We are developing an analog-to-digital converter (ADC) based on rapid single-flux quantum technology for radio-astronomic spectroscopy applications where very wide bandwidth is required and relatively small resolution is sufficient. The ADC consists of periodic-flash comparators, a demultiplexer and output drivers; and is sufficiently simple to be implemented on a single chip using a conventional 2–3 μm Nb trilayer technology. A 2-bit ADC has been designed for operation at 16 GHz of the sampling frequency. All the subsystems of the ADC have been fabricated using standard 1.6 kA cm −2 Nb/AlO x /Nb technology and have been successfully tested.
We are developing an analog-to-digital converter (ADC) based on rapid single-flux quantum technology for radio-astronomic spectroscopy applications where very wide bandwidth is required and relatively small resolution is sufficient. The ADC consists of periodic-flash comparators, a demultiplexer and output drivers; and is sufficiently simple to be implemented on a single chip using a conventional 2–3 μm Nb trilayer technology. A 2-bit ADC has been designed for operation at 16 GHz of the sampling frequency. All the subsystems of the ADC have been fabricated using standard 1.6 kA cm −2 Nb/AlO x /Nb technology and have been successfully tested.
Successful utilization of the quasi one-junction SQUID (QOS) as a signal comparator for analog-to-digital conversion (ADC) has been demonstrated by several groups, This idea is extended to show how similar comparators can be integrated into an all rapid single flux quantum (RSFQ) digital architecture. Comparators are interrogated by SFQ sampling pulses and in turn give output according to the RSFQ convention. One- and two-bit ADC's have been simulated, fabricated and tested at low speed. Total performance of these devices is estimated within the framework of a multiple bit parallel flash ADC architecture.>
We describe the design of an oversampling single-flux-counting analog-to-digital converter with the estimated bandwidth of a few tens of MHz, based on Rapid Single-Flux-Quantum (RSFQ) devices. It consists of an input analog circuit, high-speed quantizer with an original analog/digital negative feedback loop, decimation (comb) filter, and supporting subsystems including clock distribution circuits, quantization signal conditioner, and output drivers. We have applied a new approach, the 'symmetrizing' negative feedback, to free the quantizer from the intrinsic hysteresis without dynamic range sacrifice. The 16-bit version of the system comprises about 1,500 Josephson junctions and consumes 1.2 mW of DC power, when implemented using Nb-trilayer technology with 1 kA/cm/sup 2/, 3.5 /spl mu/m Josephson junctions. All subsystems of the converter have been successfully tested and testing of the system as a whole is in progress.>
We present results of a preliminary analysis of possible front-ends of a software defined radio base station receiver containing superconductor Rapid Single-Flux-Quantum (RSFQ) components. The main component of such a front-end, an oversampling analog-to-digital converter (ADC) with expected internal clock rate up to 20 GHz has already been developed and fabricated with commercially available 3.5-/spl mu/m, 1-kA/cm/sup 2/ niobium-trilayer technology. Simulations show that, even with such crude feature size, the superconductor ADC components can outperform their semiconductor counterparts.
An analog to digital converter (ADC) using the rapid single flux quantum (RSFQ) logic family implemented in niobium nitride (NbN) technology is described. The circuit was originally developed and demonstrated in niobium technology. An identical circuit was then laid out, fabricated and demonstrated in NbN technology. The chips were fabricated using an eight-layer NbN-based process with Josephson junction critical current density of 500 A/cm/sup 2/. In this paper, we report on the measurement results for a 6-bit flux quantizing ADC which exhibited proper operation and good DC bias margins. We also demonstrate results from an ADC chip operating up to 9.5 K.>
A new generation of the Josephson digital circuits-rapid single flux quantum (RSFQ) devices-based on overdamped externally shunted high quality Nb-AlO x -Nb tunnel junctions have been designed, fabricated and experimentally investigated. All-refractory material 11-layer 5 mu m integrated technology has been successfully employed for the preparation of the RSFQ microcircuits. The T flip-flop has been demonstrated to operate properly up to clock frequencies of 100 GHz at 25% margins. The proper operation of the buffer stage for a one-directional SFQ pulse transmission at clock frequencies up to 125 GHz has been achieved. The possibilities to convert the information from the usual DC form to SFQ and vice versa have been demonstrated. An output signal in an SFQ/DC converter as high as 220 mu V has been measured. A new counter type A/D converter which includes a comparator and reversible binary counter with DC outputs has been fabricated and tested. The proposed ADC seems to be very promising for high-accuracy measurement of medium-bandwidth signals. The possibilities of creating a number of SFQ devices with outstanding parameters are discussed.
Analog-to-digital converters (ADCs) are key components of most digital systems, as the necessary interface between the analogue world to send and receive signals. Semiconductor ADC systems are intrinsically limited to low frequency ranges of a few GHz and associated to dynamic ranges limited by linearity issues. Superconductor electronic ADCs rely on the magnetic flux quantization and do not suffer from the linearity issues. Moreover, the Rapid-Single-Flux Quantum (RSFQ) technique [1] allows the sampling of signals far in the microwave range, of the order of 100 GHz for the fastest circuits with state-of-the-art low critical temperature niobium-based technology.Two main applications require the use of fast and high dynamic range superconducting ADCs: future ground- or space-based telecommunication systems for software defined radio (SDR) and all systems requiring very high dynamic range in the 120-180 dB range. In this last category, one can find the digital Superconducting Quantum Interference Devices (SQUIDs) that combine the digitization due to the RSFQ technique, with the ultrasensitive sensing of magnetic fields, that are of interest for several applications, ranging from Non-Destructive Evaluation (NDE) to the detection of faint geomagnetic signatures [2].In this work, we will describe in details an analysis of performances of two different kinds of ADCs, respectively for space and geophysics applications. New designs with their electrical circuits will be described for operation in the microwave frequency band with a sigma-delta architecture, and for improved dynamic range with a delta design. The performance in terms of number of bits or dynamic range, frequency bandwidth and ultimate sampling speed will be compared with the ones of existing ADCs. Considerations about the layout due to technological considerations are taken into account in the design. Trade-offs between performance and technologies will be emphasized.[1] K. Likharev and V. Semenov, IEEE Trans. Appl. Supercond. 1, 3 (1991).[2] T. Reich, P. Febvre, T. Ortlepp, F. H. Uhlmann, J. Kunert, R. Stolz, and H.-G. Meyer, Journal of Applied Physics 104(2), 024509 (2008).