Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Communications in Theoretical Physics

Sensibility to Changes of Vibrational Modes of Excited Electron: Sum Frequency Signals Versus Difference Frequency Signals

An-Na Gu, Xian-Ting Liang

Published Mar 1, 2011• 0 citations
Publisher

Abstract

In this paper, we investigate a two electronic level system with vibrational modes coupled to a Brownian oscillator bath. The difference frequency generation (DFG) signals and sum frequency generation (SFG) signals are calculated. It is shown that, for the same model, the SFG signals are more sensitive than the DFG signals to the changes of the vibrational modes of the electronic two-level system. Because the SFG conversion efficiency can be improved by using the time-delay method, the findings in this paper predict that the SFG spectrum may probe the changes of the microstructure more effectively.

DOI
10.1088/0253-6102/55/3/25

Related papers

Signal replication by multiple sum- or difference-frequency generation

Colin J. McKinstrie, Anjali Agarwal, T.C. Banwell +1 more

In this paper, the coupled-mode equations for sum-frequency generation (SFG) and difference-frequency generation (DFG) driven by multiple pumps are solved, and the noise figures of idler generation are determined. For SFG, the (common) noise figure is n, the number of pumps (and idlers), whereas for DFG, the (common) noise figure is 2, independent of n. Thus, DFG driven by multiple pumps enables the generation of multiple low-noise idlers.

Optics Express•Sep 10, 2015•0 citations

Maximizing Sum Frequency Generation Efficiency

Yutian Zhang

In this thesis, high-efficiency frequency conversion Sum Frequency Generation (SFG) is theoretically analyzed and experimentally demonstrated. Our approach to SFG consists of two input phase conjugated broadband signal and idler beams undergoing SFG. By using the signal waveform as a gating beam, a specific mode may be recognized and separated out, providing a promising method for mode selection. The signal and idler are produced by a monochromatic pump and a broadband signal through Difference Frequency Generation (DFG). To obtain good mode selectivity, high conversion efficiency of the selected mode is required. We study the factors that influence the conversion efficiency of the selected mode, like the length of the waveguide and the power of the gating beam. The highest conversion efficiency of the mode achieved is over 90%. By breaking the correlation between mode and gating beams, we find around 40% conversion efficiency of the mismatched mode.

•Nov 1, 2022•0 citations

Time- and frequency-gated spontaneous emission as a tool for studying vibrational dynamics in the excited state

Maxim F. Gelin, Andrei V. Pisliakov, Wolfgang Domcke

The theory of time- and frequency-gated (TFG) spontaneous emission (SE) spectra is elaborated. The present formulation generalizes previous derivations, clarifies the interrelations between different existing expressions, and establishes the validity of certain commonly assumed approximations. We obtain various explicit expressions for TFG SE spectra, which are suitable for performing actual calculations for nontrivial systems and which allow us to establish generic (that is, model-independent) properties of TFG spectra. The doorway-window picture of temporally and spectrally resolved spectra is further developed. It is shown that, to the leading order in the pump and probe pulses, the TFG SE signal is equivalent to the stimulated-emission contribution to the integral pump-probe spectrum in the case of nonoverlapping pulses. The theory is illustrated for the example of an electronic two-level system with a single Condon-active harmonic vibrational mode that is coupled to a thermal bath. The effect of imperfect time and frequency resolution is studied. It is pointed out that the TFG SE spectrum carries information not only on the strength of the system-bath coupling, but also on the relative magnitude of the bath correlation time.

Physical Review A•Jun 17, 2002•42 citations

Landau-Zener tunneling in the process of sum frequency generation

Baihong Li, Yongfang Li

Based on an analogy between the macroscopic phenomena and quantum physics, we study the problem of energy conversion for the sum frequency generation (SFG) process in a linear chirped quasi-phase-matched (QPM) crystal. We show that the process of energy conversion from the signal to the sum frequency field is very similar to the process of Landau-Zener tunneling (LZT) in a two-level system. Therefore, the energy conversion mechanism of SFG process can be explained by the theory of LZT. In addition, we obtain the asymptotic and analytical solution of the sum frequency field by solving the coupled equations with the model of Landau-Zener.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 21, 2014•1 citation

Sum Frequency Generation Spectroscopy of Rydberg States

A. Schnitzer, K. Hollenberg, Wolfgang Behmenburg

Consider sum frequency generation (SFG) ω3 = 2 ω1 + ω2 in a phase matched metal-noble gas mixture, using two lasers ω1 and ω2, where 2 ω1 is tuned to a two photon transition Ωg2 and ω2 is shifted across Rydberg transitions Ω2n (g groundstate, 2 excited state, n Rydberg state of the metal atom). Then the intensity of the SFG spectrum I3 (ω3)~ |χ(3) (ω3)|2 displays resonances and related antiresonances, separated by (1) which are caused respectively by constructive and destructive interference of resonant and nonresonant parts of the 3. order nonlinear susceptibility χ(3) (ω3 ≃ Ωng) = χR(ω3)+ χNR (3) The products μ2nμng:= xn of the dipole transition matrix elements may then be obtained from a simple measurement of the frequency spacings Δωn at a large number of transitions Ωgn and solving iteratively the coupled equation system (1),(3); neither absolute radiation intensity nor vapour density deter mination is needed.

Topical Meeting on Laser Techniques in the Extreme Ultraviolet•Jan 1, 1984•0 citations

Sum sideband effect in hybrid optomechanical system with two-level atom ensemble

Qinghong LIAO, Zhian TANG, Ao Jiawen

Cavity optomechanics, as a cross-discipline between nanophotonics and quantum mechanics, provides a unique platform for investigating optomechanical coupling between photons in microcavities and phonons from mechanical modes. It has a wide range of potential applications in quantum physics, and now it has become a hot topic. A theoretical scheme to enhance the sum sideband generation (SSG) via a two-level atom ensemble is proposed. The effect of the atomic ensemble’s detuning frequency on the efficiency of the SSG is considered by introducing a two-level atom medium. The results indicate that the efficiency of the generating sideband can be significantly enhanced under either red or blue detuning of the atoms, with greater dependence and more pronounced enhancement under the red detuning. In addition, we also consider the effect of pump power, which can effectively enhance the intensity of the output signal by selecting the appropriate pump power. More interestingly, the sensitivity of SSG to atomic detuning also indicates that the precise control of the atomic detuning frequency can achieve the fine-tuning of the SSG process. Furthermore, the cavity-atom coupling strength and atom decay rate are discussed for the transmission characteristics of the sum sideband signals. It is found that the efficiency of SSG can be effectively adjusted by the cavity-atom coupling strength and atom decay rate. The results show that the efficiency of SSG can be significantly improved by optimizing system parameters. The method of enhancing SSG may have potential application prospects in measuring high-precision weak forces and on-chip manipulation of light propagation.

Acta Physica Sinica•Jan 1, 2025•1 citation
In this paper, we investigate a two electronic level system with vibrational modes coupled to a Brownian oscillator bath. The difference frequency generation (DFG) signals and sum frequency generation (SFG) signals are calculated. It is shown that, for the same model, the SFG signals are more sensitive than the DFG signals to the changes of the vibrational modes of the electronic two-level system. Because the SFG conversion efficiency can be improved by using the time-delay method, the findings in this paper predict that the SFG spectrum may probe the changes of the microstructure more effectively.
In this thesis, high-efficiency frequency conversion Sum Frequency Generation (SFG) is theoretically analyzed and experimentally demonstrated. Our approach to SFG consists of two input phase conjugated broadband signal and idler beams undergoing SFG. By using the signal waveform as a gating beam, a specific mode may be recognized and separated out, providing a promising method for mode selection. The signal and idler are produced by a monochromatic pump and a broadband signal through Difference Frequency Generation (DFG). To obtain good mode selectivity, high conversion efficiency of the selected mode is required. We study the factors that influence the conversion efficiency of the selected mode, like the length of the waveguide and the power of the gating beam. The highest conversion efficiency of the mode achieved is over 90%. By breaking the correlation between mode and gating beams, we find around 40% conversion efficiency of the mismatched mode.
The theory of time- and frequency-gated (TFG) spontaneous emission (SE) spectra is elaborated. The present formulation generalizes previous derivations, clarifies the interrelations between different existing expressions, and establishes the validity of certain commonly assumed approximations. We obtain various explicit expressions for TFG SE spectra, which are suitable for performing actual calculations for nontrivial systems and which allow us to establish generic (that is, model-independent) properties of TFG spectra. The doorway-window picture of temporally and spectrally resolved spectra is further developed. It is shown that, to the leading order in the pump and probe pulses, the TFG SE signal is equivalent to the stimulated-emission contribution to the integral pump-probe spectrum in the case of nonoverlapping pulses. The theory is illustrated for the example of an electronic two-level system with a single Condon-active harmonic vibrational mode that is coupled to a thermal bath. The effect of imperfect time and frequency resolution is studied. It is pointed out that the TFG SE spectrum carries information not only on the strength of the system-bath coupling, but also on the relative magnitude of the bath correlation time.
Based on an analogy between the macroscopic phenomena and quantum physics, we study the problem of energy conversion for the sum frequency generation (SFG) process in a linear chirped quasi-phase-matched (QPM) crystal. We show that the process of energy conversion from the signal to the sum frequency field is very similar to the process of Landau-Zener tunneling (LZT) in a two-level system. Therefore, the energy conversion mechanism of SFG process can be explained by the theory of LZT. In addition, we obtain the asymptotic and analytical solution of the sum frequency field by solving the coupled equations with the model of Landau-Zener.
Consider sum frequency generation (SFG) ω3 = 2 ω1 + ω2 in a phase matched metal-noble gas mixture, using two lasers ω1 and ω2, where 2 ω1 is tuned to a two photon transition Ωg2 and ω2 is shifted across Rydberg transitions Ω2n (g groundstate, 2 excited state, n Rydberg state of the metal atom). Then the intensity of the SFG spectrum I3 (ω3)~ |χ(3) (ω3)|2 displays resonances and related antiresonances, separated by (1) which are caused respectively by constructive and destructive interference of resonant and nonresonant parts of the 3. order nonlinear susceptibility χ(3) (ω3 ≃ Ωng) = χR(ω3)+ χNR (3) The products μ2nμng:= xn of the dipole transition matrix elements may then be obtained from a simple measurement of the frequency spacings Δωn at a large number of transitions Ωgn and solving iteratively the coupled equation system (1),(3); neither absolute radiation intensity nor vapour density deter mination is needed.
Cavity optomechanics, as a cross-discipline between nanophotonics and quantum mechanics, provides a unique platform for investigating optomechanical coupling between photons in microcavities and phonons from mechanical modes. It has a wide range of potential applications in quantum physics, and now it has become a hot topic. A theoretical scheme to enhance the sum sideband generation (SSG) via a two-level atom ensemble is proposed. The effect of the atomic ensemble’s detuning frequency on the efficiency of the SSG is considered by introducing a two-level atom medium. The results indicate that the efficiency of the generating sideband can be significantly enhanced under either red or blue detuning of the atoms, with greater dependence and more pronounced enhancement under the red detuning. In addition, we also consider the effect of pump power, which can effectively enhance the intensity of the output signal by selecting the appropriate pump power. More interestingly, the sensitivity of SSG to atomic detuning also indicates that the precise control of the atomic detuning frequency can achieve the fine-tuning of the SSG process. Furthermore, the cavity-atom coupling strength and atom decay rate are discussed for the transmission characteristics of the sum sideband signals. It is found that the efficiency of SSG can be effectively adjusted by the cavity-atom coupling strength and atom decay rate. The results show that the efficiency of SSG can be significantly improved by optimizing system parameters. The method of enhancing SSG may have potential application prospects in measuring high-precision weak forces and on-chip manipulation of light propagation.