Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physica C Superconductivity

Kinetic inductance of coupled superconducting microstrip lines

Jiahao Kang, R.Q. Han, G. C. Xiong, X.Y. Liu, Y.Y. Wang

Published Aug 1, 1997• 1 citation
Publisher
DOI
10.1016/s0921-4534(97)01333-6

Related papers

Simple formulae for kinetic inductance of coupled superconducting microstrip lines

Jinfeng Kang, Ruqi Han, Guangcheng Xiong +2 more

Simple formulae for the kinetic inductance of coupled superconducting microstrip lines in odd mode and even mode have been derived by using the conformal mapping technique. Based on the simple formulae, the geometrical effects of kinetic inductance in odd mode and even mode are analyzed and compared with those of magnetic inductance. The coupling effects of two proximity microstrip lines caused by the kinetic inductance are also studied. The kinetic inductance is dominant for smaller geometrical sizes but is less important than the magnetic inductance for larger geometrical sizes.

Journal of Applied Physics•Feb 15, 1997•1 citation

Inductances in Superconducting Circuits

Pascal Febvre

•Feb 19, 2018•0 citations

Superconducting Microwave Circuits with High Kinetic Inductance Materials in High Magnetic Fields

Azarin Zarassi, Jen‐Feng Hsu, Tzu-Chiao Chien +3 more

Bulletin of the American Physical Society•Mar 8, 2019•0 citations

Measurements and Modeling of Kinetic Inductance Microstrip Delay Lines

J.M. Pond, J. H. Claassen, William L. Carter

Superconducting microstrip, with phase velocities of about 0.01c, employing kinetic inductance have been fabricated using niobium nitride and a silicon dielectric. Delay lines using this phenomenon have several advantages for analog signal processing, including low loss and very compact size. Measurements of kinetic inductance microstrip delay lines were made in the frequency domain and the time domain. The results were compared to theoretical predictions and an accurate circuit model was developed. The circuit model was used to determine the frequency- and temperature-dependent losses of the delay line.

IEEE Transactions on Microwave Theory and Techniques•Dec 1, 1987•51 citations

Experimental investigation of superconducting microwave microstrip lines

Orest G. Vendik, A. Ya. Zaionchkovskii, S. Kolesov +2 more

Technical Physics•Oct 1, 1987•0 citations

Modeling losses in microstrip traveling wave kinetic inductance parametric amplifiers using the four and three wave mixing effect

Valenzuela Henríquez, Daniel Alejandro

The performance of an amplifier is based on a high gain and a low noise. To minimize \nthe noise problem at high frequencies, the superconducting parametric amplifier has been \ndeveloped. It is a system that uses a non-linear process and a strong reference to transfer \nthe energy to the original signal and their harmonics. Two types of processes are discussed in \nthis thesis, the Four and Three-wave mixing (FWM and TWM). \nOne implementation is the travelling-wave kinetic inductance parametric amplifier (TKIPA). \nIt consists of a superconducting transmission line (TL), which uses its non-linear inductance \nto transfer the energy to the input signal. With the appropriated design, the blocking of \nundesirable harmonics to concentrate the power in the signal (and not in the harmonics) \nis possible. The first implementation of the TKIPA used a coplanar wave-guide (CPW), \nwhere impedances near 50 Ω are difficult to achieve. In this thesis, a TKIPA was designed \nusing a microstrip. A 50 Ω microstrip line is easier to obtain, circumventing the problem of \nimpedance mismatch with output electronics. \nWe have presented two designs of a TKIPA based on superconducting microstrip, supporting FWM and TWM, respectively. Simulation results show that the designs blocked \nthe undesirable frequencies, while obtaining a ≈ 50 Ω line. The losses in the device do not \ndeteriorate significantly the performance of the device.

•Jan 1, 2020•1 citation
Simple formulae for the kinetic inductance of coupled superconducting microstrip lines in odd mode and even mode have been derived by using the conformal mapping technique. Based on the simple formulae, the geometrical effects of kinetic inductance in odd mode and even mode are analyzed and compared with those of magnetic inductance. The coupling effects of two proximity microstrip lines caused by the kinetic inductance are also studied. The kinetic inductance is dominant for smaller geometrical sizes but is less important than the magnetic inductance for larger geometrical sizes.
Superconducting microstrip, with phase velocities of about 0.01c, employing kinetic inductance have been fabricated using niobium nitride and a silicon dielectric. Delay lines using this phenomenon have several advantages for analog signal processing, including low loss and very compact size. Measurements of kinetic inductance microstrip delay lines were made in the frequency domain and the time domain. The results were compared to theoretical predictions and an accurate circuit model was developed. The circuit model was used to determine the frequency- and temperature-dependent losses of the delay line.
The performance of an amplifier is based on a high gain and a low noise. To minimize \nthe noise problem at high frequencies, the superconducting parametric amplifier has been \ndeveloped. It is a system that uses a non-linear process and a strong reference to transfer \nthe energy to the original signal and their harmonics. Two types of processes are discussed in \nthis thesis, the Four and Three-wave mixing (FWM and TWM). \nOne implementation is the travelling-wave kinetic inductance parametric amplifier (TKIPA). \nIt consists of a superconducting transmission line (TL), which uses its non-linear inductance \nto transfer the energy to the input signal. With the appropriated design, the blocking of \nundesirable harmonics to concentrate the power in the signal (and not in the harmonics) \nis possible. The first implementation of the TKIPA used a coplanar wave-guide (CPW), \nwhere impedances near 50 Ω are difficult to achieve. In this thesis, a TKIPA was designed \nusing a microstrip. A 50 Ω microstrip line is easier to obtain, circumventing the problem of \nimpedance mismatch with output electronics. \nWe have presented two designs of a TKIPA based on superconducting microstrip, supporting FWM and TWM, respectively. Simulation results show that the designs blocked \nthe undesirable frequencies, while obtaining a ≈ 50 Ω line. The losses in the device do not \ndeteriorate significantly the performance of the device.