Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Submicrometer photoresponse mapping of nanowire superconducting single-photon detectors

Robert H. Hadfield, Paul A. Dalgarno, John A. O’Connor, E. Ramsay, Richard John Warburton, Eric J. Gansen, Burm Baek, Martin J. Stevens, Richard P. Mirin, Sae Woo Nam

Published Dec 10, 2007• 34 citations
Publisher

Abstract

We report on the photoresponse mapping of nanowire superconducting single-photon detectors using a focal spot significantly smaller than the device area (10×10μm2). Using a confocal microscope configuration and solid immersion lens, we achieve a spot size of 320nm full width at half maximum onto the device at 470nm wavelength. We compare the response maps of two devices: The higher detection efficiency device gives a uniform response, whereas the lower detection efficiency device is limited by a single defect or constriction.

DOI
10.1063/1.2824384

Related papers

Nano-optical studies of superconducting nanowire single-photon detectors

Robert H. Hadfield, Paul A. Dalgarno, John A. O’Connor +7 more

We report on the photoresponse mapping of nanowire superconducting single-photon detectors using a focal spot significantly smaller than the device area (10 μm x 10 μm). Using a solid immersion lens we achieve a spot size of 320 nm full-width half maximum onto the device at 470 nm wavelength. We compare the response maps of two devices: the higher detection efficiency device gives a uniform response whereas the lower detection efficiency device is limited by a single defect or constriction. A second optical setup is used to simultaneously image and measure the photoresponse of the lower detection efficiency device, allowing the constriction location to be pinpointed.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Dec 2, 2008•2 citations

Nano-optical photoresponse mapping of superconducting nanowires with enhanced near infrared absorption

Kleanthis Erotokritou, Robert M. Heath, Gregor G. Taylor +7 more

Superconducting nanowire single-photon detectors (SNSPDs) play an important role in emerging optical quantum technologies. We report on advanced nanometric characterization of a high efficiency near infrared SNSPD design based on a low roughness tantalum pentoxide (Ta 2 O 5 )/silicon dioxide (SiO 2 ) distributed Bragg reflector (DBR) cavity structure. We have performed high resolution transmission electron microscopy analysis to verify the smoothness of the DBR. Optical reflectance measurements show excellent correspondence with DBR simulations. We have carried out precision nano-optical photoresponse mapping studies at 940 nm wavelength at T = 3.5 K, indicating excellent large area device uniformity (peak efficiency 55% at 100 Hz dark count rate (DCR)) with a full width half maximum timing jitter of 60 ps. With manual fibre coupling with single mode fibre, we achieve a system detection efficiency (SDE) of 57.5% at 940 nm wavelength (100 Hz DCR) at T = 2.3 K and a low polarization dependence of 1.20 ± 0.03. For coupling with multimode fibre, we achieve SDE of 90% at 940 nm (200 Hz DCR) at T = 2.3 K. These SNSPD devices are promising candidates for use in quantum dot photoluminescence studies and optical quantum technology applications.

Superconductor Science and Technology•Sep 27, 2018•12 citations

Constriction-limited detection efficiency of superconducting nanowire single-photon detectors

Andrew J. Kerman, Eric A. Dauler, Joel K. W. Yang +5 more

We investigate the source of the large variations in the observed detection efficiencies of superconducting nanowire single-photon detectors between many nominally identical devices. Through both electrical and optical measurements, we infer that these variations arise from “constrictions:” highly localized regions of the nanowires where the effective cross-sectional area for superconducting current is reduced. These constrictions limit the bias-current density to well below its critical value over the remainder of the wire, and thus prevent the detection efficiency from reaching the high values that occur in these devices when they are biased near the critical current density.

arXiv:physics/0611260•Applied Physics Letters•Mar 5, 2007•214 citations

Single-Photon Detectors Based on Ultranarrow Superconducting Nanowires

Francesco Marsili, Faraz Najafi, Eric A. Dauler +5 more

We report efficient single-photon detection (η = 20% at 1550 nm wavelength) with ultranarrow (20 and 30 nm wide) superconducting nanowires, which were shown to be more robust to constrictions and more responsive to 1550 nm wavelength photons than standard superconducting nanowire single-photon detectors, based on 90 nm wide nanowires. We also improved our understanding of the physics of superconducting nanowire avalanche photodetectors, which we used to increase the signal-to-noise ratio of ultranarrow-nanowire detectors by a factor of 4, thus relaxing the requirements on the read-out circuitry and making the devices suitable for a broader range of applications.

arXiv:1012.4149•Nano Letters•Apr 1, 2011•193 citations

Spatial dependence of output pulse delay in a niobium nitride nanowire superconducting single-photon detector

John A. O’Connor, Michael G. Tanner, Chandra M. Natarajan +6 more

We report on the position-dependent variation in output pulse timing across a superconducting single-photon detector. Our device consists of a single niobium nitride nanowire meander (100 nm width, 4 nm film thickness, 2 mm length). We use a confocal microscope configuration (full width at half maximum-spot size 1.3 μm at 1550 nm wavelength) and a femtosecond laser to study local variations in detection efficiency and output pulse timing. Pulse delays of up to 50 ps across the device correlate to local detection efficiency and resistance variations. This study indicates an underlying mechanism for timing jitter in superconducting nanowire devices.

Applied Physics Letters•May 16, 2011•37 citations

Nano-optical studies of superconducting nanowire devices for single-photon detection

Robert M. Heath

Superconducting nanowire single photon detectors (SNSPDs) are a rapidly maturing detector technology that offer superior performance relative to competing infrared photon counting technologies. The original experimental work presented here explores three novel methods of improving and analysing detector characteristics, employing low-temperature piezoelectric motors at temperatures below 4 K in a closed-cycle cryostat. Utilizing the low-temperature piezoelectric nanopositioners in tandem with a miniature confocal microscope, this work specifically shows a spatially-separable parallel-wire SNSPD demonstrating one- and two-pixel photon discrimination, with the detector responding more quickly when triggering two pixels. The work demonstrates nanoantenna-coupled SNSPDs, which are simulated, designed, and tested using the same nano-optical setup. In these an increased local absorption into the nanowire is seen at the antennas' resonant wavelengths, enhancing the efficiency of the detector by up to 130 %. Finally, a modified optical setup using a distributed Bragg reflector fibre in place of the microscope to form a tunable cavity around two configurations of SNSPD is demonstrated, improving absorption of the incident light into the nanowire across the whole active area. For these, enhancement in the system detection efficiency of up to 40 % is seen.

•Jan 1, 2015•1 citation
We report on the photoresponse mapping of nanowire superconducting single-photon detectors using a focal spot significantly smaller than the device area (10×10μm2). Using a confocal microscope configuration and solid immersion lens, we achieve a spot size of 320nm full width at half maximum onto the device at 470nm wavelength. We compare the response maps of two devices: The higher detection efficiency device gives a uniform response, whereas the lower detection efficiency device is limited by a single defect or constriction.
We report on the photoresponse mapping of nanowire superconducting single-photon detectors using a focal spot significantly smaller than the device area (10 μm x 10 μm). Using a solid immersion lens we achieve a spot size of 320 nm full-width half maximum onto the device at 470 nm wavelength. We compare the response maps of two devices: the higher detection efficiency device gives a uniform response whereas the lower detection efficiency device is limited by a single defect or constriction. A second optical setup is used to simultaneously image and measure the photoresponse of the lower detection efficiency device, allowing the constriction location to be pinpointed.
Superconducting nanowire single-photon detectors (SNSPDs) play an important role in emerging optical quantum technologies. We report on advanced nanometric characterization of a high efficiency near infrared SNSPD design based on a low roughness tantalum pentoxide (Ta 2 O 5 )/silicon dioxide (SiO 2 ) distributed Bragg reflector (DBR) cavity structure. We have performed high resolution transmission electron microscopy analysis to verify the smoothness of the DBR. Optical reflectance measurements show excellent correspondence with DBR simulations. We have carried out precision nano-optical photoresponse mapping studies at 940 nm wavelength at T = 3.5 K, indicating excellent large area device uniformity (peak efficiency 55% at 100 Hz dark count rate (DCR)) with a full width half maximum timing jitter of 60 ps. With manual fibre coupling with single mode fibre, we achieve a system detection efficiency (SDE) of 57.5% at 940 nm wavelength (100 Hz DCR) at T = 2.3 K and a low polarization dependence of 1.20 ± 0.03. For coupling with multimode fibre, we achieve SDE of 90% at 940 nm (200 Hz DCR) at T = 2.3 K. These SNSPD devices are promising candidates for use in quantum dot photoluminescence studies and optical quantum technology applications.
We investigate the source of the large variations in the observed detection efficiencies of superconducting nanowire single-photon detectors between many nominally identical devices. Through both electrical and optical measurements, we infer that these variations arise from “constrictions:” highly localized regions of the nanowires where the effective cross-sectional area for superconducting current is reduced. These constrictions limit the bias-current density to well below its critical value over the remainder of the wire, and thus prevent the detection efficiency from reaching the high values that occur in these devices when they are biased near the critical current density.
We report efficient single-photon detection (η = 20% at 1550 nm wavelength) with ultranarrow (20 and 30 nm wide) superconducting nanowires, which were shown to be more robust to constrictions and more responsive to 1550 nm wavelength photons than standard superconducting nanowire single-photon detectors, based on 90 nm wide nanowires. We also improved our understanding of the physics of superconducting nanowire avalanche photodetectors, which we used to increase the signal-to-noise ratio of ultranarrow-nanowire detectors by a factor of 4, thus relaxing the requirements on the read-out circuitry and making the devices suitable for a broader range of applications.
We report on the position-dependent variation in output pulse timing across a superconducting single-photon detector. Our device consists of a single niobium nitride nanowire meander (100 nm width, 4 nm film thickness, 2 mm length). We use a confocal microscope configuration (full width at half maximum-spot size 1.3 μm at 1550 nm wavelength) and a femtosecond laser to study local variations in detection efficiency and output pulse timing. Pulse delays of up to 50 ps across the device correlate to local detection efficiency and resistance variations. This study indicates an underlying mechanism for timing jitter in superconducting nanowire devices.
Superconducting nanowire single photon detectors (SNSPDs) are a rapidly maturing detector technology that offer superior performance relative to competing infrared photon counting technologies. The original experimental work presented here explores three novel methods of improving and analysing detector characteristics, employing low-temperature piezoelectric motors at temperatures below 4 K in a closed-cycle cryostat. Utilizing the low-temperature piezoelectric nanopositioners in tandem with a miniature confocal microscope, this work specifically shows a spatially-separable parallel-wire SNSPD demonstrating one- and two-pixel photon discrimination, with the detector responding more quickly when triggering two pixels. The work demonstrates nanoantenna-coupled SNSPDs, which are simulated, designed, and tested using the same nano-optical setup. In these an increased local absorption into the nanowire is seen at the antennas' resonant wavelengths, enhancing the efficiency of the detector by up to 130 %. Finally, a modified optical setup using a distributed Bragg reflector fibre in place of the microscope to form a tunable cavity around two configurations of SNSPD is demonstrated, improving absorption of the incident light into the nanowire across the whole active area. For these, enhancement in the system detection efficiency of up to 40 % is seen.