Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Kharkiv Symposium on Physics and Engineering of Microwaves, Millimeter and Submillimeter Waves

Josephson generation of the HTS josephson junction array embedded in a resonant system

O.M. Ivanyuta, V.M. Raksha

Published Nov 8, 2004• 0 citations
Publisher

Abstract

Josephson junction (JJ) arrays can be used as a basis for the creation of different microminiature devices, such as tunable Josephson generators, primary voltage standards, detectors of radiation, etc. However the using of JJ arrays entails a problem of its synchronous operation. One of the solutions of this problem is using the surface wave resonators (SWR). The aim of our work is the detection of Josephson generation of an array of synchronized high-temperature superconductor (HTS) JJ embedded in the SWR.

DOI
10.1109/msmw.2004.1345908

Related papers

Irradiation of HTS Josephson junctions with the surface wave resonator

Gennadiy A. Melkov, Alexander M. Klushin, O. D. Poustylnik +2 more

The new type of surface wave resonator (SWR) consists of HTS film on a dielectric substrate is developed. A possibility of optimal coupling between the electromagnetic field of the SWR and the HTS Josephson junction array is shown; The topologies for embedding the bicrystal HTS Josephson junctions in the SWR are developed. These topology ensure the junction synchronization, that can be used for creation voltage standards, microwave detectors and Josephson generators and so on; The microwave properties of the SWR with HTS Josephson junction arrays (up to 450 junctions) and nonlinear elements based on Shottky-barrier diodes have been investigated. For the array with 450 HTS Josephson junctions the voltage sequence with 10 mV step has been obtained, sensitivity of the detector based on this array is 0.1 A/W with dynamic range 10/sup 2/ dB; The Josephson generation with microwave power at several nW for the SWR with bicrystal HTS JJs is detected. There were two groups of junctions. These groups are formed at the time of fabrication due to imperfection of HTS junction fabrication technology.

International Kharkiv Symposium on Physics and Engineering of Microwaves, Millimeter and Submillimeter Waves•Nov 8, 2004•5 citations

Microwave detection using Josephson junction arrays integrated in a resonator

O.M. Ivanyuta, Oleksandr V. Prokopenko, V.M. Raksha +1 more

The possibilities and physical mechanisms of detection of microwave X- and Ka-band radiation by high-temperature superconducting (HTS) YBa2Cu3O7-0.05 (YBCO) bicrystalline Josephson junctions (JJ) embedded in a surface wave resonator (SWR) are considered. Microwave detection was investigated experimentally by using a linear Josephson junction array (JJA) embedded in the SWR. Measurements were carried out starting from the critical temperature of HTS film (T = 92 K), down to the liquid nitrogen level (T = 77 K) and beyond (down to 20 K) using the Gifford-McMahon closed-cycle cryo-cooler. The sensitivity of such type of detectors was determined to be approximately 104 V/W. (© 2005 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim)

Physica status solidi. C, Conferences and critical reviews/Physica status solidi. C, Current topics in solid state physics•Mar 1, 2005•9 citations

Tunable cryocooled nanooscillator

Yudina Olena, Oleksandr V. Prokopenko, O.M. Ivanyuta

The microwave surface wave resonator (SWR) made of high-temperature superconductor (HTS) is proposed as the base element of tunable cryocooled nanooscillators (NO) based on Josephson effect. The SWR with Josephson junction array (JJA) allows the parallel microwave and series do biasing for every junction in the array. By applying the external do current and external microwave power to the JJA we achieved the synchronous microwave radiation from the array with power near 14 nW (for NO with 10 Josephson junction). The frequency of the microwave radiation depend on do current and resonant frequency of the SWR; the radiation power depend on SWR Q-factor. This NO can be tuned by changing the resonant frequency of the SWR.

International Radar Symposium•May 1, 2008•0 citations

Millimetre-wave radiation from arrays of high- Josephson junctions

Gerhard Kunkel, Ronald H. Ono, Alexander M. Klushin

We have used a novel high-frequency circuit incorporating a resonant parallel-bias scheme to demonstrate millimetre-wave radiation from arrays of high-temperature superconductor Josephson junctions. The power of a five-junction array was measured with a detector junction on chip, and the Josephson oscillations of a ten-junction array were detected directly with a radiometer from 73 GHz to 123 GHz.

Superconductor Science and Technology•Apr 1, 1996•11 citations

Metrological Study of YBCO Josephson Junction Arrays Integrated in a Fabry-Perot Resonator

A. Sosso, Domenico Andreone, V. Lacquaniti +3 more

The application of high temperature superconductor Josephson junctions to voltage metrology is promising for many reasons, beyond the evident advantage of simplified cryogenics and reduced costs of the apparatus. Owing to their intrinsic non-hysteretic behavior, arrays of shunted bicrystal YBCO junctions are particularly interesting for the realization of an AC voltage standard with quantum accuracy. Moreover, shunted bicrystal YBCO junctions arrays are advantageous because of the reduced area of the junctions, the wide range of characteristic voltages, and large critical currents. However, some specific problems arise, like possible effects related to the higher operating temperature. Furthermore, fabrication technology sets tight constraints on the design of structures for the distribution of microwave currents along the array junctions. We investigated the step properties under millimeter wave irradiation at frequencies about 75 GHz of HTS junction and arrays prepared on bicrystal substrates having grain boundaries. High sensitivity techniques were adopted to evaluate the step flatness at nV level and assess the accuracy of the step voltage. A new method that makes use of an open resonator, was implemented to irradiate the array, providing synchronization of a large number of junctions.

IEEE Transactions on Applied Superconductivity•Jun 1, 2007•9 citations

Towards Continuously Tunable Superconductor Terahertz Range Local Oscillators based on JJ Arrays

Fedor V. Khan, Lyudmila V. Filippenko, Maria A. Markina +3 more

Superconductor terahertz oscillators based on Josephson junction arrays have attracted scientific interest for many decades. We recently reported an array with a new topology, in which the junctions are connected in series and embedded into the central electrode of a coplanar line, that operates successfully at frequencies up to 700 GHz. Here we continue this work and report on our efforts to achieve higher radiation power and higher frequencies using junctions with a higher critical current density. We have achieved an operating frequency above 700 GHz with a maximum power exceeding 0.6μW, which is sufficient for the operation of integrated SIS mixer. However, we found that as the critical current density increased, the operating frequency range narrowed because of synchronization problems accompanied by a rise in the noise level. Calculations within the RLCSJ model show that, at certain operating points on the current–voltage characteristic of a shunted Josephson junction, subharmonics of the fundamental frequencyf = 2eV/hwith very broad spectra emerge; these may be responsible for desynchronizing the junctions in the array. Possible ways of mitigating these effects are discussed.

IEEE Transactions on Terahertz Science and Technology•Jan 1, 2026•0 citations
Josephson junction (JJ) arrays can be used as a basis for the creation of different microminiature devices, such as tunable Josephson generators, primary voltage standards, detectors of radiation, etc. However the using of JJ arrays entails a problem of its synchronous operation. One of the solutions of this problem is using the surface wave resonators (SWR). The aim of our work is the detection of Josephson generation of an array of synchronized high-temperature superconductor (HTS) JJ embedded in the SWR.
The new type of surface wave resonator (SWR) consists of HTS film on a dielectric substrate is developed. A possibility of optimal coupling between the electromagnetic field of the SWR and the HTS Josephson junction array is shown; The topologies for embedding the bicrystal HTS Josephson junctions in the SWR are developed. These topology ensure the junction synchronization, that can be used for creation voltage standards, microwave detectors and Josephson generators and so on; The microwave properties of the SWR with HTS Josephson junction arrays (up to 450 junctions) and nonlinear elements based on Shottky-barrier diodes have been investigated. For the array with 450 HTS Josephson junctions the voltage sequence with 10 mV step has been obtained, sensitivity of the detector based on this array is 0.1 A/W with dynamic range 10/sup 2/ dB; The Josephson generation with microwave power at several nW for the SWR with bicrystal HTS JJs is detected. There were two groups of junctions. These groups are formed at the time of fabrication due to imperfection of HTS junction fabrication technology.
The possibilities and physical mechanisms of detection of microwave X- and Ka-band radiation by high-temperature superconducting (HTS) YBa2Cu3O7-0.05 (YBCO) bicrystalline Josephson junctions (JJ) embedded in a surface wave resonator (SWR) are considered. Microwave detection was investigated experimentally by using a linear Josephson junction array (JJA) embedded in the SWR. Measurements were carried out starting from the critical temperature of HTS film (T = 92 K), down to the liquid nitrogen level (T = 77 K) and beyond (down to 20 K) using the Gifford-McMahon closed-cycle cryo-cooler. The sensitivity of such type of detectors was determined to be approximately 104 V/W. (© 2005 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim)
The microwave surface wave resonator (SWR) made of high-temperature superconductor (HTS) is proposed as the base element of tunable cryocooled nanooscillators (NO) based on Josephson effect. The SWR with Josephson junction array (JJA) allows the parallel microwave and series do biasing for every junction in the array. By applying the external do current and external microwave power to the JJA we achieved the synchronous microwave radiation from the array with power near 14 nW (for NO with 10 Josephson junction). The frequency of the microwave radiation depend on do current and resonant frequency of the SWR; the radiation power depend on SWR Q-factor. This NO can be tuned by changing the resonant frequency of the SWR.
The application of high temperature superconductor Josephson junctions to voltage metrology is promising for many reasons, beyond the evident advantage of simplified cryogenics and reduced costs of the apparatus. Owing to their intrinsic non-hysteretic behavior, arrays of shunted bicrystal YBCO junctions are particularly interesting for the realization of an AC voltage standard with quantum accuracy. Moreover, shunted bicrystal YBCO junctions arrays are advantageous because of the reduced area of the junctions, the wide range of characteristic voltages, and large critical currents. However, some specific problems arise, like possible effects related to the higher operating temperature. Furthermore, fabrication technology sets tight constraints on the design of structures for the distribution of microwave currents along the array junctions. We investigated the step properties under millimeter wave irradiation at frequencies about 75 GHz of HTS junction and arrays prepared on bicrystal substrates having grain boundaries. High sensitivity techniques were adopted to evaluate the step flatness at nV level and assess the accuracy of the step voltage. A new method that makes use of an open resonator, was implemented to irradiate the array, providing synchronization of a large number of junctions.
Superconductor terahertz oscillators based on Josephson junction arrays have attracted scientific interest for many decades. We recently reported an array with a new topology, in which the junctions are connected in series and embedded into the central electrode of a coplanar line, that operates successfully at frequencies up to 700 GHz. Here we continue this work and report on our efforts to achieve higher radiation power and higher frequencies using junctions with a higher critical current density. We have achieved an operating frequency above 700 GHz with a maximum power exceeding 0.6μW, which is sufficient for the operation of integrated SIS mixer. However, we found that as the critical current density increased, the operating frequency range narrowed because of synchronization problems accompanied by a rise in the noise level. Calculations within the RLCSJ model show that, at certain operating points on the current–voltage characteristic of a shunted Josephson junction, subharmonics of the fundamental frequencyf = 2eV/hwith very broad spectra emerge; these may be responsible for desynchronizing the junctions in the array. Possible ways of mitigating these effects are discussed.