Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

Signal replication by multiple sum- or difference-frequency generation

Colin J. McKinstrie, Anjali Agarwal, T.C. Banwell, James M. Dailey

Published Sep 10, 2015• 0 citations
Publisher

Abstract

In this paper, the coupled-mode equations for sum-frequency generation (SFG) and difference-frequency generation (DFG) driven by multiple pumps are solved, and the noise figures of idler generation are determined. For SFG, the (common) noise figure is n, the number of pumps (and idlers), whereas for DFG, the (common) noise figure is 2, independent of n. Thus, DFG driven by multiple pumps enables the generation of multiple low-noise idlers.

DOI
10.1364/oe.23.024675

Related papers

Maximizing Sum Frequency Generation Efficiency

Yutian Zhang

In this thesis, high-efficiency frequency conversion Sum Frequency Generation (SFG) is theoretically analyzed and experimentally demonstrated. Our approach to SFG consists of two input phase conjugated broadband signal and idler beams undergoing SFG. By using the signal waveform as a gating beam, a specific mode may be recognized and separated out, providing a promising method for mode selection. The signal and idler are produced by a monochromatic pump and a broadband signal through Difference Frequency Generation (DFG). To obtain good mode selectivity, high conversion efficiency of the selected mode is required. We study the factors that influence the conversion efficiency of the selected mode, like the length of the waveguide and the power of the gating beam. The highest conversion efficiency of the mode achieved is over 90%. By breaking the correlation between mode and gating beams, we find around 40% conversion efficiency of the mismatched mode.

•Nov 1, 2022•0 citations

Sum and difference frequency generation in a two-level system with permanent dipole moments

Raanan Bavli, Y. B. Band

We calculate the sum- and difference-frequency-generation (SFG and DFG) susceptibilities, ${\mathrm{\ensuremath{\chi}}}^{(2)}$(-(${\mathrm{\ensuremath{\omega}}}_{1}$+${\mathrm{\ensuremath{\omega}}}_{2}$);${\mathrm{\ensuremath{\omega}}}_{1}$,${\mathrm{\ensuremath{\omega}}}_{2}$) and ${\mathrm{\ensuremath{\chi}}}^{(2)}$(-(${\mathrm{\ensuremath{\omega}}}_{1}$-${\mathrm{\ensuremath{\omega}}}_{2}$);${\mathrm{\ensuremath{\omega}}}_{1}$,-${\mathrm{\ensuremath{\omega}}}_{2}$), of a homogeneously broadened two-level system with permanent dipole moments in the presence of pump fields at frequencies ${\mathrm{\ensuremath{\omega}}}_{1}$ and ${\mathrm{\ensuremath{\omega}}}_{2}$. Both SFG and DFG susceptibilities have two maxima at frequencies corresponding to the one- and two-photon resonances of the two-level system. Knowledge of the magnitude of one of the maxima of either SFG or DFG is sufficient for determining the magnitude of the second peak of that process and also the two peaks of the other process. In both processes the peak at the two-photon resonance has dominant contributions arising from off-diagonal elements of the density matrix. The interference between these contributions is constructive in SFG and destructive in DFG. Therefore, SFG is more efficient at the two-photon resonance than DFG. An expression for the ratio between these peaks is obtained. The peak of the spectrum of each process corresponding to the one-photon resonance has two main contributions, one of which is diagonal and the other off diagonal. In DFG the interference between the two contributions is constructive and in SFG the interference is destructive. Hence, DFG is more efficient in the vicinity of the one-photon resonance. However, since the off-diagonal contributions to SFG and DFG on the one-photon resonance are equal in magnitude (and differ by a phase difference of \ensuremath{\sim}\ensuremath{\pi}) the efficiencies of the two processes are equal when the duration of the pulses is comparable to or shorter than ${\mathit{T}}_{1}$.

Physical Review A•May 1, 1991•16 citations

Sensibility to Changes of Vibrational Modes of Excited Electron: Sum Frequency Signals Versus Difference Frequency Signals

An-Na Gu, Xian-Ting Liang

In this paper, we investigate a two electronic level system with vibrational modes coupled to a Brownian oscillator bath. The difference frequency generation (DFG) signals and sum frequency generation (SFG) signals are calculated. It is shown that, for the same model, the SFG signals are more sensitive than the DFG signals to the changes of the vibrational modes of the electronic two-level system. Because the SFG conversion efficiency can be improved by using the time-delay method, the findings in this paper predict that the SFG spectrum may probe the changes of the microstructure more effectively.

Communications in Theoretical Physics•Mar 1, 2011•0 citations

Sum Frequency Generation Spectroscopy of Rydberg States

A. Schnitzer, K. Hollenberg, Wolfgang Behmenburg

Consider sum frequency generation (SFG) ω3 = 2 ω1 + ω2 in a phase matched metal-noble gas mixture, using two lasers ω1 and ω2, where 2 ω1 is tuned to a two photon transition Ωg2 and ω2 is shifted across Rydberg transitions Ω2n (g groundstate, 2 excited state, n Rydberg state of the metal atom). Then the intensity of the SFG spectrum I3 (ω3)~ |χ(3) (ω3)|2 displays resonances and related antiresonances, separated by (1) which are caused respectively by constructive and destructive interference of resonant and nonresonant parts of the 3. order nonlinear susceptibility χ(3) (ω3 ≃ Ωng) = χR(ω3)+ χNR (3) The products μ2nμng:= xn of the dipole transition matrix elements may then be obtained from a simple measurement of the frequency spacings Δωn at a large number of transitions Ωgn and solving iteratively the coupled equation system (1),(3); neither absolute radiation intensity nor vapour density deter mination is needed.

Topical Meeting on Laser Techniques in the Extreme Ultraviolet•Jan 1, 1984•0 citations

DOUBLE-PUMPED LOW-NOISE PARAMETRIC DOWN-CONVERTER

Sumeth Vongpanitlerd, Brian D. O. Anderson

Theoretical discussion is given of low-noise uncooled parametric down-converter which is realized by using two unsynchronized pump generators at different frequencies.

•Jan 1, 1969•0 citations

Comparison of cascaded χ2 wavelength conversions in quasi-phase-matched (QPM) waveguides

Bo Chen, Chang‐Qing Xu

Cascaded second-order nonlinear interaction (&chi(2));based wavelength conversion technique has attracted much attention due to its unique characteristics such as low noise and broadband, which are critical in fiber communication networks. In this report, wavelength conversions based on the newly proposed SFG-DFG (sum frequency generation - difference frequency generation) and conventional SHG-DFG (second harmonic generation - difference frequency generation) are studied and compared both experimentally and theoretically in a LiNbO3 quasi-phase matched (QPM) waveguide. It is shown that the same conversion efficiency can be achieved by employing two pump sources with only half power each (P1, P2) in the SFG-DFG scheme as compared with the SHG-DFG scheme with a single higher power pump beam (P=P1+P2). It is shown that the cascaded SFG-DFG based wavelength conversion has a larger 3-dB pump tolerance bandwidth. The theoretical results are consistent well with the experimental ones. It is found that the pump wavelength difference can be separated by a span as large as 75 nm, while 3-dB signal conversion efficiency is retained in a 45 mm-long device. It is also exhibited that tolerance of temperature for the cascaded SFG-DFG remains the same as that of the cascaded SHG-DFG based devices. The results show that the SFG-DFG wavelength conversion scheme is very attractive for practical applications.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 16, 2004•0 citations
In this paper, the coupled-mode equations for sum-frequency generation (SFG) and difference-frequency generation (DFG) driven by multiple pumps are solved, and the noise figures of idler generation are determined. For SFG, the (common) noise figure is n, the number of pumps (and idlers), whereas for DFG, the (common) noise figure is 2, independent of n. Thus, DFG driven by multiple pumps enables the generation of multiple low-noise idlers.
In this thesis, high-efficiency frequency conversion Sum Frequency Generation (SFG) is theoretically analyzed and experimentally demonstrated. Our approach to SFG consists of two input phase conjugated broadband signal and idler beams undergoing SFG. By using the signal waveform as a gating beam, a specific mode may be recognized and separated out, providing a promising method for mode selection. The signal and idler are produced by a monochromatic pump and a broadband signal through Difference Frequency Generation (DFG). To obtain good mode selectivity, high conversion efficiency of the selected mode is required. We study the factors that influence the conversion efficiency of the selected mode, like the length of the waveguide and the power of the gating beam. The highest conversion efficiency of the mode achieved is over 90%. By breaking the correlation between mode and gating beams, we find around 40% conversion efficiency of the mismatched mode.
We calculate the sum- and difference-frequency-generation (SFG and DFG) susceptibilities, ${\mathrm{\ensuremath{\chi}}}^{(2)}$(-(${\mathrm{\ensuremath{\omega}}}_{1}$+${\mathrm{\ensuremath{\omega}}}_{2}$);${\mathrm{\ensuremath{\omega}}}_{1}$,${\mathrm{\ensuremath{\omega}}}_{2}$) and ${\mathrm{\ensuremath{\chi}}}^{(2)}$(-(${\mathrm{\ensuremath{\omega}}}_{1}$-${\mathrm{\ensuremath{\omega}}}_{2}$);${\mathrm{\ensuremath{\omega}}}_{1}$,-${\mathrm{\ensuremath{\omega}}}_{2}$), of a homogeneously broadened two-level system with permanent dipole moments in the presence of pump fields at frequencies ${\mathrm{\ensuremath{\omega}}}_{1}$ and ${\mathrm{\ensuremath{\omega}}}_{2}$. Both SFG and DFG susceptibilities have two maxima at frequencies corresponding to the one- and two-photon resonances of the two-level system. Knowledge of the magnitude of one of the maxima of either SFG or DFG is sufficient for determining the magnitude of the second peak of that process and also the two peaks of the other process. In both processes the peak at the two-photon resonance has dominant contributions arising from off-diagonal elements of the density matrix. The interference between these contributions is constructive in SFG and destructive in DFG. Therefore, SFG is more efficient at the two-photon resonance than DFG. An expression for the ratio between these peaks is obtained. The peak of the spectrum of each process corresponding to the one-photon resonance has two main contributions, one of which is diagonal and the other off diagonal. In DFG the interference between the two contributions is constructive and in SFG the interference is destructive. Hence, DFG is more efficient in the vicinity of the one-photon resonance. However, since the off-diagonal contributions to SFG and DFG on the one-photon resonance are equal in magnitude (and differ by a phase difference of \ensuremath{\sim}\ensuremath{\pi}) the efficiencies of the two processes are equal when the duration of the pulses is comparable to or shorter than T1{\mathit{T}}_{1}T1​.
In this paper, we investigate a two electronic level system with vibrational modes coupled to a Brownian oscillator bath. The difference frequency generation (DFG) signals and sum frequency generation (SFG) signals are calculated. It is shown that, for the same model, the SFG signals are more sensitive than the DFG signals to the changes of the vibrational modes of the electronic two-level system. Because the SFG conversion efficiency can be improved by using the time-delay method, the findings in this paper predict that the SFG spectrum may probe the changes of the microstructure more effectively.
Consider sum frequency generation (SFG) ω3 = 2 ω1 + ω2 in a phase matched metal-noble gas mixture, using two lasers ω1 and ω2, where 2 ω1 is tuned to a two photon transition Ωg2 and ω2 is shifted across Rydberg transitions Ω2n (g groundstate, 2 excited state, n Rydberg state of the metal atom). Then the intensity of the SFG spectrum I3 (ω3)~ |χ(3) (ω3)|2 displays resonances and related antiresonances, separated by (1) which are caused respectively by constructive and destructive interference of resonant and nonresonant parts of the 3. order nonlinear susceptibility χ(3) (ω3 ≃ Ωng) = χR(ω3)+ χNR (3) The products μ2nμng:= xn of the dipole transition matrix elements may then be obtained from a simple measurement of the frequency spacings Δωn at a large number of transitions Ωgn and solving iteratively the coupled equation system (1),(3); neither absolute radiation intensity nor vapour density deter mination is needed.
Cascaded second-order nonlinear interaction (&chi(2));based wavelength conversion technique has attracted much attention due to its unique characteristics such as low noise and broadband, which are critical in fiber communication networks. In this report, wavelength conversions based on the newly proposed SFG-DFG (sum frequency generation - difference frequency generation) and conventional SHG-DFG (second harmonic generation - difference frequency generation) are studied and compared both experimentally and theoretically in a LiNbO3 quasi-phase matched (QPM) waveguide. It is shown that the same conversion efficiency can be achieved by employing two pump sources with only half power each (P1, P2) in the SFG-DFG scheme as compared with the SHG-DFG scheme with a single higher power pump beam (P=P1+P2). It is shown that the cascaded SFG-DFG based wavelength conversion has a larger 3-dB pump tolerance bandwidth. The theoretical results are consistent well with the experimental ones. It is found that the pump wavelength difference can be separated by a span as large as 75 nm, while 3-dB signal conversion efficiency is retained in a 45 mm-long device. It is also exhibited that tolerance of temperature for the cascaded SFG-DFG remains the same as that of the cascaded SHG-DFG based devices. The results show that the SFG-DFG wavelength conversion scheme is very attractive for practical applications.