Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

A three-dimensional, polarization-insensitive superconducting nanowire avalanche photodetector

Varun Boehm Verma, Francesco Marsili, Sean David Harrington, Adriana E. Lita, Richard P. Mirin, Sae Woo Nam

Published Dec 17, 2012• 87 citations
Publisher

Abstract

We demonstrate an approach to improving the detection efficiency, removing the polarization dependence, and increasing the signal-to-noise ratio of conventional superconducting nanowire single photon detectors (SNSPDs) by vertically stacking two WSi SNSPDs and electrically connecting them in parallel, forming a three-dimensional superconducting nanowire avalanche photodetector. We measure a peak system detection efficiency of 87.7% ± 0.5% and a polarization dependence of less than 2%, representing nearly an order of magnitude improvement in both system detection efficiency and reduction of polarization dependence compared to conventional SNSPDs.

DOI
10.1063/1.4768788

Related papers

A three-dimensional, polarization-insensitive superconducting nanowire avalanche photodetector

Varun Boehm Verma, Francesco Marsili, Sean David Harrington +3 more

We measure a peak system detection efficiency (SDE) of 87.7 ± 0.5 % and a polarization dependence of less than 2 % using vertically-stacked superconducting nanowire single-photon detectors connected electrically in parallel.

Conference on Lasers and Electro-Optics•Jan 1, 2013•5 citations

Superconducting nanowire avalanche photodetectors

Sae Woo Nam, Brice Calkins, T. Gerritts +9 more

Superconducting devices offer the potential to perform at speeds and detection efficiencies higher than what is possible using conventional technologies (such as semiconducting avalanche photodiodes and photomultiplier tubs) for wavelengths from the ultraviolet to the mid-infrared. As a result, there has been increasing interest in using superconducting optical photon detectors in a variety of applications. There has been significant progress in using these types of detectors in areas of basic research such as quantum information science and quantum optics. These applications require detectors that have extremely low dark count rates, high count rates, and high quantum efficiency. I will begin by describing some of our earlier work on superconducting Transition-Edge Sensor (TES). In particular, I will describe some of the engineering involved in the cryogenic, electrical, and optical packaging so that these devices can be easily coupled into fiber-based optics. I will also describe our recent work on developing superconducting nanowire single photon detectors (SNSPD or SSPD). An SNSPD is an ultra-thin, ultra-narrow (nm scale) superconducting meander that is current biased just below its critical current density. When one or more photon is absorbed, a hot spot is formed that causes the superconductor to develop a resistance and consequently a voltage pulse. At NIST and JPL, we have been developing nanowire detectors using an amorphous alloy of tungsten-silicide. We will describe to construct systems using tungsten-silicide nanowires to achieve high detection efficiency (>90% at 1550nm). I will also describe our work to improve the performance of the device by fabricating multiple nanowires in an electrically parallel structure to implement a superconducting nanowire avalanche photodiode (SNAP)[1]. One example of this type of detector is shown in Fig 1. In this case, there are two tungsten silicide layers separated by a dielectric layer to optimize detection of light for any polarization[2]. In addition, progress on other types of SNAP detectors will be described to increase the signal size from a single photon, reduce the recovery time of the device, and to improve the jitter.

IEEE Photonics Conference•Sep 1, 2013•4 citations

Design of a polarization-insensitive superconducting nanowire single photon detector with high detection efficiency

Fan Zheng, Ruiying Xu, Guanghao Zhu +5 more

Superconducting nanowire single photon detectors (SNSPDs) deliver superior performance over their competitors in the near-infrared regime. However, these detectors have an intrinsic polarization dependence on the incident wave because of their one-dimensional meander structure. In this paper, we propose an approach to eliminate the polarization sensitivity of SNSPDs by using near-field optics to increase the absorption of SNSPDs under transverse magnetic (TM) illumination. In addition, an optical cavity is added to our SNSPD to obtain nearly perfect absorption of the incident wave. Numerical simulations show that the maximum absorption of a designed SNSPD can reach 96% at 1550 nm, and indicate that the absorption difference between transverse electric (TE) and TM polarization is less than 0.5% across a wavelength window of 300 nm. Our work provides the first demonstration of the possibility of designing a polarization-insensitive and highly efficient SNSPD without performing device symmetry improvements.

Scientific Reports•Mar 7, 2016•37 citations

Fractal superconducting nanowire avalanche photodetector at 1550 nm with 60% system detection efficiency and 1.05 polarization sensitivity

Yun Meng, Kai Zou, Nan Hu +6 more

Superconducting nanowire (nanostrip) single-photon detectors (SNSPDs) have shown unprecedented detection efficiency and timing properties, but simultaneously achieving polarization-insensitive high detection efficiency, low dark-count rate (DCR), fast speed, and low timing jitter remains a challenge. Here we report on our design, fabrication, and characterization of a cascaded superconducting avalanche photodetector composed of 40 nm wide NbTiN nanowires patterned into fractal curves. At the base temperature of 2.7 K, the device exhibits 60±3% system detection efficiency at the wavelength of 1550 nm, 1.05 polarization sensitivity, 220 cps DCR, 4 ns recovery time, and 45 ps timing jitter. This Letter not only demonstrates these combined properties on a single detector that was unobtainable previously, but also shows that that current-crowding effect remarkably permits decent internal detection efficiency. These counter-intuitive results expand the understanding pertaining to the device physics of SNSPDs.

Optics Letters•Dec 12, 2019•23 citations

High-efficiency polarization-insensitive superconducting nanowire single photon detector

Wenying Zhang, Peng Hu, You Xiao +2 more

Superconducting nanowire single photon detector (SNSPD) has been widely used in many fields such as quantum communication due to its extremely high detection efficiency, low dark count rate, high count rate, and low timing jitter. Compared with conventional single-photon detectors with planar structure, SNSPD is typically made a periodical meandering structure consisting of parallel straight nanowires. However, owing to its unique linear structure, the detection efficiency of SNSPD is dependent on the polarization state of incident light, thus limiting SNSPD’s applications in unconventional fiber links or other incoherent light detection. In this paper, a polarization-insensitive SNSPD with high detection efficiency is proposed based on the traditional meandering nanowire structure. A thin silicon film with a high refractive index is introduced as a cladding layer of nanowires to reduce the dielectric mismatch between the nanowire and its surroundings, thereby improving the optical absorption efficiency of nanowires to the transverse-magnetic (TM) polarized incident light. The cladding layer is designed as a sinusoidal-shaped grating structure to minimize the difference in optical absorption efficiency between the transverse electric (TE) polarized incident light and the TM polarized incident light in a wide wavelength range. In addition, the twin-layer nanowire structure and the dielectric mirror are used to improve the optical absorption efficiency of the device. Our simulation results show that with the optimal parameters, the optical absorption efficiency of nanowires to both of the TE polarized incident light and TM polarized incident light has a maximum of over 90% at 1550 nm, and the corresponding polarization extinction ratio is less than 1.22. The fabricated device possesses a maximum detection efficiency of 87% at 1605 nm and a polarization extinction ratio of 1.06. The measured detection efficiency exceeds 50% with a polarization extinction ratio less than 1.2 in a wavelength range from 1505 nm to 1630 nm. This work provides a reference for high-efficiency polarization-insensitive SNSPD in the future.

Acta Physica Sinica•Jan 1, 2021•5 citations

Fractal superconducting nanowire avalanche photodetector with 60% system efficiency and 1.05 polarization sensitivity

Xiaojian Lan, Yun Meng, Kai Zou +8 more

We report on a fractal superconducting nanowire avalanche photodetector simultaneously with 60% system efficiency, 1.05 polarization sensitivity, 4-ns recovery time, and 45-ps timing jitter. The efficiency is the highest among polycrystalline SNSPDs with polarization-insensitive designs.

Conference on Lasers and Electro-Optics•Jan 1, 2020•0 citations
We demonstrate an approach to improving the detection efficiency, removing the polarization dependence, and increasing the signal-to-noise ratio of conventional superconducting nanowire single photon detectors (SNSPDs) by vertically stacking two WSi SNSPDs and electrically connecting them in parallel, forming a three-dimensional superconducting nanowire avalanche photodetector. We measure a peak system detection efficiency of 87.7% ± 0.5% and a polarization dependence of less than 2%, representing nearly an order of magnitude improvement in both system detection efficiency and reduction of polarization dependence compared to conventional SNSPDs.
Superconducting devices offer the potential to perform at speeds and detection efficiencies higher than what is possible using conventional technologies (such as semiconducting avalanche photodiodes and photomultiplier tubs) for wavelengths from the ultraviolet to the mid-infrared. As a result, there has been increasing interest in using superconducting optical photon detectors in a variety of applications. There has been significant progress in using these types of detectors in areas of basic research such as quantum information science and quantum optics. These applications require detectors that have extremely low dark count rates, high count rates, and high quantum efficiency. I will begin by describing some of our earlier work on superconducting Transition-Edge Sensor (TES). In particular, I will describe some of the engineering involved in the cryogenic, electrical, and optical packaging so that these devices can be easily coupled into fiber-based optics. I will also describe our recent work on developing superconducting nanowire single photon detectors (SNSPD or SSPD). An SNSPD is an ultra-thin, ultra-narrow (nm scale) superconducting meander that is current biased just below its critical current density. When one or more photon is absorbed, a hot spot is formed that causes the superconductor to develop a resistance and consequently a voltage pulse. At NIST and JPL, we have been developing nanowire detectors using an amorphous alloy of tungsten-silicide. We will describe to construct systems using tungsten-silicide nanowires to achieve high detection efficiency (>90% at 1550nm). I will also describe our work to improve the performance of the device by fabricating multiple nanowires in an electrically parallel structure to implement a superconducting nanowire avalanche photodiode (SNAP)[1]. One example of this type of detector is shown in Fig 1. In this case, there are two tungsten silicide layers separated by a dielectric layer to optimize detection of light for any polarization[2]. In addition, progress on other types of SNAP detectors will be described to increase the signal size from a single photon, reduce the recovery time of the device, and to improve the jitter.
Superconducting nanowire single photon detectors (SNSPDs) deliver superior performance over their competitors in the near-infrared regime. However, these detectors have an intrinsic polarization dependence on the incident wave because of their one-dimensional meander structure. In this paper, we propose an approach to eliminate the polarization sensitivity of SNSPDs by using near-field optics to increase the absorption of SNSPDs under transverse magnetic (TM) illumination. In addition, an optical cavity is added to our SNSPD to obtain nearly perfect absorption of the incident wave. Numerical simulations show that the maximum absorption of a designed SNSPD can reach 96% at 1550 nm, and indicate that the absorption difference between transverse electric (TE) and TM polarization is less than 0.5% across a wavelength window of 300 nm. Our work provides the first demonstration of the possibility of designing a polarization-insensitive and highly efficient SNSPD without performing device symmetry improvements.
Superconducting nanowire (nanostrip) single-photon detectors (SNSPDs) have shown unprecedented detection efficiency and timing properties, but simultaneously achieving polarization-insensitive high detection efficiency, low dark-count rate (DCR), fast speed, and low timing jitter remains a challenge. Here we report on our design, fabrication, and characterization of a cascaded superconducting avalanche photodetector composed of 40 nm wide NbTiN nanowires patterned into fractal curves. At the base temperature of 2.7 K, the device exhibits 60±3% system detection efficiency at the wavelength of 1550 nm, 1.05 polarization sensitivity, 220 cps DCR, 4 ns recovery time, and 45 ps timing jitter. This Letter not only demonstrates these combined properties on a single detector that was unobtainable previously, but also shows that that current-crowding effect remarkably permits decent internal detection efficiency. These counter-intuitive results expand the understanding pertaining to the device physics of SNSPDs.
Superconducting nanowire single photon detector (SNSPD) has been widely used in many fields such as quantum communication due to its extremely high detection efficiency, low dark count rate, high count rate, and low timing jitter. Compared with conventional single-photon detectors with planar structure, SNSPD is typically made a periodical meandering structure consisting of parallel straight nanowires. However, owing to its unique linear structure, the detection efficiency of SNSPD is dependent on the polarization state of incident light, thus limiting SNSPD’s applications in unconventional fiber links or other incoherent light detection. In this paper, a polarization-insensitive SNSPD with high detection efficiency is proposed based on the traditional meandering nanowire structure. A thin silicon film with a high refractive index is introduced as a cladding layer of nanowires to reduce the dielectric mismatch between the nanowire and its surroundings, thereby improving the optical absorption efficiency of nanowires to the transverse-magnetic (TM) polarized incident light. The cladding layer is designed as a sinusoidal-shaped grating structure to minimize the difference in optical absorption efficiency between the transverse electric (TE) polarized incident light and the TM polarized incident light in a wide wavelength range. In addition, the twin-layer nanowire structure and the dielectric mirror are used to improve the optical absorption efficiency of the device. Our simulation results show that with the optimal parameters, the optical absorption efficiency of nanowires to both of the TE polarized incident light and TM polarized incident light has a maximum of over 90% at 1550 nm, and the corresponding polarization extinction ratio is less than 1.22. The fabricated device possesses a maximum detection efficiency of 87% at 1605 nm and a polarization extinction ratio of 1.06. The measured detection efficiency exceeds 50% with a polarization extinction ratio less than 1.2 in a wavelength range from 1505 nm to 1630 nm. This work provides a reference for high-efficiency polarization-insensitive SNSPD in the future.