By using an Ar + ion laser, a tunable Rh 6 G dye laser (linewidth 0.5 cm −1 ) pumped by the second harmonic of a YAG:Nd laser and a Coherent 899-21 dye laser as light sources and using a monochromator, a phase-locking amplifier and a computer as the data detecting system, we detect the optical properties of Eu 3+ -doped Y 2 SiO 5 crystal. Persistent spectral hole burning (PSHB) are observed in the Eu 3+ ions spectral lines ( 5 D 0 − 7 F 0 transition) in the crystal at the temperature of 16 K. For 15 mW dye laser burning the crystal for 0.1 s spectral holes with hole width about 80 MHz both at 579.62 nm and at 579.82 nm are detected and the holes can remain for a long time, more than 10 h.
By using an Ar + ion laser, a tunable Rh 6 G dye laser (linewidth 0.5 cm −1 ) pumped by the second harmonic of a YAG:Nd laser and a Coherent 899-21 dye laser as light sources and using a monochromator, a phase-locking amplifier and a computer as the data detecting system, we detect the optical properties of Eu 3+ -doped Y 2 SiO 5 crystal. Persistent spectral hole burning (PSHB) are observed in the Eu 3+ ions spectral lines ( 5 D 0 − 7 F 0 transition) in the crystal at the temperature of 16 K. For 15 mW dye laser burning the crystal for 0.1 s spectral holes with hole width about 80 MHz both at 579.62 nm and at 579.82 nm are detected and the holes can remain for a long time, more than 10 h.
By using an Ar+ ion laser, a tunable Rh 6G dye laser(Linewidth : 0.5 cm(-1)) and a Coherent 899-21 dye laser as light sources and using a monochromator and a phase-locking amplifier, the optical properties of Eu3+ : Y2SiO5 crystal were detected. Persistent spectral hole burning (PSHB) were also observed in (5)Do-(7)Fo transition in the crystal at the temperature of 16 K. For 15 mW dye laser (Wavelength : 579.62 nm) burning the crystal for 0.1 s a spectral hole with about 80 MHz hole width were detected and the hole can been keep for longer than 10 h.
Persistent spectral hole burning (PSHB) is demonstrated in the (7)F(0)-->(5)D(0) optical transition of Eu(3+) doped into crystals of BaFCl. For Eu(3+) ions at two different lattice sites, persistent holes can be burned at temperatures below 77 K. The characteristics of the hole-burning process suggest that the observed PSHB effect is due to laser-excitation-induced site-to-site conversion. One type of Eu(3+) site is converted into another type of defect site. This process is not optically reversible, and holes can be erased only when the temperature increases to 150 K.
Using an ultrastable continuous-wave laser at 580 nm we performed spectral hole burning of Eu(3+):Y(2)SiO(5) at a very high spectral resolution. The essential parameters determining the usefulness as a macroscopic frequency reference, linewidth, temperature sensitivity, and long-term stability, were characterized using a H-maser stabilized frequency comb. Spectral holes with a linewidth as low as 6 kHz were observed and the upper limit of the drift of the hole frequency was determined to be 5±3 mHz/s. We discuss the necessary requirements for achieving ultrahigh stability in laser frequency stabilization to these spectral holes.
As basic building blocks for quantum devices, ultra-stable lasers have a profound impact on various fields. Longer laser coherence times enhance the performance of quantum sensors, computers, communications, and optical clocks. Although optical lattice clocks have accomplished significant high-precision measurements, they often fall short of their quantum projection noise limits due to dead times during atom preparation: the instability in the laser frequency introduces stochastic fluctuations during the interrogation of atomic transitions (Dick effect). High-resolution optical clock comparisons are crucial for evaluating their accuracy and could lead to a redefinition of the SI second based on optical transitions [1].However, the most common technique for achieving ultra-stable lasers, the Pound-Drever-Hall method with Fabry-Perot cavities, faces thermal noise limitations of the cavities. To overcome these constraints, alternative methods such as Spectral Hole Burning (SHB) in rare-earth-doped crystals (REICs) have been explored. Indeed, REICs experience inhomogeneous broadening due to local lattice distortions caused by the size difference between dopant and host ions. An SHB protocol, which creates narrow spectral features through selective depletion of specific dopant ion populations using narrow-linewidth lasers, allows to overcome the inhomogeneous broadening and fully exploit the coherence of rare-earth ions. At cryogenic temperatures, Eu:YSO crystal exhibit persistent Spectral Holes a few kHz narrow and with a lifetime up to 10 h, at 4 K [2], making it a high-precision frequency reference, ideal for intermediate-timescale sensing.We report recent experimental progress on SHB in Eu:YSO crystals at specific sub-K dilution temperature setpoints that cancel the thermal sensitivity of the hole frequency [3]. The latest recorded performances on our experiment reach a fractional frequency stability of 4.10-16 at 1 s [4], which is close to the perfomance of our reference cavity at LTE. Therefore, a second SHB setup is needed for our future stability comparisons. On one front, we rationalize our SHB protocol and investigate new optimal burning parameters as well as test various doping concentrations to achieve the narrowest possible spectral holes on both setups. On another, we continue to further improving the laser frequency lock onto spectral holes, by cancelling as many systematic noise sources as possible. We provide the performances of our Michelson interferometer to reject frequency noise induced on light propagation to the crystal and by the cryostat acoustic vibrations. In addition, we explore a group delay measurement technique via phase modulation to enhance the precision on the pointing of the center of spectral holes. This should help removing slow frequency drifts due to asymmetric burning of the hole while it is probed by the laser.
For next generation high density optical storage, extensive studies on persistent spectral hole burning (PSHB) have been performed, because they have a large potential for a high density frequency-domain optical data storage. PSHB has been observed at room temperature in Sm-doped crystals and glasses. Among them, glasses are considered to be more favorable than single crystals, due to their wide inhomogeneous line width and easy process for mass production. In the study, we developed a new glass mixture which shows room temperature PSHB with a inhomogeneous line width broadened up to 70 cm/sup -1/. The PSHB was characterized by investigating the time decay pattern of fluorescence and the excitation spectra.
Laser induced hole burning in optical absorption bands of low temperature solids has been investigated with emphasis on mechanisms for population hole burning, the interactions with the environment which limit the hole widths and the use of hole burning for ultra high resolution spectroscopy. Hole burning was observed in a wide range of solids including organic and organometallic molecules in crystals and rare earth ions in crystals and glasses. The mechanisms for hole burning also varied widely and a new mechanism involving optically induced nuclear spin flips of near neighbor nuclei was discovered. Examples of hole burning in new classes of materials are presented here for the first time, namely inorganic glasses (silicate glasses containing Nd(3+), Pr(3+) or Eu(3+)) and undoped stoichiometric compounds (e.g., EuP5O14). Hole recovery was used to determine nuclear spin lattice relaxation rates in praseodymium doped crystals. For allowed optical transitions (e.g., singlet states of zinc porphyrin, dibromoindigo and color centers in alkali halides) the hole widths at 2K are limited by population decay to approximately 50 MHz. For longer lived optical levels in crystalline materials, e.g., those containing rare earth ions, the hole widths are narrower (less than 10 MHz) and are limited by dynamical interactions with surrounding nuclei. In amorphous materials such as europium doped silicate glass, hole widths are much broader, being limited by low frequency tunneling motions. Hole burning measurements were complemented by time domain coherent transient (photon echo, and optical free decay) measurements of homogeneous linewidths which enabled us to measure optical resonances as narrow as 760 Hz in Eu(3+):Y2O3.