Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE International Midwest Symposium on Circuits and Systems (MWSCAS)

Reduction of signal-spontaneous noise in optical amplifiers

G. Du, Scott Roger Shepard, A. Wright

Published Nov 11, 2002• 0 citations
Publisher

Abstract

The beat between an amplified optical signal and the amplified spontaneous emission (ASE) noise is typically the primary limitation to the performance of optical fiber amplifiers. A filtering technique which might reduce this beat noise by 3dB creates a paradox since the noise figure's quantum limit of 3dB could then be reduced to 0dB implying noiseless amplification, which is impossible. The conjecture that this paradox might be resolved by different attenuations of the quantum and semiclassical descriptions of signal-spontaneous noise has been experimentally rejected . Herein, we present a variation of that experiment and telecommunication' applications of this filtering technique are discussed.

DOI
10.1109/mwscas.2000.952879

Related papers

A noiseless amplifier paradox

Scott Roger Shepard

Semiclassically, the signal-spontaneous beat noise in an optical amplifier can be reduced by 3 dB via a filtering technique. This creates a paradox since the noise figure's quantum limit of 3 dB could then be reduced to 0 dB, implying noiseless amplification even though noise is still being introduced by the amplifier. We discuss ways in which this paradox might be resolved and present experimental evidence that dispenses (up to the noise floor of our detectors) with one of these. A semiclassical treatment of the effects of a real (rather than ideal) filter is also presented and suggestions are made for improved (multi-mode) quantum models of this noise.

Journal of Optics B Quantum and Semiclassical Optics•May 24, 2002•1 citation

Noise in optical amplifiers

Gianfranco Cariolaro, Roberto Corvaja, Pierluigi Franco +2 more

This article presents an application of a recently published probablistic model for traveling wave optical amplification. Both optical signal and amplified spontaneous emission (ASE) noise are modeled as bunches of photons traveling along the amplifying region with size varying according to simple random rules. The results of the theory enable one to obtain a complete and accurate characterization of the signal and noise counting at the amplifier output. On the basis of the above statistics, we find a realistic evaluation of the limits imposed by both quantum and ASE noise on the performances of a receiver including an optical amplifier at a preamplifier stage.

Fiber & Integrated Optics•Jan 1, 1994•2 citations

Signal Enhancement by Optical Amplification in Autocorrelation Measurements

Michael Harris, R. Loudon, Terence J. Shepherd +1 more

The effect of optical amplification on the signal-to-noise ratio of autocorrelation measurements has been investigated experimentally. A light signal containing correlation information was amplified by an inverted population (phase-insensitive) optical amplifier. The data clearly show that the amplification may either degrade or enhance a subsequent autocorrelation measurement, depending on the experimental conditions. In particular, enhancement is possible when the detector quantum efficiency is low, or its noise is high. However, when all the signal photons are already being detected with no extra noise, then any optical amplification will inevitably lead to degradation of the data quality, due to addition of amplified spontaneous emission noise (ASE) from the amplifier itself.

Journal of Modern Optics•Apr 1, 1991•5 citations

Optimum noise performance of optical amplifiers

H. A. Haus

The concept of noise figure F and noise measure M applicable to radio frequency and microwave amplifiers is reviewed and extended to cover optical amplifiers. Two noise figures are defined in the optical regime: one gives the ASE output, while the other gives the ratio of signal-to-noise ratios at the input and output. In the quantum regime, the lower limit on these optimum values is set by a generalization of Heisenberg's uncertainty relation. A Raman back-pumped fiber link with post-amplification with an erbium-doped fiber amplifier is used to illustrate the use of noise measure.

IEEE Journal of Quantum Electronics•Jun 1, 2001•16 citations

Noise in an optical amplifier: formulation of a new semiclassical model

Silvano Donati, Guido Giuliani

After pointing out some questionable assumptions of the standard beating theory, we formulate a new semiclassical wave theory of the noise in optical amplifiers. The theory is simple yet rigorous and uses a few quantum statements in a classical signal framework. The amplifier is modeled as a 2/spl times/2 port device, and the amplified spontaneous emission and associated noise are shown to be just the amplified coherent state (or vacuum state) fluctuation of the field entering the idler input. The new theory can treat other closely related detection schemes as well, correctly supplying both mean signal and noise.

IEEE Journal of Quantum Electronics•Jan 1, 1997•41 citations

Semi-quantum noise randomized data encryption based on an amplified spontaneous emission light source

Haisong Jiao, Tao Pu, Jilin Zheng +5 more

The first semi-quantum noise randomized cipher based on amplified spontaneous emission (ASE) light source employing Y-00 protocol is proposed and demonstrated by a proof-of-principle experiment. As the signal carrier, ASE light can provide another fundamental uncertainty, namely, self-beating noise of ASE signal, which is much bigger than quantum shot noise of mesoscopic coherent state and also inevitable. By incorporating both the shot noise and beat noise of ASE signals, the security will be improved with a larger number of masked signals (NMS) under intrinsic noise. After formulating NMS and Q-factor in theory, we investigate the impacts of key system parameters on the security and transmission performances, respectively, in order to optimize the system design. To evidence the theoretical results, an experimental setup with balanced photodetector (BPD) as decoder is constructed. The local light modulated by M/2-ary running key is applied as optical threshold signal, which is fed into BPD together with the M-ary ASE signal, outputting the binary signal. Eventually, a 128-level Y-00 realization based on ASE source is realized at 2.5Gb/s over 100-km fiber. The experimental results agree with the theory in the trend, which indicate the validity and feasibility of the proposed scheme.

Optics Express•Apr 20, 2018•16 citations
The beat between an amplified optical signal and the amplified spontaneous emission (ASE) noise is typically the primary limitation to the performance of optical fiber amplifiers. A filtering technique which might reduce this beat noise by 3dB creates a paradox since the noise figure's quantum limit of 3dB could then be reduced to 0dB implying noiseless amplification, which is impossible. The conjecture that this paradox might be resolved by different attenuations of the quantum and semiclassical descriptions of signal-spontaneous noise has been experimentally rejected . Herein, we present a variation of that experiment and telecommunication' applications of this filtering technique are discussed.
Semiclassically, the signal-spontaneous beat noise in an optical amplifier can be reduced by 3 dB via a filtering technique. This creates a paradox since the noise figure's quantum limit of 3 dB could then be reduced to 0 dB, implying noiseless amplification even though noise is still being introduced by the amplifier. We discuss ways in which this paradox might be resolved and present experimental evidence that dispenses (up to the noise floor of our detectors) with one of these. A semiclassical treatment of the effects of a real (rather than ideal) filter is also presented and suggestions are made for improved (multi-mode) quantum models of this noise.
This article presents an application of a recently published probablistic model for traveling wave optical amplification. Both optical signal and amplified spontaneous emission (ASE) noise are modeled as bunches of photons traveling along the amplifying region with size varying according to simple random rules. The results of the theory enable one to obtain a complete and accurate characterization of the signal and noise counting at the amplifier output. On the basis of the above statistics, we find a realistic evaluation of the limits imposed by both quantum and ASE noise on the performances of a receiver including an optical amplifier at a preamplifier stage.
The effect of optical amplification on the signal-to-noise ratio of autocorrelation measurements has been investigated experimentally. A light signal containing correlation information was amplified by an inverted population (phase-insensitive) optical amplifier. The data clearly show that the amplification may either degrade or enhance a subsequent autocorrelation measurement, depending on the experimental conditions. In particular, enhancement is possible when the detector quantum efficiency is low, or its noise is high. However, when all the signal photons are already being detected with no extra noise, then any optical amplification will inevitably lead to degradation of the data quality, due to addition of amplified spontaneous emission noise (ASE) from the amplifier itself.
The concept of noise figure F and noise measure M applicable to radio frequency and microwave amplifiers is reviewed and extended to cover optical amplifiers. Two noise figures are defined in the optical regime: one gives the ASE output, while the other gives the ratio of signal-to-noise ratios at the input and output. In the quantum regime, the lower limit on these optimum values is set by a generalization of Heisenberg's uncertainty relation. A Raman back-pumped fiber link with post-amplification with an erbium-doped fiber amplifier is used to illustrate the use of noise measure.
After pointing out some questionable assumptions of the standard beating theory, we formulate a new semiclassical wave theory of the noise in optical amplifiers. The theory is simple yet rigorous and uses a few quantum statements in a classical signal framework. The amplifier is modeled as a 2/spl times/2 port device, and the amplified spontaneous emission and associated noise are shown to be just the amplified coherent state (or vacuum state) fluctuation of the field entering the idler input. The new theory can treat other closely related detection schemes as well, correctly supplying both mean signal and noise.
The first semi-quantum noise randomized cipher based on amplified spontaneous emission (ASE) light source employing Y-00 protocol is proposed and demonstrated by a proof-of-principle experiment. As the signal carrier, ASE light can provide another fundamental uncertainty, namely, self-beating noise of ASE signal, which is much bigger than quantum shot noise of mesoscopic coherent state and also inevitable. By incorporating both the shot noise and beat noise of ASE signals, the security will be improved with a larger number of masked signals (NMS) under intrinsic noise. After formulating NMS and Q-factor in theory, we investigate the impacts of key system parameters on the security and transmission performances, respectively, in order to optimize the system design. To evidence the theoretical results, an experimental setup with balanced photodetector (BPD) as decoder is constructed. The local light modulated by M/2-ary running key is applied as optical threshold signal, which is fed into BPD together with the M-ary ASE signal, outputting the binary signal. Eventually, a 128-level Y-00 realization based on ASE source is realized at 2.5Gb/s over 100-km fiber. The experimental results agree with the theory in the trend, which indicate the validity and feasibility of the proposed scheme.