Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)

Progress of Active Optical Frequency Standard based on thermal Ca atomic beam

Wei Zhuang, Jingbiao Chen

Published Jun 1, 2010• 7 citations
Publisher

Abstract

The experiment system for Active Optical Frequency Standard(AOFS) based on thermal Ca atomic beam has been set up. Making use of magnetic field for the atomic beam, we have realized population inversion between ground state1S0and metastable state3P1(m=0) which is primary for AOFS. Detection results are presented by applying electron-shelving technique on thermal Ca atomic beam.

DOI
10.1109/freq.2010.5556340

Related papers

Proposed Active Optical Frequency Standards based on Magneto-optical Trap Trapped Atoms

Wei Zhuang, Deshui Yu, Zhenhui Chen +2 more

A new conception of optical frequency standards, active optical frequency standards (AOFS) is under developing. In this report, we propose a novel scheme for active optical frequency standards based on magneto-optical trap (MOT) trapped atoms. With the advantages of 4-level atomic system proposed here, this scheme overcomes the main limitations on the accuracy of active optical clock based on atomic beam due to Doppler effect.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2007•9 citations

Dispersion detection of optical clock transition in thermal atomic beam

Xiaogang Zhang, Xiaobo Xue, Duo Pan +3 more

In order to develop small optical clock for various transportable applications with better stability and accuracy than that of commercial small Cs clock and H-maser clock, our group has proposed a small Ca atomic beam clock scheme with electron-shelving detection. Its potential stability was experimentally demonstrated recently. Here, we first demonstrated the dispersive detection of 657 nm transition via the Faraday rotation effect of 423 nm transition based on a thermal Ca atomic beam, this alternative detection method can effectively detect the clock signal by the ground state atoms after the clock laser interrogation. The Faraday anomalous dispersion optical filter of 423 nm transition can reach a maximum transmission of 10%. With a magnetic field of 84 G, the observed 3.3% of the ground state atoms has been excited to the σ±level of metastable3P1(m=±1) state, which are separated 176.6 MHz to m=0 level.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Jul 1, 2013•1 citation

Application of Electron-Shelving Detection via 423 nm Transition in Calcium-Beam Optical Frequency Standard

Huang Kai-Kai, Zhang Jian-Wei, Deshui Yu +3 more

A new scheme of small compact optical frequency standard based on thermal calcium beam with application of 423 nm shelving detection and sharp-angle velocity selection detection is proposed. Combining these presented techniques, we conclude that a small compact optical frequency standard based on thermal calcium beam will outperform the commercial caesium-beam microwave clock, like the 5071 Cs clock (from HP to Agilent, now Symmetricom company), both in accuracy and stability.

Chinese Physics Letters•Nov 29, 2006•26 citations

Different ways to active optical frequency standards

Duo Pan, Xiaobo Xue, Xiaogang Zhang +1 more

Active optical frequency standard, or active optical clock, is a new concept of optical frequency standard, where a weak feedback with phase coherence information in optical bad-cavity limitation is formed, and the continuous self-sustained coherent stimulated emission between two atomic transition levels with population inversion is realized. Through ten years of both theoretical and experimental exploration, the narrow linewidth and suppression of cavity pulling effect of active optical frequency standard have been initially proved. In this paper, after a simple review, we will mainly present the most recent experimental progresses of active optical frequency standards in Peking University, including 4-level cesium active optical frequency standards and active Faraday optical frequency standards. The future development of active optical frequency standards is also discussed.

Journal of Physics Conference Series•Jun 1, 2016•1 citation

Population l 88Sr atomic beam for active optical clock

Xiaobo Xue, Duo Pan, Xiaogang Zhang +2 more

An active optical clock can provide laser light source with potential much narrower linewidth than that of conventional cavity stabilized laser for optical clocks since many cavity noises, including the Brownian thermal noise, can be reduced by orders of magnitude. In this report, a scheme of active optical clock based on Sr atomic beam is proposed. The experimental work of population inversion has been done. A 689 nm laser is used to realize the population inversion between (5s5p)3P1state and (5s2)1S0state by the method of adiabatic rapid passage. A pumping rate of 59% is obtained. In order to establish the population inversion more effectively, an experimental scheme is proposed with a 483 nm pumping laser. A 687 nm laser is used for verification of pumping effectiveness. The atoms left in ground state after 689 nm laser and 687 nm laser pumping is about 7%, which may mainly result from87Sr isotope.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•May 1, 2014•1 citation

Frequency stabilization of 423 nm laser for calcium-beam optical frequency standard

Shengnan Zhang, Xiaogang Zhang, Haosen Shang +2 more

The Ca beam optical frequency standard has the potential to be small optical clock like small Cs beam clock in microwave regime. For improving the signal-to-noise ratio of the clock transition spectroscopy, the electron shelving detection, which uses the fast1S0-1P1423nm transition to detect the narrow1S0-3P1657nm clock transition, was applied for Ca beam optical frequency standard. Therefore the frequency stability of 423 nm laser to some extent determines the performance of the optical frequency standard. In this paper, we stabilize the 423 nm laser frequency to Ca beam signal with side-band locking technique and estimate the preliminary stability of 423 nm laser which is 1.4×10-11at 1 s and 2×10-12at 100 s.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Jul 1, 2017•1 citation
The experiment system for Active Optical Frequency Standard(AOFS) based on thermal Ca atomic beam has been set up. Making use of magnetic field for the atomic beam, we have realized population inversion between ground state1S0and metastable state3P1(m=0) which is primary for AOFS. Detection results are presented by applying electron-shelving technique on thermal Ca atomic beam.
In order to develop small optical clock for various transportable applications with better stability and accuracy than that of commercial small Cs clock and H-maser clock, our group has proposed a small Ca atomic beam clock scheme with electron-shelving detection. Its potential stability was experimentally demonstrated recently. Here, we first demonstrated the dispersive detection of 657 nm transition via the Faraday rotation effect of 423 nm transition based on a thermal Ca atomic beam, this alternative detection method can effectively detect the clock signal by the ground state atoms after the clock laser interrogation. The Faraday anomalous dispersion optical filter of 423 nm transition can reach a maximum transmission of 10%. With a magnetic field of 84 G, the observed 3.3% of the ground state atoms has been excited to the σ±level of metastable3P1(m=±1) state, which are separated 176.6 MHz to m=0 level.
Active optical frequency standard, or active optical clock, is a new concept of optical frequency standard, where a weak feedback with phase coherence information in optical bad-cavity limitation is formed, and the continuous self-sustained coherent stimulated emission between two atomic transition levels with population inversion is realized. Through ten years of both theoretical and experimental exploration, the narrow linewidth and suppression of cavity pulling effect of active optical frequency standard have been initially proved. In this paper, after a simple review, we will mainly present the most recent experimental progresses of active optical frequency standards in Peking University, including 4-level cesium active optical frequency standards and active Faraday optical frequency standards. The future development of active optical frequency standards is also discussed.
An active optical clock can provide laser light source with potential much narrower linewidth than that of conventional cavity stabilized laser for optical clocks since many cavity noises, including the Brownian thermal noise, can be reduced by orders of magnitude. In this report, a scheme of active optical clock based on Sr atomic beam is proposed. The experimental work of population inversion has been done. A 689 nm laser is used to realize the population inversion between (5s5p)3P1state and (5s2)1S0state by the method of adiabatic rapid passage. A pumping rate of 59% is obtained. In order to establish the population inversion more effectively, an experimental scheme is proposed with a 483 nm pumping laser. A 687 nm laser is used for verification of pumping effectiveness. The atoms left in ground state after 689 nm laser and 687 nm laser pumping is about 7%, which may mainly result from87Sr isotope.
The Ca beam optical frequency standard has the potential to be small optical clock like small Cs beam clock in microwave regime. For improving the signal-to-noise ratio of the clock transition spectroscopy, the electron shelving detection, which uses the fast1S0-1P1423nm transition to detect the narrow1S0-3P1657nm clock transition, was applied for Ca beam optical frequency standard. Therefore the frequency stability of 423 nm laser to some extent determines the performance of the optical frequency standard. In this paper, we stabilize the 423 nm laser frequency to Ca beam signal with side-band locking technique and estimate the preliminary stability of 423 nm laser which is 1.4×10-11at 1 s and 2×10-12at 100 s.