displayed in the figures. The regions of bistable operation are determined and conditions for the occurrence of an inverted Lamb dip are given. The effect of a slow modulation of the pumping rates is discussed. The range of validity of the lowest approximation is investigated both analytically and numerically. Finally, there is a brief discussion of the influence of pressure on the parameters of the theory.
This chapter begins with a heuristic derivation of atomic population rate equations which include changes to level populations due to stimulated transitions as well as level relaxations and pump. These equations are used to study the saturation of population inversion with increasing light intensity and its dependence on the type of gain medium (three-level gain media vs. four-level gain media), lineshape and nature of line broadening (homogeneous vs inhomogeneous broadening). How saturation affects lineshape and thus gain and absorption giving rise to phenomena like power broadening and spectral hole burning is also discussed. The chapter summarizes the equations of motion for atomic polarization, inversion and the cavity field describing their nonlinear dynamical coupling. These equations, known as the Maxwell-Bloch equations, provide a complete description of atom-field interaction in a laser. Approximations of these equations, including the rate equation approximation, to deal with different laser classes are briefly described. These will be used in the next few chapters to explore and understand the rich and varied behavior of lasers. The chapter ends with a summary of select gain media for different types of commonly used lasers.
Optical bistability in a CO2 infrared laser containing SF6 as a saturable intracavity absorber has been studied under dynamic conditions as a function of a time-dependent laser control parameter. The width of the optical bistability region, the fluctuations in the bistability switching values, and the dependence on the initial conditions have been investigated in this transient optical bistability. A numerical solution of the laser rate equations provides a good interpretation of the experimental results, but some experimental observations cannot be completely explained.
Solutions of the rate equations for a two-level system describing spectral properties in the presence of stimulated emission under picosecond-pulse pumping conditions are examined. The materials of interest are broad band tunable, vibronic laser crystals whose lasing properties under normal pumping conditions have been related to spectral properties through the McCumber theory1. The population inversion at threshold can then be determined by three methods: lifetime shortening, band narrowing, and peak gain measurements.