Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Nano-optical studies of superconducting nanowire single-photon detectors

Robert H. Hadfield, Paul A. Dalgarno, John A. O’Connor, E. Ramsay, Richard John Warburton, Eric J. Gansen, Burm Baek, Martin J. Stevens, Richard P. Mirin, Sae Woo Nam

Published Dec 2, 2008• 2 citations
Publisher

Abstract

We report on the photoresponse mapping of nanowire superconducting single-photon detectors using a focal spot significantly smaller than the device area (10 μm x 10 μm). Using a solid immersion lens we achieve a spot size of 320 nm full-width half maximum onto the device at 470 nm wavelength. We compare the response maps of two devices: the higher detection efficiency device gives a uniform response whereas the lower detection efficiency device is limited by a single defect or constriction. A second optical setup is used to simultaneously image and measure the photoresponse of the lower detection efficiency device, allowing the constriction location to be pinpointed.

DOI
10.1117/12.819360

Related papers

Submicrometer photoresponse mapping of nanowire superconducting single-photon detectors

Robert H. Hadfield, Paul A. Dalgarno, John A. O’Connor +7 more

We report on the photoresponse mapping of nanowire superconducting single-photon detectors using a focal spot significantly smaller than the device area (10×10μm2). Using a confocal microscope configuration and solid immersion lens, we achieve a spot size of 320nm full width at half maximum onto the device at 470nm wavelength. We compare the response maps of two devices: The higher detection efficiency device gives a uniform response, whereas the lower detection efficiency device is limited by a single defect or constriction.

Applied Physics Letters•Dec 10, 2007•34 citations

Nano-optical photoresponse mapping of superconducting nanowires with enhanced near infrared absorption

Kleanthis Erotokritou, Robert M. Heath, Gregor G. Taylor +7 more

Superconducting nanowire single-photon detectors (SNSPDs) play an important role in emerging optical quantum technologies. We report on advanced nanometric characterization of a high efficiency near infrared SNSPD design based on a low roughness tantalum pentoxide (Ta 2 O 5 )/silicon dioxide (SiO 2 ) distributed Bragg reflector (DBR) cavity structure. We have performed high resolution transmission electron microscopy analysis to verify the smoothness of the DBR. Optical reflectance measurements show excellent correspondence with DBR simulations. We have carried out precision nano-optical photoresponse mapping studies at 940 nm wavelength at T = 3.5 K, indicating excellent large area device uniformity (peak efficiency 55% at 100 Hz dark count rate (DCR)) with a full width half maximum timing jitter of 60 ps. With manual fibre coupling with single mode fibre, we achieve a system detection efficiency (SDE) of 57.5% at 940 nm wavelength (100 Hz DCR) at T = 2.3 K and a low polarization dependence of 1.20 ± 0.03. For coupling with multimode fibre, we achieve SDE of 90% at 940 nm (200 Hz DCR) at T = 2.3 K. These SNSPD devices are promising candidates for use in quantum dot photoluminescence studies and optical quantum technology applications.

Superconductor Science and Technology•Sep 27, 2018•12 citations

Single-Photon Detectors Based on Ultranarrow Superconducting Nanowires

Francesco Marsili, Faraz Najafi, Eric A. Dauler +5 more

We report efficient single-photon detection (η = 20% at 1550 nm wavelength) with ultranarrow (20 and 30 nm wide) superconducting nanowires, which were shown to be more robust to constrictions and more responsive to 1550 nm wavelength photons than standard superconducting nanowire single-photon detectors, based on 90 nm wide nanowires. We also improved our understanding of the physics of superconducting nanowire avalanche photodetectors, which we used to increase the signal-to-noise ratio of ultranarrow-nanowire detectors by a factor of 4, thus relaxing the requirements on the read-out circuitry and making the devices suitable for a broader range of applications.

arXiv:1012.4149•Nano Letters•Apr 1, 2011•193 citations

Efficient Single Photon Detection from 500 nm to 5 μm Wavelength

Francesco Marsili, Francesco Bellei, Faraz Najafi +4 more

We report on superconducting nanowire single photon detectors (SNSPDs) based on 30 nm wide nanowires with detection efficiency η ∼ 2.6-5.5% in the wavelength range λ = 0.5-5 μm. We compared the sensitivity of 30 nm wide SNSPDs with the sensitivity of SNSPDs based on wider (85 and 50 nm wide) nanowires for λ = 0.5-5 μm. The detection efficiency of the detectors based on the wider nanowires became negligible at shorter wavelengths than the 30 nm wide SNSPDs. Our 30 nm wide SNSPDs showed 2 orders of magnitude higher detection efficiency (η ∼ 2%) up to longer wavelength (λ = 5 μm) than previously reported. On the basis of our simulations, we expect that by changing the optical coupling scheme and by integrating the detectors in an optical cavity, the detection efficiency of our detectors could be increased by a factor of ∼6.

Nano Letters•Aug 13, 2012•196 citations

Constriction-limited detection efficiency of superconducting nanowire single-photon detectors

Andrew J. Kerman, Eric A. Dauler, Joel K. W. Yang +5 more

We investigate the source of the large variations in the observed detection efficiencies of superconducting nanowire single-photon detectors between many nominally identical devices. Through both electrical and optical measurements, we infer that these variations arise from “constrictions:” highly localized regions of the nanowires where the effective cross-sectional area for superconducting current is reduced. These constrictions limit the bias-current density to well below its critical value over the remainder of the wire, and thus prevent the detection efficiency from reaching the high values that occur in these devices when they are biased near the critical current density.

arXiv:physics/0611260•Applied Physics Letters•Mar 5, 2007•214 citations

Superconducting nanowire single-photon imager

Qingyuan Zhao, Francesco Bellei, Di Zhu +6 more

Detecting spatial and temporal information of individual photons is a crucial technology in today's quantum information science. Among the existing single-photon detectors, superconducting nanowire single-photon detectors (SNSPDs) have been demonstrated with a sub-50 ps timing jitter, near unity detection efficiency1, wide response spectrum from visible to infrared and ~10 ns reset time. However, to gain spatial sensitivity, multiple SNSPDs have to be integrated into an array, whose spatial and temporal resolutions are limited by the multiplexing circuit. Here, we add spatial sensitivity to a single nanowire while preserving the temporal resolution from an SNSPD, thereby turning an SNSPD into a superconducting nanowire single-photon imager (SNSPI). To achieve an SNSPI, we modify a nanowire's electrical behavior from a lumped inductor to a transmission line, where the signal velocity is slowed down to 0.02c (where c is the speed of light). Consequently, we are able to simultaneously read out the landing locations and arrival times of the photons from the output electrical pulses using only two connections. We have demonstrated single-photon imaging by using a 19.7 mm long SNSPI, which is meandered into an imaging area of 286 {\mu}m*193 {\mu}m. The nanowire has a temporal resolution of 50 ps for detecting 1.5 {\mu}m photons. The 2D spatial resolution is 13.0 {\mu}m in the vertical direction and 5.6 {\mu}m in the horizontal direction. The maximum number of resolvable locations (i.e., the effective number of pixels) in such a long nanowire is calculated to be 590. Rather than operating an individual detector in a scanning mode or using SPD arrays, this SNSPI gives an alternative approach to taking large-scale single-photon images and measuring temporal and spatial correlation.

•May 27, 2016•0 citations
We report on the photoresponse mapping of nanowire superconducting single-photon detectors using a focal spot significantly smaller than the device area (10 μm x 10 μm). Using a solid immersion lens we achieve a spot size of 320 nm full-width half maximum onto the device at 470 nm wavelength. We compare the response maps of two devices: the higher detection efficiency device gives a uniform response whereas the lower detection efficiency device is limited by a single defect or constriction. A second optical setup is used to simultaneously image and measure the photoresponse of the lower detection efficiency device, allowing the constriction location to be pinpointed.
We report on the photoresponse mapping of nanowire superconducting single-photon detectors using a focal spot significantly smaller than the device area (10×10μm2). Using a confocal microscope configuration and solid immersion lens, we achieve a spot size of 320nm full width at half maximum onto the device at 470nm wavelength. We compare the response maps of two devices: The higher detection efficiency device gives a uniform response, whereas the lower detection efficiency device is limited by a single defect or constriction.
Superconducting nanowire single-photon detectors (SNSPDs) play an important role in emerging optical quantum technologies. We report on advanced nanometric characterization of a high efficiency near infrared SNSPD design based on a low roughness tantalum pentoxide (Ta 2 O 5 )/silicon dioxide (SiO 2 ) distributed Bragg reflector (DBR) cavity structure. We have performed high resolution transmission electron microscopy analysis to verify the smoothness of the DBR. Optical reflectance measurements show excellent correspondence with DBR simulations. We have carried out precision nano-optical photoresponse mapping studies at 940 nm wavelength at T = 3.5 K, indicating excellent large area device uniformity (peak efficiency 55% at 100 Hz dark count rate (DCR)) with a full width half maximum timing jitter of 60 ps. With manual fibre coupling with single mode fibre, we achieve a system detection efficiency (SDE) of 57.5% at 940 nm wavelength (100 Hz DCR) at T = 2.3 K and a low polarization dependence of 1.20 ± 0.03. For coupling with multimode fibre, we achieve SDE of 90% at 940 nm (200 Hz DCR) at T = 2.3 K. These SNSPD devices are promising candidates for use in quantum dot photoluminescence studies and optical quantum technology applications.
We report efficient single-photon detection (η = 20% at 1550 nm wavelength) with ultranarrow (20 and 30 nm wide) superconducting nanowires, which were shown to be more robust to constrictions and more responsive to 1550 nm wavelength photons than standard superconducting nanowire single-photon detectors, based on 90 nm wide nanowires. We also improved our understanding of the physics of superconducting nanowire avalanche photodetectors, which we used to increase the signal-to-noise ratio of ultranarrow-nanowire detectors by a factor of 4, thus relaxing the requirements on the read-out circuitry and making the devices suitable for a broader range of applications.
We report on superconducting nanowire single photon detectors (SNSPDs) based on 30 nm wide nanowires with detection efficiency η ∼ 2.6-5.5% in the wavelength range λ = 0.5-5 μm. We compared the sensitivity of 30 nm wide SNSPDs with the sensitivity of SNSPDs based on wider (85 and 50 nm wide) nanowires for λ = 0.5-5 μm. The detection efficiency of the detectors based on the wider nanowires became negligible at shorter wavelengths than the 30 nm wide SNSPDs. Our 30 nm wide SNSPDs showed 2 orders of magnitude higher detection efficiency (η ∼ 2%) up to longer wavelength (λ = 5 μm) than previously reported. On the basis of our simulations, we expect that by changing the optical coupling scheme and by integrating the detectors in an optical cavity, the detection efficiency of our detectors could be increased by a factor of ∼6.
We investigate the source of the large variations in the observed detection efficiencies of superconducting nanowire single-photon detectors between many nominally identical devices. Through both electrical and optical measurements, we infer that these variations arise from “constrictions:” highly localized regions of the nanowires where the effective cross-sectional area for superconducting current is reduced. These constrictions limit the bias-current density to well below its critical value over the remainder of the wire, and thus prevent the detection efficiency from reaching the high values that occur in these devices when they are biased near the critical current density.
Detecting spatial and temporal information of individual photons is a crucial technology in today's quantum information science. Among the existing single-photon detectors, superconducting nanowire single-photon detectors (SNSPDs) have been demonstrated with a sub-50 ps timing jitter, near unity detection efficiency1, wide response spectrum from visible to infrared and ~10 ns reset time. However, to gain spatial sensitivity, multiple SNSPDs have to be integrated into an array, whose spatial and temporal resolutions are limited by the multiplexing circuit. Here, we add spatial sensitivity to a single nanowire while preserving the temporal resolution from an SNSPD, thereby turning an SNSPD into a superconducting nanowire single-photon imager (SNSPI). To achieve an SNSPI, we modify a nanowire's electrical behavior from a lumped inductor to a transmission line, where the signal velocity is slowed down to 0.02c (where c is the speed of light). Consequently, we are able to simultaneously read out the landing locations and arrival times of the photons from the output electrical pulses using only two connections. We have demonstrated single-photon imaging by using a 19.7 mm long SNSPI, which is meandered into an imaging area of 286 {\mu}m*193 {\mu}m. The nanowire has a temporal resolution of 50 ps for detecting 1.5 {\mu}m photons. The 2D spatial resolution is 13.0 {\mu}m in the vertical direction and 5.6 {\mu}m in the horizontal direction. The maximum number of resolvable locations (i.e., the effective number of pixels) in such a long nanowire is calculated to be 590. Rather than operating an individual detector in a scanning mode or using SPD arrays, this SNSPI gives an alternative approach to taking large-scale single-photon images and measuring temporal and spatial correlation.