Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE/LEOS Winter Topicals Meeting Series (WTM)

Four Wave Mixing and wavelength conversion in slow light regime

Andrea Ivano Melloni, Matteo Torregiani, Antonio Canciamilla, Francesco Morichetti

Published Jan 1, 2009• 1 citation
Publisher

Abstract

In ideal conditions the four wave mixing conversion efficiency is enhanced by the slowing down factor to the fourth power. We have investigated FWM. In ideal conditions the four wave mixing conversion efficiency is enhanced by the slowing down factor to the fourth power. We have investigated FWM in coupled resonator optical waveguides both numerically and experimentally this phenomena, also in presence of attenuation and chromatic dispersion.

DOI
10.1109/leoswt.2009.4771700

Related papers

Experimental study of slow light based on four-wave mixing wavelength conversion and dispersion in optical fibers

Yin Jing-Chan, Xiaosheng Xiao, Changxi Yang +1 more

Slow light based on four-wave mixing (FWM) wavelength conversion and dispersion is experimentally studied. The FWM bandwidth of the highly nonlinear fiber is measured to be 40 nm, which is also the slow light tunable bandwidth. A 34 ns delay of 500 MHz sine signal is achieved in standard single mode fiber, and 198 ns delay of short pulses with 100 ps width is achieved in dispersion compensation fiber (DCF). An advancement of 209 ns for the 100 ps short pulses is also achieved in the DCF. The method to increase the slow light delay is discussed, and large delay up to microseconds is expected when wideband FWM wavelength conversion and large dispersion fibers are used. The expected large delay will help us realize high efficiency fiber delay lines and all-fiber buffers.

Acta Physica Sinica•Jan 1, 2010•4 citations

Broad wavelength generation and conversion with multi modal Four Wave Mixing in silicon waveguides

Stefano Signorini, Mattia Mancinelli, Martino Bernard +3 more

The possibility to perform broad wavelength generation and conversion is of great interest in classical and quantum optics. With the introduction of integrated nonlinear silicon photonics, these tasks have been made even more viable thanks to the combination of the high nonlinear refractive index of silicon with the high confinement provided by the photonic waveguides. Exploiting this platform, several solutions for wavelength conversion have been investigated, for both optical processing [1] and applications in the Mid Infrared (MIR) [2]. The possibility to perform broad and controllable wavelength generation can be exploited also for creating integrated sources of quantum states of light based on single photons [3] or correlated photon pairs [4]. Both the generation and conversion can be accomplished by means of Four Wave Mixing (FWM). FWM is a nonlinear optical process in which two pump photons at frequency are converted into signal and idler photons at frequencies and ω/ respectively (with ωI/ωS). In the particular case of wavelength conversion, FWM is stimulated by a seed wave at the same wavelength of the signal (idler) that will be converted to the wavelength of the idler (signal). FWM has to satisfy the energy conservation, according to which the relation ωP+ ωP= ωS+ ωIholds, and its efficiency is ruled by the phase matching condition. This latter condition is related to the phase mismatch among the waves involved in the FWM process, that is evaluated as Δk = kp+ kp−kS−kI, where kP, kS, kIare the wavevectors for the pump, the signal and the idler, respectively. When Δk = 0, the phase matching condition is fulfilled and the efficiency of FWM is maximized. What is important for wavelength generation and conversion is the spectral position of the phase matching condition, which determines the wavelength at which the maximum efficiency of the conversion or generation process is achieved. Because of this, techniques for the control of the phase matching condition have been developed, focusing on the possibility to tailor the Group Velocity Dispersion (GVD) through a proper engineering of the waveguide geometry [5]. While these techniques consider only the first order waveguide mode, here we propose to exploit the higher order modes propagating inside a multimode waveguide. The dispersion of the higher order modes can be used to tune the spectral position of the phase matching condition for the FWM process, achieving controllable and large spectral translation in both Stimulated Four Wave Mixing (sFWM) and Spontaneous Four Wave Mixing (SFWM).

IEEE International Conference on Group IV Photonics (GFP)•Aug 1, 2017•7 citations

Four-wave mixing in slow light waveguides

Vishnupriya Govindan, Steve Blair

We study the effects of pulse distortion on four-wave mixing (FWM) for different slow-light architectures. REMZI has the highest FWM conversion. Distortion constraint limits the performance of FWM conversion in CROW with higher number of stages.

Advances in Optical Sciences Congress•Jan 1, 2009•0 citations

Detrimental effects in four wave mixing

Karsten K. Rottwitt, Thjalfe Ulvenberg, Lars Søgaard Rishøj +2 more

Four wave mixing (FWM) holds great promise as a tool to perform signal processing of classical light as well as of quantum states. However, typically FWM require use of high power pumps and as a consequence, the FWM process is accompanied by spontaneous Raman scattering as well as spontaneous FWM. In addition, FWM is also very sensitive to changes in the phase matching along propagation, caused by fluctuations in the core geometry of the fiber. In this work, we review recent progress in predicting and measuring the conversion efficiency and noise figure of wavelength conversion using FWM and we show consequences due fluctuations in the core geometry.

International Conference on Transparent Optical Networks•Jul 14, 2024•1 citation

Experimental study on slow light based on all-optical wavelength conversion and dispersion medium

Xiaoyu Fu, Dongfang Jia, Chunfeng Ge +3 more

Slow light delay based on all-optical wavelength conversion using four-wave mixing (FWM) and dispersion medium is experimentally studied. Firstly, all-optical wavelength conversion with band-width of 28.4nm (from 1549.3nm to 1520.9nm) by FWM in 1500m dispersion flattened highly nonlinear fiber (DF-HNLF) is realized. Then, the maximum delay of 12.0ns is experimentally achieved by transmitting the original signal and wavelength-converted signal in 3.88 km dispersion compensating fiber (DCF). The experimental results are in good agreement with the principles.

International Conference on Optical Communications and Networks (ICOCN)•Sep 1, 2016•0 citations

Stimulated four-wave mixing in a low footprint Q-InP channel waveguide

MUNEEB FAROOQ, Tanmay Mondal, Leidy Rodríguez +3 more

Four-wave mixing (FWM) offers promising applications in wavelength conversion, optical signal processing, and even quantum photonics. We report a study of stimulated FWM in a Q-InP channel waveguide fabricated at a commercial foundry (SMART Photonics). We performed FWM experiments and observed a nearly flat wavelength-conversion efficiency of -56.5 dB over a wide detuning range. This is attributed to the broadspectrum phase matching resulting from the small interaction length of 0.564 mm. The low-power pump and signal wavelengths are employed in these measurements to minimise absorption effects, such as two-photon absorption (TPA). Our results demonstrate that InP has high potential for nonlinear processes that require lower input power, such as spontaneous four-wave mixing (SFWM) for single-photon generation.

Integrated Photonics Platforms•May 29, 2026•0 citations
In ideal conditions the four wave mixing conversion efficiency is enhanced by the slowing down factor to the fourth power. We have investigated FWM. In ideal conditions the four wave mixing conversion efficiency is enhanced by the slowing down factor to the fourth power. We have investigated FWM in coupled resonator optical waveguides both numerically and experimentally this phenomena, also in presence of attenuation and chromatic dispersion.
Slow light based on four-wave mixing (FWM) wavelength conversion and dispersion is experimentally studied. The FWM bandwidth of the highly nonlinear fiber is measured to be 40 nm, which is also the slow light tunable bandwidth. A 34 ns delay of 500 MHz sine signal is achieved in standard single mode fiber, and 198 ns delay of short pulses with 100 ps width is achieved in dispersion compensation fiber (DCF). An advancement of 209 ns for the 100 ps short pulses is also achieved in the DCF. The method to increase the slow light delay is discussed, and large delay up to microseconds is expected when wideband FWM wavelength conversion and large dispersion fibers are used. The expected large delay will help us realize high efficiency fiber delay lines and all-fiber buffers.
The possibility to perform broad wavelength generation and conversion is of great interest in classical and quantum optics. With the introduction of integrated nonlinear silicon photonics, these tasks have been made even more viable thanks to the combination of the high nonlinear refractive index of silicon with the high confinement provided by the photonic waveguides. Exploiting this platform, several solutions for wavelength conversion have been investigated, for both optical processing [1] and applications in the Mid Infrared (MIR) [2]. The possibility to perform broad and controllable wavelength generation can be exploited also for creating integrated sources of quantum states of light based on single photons [3] or correlated photon pairs [4]. Both the generation and conversion can be accomplished by means of Four Wave Mixing (FWM). FWM is a nonlinear optical process in which two pump photons at frequency are converted into signal and idler photons at frequencies and ω/ respectively (with ωI/ωS). In the particular case of wavelength conversion, FWM is stimulated by a seed wave at the same wavelength of the signal (idler) that will be converted to the wavelength of the idler (signal). FWM has to satisfy the energy conservation, according to which the relation ωP+ ωP= ωS+ ωIholds, and its efficiency is ruled by the phase matching condition. This latter condition is related to the phase mismatch among the waves involved in the FWM process, that is evaluated as Δk = kp+ kp−kS−kI, where kP, kS, kIare the wavevectors for the pump, the signal and the idler, respectively. When Δk = 0, the phase matching condition is fulfilled and the efficiency of FWM is maximized. What is important for wavelength generation and conversion is the spectral position of the phase matching condition, which determines the wavelength at which the maximum efficiency of the conversion or generation process is achieved. Because of this, techniques for the control of the phase matching condition have been developed, focusing on the possibility to tailor the Group Velocity Dispersion (GVD) through a proper engineering of the waveguide geometry [5]. While these techniques consider only the first order waveguide mode, here we propose to exploit the higher order modes propagating inside a multimode waveguide. The dispersion of the higher order modes can be used to tune the spectral position of the phase matching condition for the FWM process, achieving controllable and large spectral translation in both Stimulated Four Wave Mixing (sFWM) and Spontaneous Four Wave Mixing (SFWM).
Four wave mixing (FWM) holds great promise as a tool to perform signal processing of classical light as well as of quantum states. However, typically FWM require use of high power pumps and as a consequence, the FWM process is accompanied by spontaneous Raman scattering as well as spontaneous FWM. In addition, FWM is also very sensitive to changes in the phase matching along propagation, caused by fluctuations in the core geometry of the fiber. In this work, we review recent progress in predicting and measuring the conversion efficiency and noise figure of wavelength conversion using FWM and we show consequences due fluctuations in the core geometry.
Slow light delay based on all-optical wavelength conversion using four-wave mixing (FWM) and dispersion medium is experimentally studied. Firstly, all-optical wavelength conversion with band-width of 28.4nm (from 1549.3nm to 1520.9nm) by FWM in 1500m dispersion flattened highly nonlinear fiber (DF-HNLF) is realized. Then, the maximum delay of 12.0ns is experimentally achieved by transmitting the original signal and wavelength-converted signal in 3.88 km dispersion compensating fiber (DCF). The experimental results are in good agreement with the principles.
Four-wave mixing (FWM) offers promising applications in wavelength conversion, optical signal processing, and even quantum photonics. We report a study of stimulated FWM in a Q-InP channel waveguide fabricated at a commercial foundry (SMART Photonics). We performed FWM experiments and observed a nearly flat wavelength-conversion efficiency of -56.5 dB over a wide detuning range. This is attributed to the broadspectrum phase matching resulting from the small interaction length of 0.564 mm. The low-power pump and signal wavelengths are employed in these measurements to minimise absorption effects, such as two-photon absorption (TPA). Our results demonstrate that InP has high potential for nonlinear processes that require lower input power, such as spontaneous four-wave mixing (SFWM) for single-photon generation.