Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics

A three-dimensional, polarization-insensitive superconducting nanowire avalanche photodetector

Varun Boehm Verma, Francesco Marsili, Sean David Harrington, Adriana E. Lita, Richard P. Mirin, Sae Woo Nam

Published Jan 1, 2013• 5 citations
Publisher

Abstract

We measure a peak system detection efficiency (SDE) of 87.7 ± 0.5 % and a polarization dependence of less than 2 % using vertically-stacked superconducting nanowire single-photon detectors connected electrically in parallel.
DOI
10.1364/cleo_qels.2013.qm4l.8

Related papers

A three-dimensional, polarization-insensitive superconducting nanowire avalanche photodetector

Varun Boehm Verma, Francesco Marsili, Sean David Harrington +3 more

We demonstrate an approach to improving the detection efficiency, removing the polarization dependence, and increasing the signal-to-noise ratio of conventional superconducting nanowire single photon detectors (SNSPDs) by vertically stacking two WSi SNSPDs and electrically connecting them in parallel, forming a three-dimensional superconducting nanowire avalanche photodetector. We measure a peak system detection efficiency of 87.7% ± 0.5% and a polarization dependence of less than 2%, representing nearly an order of magnitude improvement in both system detection efficiency and reduction of polarization dependence compared to conventional SNSPDs.

Applied Physics Letters•Dec 17, 2012•87 citations

Fractal Superconducting Nanowire Avalanche Photodetectors with 84% System Efficiency at 1600 nm, 1.02 Polarization Sensitivity, and 29 ps Timing Resolution

Yun Meng, Kai Zou, Nan Hu +6 more

We demonstrate a fractal superconducting nanowire single-photon detector with 84% system efficiency at 1600 nm, 1.02 polarization sensitivity, and 29 ps timing resolution, which have never been simultaneously achieved before.

Conference on Lasers and Electro-Optics•Jan 1, 2021•0 citations

Fractal superconducting nanowire avalanche photodetector with 60% system efficiency and 1.05 polarization sensitivity

Xiaojian Lan, Yun Meng, Kai Zou +8 more

We report on a fractal superconducting nanowire avalanche photodetector simultaneously with 60% system efficiency, 1.05 polarization sensitivity, 4-ns recovery time, and 45-ps timing jitter. The efficiency is the highest among polycrystalline SNSPDs with polarization-insensitive designs.

Conference on Lasers and Electro-Optics•Jan 1, 2020•0 citations

Superconducting nanowire avalanche photodetectors

Sae Woo Nam, Brice Calkins, T. Gerritts +9 more

Superconducting devices offer the potential to perform at speeds and detection efficiencies higher than what is possible using conventional technologies (such as semiconducting avalanche photodiodes and photomultiplier tubs) for wavelengths from the ultraviolet to the mid-infrared. As a result, there has been increasing interest in using superconducting optical photon detectors in a variety of applications. There has been significant progress in using these types of detectors in areas of basic research such as quantum information science and quantum optics. These applications require detectors that have extremely low dark count rates, high count rates, and high quantum efficiency. I will begin by describing some of our earlier work on superconducting Transition-Edge Sensor (TES). In particular, I will describe some of the engineering involved in the cryogenic, electrical, and optical packaging so that these devices can be easily coupled into fiber-based optics. I will also describe our recent work on developing superconducting nanowire single photon detectors (SNSPD or SSPD). An SNSPD is an ultra-thin, ultra-narrow (nm scale) superconducting meander that is current biased just below its critical current density. When one or more photon is absorbed, a hot spot is formed that causes the superconductor to develop a resistance and consequently a voltage pulse. At NIST and JPL, we have been developing nanowire detectors using an amorphous alloy of tungsten-silicide. We will describe to construct systems using tungsten-silicide nanowires to achieve high detection efficiency (>90% at 1550nm). I will also describe our work to improve the performance of the device by fabricating multiple nanowires in an electrically parallel structure to implement a superconducting nanowire avalanche photodiode (SNAP)[1]. One example of this type of detector is shown in Fig 1. In this case, there are two tungsten silicide layers separated by a dielectric layer to optimize detection of light for any polarization[2]. In addition, progress on other types of SNAP detectors will be described to increase the signal size from a single photon, reduce the recovery time of the device, and to improve the jitter.

IEEE Photonics Conference•Sep 1, 2013•4 citations

Polarization-insensitive high-efficiency superconducting nanowire single-photon detector

xin xu, Yue Fei, Qi Chen +10 more

Superconducting nanowire single-photon detectors (SNSPDs) struggle to balance high system detection efficiency (SDE) and low polarization dependence. This work proposes a co-design of the NbN films, α -Si anti-reflection coating (ARC), and SiO 2 /Ta 2 O 5 distributed Bragg reflector (DBR) to reduce the polarization-dependent optical response of the nanowires. Simulations based on rigorous coupled-wave analysis (RCWA) and the finite-element method show absorptance above 99% for both transverse-electric (TE) and transverse-magnetic (TM) polarizations and absorptance above 90% over the wavelength range from 1530 to 1640 nm. Experimentally, the device achieves 97% SDE at 1530 nm (polarization sensitivity, PS = 1.1), PS < 1.3 over 1490–1640 nm, 39.5 ns recovery time, and 63.5 ps timing jitter. Retaining a conventional single-layer meander nanowire geometry, this design unifies high efficiency and polarization insensitivity, advancing SNSPD applications in quantum communications, free-space links, and single-photon imaging.

Optics Express•Oct 8, 2026•0 citations

High-performance eight-channel system with fractal superconducting nanowire single-photon detectors

Zifan Hao, Kai Zou, Yun Meng +9 more

Superconducting nanowire single-photon detectors (SNSPDs) have become a mainstream photon-counting technology that has been used in various applications. So far, most multi-channel SNSPD systems, either reported in literature or been commercially available, are polarization sensitive, that is, the system detection efficiency (SDE) of each channel is dependent on the state of polarization of the to-be-detected photons. Here, we report on an eight-channel system with fractal superconducting nanowire single-photon detectors working in the wavelength range of 930-940 nm that all feature low polarization sensitivity. In a close-cycled Gifford-McMahon cryocooler system with the base temperature of 2.2 K, we install and compare the performance of two types of devices: (1) SNSPD, composed of a single, continuous nanowire, and (2) superconducting nanowire avalanche photodetector (SNAP), composed of 16 cascaded units of two nanowires electrically connected in parallel. The highest system detection efficiency (SDE) among the eight channels reaches 96−5+4%, with polarization sensitivity of 1.02 and dark-count rate of 13 counts per second. The average SDE for eight channels for all states of polarization is estimated to be 90 ± 5%. We conclude that both the SNSPDs and the SNAPs can reach saturated, high SDE at the wavelength of interest, and the SNSPDs show lower dark- (false-) count rates while the SNAPs show better properties in the time domain. Using this system, we showcase the measurements of the second-order photon-correlation functions of light emission from a single-photon source based on a semiconductor quantum dot and from a pulsed laser. We believe that our work provides new choices of systems with single-photon detectors combining the merits of high SDE, low polarization sensitivity, and low noise that can be tailored for different applications.

Chip•Feb 27, 2024•18 citations
We demonstrate an approach to improving the detection efficiency, removing the polarization dependence, and increasing the signal-to-noise ratio of conventional superconducting nanowire single photon detectors (SNSPDs) by vertically stacking two WSi SNSPDs and electrically connecting them in parallel, forming a three-dimensional superconducting nanowire avalanche photodetector. We measure a peak system detection efficiency of 87.7% ± 0.5% and a polarization dependence of less than 2%, representing nearly an order of magnitude improvement in both system detection efficiency and reduction of polarization dependence compared to conventional SNSPDs.
Superconducting devices offer the potential to perform at speeds and detection efficiencies higher than what is possible using conventional technologies (such as semiconducting avalanche photodiodes and photomultiplier tubs) for wavelengths from the ultraviolet to the mid-infrared. As a result, there has been increasing interest in using superconducting optical photon detectors in a variety of applications. There has been significant progress in using these types of detectors in areas of basic research such as quantum information science and quantum optics. These applications require detectors that have extremely low dark count rates, high count rates, and high quantum efficiency. I will begin by describing some of our earlier work on superconducting Transition-Edge Sensor (TES). In particular, I will describe some of the engineering involved in the cryogenic, electrical, and optical packaging so that these devices can be easily coupled into fiber-based optics. I will also describe our recent work on developing superconducting nanowire single photon detectors (SNSPD or SSPD). An SNSPD is an ultra-thin, ultra-narrow (nm scale) superconducting meander that is current biased just below its critical current density. When one or more photon is absorbed, a hot spot is formed that causes the superconductor to develop a resistance and consequently a voltage pulse. At NIST and JPL, we have been developing nanowire detectors using an amorphous alloy of tungsten-silicide. We will describe to construct systems using tungsten-silicide nanowires to achieve high detection efficiency (>90% at 1550nm). I will also describe our work to improve the performance of the device by fabricating multiple nanowires in an electrically parallel structure to implement a superconducting nanowire avalanche photodiode (SNAP)[1]. One example of this type of detector is shown in Fig 1. In this case, there are two tungsten silicide layers separated by a dielectric layer to optimize detection of light for any polarization[2]. In addition, progress on other types of SNAP detectors will be described to increase the signal size from a single photon, reduce the recovery time of the device, and to improve the jitter.
Superconducting nanowire single-photon detectors (SNSPDs) struggle to balance high system detection efficiency (SDE) and low polarization dependence. This work proposes a co-design of the NbN films, α -Si anti-reflection coating (ARC), and SiO 2 /Ta 2 O 5 distributed Bragg reflector (DBR) to reduce the polarization-dependent optical response of the nanowires. Simulations based on rigorous coupled-wave analysis (RCWA) and the finite-element method show absorptance above 99% for both transverse-electric (TE) and transverse-magnetic (TM) polarizations and absorptance above 90% over the wavelength range from 1530 to 1640 nm. Experimentally, the device achieves 97% SDE at 1530 nm (polarization sensitivity, PS = 1.1), PS < 1.3 over 1490–1640 nm, 39.5 ns recovery time, and 63.5 ps timing jitter. Retaining a conventional single-layer meander nanowire geometry, this design unifies high efficiency and polarization insensitivity, advancing SNSPD applications in quantum communications, free-space links, and single-photon imaging.
Superconducting nanowire single-photon detectors (SNSPDs) have become a mainstream photon-counting technology that has been used in various applications. So far, most multi-channel SNSPD systems, either reported in literature or been commercially available, are polarization sensitive, that is, the system detection efficiency (SDE) of each channel is dependent on the state of polarization of the to-be-detected photons. Here, we report on an eight-channel system with fractal superconducting nanowire single-photon detectors working in the wavelength range of 930-940 nm that all feature low polarization sensitivity. In a close-cycled Gifford-McMahon cryocooler system with the base temperature of 2.2 K, we install and compare the performance of two types of devices: (1) SNSPD, composed of a single, continuous nanowire, and (2) superconducting nanowire avalanche photodetector (SNAP), composed of 16 cascaded units of two nanowires electrically connected in parallel. The highest system detection efficiency (SDE) among the eight channels reaches 96−5+4%, with polarization sensitivity of 1.02 and dark-count rate of 13 counts per second. The average SDE for eight channels for all states of polarization is estimated to be 90 ± 5%. We conclude that both the SNSPDs and the SNAPs can reach saturated, high SDE at the wavelength of interest, and the SNSPDs show lower dark- (false-) count rates while the SNAPs show better properties in the time domain. Using this system, we showcase the measurements of the second-order photon-correlation functions of light emission from a single-photon source based on a semiconductor quantum dot and from a pulsed laser. We believe that our work provides new choices of systems with single-photon detectors combining the merits of high SDE, low polarization sensitivity, and low noise that can be tailored for different applications.