Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Experimental demonstration of superconducting bandpass delta-sigma modulator

John F. Bulzacchelli, Hae-Seung Lee, James A. Misewich, M. B. Ketchen

Published Jun 1, 2003• 12 citations
Publisher

Abstract

Superconducting bandpass delta-sigma (/spl Delta//spl Sigma/) modulators are being developed for direct analog-to-digital conversion of radio frequency signals in the GHz range. Recently we demonstrated operation of a superconducting bandpass /spl Delta//spl Sigma/ modulator with the highest center frequency (2.23 GHz) and sampling rate (up to 45 GHz) reported to date. The test chip used in that experiment includes an integrated acquisition memory, which eliminates the need for very high speed interfacing. This paper describes key implementation details of this complex test chip, which contains 4065 Josephson junctions. The paper also explains how magnetic coupling from large power supply currents can be reduced through the use of optically-isolated current sources with independent grounds. The measured output spectra of the modulator at a 45 GHz sampling rate are presented.

DOI
10.1109/tasc.2003.813903

Related papers

Superconducting bandpass ΔΣ modulator with 2.23-GHz center frequency and 42.6-GHz sampling rate

John F. Bulzacchelli, Hae-Seung Lee, James A. Misewich +1 more

This paper presents a superconducting bandpass /spl Delta//spl Sigma/ modulator for direct analog-to-digital conversion of radio frequency signals in the gigahertz range. The design, based on a 2.23-GHz microstrip resonator and a single flux quantum comparator, exploits several advantages of superconducting electronics: the high quality factor of resonators, the fast switching speed of the Josephson junction, natural quantization of voltage pulses, and high circuit sensitivity. The modulator test chip includes an integrated acquisition memory for capturing output data at sampling rates up to 45 GHz. The small size (256 b) of the acquisition memory limits the frequency resolution of spectra based on standard fast Fourier transforms. Output spectra with enhanced resolution are obtained with a segmented correlation method. At a 42.6-GHz sampling rate, the measured SNR is 49 dB over a 20.8-MHz bandwidth, and a full-scale (FS) input is -17.4 dBm. At a 40.2-GHz sampling rate, the measured in-band noise is -57 dBFS over a 19.6-MHz bandwidth. The modulator test chip contains 4065 Josephson junctions and dissipates 1.9 mW at T=4.2 K.

IEEE Journal of Solid-State Circuits•Dec 1, 2002•21 citations

Superconducting bandpass ΔΣ modulator with 2.23 GHz center frequency and 42.6 GHz sampling rate

John F. Bulzacchelli, Hae-Seung Lee, James A. Misewich +1 more

A superconducting bandpass /spl Delta//spl Sigma/ modulator employing a 2.23 GHz microstrip resonator and a single flux quantum comparator clocked at 42.6 GHz achieves 49 dB peak SNR over a 20.8 MHz bandwidth. At 40.2 GHz clock rate, in-band noise over a 19.6 MHz bandwidth is -57 dBFS. The test chip with integrated acquisition memory contains 4065 Josephson junctions and dissipates 1.9 mW at T=4.2K.

Digest of technical papers/Digest of technical papers - IEEE International Solid-State Circuits Conference•Jun 25, 2003•13 citations

Superconducting bandpass delta-sigma modulator

John F. Bulzacchelli, H.-S. Lee, James A. Misewich +1 more

Bandpass delta-sigma modulators digitize narrowband signals with high dynamic range and linearity. The required sampling rate is only a few times higher than the centre frequency of the input. This paper presents a superconducting bandpass delta-sigma modulator for direct analogue-to-digital conversion of RF signals in the GHz range. The input signal is capacitively coupled to one end of a microstrip transmission line, and a single flux quantum balanced comparator quantizes the current flowing out of the other end. Quantization noise is suppressed at the quarter-wave resonance of the transmission line (about 2 GHz in our design). Circuit performance at a 20 GHz sampling rate has been studied with several long JSIM simulations. Full-scale (FS) input sensitivity is 20 mV (rms), and in-band noise is -53 dBFS and -57 dBFS over bandwidths of 39 MHz and 19.5 MHz, respectively. In-band intermodulation distortion is better than -69 dBFS.

Superconductor Science and Technology•Nov 1, 1999•12 citations

Analogue demonstration of a high temperature superconducting sigma-delta modulator with 27 GHz sampling

Martin G. Forrester, B. D. Hunt, Donald L. Miller +2 more

We have successfully fabricated and tested a high temperature superconducting (HTS) sigma-delta modulator for analogue-to-digital conversion. This is the first demonstration of a GHz sampling A-to-D in HTS. The 15-junction single-flux-quantum (SFQ) circuit, fabricated using an epitaxial multilayer HTS process with YBCO/Co-YBCO/YBCO edge junctions, was internally clocked at 27 GHz and used to convert a 5.01 MHz signal. The modulator demonstrated a spur-free dynamic range of more than 75 dB. Two-tone measurements with 5.01 MHz and 5.51 MHz signals demonstrated third-order intermodulation products to be lower than -59 dBc. Demonstration of a functional HTS modulator represents a significant milestone in the development of high dynamic range ADCs suitable for such applications as surveillance radar.

Superconductor Science and Technology•Nov 1, 1999•11 citations

Dc-characteristics of a high-Tcsuperconducting sigma–delta modulator using interface-engineered Josephson junctions

K. Saitoh, Yoshihisa Soutome, Tokuumi Fukazawa +1 more

We fabricated and tested a high-temperature superconducting (HTS) sigma–delta modulator using interface-engineered Josephson junctions. Proper dc-characteristics were obtained with a sampling frequency of 100 GHz at 20 K. To achieve high-speed sampling, Josephson junctions with a higher critical-current normal-resistance product were used. Circuit simulations with thermal noise were performed for the analysis of switching characteristics and SFQ dynamics.

Superconductor Science and Technology•Jan 18, 2002•9 citations

Design of Front-End Circuit for Superconductive A/D Converter and Demonstration of Operation Up to 43 GHz

Futoshi Furuta, K. Saitoh, Kazumasa Takagi

We designed a front-end circuit for an analog-to-digital (A/D) converter based on single flux quantum circuitry and tested its functionality at a frequency of up to 43 GHz. The front-end circuit consisted of a pulse generator, a sigma-delta modulator, a 1-to-8 demultiplexer (DEMUX), and superconducting quantum interference device (SQUID) amplifiers. There were 2518 Josephson junctions in the front-end circuit. To operate the circuit at high speed, we designed robust timing against variations in circuit parameters. By using circuit simulations based on the Monte Carlo method, we estimated spread in time lag between clock and data pulses. From this estimate, the timing was optimized to operate the circuit at 40 GHz. The demonstration of the front-end circuit was carried out using the on-chip testing method. Output data were acquired from the modulator through DEMUX. We confirmed proper sigma-delta modulation by analyzing the dependence of the density "1" in the output data on input current level. The proper operation was confirmed in a range of 37-43 GHz. Furthermore, the amplification by the SQUID amplifier was also confirmed at low speed. These results indicate the complete operation of the front-end circuit for superconductive A/D converter.

IEEE Transactions on Applied Superconductivity•Mar 1, 2004•10 citations
Superconducting bandpass delta-sigma (/spl Delta//spl Sigma/) modulators are being developed for direct analog-to-digital conversion of radio frequency signals in the GHz range. Recently we demonstrated operation of a superconducting bandpass /spl Delta//spl Sigma/ modulator with the highest center frequency (2.23 GHz) and sampling rate (up to 45 GHz) reported to date. The test chip used in that experiment includes an integrated acquisition memory, which eliminates the need for very high speed interfacing. This paper describes key implementation details of this complex test chip, which contains 4065 Josephson junctions. The paper also explains how magnetic coupling from large power supply currents can be reduced through the use of optically-isolated current sources with independent grounds. The measured output spectra of the modulator at a 45 GHz sampling rate are presented.
This paper presents a superconducting bandpass /spl Delta//spl Sigma/ modulator for direct analog-to-digital conversion of radio frequency signals in the gigahertz range. The design, based on a 2.23-GHz microstrip resonator and a single flux quantum comparator, exploits several advantages of superconducting electronics: the high quality factor of resonators, the fast switching speed of the Josephson junction, natural quantization of voltage pulses, and high circuit sensitivity. The modulator test chip includes an integrated acquisition memory for capturing output data at sampling rates up to 45 GHz. The small size (256 b) of the acquisition memory limits the frequency resolution of spectra based on standard fast Fourier transforms. Output spectra with enhanced resolution are obtained with a segmented correlation method. At a 42.6-GHz sampling rate, the measured SNR is 49 dB over a 20.8-MHz bandwidth, and a full-scale (FS) input is -17.4 dBm. At a 40.2-GHz sampling rate, the measured in-band noise is -57 dBFS over a 19.6-MHz bandwidth. The modulator test chip contains 4065 Josephson junctions and dissipates 1.9 mW at T=4.2 K.
Bandpass delta-sigma modulators digitize narrowband signals with high dynamic range and linearity. The required sampling rate is only a few times higher than the centre frequency of the input. This paper presents a superconducting bandpass delta-sigma modulator for direct analogue-to-digital conversion of RF signals in the GHz range. The input signal is capacitively coupled to one end of a microstrip transmission line, and a single flux quantum balanced comparator quantizes the current flowing out of the other end. Quantization noise is suppressed at the quarter-wave resonance of the transmission line (about 2 GHz in our design). Circuit performance at a 20 GHz sampling rate has been studied with several long JSIM simulations. Full-scale (FS) input sensitivity is 20 mV (rms), and in-band noise is -53 dBFS and -57 dBFS over bandwidths of 39 MHz and 19.5 MHz, respectively. In-band intermodulation distortion is better than -69 dBFS.
We have successfully fabricated and tested a high temperature superconducting (HTS) sigma-delta modulator for analogue-to-digital conversion. This is the first demonstration of a GHz sampling A-to-D in HTS. The 15-junction single-flux-quantum (SFQ) circuit, fabricated using an epitaxial multilayer HTS process with YBCO/Co-YBCO/YBCO edge junctions, was internally clocked at 27 GHz and used to convert a 5.01 MHz signal. The modulator demonstrated a spur-free dynamic range of more than 75 dB. Two-tone measurements with 5.01 MHz and 5.51 MHz signals demonstrated third-order intermodulation products to be lower than -59 dBc. Demonstration of a functional HTS modulator represents a significant milestone in the development of high dynamic range ADCs suitable for such applications as surveillance radar.
We designed a front-end circuit for an analog-to-digital (A/D) converter based on single flux quantum circuitry and tested its functionality at a frequency of up to 43 GHz. The front-end circuit consisted of a pulse generator, a sigma-delta modulator, a 1-to-8 demultiplexer (DEMUX), and superconducting quantum interference device (SQUID) amplifiers. There were 2518 Josephson junctions in the front-end circuit. To operate the circuit at high speed, we designed robust timing against variations in circuit parameters. By using circuit simulations based on the Monte Carlo method, we estimated spread in time lag between clock and data pulses. From this estimate, the timing was optimized to operate the circuit at 40 GHz. The demonstration of the front-end circuit was carried out using the on-chip testing method. Output data were acquired from the modulator through DEMUX. We confirmed proper sigma-delta modulation by analyzing the dependence of the density "1" in the output data on input current level. The proper operation was confirmed in a range of 37-43 GHz. Furthermore, the amplification by the SQUID amplifier was also confirmed at low speed. These results indicate the complete operation of the front-end circuit for superconductive A/D converter.