Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

Semiclassical model of semiconductor laser noise and amplitude noise squeezing. II. Application to complex laser structures

J.-L. Vey, Philippe B. Gallion

Published Jan 1, 1997• 9 citations
Publisher

Abstract

For pt.I see ibid., vol.33, no.11, p.2097-2104 (1997). We present noise studies of distributed feedback (DFB) laser structures, where spatial hole burning (SHB) plays a key role performed using the model described in part I of this paper with particular emphasis on the influence of SHB, on the coupling coefficient /spl kappa/L, and on the laser facet reflectivities. These structures exhibit high amplitude noise and the possible noise reduction is strongly reduced compared to Fabry-Perot structures. Distributed Bragg reflector (DBR) lasers are better candidates even if their performances are also strictly determined by SHB and the loss in the Bragg reflector. Finally, limitations due to gain suppression are demonstrated for such complex lasers structures. We conclude on the optimum laser structure for amplitude squeezed states generation.

DOI
10.1109/3.641326

Related papers

Semiclassical model of semiconductor laser noise and amplitude noise squeezing. I. Description and application to Fabry-Perot laser

J.-L. Vey, Philippe B. Gallion

A semiclassical model of semiconductor laser noise, based on the Green's function method, is used to derive analytical formulas for the amplitude and frequency noise spectra taking into account incoming vacuum fluctuations and noise due to internal loss. This formalism also takes into account phenomena such as gain suppression as well as spatial hole burning (SHB). The amplitude noise squeezing is studied for Fabry-Perot structures pointing out the influence of the laser structural parameters. A complete agreement with already existing quantum mechanical models is found. However, extension of the model to SHB induces limitations in the squeezing performances, which are very important for more complex structures as will be pointed out in detail, in Part II.

IEEE Journal of Quantum Electronics•Jan 1, 1997•22 citations

Room temperature generation of amplitude squeezed light from 1550 nm distributed feedback semiconductor laser

Francine Jérémie, C. Chabran, Philippe B. Gallion

The control of the quantum state of light has recently been studied extensively, aiming at the achievement of ultra-low noise below the shot noise limit. Several experiments showed that amplitude squeezing could be achieved in constant-current-driven semiconductor lasers. However, the generation of amplitude-squeezed light from distributed feedback semiconductor lasers (DFB) has been up to now considerably less successful than that from Fabry-Perot devices. Simulations indicate that DFB structures with high coupling coefficient length product kL are unlikely to be good sources of squeezed light, because of the evanescence of the optical fields along the grating [1]. They also show, that for low kL values the lowest achievable intensity noise depends on the structure of the laser diode and can be higher than expected from the laser quantum efficiency alone.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jan 1, 1998•0 citations

Semiclassical description of noise and generation of amplitude squeezed states with vertical cavity surface-emitting semiconductor lasers

Jean-Luc C. Vey, Wolfgang Elsäßer

Theoretical investigations of the generation of light with sub-shot-noise intensity fluctuations by vertical cavity surface-emitting lasers are performed with a semiclassical model. From these results we conclude that, because of their dimensions and structure, vertical cavity surface-emitting lasers are promising candidates for generation of amplitude squeezed states. Finally, the influence of internal loss, distributed reflection coefficients, and gain suppression is emphasized and discussed.

Journal of the Optical Society of America B•Jun 1, 1997•11 citations

Modeling of intensity noise including squeezing in DFB and Fabry-Perot semiconductor laser diodes

D.D. Marcenac, J.E. Carroll

A new time-domain model using the quantum formalism of the positive-P distribution is used to investigate squeezing in laser diodes, taking into account longitudinal hole burning and distributed noise sources, under steady-state and large-signal modulation. Simulations indicate that the laser structure determines the lowest achievable intensity noise. With losses present or power escaping from the rear facet, this minimum noise may be much higher than expected from the device quantum efficiency. Squeezing appears more difficult in DFB lasers than in Fabry-Perot lasers in our simulations. Mode-partition noise is removed by low-loss passive DBR sections, and such laser diodes are promising sources with low-intensity noise. Intensity noise in the large-signal dynamic regime is also simulated, showing that intensity-squeezed light output is possible.>

IEEE Journal of Quantum Electronics•Jan 1, 1994•25 citations

Amplitude squeezing from spectral-hole burning: A semiclassical theory

Jacques Arnaud

Spectral-hole burning (SHB) profoundly affects the modulation and noise properties of laser oscillators and amplifiers at high optical power. The present semiclassical theory of SHB shows that the optical gain should be considered a function of the carrier number and photon rate (rather than photon number) plus a fluctuation at the shot-noise level (for full population inversion). Constant-voltage-driven laser diodes generate amplitude-squeezed light, a result not predicted by previous theories that treat gain compression in a formal way. Amplitude and phase noise of oscillators and amplifiers are considered.

Physical Review A•Sep 1, 1993•11 citations

Amplitude squeezing with a Fabry–Perot semiconductor laser: existence of an optimum biasing condition

J.-L. Vey, Philippe B. Gallion

The effect of gain suppression on amplitude squeezing with a Fabry-Perot semiconductor laser is studied with a semiclassical model. A strong decrease of the internal amplitude noise and an optimum biasing point with minimum amplitude noise are demonstrated. Small gain nonlinearities improve external compression.

Optics Letters•Oct 1, 1995•11 citations
For pt.I see ibid., vol.33, no.11, p.2097-2104 (1997). We present noise studies of distributed feedback (DFB) laser structures, where spatial hole burning (SHB) plays a key role performed using the model described in part I of this paper with particular emphasis on the influence of SHB, on the coupling coefficient /spl kappa/L, and on the laser facet reflectivities. These structures exhibit high amplitude noise and the possible noise reduction is strongly reduced compared to Fabry-Perot structures. Distributed Bragg reflector (DBR) lasers are better candidates even if their performances are also strictly determined by SHB and the loss in the Bragg reflector. Finally, limitations due to gain suppression are demonstrated for such complex lasers structures. We conclude on the optimum laser structure for amplitude squeezed states generation.
A semiclassical model of semiconductor laser noise, based on the Green's function method, is used to derive analytical formulas for the amplitude and frequency noise spectra taking into account incoming vacuum fluctuations and noise due to internal loss. This formalism also takes into account phenomena such as gain suppression as well as spatial hole burning (SHB). The amplitude noise squeezing is studied for Fabry-Perot structures pointing out the influence of the laser structural parameters. A complete agreement with already existing quantum mechanical models is found. However, extension of the model to SHB induces limitations in the squeezing performances, which are very important for more complex structures as will be pointed out in detail, in Part II.
The control of the quantum state of light has recently been studied extensively, aiming at the achievement of ultra-low noise below the shot noise limit. Several experiments showed that amplitude squeezing could be achieved in constant-current-driven semiconductor lasers. However, the generation of amplitude-squeezed light from distributed feedback semiconductor lasers (DFB) has been up to now considerably less successful than that from Fabry-Perot devices. Simulations indicate that DFB structures with high coupling coefficient length product kL are unlikely to be good sources of squeezed light, because of the evanescence of the optical fields along the grating [1]. They also show, that for low kL values the lowest achievable intensity noise depends on the structure of the laser diode and can be higher than expected from the laser quantum efficiency alone.
A new time-domain model using the quantum formalism of the positive-P distribution is used to investigate squeezing in laser diodes, taking into account longitudinal hole burning and distributed noise sources, under steady-state and large-signal modulation. Simulations indicate that the laser structure determines the lowest achievable intensity noise. With losses present or power escaping from the rear facet, this minimum noise may be much higher than expected from the device quantum efficiency. Squeezing appears more difficult in DFB lasers than in Fabry-Perot lasers in our simulations. Mode-partition noise is removed by low-loss passive DBR sections, and such laser diodes are promising sources with low-intensity noise. Intensity noise in the large-signal dynamic regime is also simulated, showing that intensity-squeezed light output is possible.>
Spectral-hole burning (SHB) profoundly affects the modulation and noise properties of laser oscillators and amplifiers at high optical power. The present semiclassical theory of SHB shows that the optical gain should be considered a function of the carrier number and photon rate (rather than photon number) plus a fluctuation at the shot-noise level (for full population inversion). Constant-voltage-driven laser diodes generate amplitude-squeezed light, a result not predicted by previous theories that treat gain compression in a formal way. Amplitude and phase noise of oscillators and amplifiers are considered.