Successful utilization of the quasi one-junction SQUID (QOS) as a signal comparator for analog-to-digital conversion (ADC) has been demonstrated by several groups, This idea is extended to show how similar comparators can be integrated into an all rapid single flux quantum (RSFQ) digital architecture. Comparators are interrogated by SFQ sampling pulses and in turn give output according to the RSFQ convention. One- and two-bit ADC's have been simulated, fabricated and tested at low speed. Total performance of these devices is estimated within the framework of a multiple bit parallel flash ADC architecture.>
Successful utilization of the quasi one-junction SQUID (QOS) as a signal comparator for analog-to-digital conversion (ADC) has been demonstrated by several groups, This idea is extended to show how similar comparators can be integrated into an all rapid single flux quantum (RSFQ) digital architecture. Comparators are interrogated by SFQ sampling pulses and in turn give output according to the RSFQ convention. One- and two-bit ADC's have been simulated, fabricated and tested at low speed. Total performance of these devices is estimated within the framework of a multiple bit parallel flash ADC architecture.>
We have designed a fully integrated 5-bit flash-type single-flux quantum (SFQ) analog-to-digital converter (ADC), in which an error correction and a bit-interleaving circuit are integrated with complementary quasi-one-junction SQUID (CQOS) comparators, and we verified its operation in experiments. Two types of look-back error correction circuits with different clock schemes were designed for the integrated ADCs to avoid the gray zone in comparators and to convert gray code to binary code. The interleaving circuit was also used in the ADC to add one extra bit. A binary 5-bit A/D converter was integrated into an IC chip. Then, input waveforms at low frequencies were successfully retrieved from the binary data of the A/D converter without any errors. We also confirmed that the A/D converter operated properly by conducting tests in our cryocooling system using a 4K-GM cryocooler after the chip was flip-chip bonded onto a multi-chip-module (MCM) carrier. We also used the beat frequency method to test and confirm that the CQOS comparator operated effectively at high frequency, i.e., 3 bits at 15 GHz in the binary code operation and 4 bits at 15 GHz in the gray code operation. Furthermore, operations at sampling frequencies of up to 32 and 50 GHz with a low-frequency analog input signal were experimentally confirmed for a 4-bit comparator circuit with a critical current density Jcof 2.5 kA/cm2and 10 kA/cm2, respectively.
We compare the SQUID wheel/Quantum Flux Parametron (QFP) comparator to a new Rapid Single Flux Quantum (RSFQ) compatible design. Both have been simulated to demonstrate /spl sim/0.5 ps threshold accuracy which would permit the construction of a flash analog-to-digital converter with six effective bits of resolution at 10 GHz input bandwidth, over three times better than the best performance demonstrated with any technology, At lower input frequencies, both designs have demonstrated that a 10-bit flash ADC is possible. Although simulations of the QFP-based design are more accurate at high signal slew rates due to its symmetry, the RSFQ-based design has a better signal-to-noise ratio and a faster and more flexible clocking scheme which ultimately prove to be more important.
We are developing an analog-to-digital converter (ADC) based on rapid single-flux quantum technology for radio-astronomic spectroscopy applications where very wide bandwidth is required and relatively small resolution is sufficient. The ADC consists of periodic-flash comparators, a demultiplexer and output drivers; and is sufficiently simple to be implemented on a single chip using a conventional 2–3 μm Nb trilayer technology. A 2-bit ADC has been designed for operation at 16 GHz of the sampling frequency. All the subsystems of the ADC have been fabricated using standard 1.6 kA cm −2 Nb/AlO x /Nb technology and have been successfully tested.
We describe the design of an oversampling single-flux-counting analog-to-digital converter with the estimated bandwidth of a few tens of MHz, based on Rapid Single-Flux-Quantum (RSFQ) devices. It consists of an input analog circuit, high-speed quantizer with an original analog/digital negative feedback loop, decimation (comb) filter, and supporting subsystems including clock distribution circuits, quantization signal conditioner, and output drivers. We have applied a new approach, the 'symmetrizing' negative feedback, to free the quantizer from the intrinsic hysteresis without dynamic range sacrifice. The 16-bit version of the system comprises about 1,500 Josephson junctions and consumes 1.2 mW of DC power, when implemented using Nb-trilayer technology with 1 kA/cm/sup 2/, 3.5 /spl mu/m Josephson junctions. All subsystems of the converter have been successfully tested and testing of the system as a whole is in progress.>
A new generation of the Josephson digital circuits-rapid single flux quantum (RSFQ) devices-based on overdamped externally shunted high quality Nb-AlO x -Nb tunnel junctions have been designed, fabricated and experimentally investigated. All-refractory material 11-layer 5 mu m integrated technology has been successfully employed for the preparation of the RSFQ microcircuits. The T flip-flop has been demonstrated to operate properly up to clock frequencies of 100 GHz at 25% margins. The proper operation of the buffer stage for a one-directional SFQ pulse transmission at clock frequencies up to 125 GHz has been achieved. The possibilities to convert the information from the usual DC form to SFQ and vice versa have been demonstrated. An output signal in an SFQ/DC converter as high as 220 mu V has been measured. A new counter type A/D converter which includes a comparator and reversible binary counter with DC outputs has been fabricated and tested. The proposed ADC seems to be very promising for high-accuracy measurement of medium-bandwidth signals. The possibilities of creating a number of SFQ devices with outstanding parameters are discussed.
Analog-to-digital converters (ADCs) are key components of most digital systems, as the necessary interface between the analogue world to send and receive signals. Semiconductor ADC systems are intrinsically limited to low frequency ranges of a few GHz and associated to dynamic ranges limited by linearity issues. Superconductor electronic ADCs rely on the magnetic flux quantization and do not suffer from the linearity issues. Moreover, the Rapid-Single-Flux Quantum (RSFQ) technique [1] allows the sampling of signals far in the microwave range, of the order of 100 GHz for the fastest circuits with state-of-the-art low critical temperature niobium-based technology.Two main applications require the use of fast and high dynamic range superconducting ADCs: future ground- or space-based telecommunication systems for software defined radio (SDR) and all systems requiring very high dynamic range in the 120-180 dB range. In this last category, one can find the digital Superconducting Quantum Interference Devices (SQUIDs) that combine the digitization due to the RSFQ technique, with the ultrasensitive sensing of magnetic fields, that are of interest for several applications, ranging from Non-Destructive Evaluation (NDE) to the detection of faint geomagnetic signatures [2].In this work, we will describe in details an analysis of performances of two different kinds of ADCs, respectively for space and geophysics applications. New designs with their electrical circuits will be described for operation in the microwave frequency band with a sigma-delta architecture, and for improved dynamic range with a delta design. The performance in terms of number of bits or dynamic range, frequency bandwidth and ultimate sampling speed will be compared with the ones of existing ADCs. Considerations about the layout due to technological considerations are taken into account in the design. Trade-offs between performance and technologies will be emphasized.[1] K. Likharev and V. Semenov, IEEE Trans. Appl. Supercond. 1, 3 (1991).[2] T. Reich, P. Febvre, T. Ortlepp, F. H. Uhlmann, J. Kunert, R. Stolz, and H.-G. Meyer, Journal of Applied Physics 104(2), 024509 (2008).