Four-wave mixing (FWM) offers promising applications in wavelength conversion, optical signal processing, and even quantum photonics. We report a study of stimulated FWM in a Q-InP channel waveguide fabricated at a commercial foundry (SMART Photonics). We performed FWM experiments and observed a nearly flat wavelength-conversion efficiency of -56.5 dB over a wide detuning range. This is attributed to the broadspectrum phase matching resulting from the small interaction length of 0.564 mm. The low-power pump and signal wavelengths are employed in these measurements to minimise absorption effects, such as two-photon absorption (TPA). Our results demonstrate that InP has high potential for nonlinear processes that require lower input power, such as spontaneous four-wave mixing (SFWM) for single-photon generation.
Four-wave mixing (FWM) offers promising applications in wavelength conversion, optical signal processing, and even quantum photonics. We report a study of stimulated FWM in a Q-InP channel waveguide fabricated at a commercial foundry (SMART Photonics). We performed FWM experiments and observed a nearly flat wavelength-conversion efficiency of -56.5 dB over a wide detuning range. This is attributed to the broadspectrum phase matching resulting from the small interaction length of 0.564 mm. The low-power pump and signal wavelengths are employed in these measurements to minimise absorption effects, such as two-photon absorption (TPA). Our results demonstrate that InP has high potential for nonlinear processes that require lower input power, such as spontaneous four-wave mixing (SFWM) for single-photon generation.
Four-wave mixing (FWM) in silicon photonics offers promising applications in optical signal processing, wavelength conversion, and quantum photonics, necessitating a comprehensive understanding of its underlying physics and limitations. Stimulated four-wave mixing in silicon photonic wire waveguides has been investigated theoretically by considering two-photon absorption, free carrier absorption, and free carrier dispersion, etc., operating near λ∼1550 nm. It has been shown that these effects severely degrade the performance when operating at higher pump power levels. We present exact numerical calculations of idler wavelength conversion efficiency and bandwidth taking into account the abovementioned nonlinearities, to show the effects of various parameters within the waveguide structure. We extended to investigate silicon photonic microring resonators in terms of the four-wave mixing performance of high-Q-value microring resonators, which are very promising as photon sources (spontaneous four-wave mixing) for large-scale quantum photonic circuits. Our analysis illustrates the limitations of analytical models in describing FWM in ring resonator behavior at a moderate input power level, necessitating a rigorous numerical approach. Experimentally, we demonstrate stimulated FWM (1525 nm≤λp≤1575 nm) in a silicon photonic wire with a cross-section of 500 nm×220 nm and with a small waveguide length of 2 mm. The idler-to-signal conversion efficiency of about −35 dB has been measured for an approximate launched pump power of 30 mW. The conversion efficiency is improved further in the microring resonator as predicted by the simulation results.
In this work, we report the modeling and the experimental demonstration of intermodal spontaneous as well as stimulated four-wave mixing (FWM) in silicon waveguides.In intermodal FWM, the phase-matching condition is achieved by exploiting the different dispersion profiles of the optical modes in a multimode waveguide.Since both the energy and the wave vectors have to be conserved in the FWM process, this leads to a wide tunability of the generated photon wavelength, allowing us to achieve a large spectral conversion.We measured several waveguides that differ by their widths and demonstrate large signal generation spanning from the pump wavelength (1550 nm) down to 1202 nm.A suited setup evidences that the different waves propagated indeed on different order modes, which supports the modeling.Despite observing a reduced efficiency with respect to intramodal FWM due to the decreased modal overlap, we were able to show a maximum spectral distance between the signal and idler of 979.6 nm with a 1550 nm pump.Our measurements suggest the intermodal FWM is a viable means for large wavelength conversion and heralded photon sources.
The possibility to perform broad wavelength generation and conversion is of great interest in classical and quantum optics. With the introduction of integrated nonlinear silicon photonics, these tasks have been made even more viable thanks to the combination of the high nonlinear refractive index of silicon with the high confinement provided by the photonic waveguides. Exploiting this platform, several solutions for wavelength conversion have been investigated, for both optical processing [1] and applications in the Mid Infrared (MIR) [2]. The possibility to perform broad and controllable wavelength generation can be exploited also for creating integrated sources of quantum states of light based on single photons [3] or correlated photon pairs [4]. Both the generation and conversion can be accomplished by means of Four Wave Mixing (FWM). FWM is a nonlinear optical process in which two pump photons at frequency are converted into signal and idler photons at frequencies and ω/ respectively (with ωI/ωS). In the particular case of wavelength conversion, FWM is stimulated by a seed wave at the same wavelength of the signal (idler) that will be converted to the wavelength of the idler (signal). FWM has to satisfy the energy conservation, according to which the relation ωP+ ωP= ωS+ ωIholds, and its efficiency is ruled by the phase matching condition. This latter condition is related to the phase mismatch among the waves involved in the FWM process, that is evaluated as Δk = kp+ kp−kS−kI, where kP, kS, kIare the wavevectors for the pump, the signal and the idler, respectively. When Δk = 0, the phase matching condition is fulfilled and the efficiency of FWM is maximized. What is important for wavelength generation and conversion is the spectral position of the phase matching condition, which determines the wavelength at which the maximum efficiency of the conversion or generation process is achieved. Because of this, techniques for the control of the phase matching condition have been developed, focusing on the possibility to tailor the Group Velocity Dispersion (GVD) through a proper engineering of the waveguide geometry [5]. While these techniques consider only the first order waveguide mode, here we propose to exploit the higher order modes propagating inside a multimode waveguide. The dispersion of the higher order modes can be used to tune the spectral position of the phase matching condition for the FWM process, achieving controllable and large spectral translation in both Stimulated Four Wave Mixing (sFWM) and Spontaneous Four Wave Mixing (SFWM).
Integrated quantum signal sources play a key role in quantum communications in space, where compactness is of utmost importance. InP is an excellent candidate that can provide an on-chip single photon source as a device, where an excitation laser and waveguide for photon generation can be integrated on a single chip, because of its direct bandgap and high nonlinearity. However, one of the significant challenges that remains with InP is the elevated magnitude of the imaginary component of the third-order susceptibility ℑ[ χ (3) ] at 1550 nm wavelength. The higher value of ℑ[ χ (3) ] leads to two-photon absorption (TPA) and free carrier absorption (FCA) at very low powers, which drastically impacts the photon generation rate. In this paper, HHI and IMOS-based channel waveguides are modelled for the first time as an integrated platform for single photon generation, exploring spontaneous four-wave mixing (SFWM), considering TPA and FCA effects. The IMOS-based waveguide is more dynamic in generating entangled photons over a broader wavelength range, which would benefit photon demultiplexing at later stages. Nonlinear losses become dominant at power levels of 11 mW and 2 mW in HHI and IMOS waveguides, respectively, saturating the generation of single photons. TPA-free photon generation rates at these respective power levels are 4.1 MHz and 4.6 MHz , with generation bandwidths of 12.6 nm and 20.1 nm in the HHI channel and waveguide based on the IMOS platform, respectively. The saturated generation rates obtained are close to 0.15 GHz for both platforms. The on-chip monolithic integration of lasers with the proposed devices will potentially lead to more compact and stable single photon sources without relying on external lasers, in the telecommunications regime.
The generation of entangled photons by spontaneous parametric down-conversion (SPDC) or spontaneous four-wave mixing (SFWM) attracted enormous interest in the field of quantum optics. Depending on applications, entangled photon sources prioritize either bandwidth (e.g. for quantum imaging) or brightness (e.g. for quantum key distribution). Layered materials offer unique advantages for both. They have already been used to realize thinnest SPDC sources [1], which, like other layered materials such as transition-metal dichalcogenides (TMDs) [2], offer nearly unlimited bandwidth thanks to relaxed phase-matching constraints. Further, their easy integration on photonic platforms is promising for bright on-chip entangled photon sources. In this context, SPDC-based solutions are limited by phase-matching, whereas SFWM would be an almost phase-matching-free process, as pump, idler, and signal photons can be generated at similar wavelengths, thus propagating at the same group velocity in integrated devices. Moreover, exploiting excitonic resonances could enhance FWM even more. However, to date, experiments with resonant FWM in TMDs have been limited to signals in the visible [3], which is unsuitable for integrated photonics and telecom systems due to reabsorption during propagation in the photonic device.
Four wave mixing (FWM) holds great promise as a tool to perform signal processing of classical light as well as of quantum states. However, typically FWM require use of high power pumps and as a consequence, the FWM process is accompanied by spontaneous Raman scattering as well as spontaneous FWM. In addition, FWM is also very sensitive to changes in the phase matching along propagation, caused by fluctuations in the core geometry of the fiber. In this work, we review recent progress in predicting and measuring the conversion efficiency and noise figure of wavelength conversion using FWM and we show consequences due fluctuations in the core geometry.