Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

Modeling of intensity noise including squeezing in DFB and Fabry-Perot semiconductor laser diodes

D.D. Marcenac, J.E. Carroll

Published Jan 1, 1994• 25 citations
Publisher

Abstract

A new time-domain model using the quantum formalism of the positive-P distribution is used to investigate squeezing in laser diodes, taking into account longitudinal hole burning and distributed noise sources, under steady-state and large-signal modulation. Simulations indicate that the laser structure determines the lowest achievable intensity noise. With losses present or power escaping from the rear facet, this minimum noise may be much higher than expected from the device quantum efficiency. Squeezing appears more difficult in DFB lasers than in Fabry-Perot lasers in our simulations. Mode-partition noise is removed by low-loss passive DBR sections, and such laser diodes are promising sources with low-intensity noise. Intensity noise in the large-signal dynamic regime is also simulated, showing that intensity-squeezed light output is possible.>

DOI
10.1109/3.309865

Related papers

Semiclassical model of semiconductor laser noise and amplitude noise squeezing. II. Application to complex laser structures

J.-L. Vey, Philippe B. Gallion

For pt.I see ibid., vol.33, no.11, p.2097-2104 (1997). We present noise studies of distributed feedback (DFB) laser structures, where spatial hole burning (SHB) plays a key role performed using the model described in part I of this paper with particular emphasis on the influence of SHB, on the coupling coefficient /spl kappa/L, and on the laser facet reflectivities. These structures exhibit high amplitude noise and the possible noise reduction is strongly reduced compared to Fabry-Perot structures. Distributed Bragg reflector (DBR) lasers are better candidates even if their performances are also strictly determined by SHB and the loss in the Bragg reflector. Finally, limitations due to gain suppression are demonstrated for such complex lasers structures. We conclude on the optimum laser structure for amplitude squeezed states generation.

IEEE Journal of Quantum Electronics•Jan 1, 1997•9 citations

Semiclassical model of semiconductor laser noise and amplitude noise squeezing. I. Description and application to Fabry-Perot laser

J.-L. Vey, Philippe B. Gallion

A semiclassical model of semiconductor laser noise, based on the Green's function method, is used to derive analytical formulas for the amplitude and frequency noise spectra taking into account incoming vacuum fluctuations and noise due to internal loss. This formalism also takes into account phenomena such as gain suppression as well as spatial hole burning (SHB). The amplitude noise squeezing is studied for Fabry-Perot structures pointing out the influence of the laser structural parameters. A complete agreement with already existing quantum mechanical models is found. However, extension of the model to SHB induces limitations in the squeezing performances, which are very important for more complex structures as will be pointed out in detail, in Part II.

IEEE Journal of Quantum Electronics•Jan 1, 1997•22 citations

Coexistence of thermal noise and squeezing in the intensity fluctuations of small laser diodes

Holger Friedrich Hofmann, Ortwin G. Hess

The intensity fluctuations of laser light are derived from photon number rate equations. In the limit of short times, the photon statistics for small laser devices such as typical semiconductor laser diodes show thermal characteristics, even above threshold. In the limit of long-time averages represented by the low-frequency component of the noise, the same devices exhibit squeezing. It is shown that squeezing and thermal noise can coexist in the multimode output field of laser diodes. This result implies that the squeezed light generated by regularly pumped semiconductor laser diodes is qualitatively different from single-mode squeezed light. In particular, no entanglement between photons can be generated by use of this type of collective multimode squeezing.

arXiv:quant-ph/0002007•Journal of the Optical Society of America B•Nov 1, 2000•14 citations

Room temperature generation of amplitude squeezed light from 1550 nm distributed feedback semiconductor laser

Francine Jérémie, C. Chabran, Philippe B. Gallion

The control of the quantum state of light has recently been studied extensively, aiming at the achievement of ultra-low noise below the shot noise limit. Several experiments showed that amplitude squeezing could be achieved in constant-current-driven semiconductor lasers. However, the generation of amplitude-squeezed light from distributed feedback semiconductor lasers (DFB) has been up to now considerably less successful than that from Fabry-Perot devices. Simulations indicate that DFB structures with high coupling coefficient length product kL are unlikely to be good sources of squeezed light, because of the evanescence of the optical fields along the grating [1]. They also show, that for low kL values the lowest achievable intensity noise depends on the structure of the laser diode and can be higher than expected from the laser quantum efficiency alone.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jan 1, 1998•0 citations

Microscopic model of quantum noise in single-mode semiconductor lasers

Martino Travagnin, Luigi A. Lugiato

We analyze the zero-frequency intensity noise of a single-mode semiconductor laser on the basis of a full quantum-mechanical model which takes into account the carrier distributions over the k states. The theory includes the effects of (i) Coulomb scattering processes, which tend to drive the carriers into intraband Fermi-Dirac quasiequilibrium; (ii) spectral hole burning, i.e., the carrier deviation from quasiequilibrium induced mainly by light-matter interaction; (iii) pump blocking, which, in conformity with the Pauli exclusion principle, prevents the pump carriers whose k state is already occupied from entering the active layer. Our analysis shows that Coulomb scattering and spectral hole burning have only negligible effects on the noise properties of the laser, while pump blocking can bring, under appropriate parametric conditions, a sizable increase of noise intensity. This additional noise can explain why quietly pumped semiconductor lasers fail to reach the perfect squeezing which is expected on the basis of the theory so far available. The squeezing-hindering effect of pump blocking is confirmed as different pumping schemes are employed.

Physical Review A•Sep 18, 2000•7 citations

Feedback control of laser intensity noise

B. C. Buchler, Elanor H. Huntington, C. C. Harb +1 more

A fully quantum-mechanical model of feedback to the pump source of a four-level laser is developed with a view to predicting the achievable intensity noise reduction. For solid-state lasers, the model shows that quantum noise sources due to laser dynamics have a significant impact on the optimization of the feedback loop. Experimental results obtained with a diode pumped neodymium:yttrium aluminum garnet (Nd:YAG) laser are found to be in good agreement with the theoretical model. The ultimate limit to the noise suppression comes from the quantum noise due to the measurement processes in the feedback loop. A scheme to overcome this limit using a squeezed vacuum is theoretically demonstrated to be a highly efficient method of generating bright intensity squeezed light, particularly in the kHz regime where bright squeezing is otherwise difficult to obtain.

Physical Review A•Feb 1, 1998•39 citations
A new time-domain model using the quantum formalism of the positive-P distribution is used to investigate squeezing in laser diodes, taking into account longitudinal hole burning and distributed noise sources, under steady-state and large-signal modulation. Simulations indicate that the laser structure determines the lowest achievable intensity noise. With losses present or power escaping from the rear facet, this minimum noise may be much higher than expected from the device quantum efficiency. Squeezing appears more difficult in DFB lasers than in Fabry-Perot lasers in our simulations. Mode-partition noise is removed by low-loss passive DBR sections, and such laser diodes are promising sources with low-intensity noise. Intensity noise in the large-signal dynamic regime is also simulated, showing that intensity-squeezed light output is possible.>
For pt.I see ibid., vol.33, no.11, p.2097-2104 (1997). We present noise studies of distributed feedback (DFB) laser structures, where spatial hole burning (SHB) plays a key role performed using the model described in part I of this paper with particular emphasis on the influence of SHB, on the coupling coefficient /spl kappa/L, and on the laser facet reflectivities. These structures exhibit high amplitude noise and the possible noise reduction is strongly reduced compared to Fabry-Perot structures. Distributed Bragg reflector (DBR) lasers are better candidates even if their performances are also strictly determined by SHB and the loss in the Bragg reflector. Finally, limitations due to gain suppression are demonstrated for such complex lasers structures. We conclude on the optimum laser structure for amplitude squeezed states generation.
A semiclassical model of semiconductor laser noise, based on the Green's function method, is used to derive analytical formulas for the amplitude and frequency noise spectra taking into account incoming vacuum fluctuations and noise due to internal loss. This formalism also takes into account phenomena such as gain suppression as well as spatial hole burning (SHB). The amplitude noise squeezing is studied for Fabry-Perot structures pointing out the influence of the laser structural parameters. A complete agreement with already existing quantum mechanical models is found. However, extension of the model to SHB induces limitations in the squeezing performances, which are very important for more complex structures as will be pointed out in detail, in Part II.
The intensity fluctuations of laser light are derived from photon number rate equations. In the limit of short times, the photon statistics for small laser devices such as typical semiconductor laser diodes show thermal characteristics, even above threshold. In the limit of long-time averages represented by the low-frequency component of the noise, the same devices exhibit squeezing. It is shown that squeezing and thermal noise can coexist in the multimode output field of laser diodes. This result implies that the squeezed light generated by regularly pumped semiconductor laser diodes is qualitatively different from single-mode squeezed light. In particular, no entanglement between photons can be generated by use of this type of collective multimode squeezing.
The control of the quantum state of light has recently been studied extensively, aiming at the achievement of ultra-low noise below the shot noise limit. Several experiments showed that amplitude squeezing could be achieved in constant-current-driven semiconductor lasers. However, the generation of amplitude-squeezed light from distributed feedback semiconductor lasers (DFB) has been up to now considerably less successful than that from Fabry-Perot devices. Simulations indicate that DFB structures with high coupling coefficient length product kL are unlikely to be good sources of squeezed light, because of the evanescence of the optical fields along the grating [1]. They also show, that for low kL values the lowest achievable intensity noise depends on the structure of the laser diode and can be higher than expected from the laser quantum efficiency alone.
We analyze the zero-frequency intensity noise of a single-mode semiconductor laser on the basis of a full quantum-mechanical model which takes into account the carrier distributions over the k states. The theory includes the effects of (i) Coulomb scattering processes, which tend to drive the carriers into intraband Fermi-Dirac quasiequilibrium; (ii) spectral hole burning, i.e., the carrier deviation from quasiequilibrium induced mainly by light-matter interaction; (iii) pump blocking, which, in conformity with the Pauli exclusion principle, prevents the pump carriers whose k state is already occupied from entering the active layer. Our analysis shows that Coulomb scattering and spectral hole burning have only negligible effects on the noise properties of the laser, while pump blocking can bring, under appropriate parametric conditions, a sizable increase of noise intensity. This additional noise can explain why quietly pumped semiconductor lasers fail to reach the perfect squeezing which is expected on the basis of the theory so far available. The squeezing-hindering effect of pump blocking is confirmed as different pumping schemes are employed.
A fully quantum-mechanical model of feedback to the pump source of a four-level laser is developed with a view to predicting the achievable intensity noise reduction. For solid-state lasers, the model shows that quantum noise sources due to laser dynamics have a significant impact on the optimization of the feedback loop. Experimental results obtained with a diode pumped neodymium:yttrium aluminum garnet (Nd:YAG) laser are found to be in good agreement with the theoretical model. The ultimate limit to the noise suppression comes from the quantum noise due to the measurement processes in the feedback loop. A scheme to overcome this limit using a squeezed vacuum is theoretically demonstrated to be a highly efficient method of generating bright intensity squeezed light, particularly in the kHz regime where bright squeezing is otherwise difficult to obtain.