Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Analysis of a high-temperature superconductor quantum flux parametron operating at 77 K

Mark Jeffery

Published Jan 1, 1995• 4 citations
Publisher

Abstract

A Quantum Flux Parametron (QFP) circuit designed for implementation with high-temperature superconductors is analyzed with thermal noise at 77 K. Experimental considerations are discussed and design parameters given for fabrication of the device using a YBa/sub 2/Cu/sub 3/O/sub 7/ thin film on a SrTiO/sub 3/ bicrystal substrate. An application of the high T/sub c/ QFP for the detection of single flux quantum pulses is also described.

DOI
10.1109/77.482144

Related papers

Design and fabrication of QFP logic gates based on YBa/sub 2/Cu/sub 3/O/sub 7/ step-edge junctions

H. Hasegawa, Y. Tarutani, Uki Kabasawa +3 more

Quantum Flux Parametron (QFP) logic gates were designed and fabricated from a single layer of YBa/sub 2/Cu/sub 3/O/sub 7/ thin film based on step-edge Josephson junctions. Self-inductance (L) of the QFP loop, an important circuit parameter, as is critical current (J/sub c/) of the Josephson junction, was determined by using directly coupled dc superconducting quantum interference devices (SQUIDs). Magnetically coupled dc SQUIDs were used to detect the output signal from the QFP. Simulated waveforms were used to identify the operation modes of the QFP as a function of the circuit parameters. From examination of the output waveforms of the QFP, operation in agreement with simulations was confirmed.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•4 citations

High-temperature superconductor quantum flux parametron for energy efficient logic

Han Cai, Jay C. LeFebvre, Hao Li +3 more

We report the fabrication and measurement of quantum flux parametron logic from high-transition-temperature Josephson junctions operating at 25 K, above the temperature of liquid helium. The circuits are written directly into the plane of a single-layer thin film of YBa2Cu3O7 using a focused helium ion beam. A single-cell quantum flux parametron was constructed and correct logic operation was verified by using an on-chip superconducting quantum interference device for readout. A three-cell shift register was also fabricated and tested using a three-phase clock cycle. We estimate the average bit energy to be about 1×10−20 J at 1 GHz.

arXiv:2305.14184•Applied Physics Letters•May 20, 2024•8 citations

Quantum flux parametron: a single quantum flux device for Josephson supercomputer

M. Hosoya, W. Hioe, Juan Casas +6 more

A quantum flux parametron (QFP), a single quantum flux superconductive device that has a potential of up to 100-GHz switching with nW-order power dissipation, is considered. The potential of the QFP and key technologies when QFPs are applied to a Josephson supercomputer are described. Switching speed, stability, and power dissipation of a QFP are discussed. QFP gates, circuits, and systems are next described. Then, ultra-fast clock distribution using a standing wave is explained. High-speed operation at more than 10 GHz and 10/sup 14/ error-free operations per QFP have been demonstrated. Finally described is a high-density packaging scheme by three-dimensional integration, which is very important for ultra-high speed circuits because the propagation delay becomes dominant in such circuits.>

IEEE Transactions on Applied Superconductivity•Jun 1, 1991•149 citations

Noise analysis of the quantum flux parametron

H.L. Ko, G.S. Lee

An analysis of the limitations imposed by thermal noise on the application of the quantum flux parametrons (QFPs) as current comparators and timing discriminators is presented. At low operational frequencies, a thermal activation approach is used, while at high frequencies a circuit simulation method is required. At frequencies greater than the Josephson junction plasma frequency, an approximate expression for the noise is given. The calculations are in good agreement with the approximations and the experimental results.>

IEEE Transactions on Applied Superconductivity•Jan 1, 1992•28 citations

abrication of QFP Logic Gates Based on YBa2Cu3O7 Step-Edge Junctions

H. Hasegawa, Yoshinobu Tarutani, Uki Kabasawa +3 more

Abstruct-Quantum Flux Parametron (QFP) logic gates were designed and fabricated from a single layer of YJ3a2Cu307 thin film based on step-edge Josephson junctions. Self-inductance (L) of the QFP loop, an important circuit parameter, as is critical current (I,) of the Josephson junction, was determined by using directly coupled dc superconducting quantum interference devices (SQUIDS). Magnetically coupled dc SQUIDs were used to detect the output signal from the QFP. Simulated waveforms were used to identify the operation modes of the QFP as a function of the circuit parameters. From examination of the output waveforms of the QFP, operation in agreement with simulations was confirmed.

•Jan 1, 1997•0 citations

Quantum Flux Parametron: A Single Quantum Flux Superconducting Logic Device

W. Hioe, Eiichi Goto

This book concerns a Josephson device for supercomputers which has extremely low heat dissipation (about 106 times less than semiconductor devices and 103 times less than voltage-based Josephson devices). In the previous book on Quantum Flux Parametrons (QFPs), DC Flux Parametron, the basic device operation are described. This book deals in much greater depth on the problems which are faced by the QFP. The device characteristics are worked out in detail showing clearly the analysis methods used. A new logic gate using the QFP is described with respect to its basic scheme, operation, and ways for forming logic circuits. The problems faced by the basic QFP are much reduced in the new logic gate. As the QFP operates near the Heisenberg and Boltzmann limits for computing devices, we also show the relationship between speed and stability. The book contains the latest analytical results on QFPs. The material presented in the book can be understood with very little mathematical training or knowledge about superconducting physics. It is also self-contained and does not require reading of other material. Most of the device characteristics can be reproduced from the equations given using simple programs. A circuit simulator is not needed except for high speeds when transient behavior becomes important

WORLD SCIENTIFIC eBooks•Mar 1, 1991•15 citations
A Quantum Flux Parametron (QFP) circuit designed for implementation with high-temperature superconductors is analyzed with thermal noise at 77 K. Experimental considerations are discussed and design parameters given for fabrication of the device using a YBa/sub 2/Cu/sub 3/O/sub 7/ thin film on a SrTiO/sub 3/ bicrystal substrate. An application of the high T/sub c/ QFP for the detection of single flux quantum pulses is also described.
Quantum Flux Parametron (QFP) logic gates were designed and fabricated from a single layer of YBa/sub 2/Cu/sub 3/O/sub 7/ thin film based on step-edge Josephson junctions. Self-inductance (L) of the QFP loop, an important circuit parameter, as is critical current (J/sub c/) of the Josephson junction, was determined by using directly coupled dc superconducting quantum interference devices (SQUIDs). Magnetically coupled dc SQUIDs were used to detect the output signal from the QFP. Simulated waveforms were used to identify the operation modes of the QFP as a function of the circuit parameters. From examination of the output waveforms of the QFP, operation in agreement with simulations was confirmed.
We report the fabrication and measurement of quantum flux parametron logic from high-transition-temperature Josephson junctions operating at 25 K, above the temperature of liquid helium. The circuits are written directly into the plane of a single-layer thin film of YBa2Cu3O7 using a focused helium ion beam. A single-cell quantum flux parametron was constructed and correct logic operation was verified by using an on-chip superconducting quantum interference device for readout. A three-cell shift register was also fabricated and tested using a three-phase clock cycle. We estimate the average bit energy to be about 1×10−20 J at 1 GHz.
A quantum flux parametron (QFP), a single quantum flux superconductive device that has a potential of up to 100-GHz switching with nW-order power dissipation, is considered. The potential of the QFP and key technologies when QFPs are applied to a Josephson supercomputer are described. Switching speed, stability, and power dissipation of a QFP are discussed. QFP gates, circuits, and systems are next described. Then, ultra-fast clock distribution using a standing wave is explained. High-speed operation at more than 10 GHz and 10/sup 14/ error-free operations per QFP have been demonstrated. Finally described is a high-density packaging scheme by three-dimensional integration, which is very important for ultra-high speed circuits because the propagation delay becomes dominant in such circuits.>
An analysis of the limitations imposed by thermal noise on the application of the quantum flux parametrons (QFPs) as current comparators and timing discriminators is presented. At low operational frequencies, a thermal activation approach is used, while at high frequencies a circuit simulation method is required. At frequencies greater than the Josephson junction plasma frequency, an approximate expression for the noise is given. The calculations are in good agreement with the approximations and the experimental results.>
Abstruct-Quantum Flux Parametron (QFP) logic gates were designed and fabricated from a single layer of YJ3a2Cu307 thin film based on step-edge Josephson junctions. Self-inductance (L) of the QFP loop, an important circuit parameter, as is critical current (I,) of the Josephson junction, was determined by using directly coupled dc superconducting quantum interference devices (SQUIDS). Magnetically coupled dc SQUIDs were used to detect the output signal from the QFP. Simulated waveforms were used to identify the operation modes of the QFP as a function of the circuit parameters. From examination of the output waveforms of the QFP, operation in agreement with simulations was confirmed.
This book concerns a Josephson device for supercomputers which has extremely low heat dissipation (about 106 times less than semiconductor devices and 103 times less than voltage-based Josephson devices). In the previous book on Quantum Flux Parametrons (QFPs), DC Flux Parametron, the basic device operation are described. This book deals in much greater depth on the problems which are faced by the QFP. The device characteristics are worked out in detail showing clearly the analysis methods used. A new logic gate using the QFP is described with respect to its basic scheme, operation, and ways for forming logic circuits. The problems faced by the basic QFP are much reduced in the new logic gate. As the QFP operates near the Heisenberg and Boltzmann limits for computing devices, we also show the relationship between speed and stability. The book contains the latest analytical results on QFPs. The material presented in the book can be understood with very little mathematical training or knowledge about superconducting physics. It is also self-contained and does not require reading of other material. Most of the device characteristics can be reproduced from the equations given using simple programs. A circuit simulator is not needed except for high speeds when transient behavior becomes important