Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Cold Atom Interferometer as Inertial Measurement Unit for Precision Navigation

Christopher Jekeli

Published Jun 9, 2004• 3 citations
OpenAlex

Abstract

Recent technological advancements in atom interferometry have demonstrated extremely precise inertial measurements of acceleration and rotation. These could be used to develop ultra-precise inertial navigation systems that approach GPS navigation. The paper presents a rudimentary exposition of the interferometer which is based on beams of atoms cooled by lasers to a velocity of the order of 1 m/s and launched along two trajectories that re-combine, as in a classical interferometer. Using the dual wave-particle quantum mechanical properties of atoms, the differential phase of the interfering beams is indicative of inertial acceleration and rotation, similar to the Sagnac effect. Due to the much shorter wavelength of the atomic beam, the sensitivity is many orders of magnitude greater. Concluding analyses show that an inertial navigation system with 5/hr drift is technically possible.

Related papers

Navigation Error Analysis of Atom Interferometer Inertial Sensor

Christopher Jekeli

The recent development of the atom interferometer and its demonstration as an inertial sensor of acceleration and rotation rate augur a new generation of inertial navigation systems that would rival today's satellite navigation accuracy at the few-meter level. This paper reviews the principles of inertial measurement using the atom interferometer from a rudimentary viewpoint to illustrate the fundamentals and to highlight some of the potential shortcomings with a particular type, the cold-atom interferometer. One of these shortcomings is the fact that this interferometer requires a finite period of time during which the atoms are prepared (cooled) before they enter the interferometer and respond to its dynamics relative to an inertial frame. This lapse in the measurement duty cycle could be supplemented with very precise conventional inertial measurement units (IMUs), or eliminated with multiple, interleaved atom interferometers. Error analyses show that cold-atom interferometric IMUs that capture 50 percent of the dynamics must be coupled with conventional IMUs that are 50 times more accurate than typical navigation-grade units to sustain a horizontal position error of under 5 m (root mean square) after 1 h.

NAVIGATION Journal of the Institute of Navigation•Mar 1, 2005•107 citations

Development of compact cold-atom sensors for inertial navigation

Baptiste Battelier, B. Barrett, Lauriane Fouché +7 more

Inertial sensors based on cold atom interferometry exhibit many interesting features for applications related to inertial navigation, particularly in terms of sensitivity and long-term stability. However, at present the typical atom interferometer is still very much an experiment—consisting of a bulky, static apparatus with a limited dynamic range and high sensitivity to environmental effects. To be compliant with mobile applications further development is needed. In this work, we present a compact and mobile experiment, which we recently used to achieve the first inertial measurements with an atomic accelerometer onboard an aircraft. By integrating classical inertial sensors into our apparatus, we are able to operate the atomic sensor well beyond its standard operating range, corresponding to half of an interference fringe. We report atom-based acceleration measurements along both the horizontal and vertical axes of the aircraft with one-shot sensitivities of 2.3 × 10−4 g over a range of ∼ 0.1 g. The same technology can be used to develop cold-atom gyroscopes, which could surpass the best optical gyroscopes in terms of long-term sensitivity. Our apparatus was also designed to study multi-axis atom interferometry with the goal of realizing a full inertial measurement unit comprised of the three axes of acceleration and rotation. Finally, we present a compact and tunable laser system, which constitutes an essential part of any cold-atom-based sensor. The architecture of the laser is based on phase modulating a single fiber-optic laser diode, and can be tuned over a range of 1 GHz in less than 200 μs.

arXiv:1605.02454•Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 29, 2016•84 citations

An atom interferometer for measuring horizontal accelerations

Jimmy Stammers

Matter-wave interferometry has enabled high precision measurements of inertial forces such as gravity and the Coriolis force. This is facilitated by the long-term stability of the physical properties of atoms and lasers. Recent experiments have demonstrated the operation of portable, robust sensors using atom interferometry. This has potential uses in the context of inertial navigation, where conventional devices suffer from long-term drifts due to bias instability. Furthermore, determining position via dead reckoning requires minimisation of dead time between measurements. This thesis presents the development of an atom interferometer for measuring horizontal accelerations. In this configuration, gravity induces motion across the laser wavefront, which constrains the tolerable level of wavefront distortions. Effective control of the experiment allows the interferometer to be operated at a rate of 4 Hz. A cold ensemble of 10^6 atoms in the same internal state is prepared in 150 ms. The interferometer operates using a sequence of three laser pulses separated by T= 25 ms to achieve sensitivity to horizontal accelerations. Combining this with a classical accelerometer provides a method of correcting for vibration-induced noise, as well as determining the interferometer fringe order. After an integration time of 40 s, the sensitivity to horizontal accelerations is better than 3^-6 m s^-2. Effects which limit this sensitivity are discussed.

•Nov 1, 2018•6 citations

New Generation Inertial Navigation Technology:Cold Atom Gyroscope

Mingsheng Zhan

In this paper,we described the progress of cold atom gyroscope.We launched the atoms along the same trajectory accurately and the opposite direction by controlling the frequency of directed digital system circuit.Using stimulated Raman beams,we operated the cold atoms and realized the atom interferometer fringes.With this configuration,it will greatly eliminate the common mode noise caused by uncertainty factor,such as the phase of the Raman laser beams,the gravity acceleration.It will significantly improve the precision in our experiment.The atom gyroscope will give a new way for the inertial navigation technology in the future.

Gnss World of China•Jan 1, 2010•1 citation

High resolution sagnac interferometry with cold atoms

Michael Gilowski, Christian Schubert, Thijs Wendrich +4 more

The status of the dual atom interferometer for the precise measurement of inertial forces, based on optical Raman transitions for the coherent beam splitting process is reported. Two interferometers with overlapping counter propagating atomic trajectories are used to exactly distinguish between rotation and acceleration.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 1, 2009•0 citations

Hybrid Inertial sensors – future prospects of inertial sensors based on atom interferometry fused with opto-mechanical accelerometers

M. Warner, Jens Große, Lisa Wörner +6 more

Positioning currently relies heavily on Global Navigation Satellite Systems (GNSS). Combined with classical accelerometers and gyroscopes, precise determination of orientation and position at any given time become available. However, but the availability of GNSS (e.g. GPS) is limited and not guaranteed at all times.In this paper we present an alternative based on atom interferometry using cold atom ensembles. An inertial sensor based on cold atoms allows, in theory, for nearly drift-free measurements of inertial forces with accuracies unreached by classical sensors, but the technology is still locked away in large physics laboratories [1].This paper introduces a compact device called SECAMP, which is capable of cooling atoms down to μ-Kelvin. SECAMP has the potential to measure inertial acceleration in three degrees of freedom. In the following, we present the current experimental setup of the apparatus and outline the next steps for the inertial sensor.

DGON Inertial Sensors and Systems (ISS)•Sep 1, 2019•1 citation
Recent technological advancements in atom interferometry have demonstrated extremely precise inertial measurements of acceleration and rotation. These could be used to develop ultra-precise inertial navigation systems that approach GPS navigation. The paper presents a rudimentary exposition of the interferometer which is based on beams of atoms cooled by lasers to a velocity of the order of 1 m/s and launched along two trajectories that re-combine, as in a classical interferometer. Using the dual wave-particle quantum mechanical properties of atoms, the differential phase of the interfering beams is indicative of inertial acceleration and rotation, similar to the Sagnac effect. Due to the much shorter wavelength of the atomic beam, the sensitivity is many orders of magnitude greater. Concluding analyses show that an inertial navigation system with 5/hr drift is technically possible.
The recent development of the atom interferometer and its demonstration as an inertial sensor of acceleration and rotation rate augur a new generation of inertial navigation systems that would rival today's satellite navigation accuracy at the few-meter level. This paper reviews the principles of inertial measurement using the atom interferometer from a rudimentary viewpoint to illustrate the fundamentals and to highlight some of the potential shortcomings with a particular type, the cold-atom interferometer. One of these shortcomings is the fact that this interferometer requires a finite period of time during which the atoms are prepared (cooled) before they enter the interferometer and respond to its dynamics relative to an inertial frame. This lapse in the measurement duty cycle could be supplemented with very precise conventional inertial measurement units (IMUs), or eliminated with multiple, interleaved atom interferometers. Error analyses show that cold-atom interferometric IMUs that capture 50 percent of the dynamics must be coupled with conventional IMUs that are 50 times more accurate than typical navigation-grade units to sustain a horizontal position error of under 5 m (root mean square) after 1 h.
Inertial sensors based on cold atom interferometry exhibit many interesting features for applications related to inertial navigation, particularly in terms of sensitivity and long-term stability. However, at present the typical atom interferometer is still very much an experiment—consisting of a bulky, static apparatus with a limited dynamic range and high sensitivity to environmental effects. To be compliant with mobile applications further development is needed. In this work, we present a compact and mobile experiment, which we recently used to achieve the first inertial measurements with an atomic accelerometer onboard an aircraft. By integrating classical inertial sensors into our apparatus, we are able to operate the atomic sensor well beyond its standard operating range, corresponding to half of an interference fringe. We report atom-based acceleration measurements along both the horizontal and vertical axes of the aircraft with one-shot sensitivities of 2.3 × 10−4 g over a range of ∼ 0.1 g. The same technology can be used to develop cold-atom gyroscopes, which could surpass the best optical gyroscopes in terms of long-term sensitivity. Our apparatus was also designed to study multi-axis atom interferometry with the goal of realizing a full inertial measurement unit comprised of the three axes of acceleration and rotation. Finally, we present a compact and tunable laser system, which constitutes an essential part of any cold-atom-based sensor. The architecture of the laser is based on phase modulating a single fiber-optic laser diode, and can be tuned over a range of 1 GHz in less than 200 μs.
Matter-wave interferometry has enabled high precision measurements of inertial forces such as gravity and the Coriolis force. This is facilitated by the long-term stability of the physical properties of atoms and lasers. Recent experiments have demonstrated the operation of portable, robust sensors using atom interferometry. This has potential uses in the context of inertial navigation, where conventional devices suffer from long-term drifts due to bias instability. Furthermore, determining position via dead reckoning requires minimisation of dead time between measurements. This thesis presents the development of an atom interferometer for measuring horizontal accelerations. In this configuration, gravity induces motion across the laser wavefront, which constrains the tolerable level of wavefront distortions. Effective control of the experiment allows the interferometer to be operated at a rate of 4 Hz. A cold ensemble of 10^6 atoms in the same internal state is prepared in 150 ms. The interferometer operates using a sequence of three laser pulses separated by T= 25 ms to achieve sensitivity to horizontal accelerations. Combining this with a classical accelerometer provides a method of correcting for vibration-induced noise, as well as determining the interferometer fringe order. After an integration time of 40 s, the sensitivity to horizontal accelerations is better than 3^-6 m s^-2. Effects which limit this sensitivity are discussed.
In this paper,we described the progress of cold atom gyroscope.We launched the atoms along the same trajectory accurately and the opposite direction by controlling the frequency of directed digital system circuit.Using stimulated Raman beams,we operated the cold atoms and realized the atom interferometer fringes.With this configuration,it will greatly eliminate the common mode noise caused by uncertainty factor,such as the phase of the Raman laser beams,the gravity acceleration.It will significantly improve the precision in our experiment.The atom gyroscope will give a new way for the inertial navigation technology in the future.
Positioning currently relies heavily on Global Navigation Satellite Systems (GNSS). Combined with classical accelerometers and gyroscopes, precise determination of orientation and position at any given time become available. However, but the availability of GNSS (e.g. GPS) is limited and not guaranteed at all times.In this paper we present an alternative based on atom interferometry using cold atom ensembles. An inertial sensor based on cold atoms allows, in theory, for nearly drift-free measurements of inertial forces with accuracies unreached by classical sensors, but the technology is still locked away in large physics laboratories [1].This paper introduces a compact device called SECAMP, which is capable of cooling atoms down to μ-Kelvin. SECAMP has the potential to measure inertial acceleration in three degrees of freedom. In the following, we present the current experimental setup of the apparatus and outline the next steps for the inertial sensor.